Dynamics of dense sheared granular flows. Part II. The relative velocity distributions

The distribution of relative velocities between colliding particles in shear flows of inelastic spheres is analysed in the Volume fraction range 0.4-0.64. Particle interactions are considered to be due to instantaneous binary collisions, and the collision model has a normal coefficient of restitution e(n) (negative of the ratio of the post- and pre-collisional relative velocities of the particles along the line joining the centres) and a tangential coefficient of restitution e(t) (negative of the ratio of post- and pre-collisional velocities perpendicular to line joining the centres). The distribution or pre-collisional normal relative velocities (along the line Joining the centres of the particles) is Found to be an exponential distribution for particles with low normal coefficient of restitution in the range 0.6-0.7. This is in contrast to the Gaussian distribution for the normal relative velocity in all elastic fluid in the absence of shear. A composite distribution function, which consists of an exponential and a Gaussian component, is proposed to span the range of inelasticities considered here. In the case of roughd particles, the relative velocity tangential to the surfaces at contact is also evaluated, and it is found to be close to a Gaussian distribution even for highly inelastic particles.Empirical relations are formulated for the relative velocity distribution. These are used to calculate the collisional contributions to the pressure, shear stress and the energy dissipation rate in a shear flow. The results of the calculation were round to be in quantitative agreement with simulation results, even for low coefficients of restitution for which the predictions obtained using the Enskog approximation are in error by an order of magnitude. The results are also applied to the flow down an inclined plane, to predict the angle of repose and the variation of the volume fraction with angle of inclination. These results are also found to be in quantitative agreement with previous simulations.

Nutritional status of a nereidid polychaete cultured in sand filters of mariculture wastewater

This study examined the nutritional composition of the intertidal marine polychaete Perinereis helleri (Nereididae)when artificially cultured in sand filters treating mariculture wastewater. Moisture levels in harvested P. helleri ranged from 758 to 855 g kg1, and ash, from 23 to 61 g kg1 wet matter (WM). Stocking density and graded size after harvest significantly affected their composition. Higher total lipid contents were found in large (>0.6 g) P. helleri(16–19 g kg1 WM) and those grown at the lowest density(1000 m2: 18 g kg 1 WM) than in small (≤0.6 g) ones (14 g kg1 WM) and those grown at the highest densities (4000–6000 m2: 13–16 g kg1 WM). Several fatty acids within a very broad profile (some 30 identified) reflected this pattern, yet their ARA/EPA/DHA ratios were relatively unaffected. Feeding the polychaete-assisted sand filters (PASF) with fish meal to increase worm biomass productivity significantly increased their DHA content. Other components (e.g. protein, phospholipids, cholesterol, carbohydrate, amino acids, nitrogen, minerals and bromophenols) and nutritional factors (e.g. maturity, feeding seaweed and endemic shrimp viral content) were also investigated. Results suggest that PASF-produced P. helleri have a well-balanced nutritional profile for penaeid shrimp and fish broodstock.

A simple method of estimating the detonation velocity from chemical composition of organic explosives

A simple yet fairly accurate method of calculating the ideal detonation velocity of an organic explosive from a knowledge of the chemical composition alone is proposed. The method is based on the concept that the energetics of a stoichiometrically balanced fuel-oxidizer system is a function of the total oxidizing or reducing valences of the composition. A combination of the valences in the form of Image , where R and P are, respectively, the reducing and oxidizing valences and MW is the molecular weight, has been found to be linearly related to the detonation velocity of the expolosive. The predicting capacity of the method has been found to be superior to other methods in the literature.

Hydration numbers of some metal acetates, monochloroacetates and trichloroacetates in solution from ultrasonic velocity and conpressibility measurements

Ultrasonic velocities in aqueous solutions of some metal acetates, monochloroacelates and trichloroacetates, and the respective acids have been measured at 1 MHz frequency using the pulse technique. The ultrsonic velocity, adiabatic compressibility and apperent molal compressibility were measured as a function of concentration. The apparent molal compressibility values at infinite dilution were calculated and used to determine the hydration numbers.

Velocity ratio in the analysis of linear dynamical systems

The transfer matrix method is known to be well suited for a complete analysis of a lumped as well as distributed element, one-dimensional, linear dynamical system with a marked chain topology. However, general subroutines of the type available for classical matrix methods are not available in the current literature on transfer matrix methods. In the present article, general expressions for various aspects of analysis-viz., natural frequency equation, modal vectors, forced response and filter performance—have been evaluated in terms of a single parameter, referred to as velocity ratio. Subprograms have been developed for use with the transfer matrix method for the evaluation of velocity ratio and related parameters. It is shown that a given system, branched or straight-through, can be completely analysed in terms of these basic subprograms, on a stored program digital computer. It is observed that the transfer matrix method with the velocity ratio approach has certain advantages over the existing general matrix methods in the analysis of one-dimensional systems.

Developing enterprise curriculum: Building on rock, not sand

Entrepreneurial education is the process of providing individuals with the ability to recognise commercial opportunities and the insight, self-esteem, knowledge and skills to act on them. It includes instruction in opportunity recognition, commercialising a concept, marshalling resources in the face of risk, and initiating a business venture. It also includes instruction in traditional business disciplines such as management, marketing, information systems and finance. The purpose of this paper is to describe the design and introduction of a new program in Entrepreneurship at the University of Tasmania. Rather than adopt a traditional business school (passive learning) approach, within this program the method and responsibility of learning has largely been reversed through the process of student centred learning. This method of learning represents a challenging departure from the traditional mainstream teaching practices. In considering the benefits achievable from this teaching method, this paper also considers the difficulties in transferring increased responsibility to students to manage their futures.

Applicability of pebble matrix filtration for the pre-treatment of surface waters containing high turbidity and NOM

Purification of drinking water is routinely achieved by use of conventional coagulants and disinfection procedures. However, there are instances such as flood events when the level of turbidity reaches extreme levels while NOM may be an issue throughout the year. Consequently, there is a need to develop technologies which can effectively treat water of high turbidity during flood events and natural organic matter (NOM) content year round. It was our hypothesis that pebble matrix filtration potentially offered a relatively cheap, simple and reliable means to clarify such challenging water samples. Therefore, a laboratory scale pebble matrix filter (PMF) column was used to evaluate the turbidity and natural organic matter (NOM) pre-treatment performance in relation to 2013 Brisbane River flood water. Since the high turbidity was only a seasonal and short term problem, the general applicability of pebble matrix filters for NOM removal was also investigated. A 1.0 m deep bed of pebbles (the matrix) partly in-filled with either sand or crushed glass was tested, upon which was situated a layer of granular activated carbon (GAC). Turbidity was measured as a surrogate for suspended solids (SS), whereas, total organic carbon (TOC) and UV Absorbance at 254 nm were measured as surrogate parameters for NOM. Experiments using natural flood water showed that without the addition of any chemical coagulants, PMF columns achieved at least 50% turbidity reduction when the source water contained moderate hardness levels. For harder water samples, above 85% turbidity reduction was obtained. The ability to remove 50% turbidity without chemical coagulants may represent significant cost savings to water treatment plants and added environmental benefits accrue due to less sludge formation. A TOC reduction of 35-47% and UV-254 nm reduction of 24-38% was also observed. In addition to turbidity removal during flood periods, the ability to remove NOM using the pebble matrix filter throughout the year may have the benefit of reducing disinfection by-products (DBP) formation potential and coagulant demand at water treatment plants. Final head losses were remarkably low, reaching only 11 cm at a filtration velocity of 0.70 m/h.

Velocity Distribution in Smooth Rectangular Open Channels-Closure

Abstract is not available.

Velocity ratio-cum-transfer matrix method for the evaluation of a muffler with mean flow

The paper deals with a method for the evaluation of exhaust muffers with mean flow. A new set of variables, convective pressure and convective mass velocity, have been defined to replace the acoustic variables. An expression for attenuation (insertion loss) of a muffler has been proposed in terms of convective terminal impedances and a velocity ratio, on the lines of the one existing for acoustic filters. In order to evaluate the velocity ratio in terms of convective variables, transfer matrices for various muffler elements have been derived from the basic relations of energy, mass and momentum. Finally, the velocity ratiocum-transfer matrix method is illustrated for a typical straight-through muffler.

Effects of 17α-ethinyl estradiol on the mating system of the sand goby (Pomatoschistus minutus)

In aquatic environments, endocrine disrupting chemicals (EDCs) that interfere with the endocrinology of males and females form a threat to the maintenance of populations. EDCs are a diverse group of natural and manmade chemicals that already at very low concentrations (at nanogram levels) can have severe effects on reproduction by individuals, e.g. complete sex reversal, feminisation of males, impaired reproduction even resulting in near extinction of populations. With regard to fish, despite the extensive literature on physiological effects of EDCs, very little is known about potential population-level effects. In this thesis, I examined how 17α-ethinyl estradiol (EE2), a synthetic estrogen used in oral contraceptive pills, affects the reproductive behaviour of a marine fish, the sand goby (Pomatoschistus minutus). The aims were fourfold. First, I investigated how exposure to EE2 affects courtship and parental care of sand goby males. Secondly, I looked at effects on the mating system and sexual selection. In the third study, I observed the effects of exposure in a social context where exposed males had to compete with non-exposed males for resources and mates. Finally, I studied the effects of exposure on male-male competition and male aggressive behaviour. This work revealed that EE2 exposure impairs the ability of males to acquire and defend a nest, as well as diminishes the attractiveness of males to females by decreasing their courtship and aggressive behaviour. These effects are harmful for a male whose reproductive success is determined by the ability to compete for limited resources and to attract mates. Furthermore, this thesis showed that selection on male size was relaxed after EE2 exposure and male size had a smaller effect on mating success. These effects can be of a profound nature as they interfere with sexual selection, and may in the long run lead to the loss of traits maintained through sexual selection. The thesis shows that an exposure to environmentally relevant levels of EE2 clearly reduces the chances of individuals to reproduce successfully. Furthermore, it strongly suggests that several types of biomarkers should be used to detect and assess the effects of EDC exposure because severe behavioural effects can sometimes be seen before effects are detectable at the molecular or morphometric level. Behavioural assays should be considered an important complementary tool for the standard ecotoxicological assays because observed behavioural changes have direct and negative effects on fitness, while the connection between changes in molecular expression and fitness may be less obvious.

Context-dependent mate choice in the sand goby, Pomatoschistus minutus

The results presented in this thesis show that all females of a given population do not necessarily choose similar mating partners. Specifically, partner preferences of a fish, the sand goby (Pomatoschistus minutus), varied among individual females and depended on the social context at the time of choice. I also show that females assess multiple mate choice cues simultaneously; partner preferences were based more strongly on an interaction effect between different choice cues than on any individual cue. Furthermore, I found that preferred matings involved fitness benefits in the form of increased offspring success, but these benefits were not significantly affected by mate compatibility. Hence, mate choice for partner compatibility does not appear to be an important determinant of the observed variation in female mate preferences in this species. The context-dependency of female mating preferences revealed is relevant to how genetic variation in sexually selected traits might be maintained: as the mating success of a certain male type varies according to the choice context, directional sexual selection on male traits is shown to be less intense than generally thought making for a slower loss of genetic variation in these traits. Mating preferences of sand gobies were assessed by giving females a binary choice between males that differed in body size and/or other focus traits. These association preferences were found to be sexually motivated, repeatable and to correspond to actual mating decisions.

Proportional Weirs as Velocity Controlling Devices

Of the many factors that govern the settling phenomenon, the flow velocity in the settling tanks can be controlled favorably by fixing suitably designed weirs at the outlets of the tanks. The velocity at the bottom should not dislodge the particles that have already settled. These requirements might be met with by velocities which are controlled to be constant with respect to the depth of flow, or velocities which reduce linearly with increasing depth or velocities that vary inversely with the depth. To achieve these types of velocity control, new proportional weirs have been designed. Very near to the outlet of the tank, over a small length, the flow was found to be turbulent and noncompliant with the expected type of velocity control. This small length of the disturbance may be provided over and above the theoretical settling length of the tank, for efficient sedimentation.

Large Low-Frequency Fluctuations in the Velocity of a Driven Vortex Lattice in a Single Crystal of 2H-NbSe2 Superconductor

The driven state of a well-ordered flux line lattice in a single crystal of 2H-NbSe2 in the time domain has revealed the presence of substantial fluctuations in velocity, with large and distinct time periods (similar to seconds). A superposition of a periodic drive in the driven vortex lattice causes distinct changes in these fluctuations. We propose that prior to the onset of the peak effect there exists a heretofore unexplored regime of coherent dynamics, with unexpected behavior in velocity fluctuations.

Effect of reinforcement form on the bearing capacity of square footings on sand

This paper presents the results of laboratory model loading tests and numerical studies carried out on square footings supported on geosynthetic reinforced sand beds. The relative performance of different forms of geosynthetic reinforcement (i.e. geocell, planar layers and randomly distributed mesh elements) in foundation beds is compared; using same quantity of reinforcement in each test. A biaxial geogrid and a geonet are used for reinforcing the sand beds. Geonet is used in two forms of reinforcement, viz. Planar layers and geocell, while the biaxial geogrid was used in three forms of reinforcement, viz. planar layers, geocell and randomly distributed mesh elements. Laboratory load tests on unreinforced and reinforced footings are simulated in a numerical model and the results are analyzed to understand the distribution of displacements and stresses below the footing better. Both the experimental and numerical studies demonstrated that the geocell is the most advantageous form of soil reinforcement technique of those investigated, provided there is no rupture of the material during loading. Geogrid used in the form of randomly distributed mesh elements is found to be inferior to the other two forms. Some significant observations on the difference in reinforcement mechanism for different forms of reinforcement are presented in this paper.