Phase control of the Kerr nonlinearity in electromagnetically induced transparency media

We investigate an enhancement of the Kerr nonlinearity in phase-dependent double electromagnetically induced transparency (EIT) media. We find, by changing the relative phase of the driven fields, that the properties of EIT and the Kerr nonlinearity can be modified significantly. Choosing the relative phase appropriately, a giant Kerr nonlinearity can be achieved with vanishing absorptions.

Role of absorption in grating erasure

In this paper, we have investigated the grating erasure of a reduced LiNbO3:Fe crystal with different erasing wavelengths. The overall hologram evolution in the process of grating erasure is nonexponential due to strong absorption which is contrary to the mono-exponential law. The hologram in the rear part of the crystal can persist for a long time in the grating erasure due to weak erasing light intensity by strong absorption, which can enlarge the erasure time constant. From the erasure experiments, the global absorption ad 5 can be taken as the optimum absorption to acquire a good trade-off between the sensitivity and hologram strength in the crystal. (c) 2006 Elsevier GmbH. All rights reserved.

Evolución geodinámica poliorogénica de los dominios septentrionales de la zona de Ossa Morena

377 p.

Experimental study of Ti : sapphire laser end-pumped Nd : YAG ceramic laser Q-switched by Cr4+: YAG saturable absorber

By employing a continuous-wave (CW) Ti:sapphire tunable laser as a pumping source and a Cr4+:YAG single crystal as the saturable absorber (SA), a passively Q-switched Nd:YAG ceramic laser has been demonstrated at room temperature. With an absorbed pumping power of 541 mW at 808 nm, an average output power of 61 mW at 1064 nm has been obtained with 3.5 mu J pulse energy, 15 ns pulse width and 18.18 kHz repetition rate, and the corresponding slope-efficiency is 15%. The relationships between the pulse width, repetition rate, average output power, pulse energy, and peak power on the absorbed pumping power for different initial transmission of the Cr4+:YAG SA are discussed separately. The Nd:YAG ceramic is one of the most promising laser materials for compact, efficient, all-solid-state pulsed lasers.

不同氧磷比对磷酸盐包边玻璃性质的影响规律

包边技术是提高大尺寸激光玻璃饱和增益系数的关键技术。采用传统的方法熔制玻璃,研究了 P2O5含量对 P2O5-Al2O3-B2O3-CuCl-Na2O-ZnO磷酸盐包边玻璃的折射率、热膨胀系数、玻璃转变温度、膨胀软化温度以及化学稳定性的影响。结果表明：当 P2O5的摩尔分数为 60%左右,玻璃样品具有最高的折射率（1.522 0）、最低的玻璃转变温度（352.4 ℃）、较好的化学稳定性[0.52 mg/（cm^2·d）]和适宜的热膨胀系数（128.427×10^-7/℃）,是用作钕磷酸盐激光玻璃硬包边的理

Investigation on properties of TiO2 thin films deposited at different oxygen pressures

TiO2 thin films were prepared by electron beam evaporation at different oxygen partial pressures. The influences of oxygen partial pressure on optical, mechanical and structural properties of TiO2 thin films were studied. The results showed that with the increase of oxygen partial pressure, the optical transmittance gradually increased, the transmittance edge gradually shifted to short wavelength, and the corresponding refractive index decreased. The residual stresses of all samples were tensile, and the value increased as oxygen partial pressure increasing, which corresponded to the evolutions of the packing densities. The structures of TiO2 thin films all were amorphous because deposition particles did not possess enough energy to crystallize. (C) 2007 Elsevier Ltd. All rights reserved.