Two-dimensional phase transitions at electrochemical interfaces

A two-state Ising model has been applied to the two-dimensional condensation of tymine at the mercury-water interface. The model predicts a quadratic dependence of the transition potential on temperature and on the logarithm of the adsorbate concentration. Both predictions have been confirmed experimentally.

Characterisation of humidity dependence of a metal oxide semiconductor (MOS) sensor array using Partial Least Squares (PLS)

Metal oxide semiconductor (MOS) sensors are a class of chemical sensor that have potential for being a practical core sensor module for an electronic nose system in various environmental monitoring applications. However, the responses of these sensors may be affected by changes in humidity and this must be taken into consideration when developing calibration models. This paper characterises the humidity dependence of a sensor array which consists of 12 MOS sensors. The results were used to develop calibration models using partial least squares. Effects of humidity on the response of the sensor array and predictive ability of partial least squares are discussed. It is shown that partial least squares can provide proper calibration models to compensate for effects caused by changes in humidity.

Characterisation of humidity dependence of a metal oxide semiconductor sensor array using partial least squares

Metal oxide semiconductor (MOS) sensors are a class of chemical sensors that have potential for being a practical core sensor module for an electronic nose system in various environmental monitoring applications. However, the responses of these sensors may be affected by changes in humidity and this must be taken into consideration when developing calibration models. This paper characterises the humidity dependence of a sensor array which consists of 12 MOS sensors. The results were used to develop calibration models using partial least squares (PLS). Effects of humidity on the response of the sensor array and predictive ability of partial least squares are discussed. It is shown that partial least squares can provide proper calibration models to compensate for effects caused by changes in humidity. Special Issue: Selected Paper from the 12th International Symposium on Olfaction and Electronic Noses - ISOEN 2007, International Symposium on Olfaction and Electronic Noses.

Doping Dependence of Semiconductor-Metal Transition in InP at High Pressures

The resistivity of selenium-doped n-InP single crystal layers grown by liquid-phase epitaxy with electron concentrations varying from 6.7 x 10$^18$ to 1.8 x 10$^20$ cm$^{-3}$ has been measured as a function of hydrostatic pressure up to 10 GPa. Semiconductor-metal transitions were observed in each case with a change in resistivity by two to three orders of magnitude. The transition pressure p$_c$ decreased monotonically from 7.24 to 5.90 GPa with increasing doping concentration n according to the relation $p_c = p_o [1 - k(n/n_m)^a]$, where n$_m$ is the concentration (per cubic centimetre) of phosphorus donor sites in InP atoms, p$_o$ is the transition pressure at low doping concentrations, k is a constant and $\alpha$ is an exponent found experimentally to be 0.637. The decrease in p$_c$ is considered to be due to increasing internal stress developed at high concentrations of ionized donors. The high-pressure metallic phase had a resistivity (2.02-6.47) x 10$^{-7}$ $\Omega$ cm, with a positive temperature coefficient dependent on doping.

Deriving artefact-centric interfaces for overloaded web services

We present a novel framework and algorithms for the analysis of Web service interfaces to improve the efficiency of application integration in wide-spanning business networks. Our approach addresses the notorious issue of large and overloaded operational signatures, which are becoming increasingly prevalent on the Internet and being opened up for third-party service aggregation. Extending upon existing techniques used to refactor service interfaces based on derived artefacts of applications, namely business entities, we propose heuristics for deriving relations between business entities, and in turn, deriving permissible orders in which operations are invoked. As a result, service operations are refactored on business entity CRUD which then leads to behavioural protocols generated, thus supportive of fine-grained and flexible service discovery, composition and interaction. A prototypical implementation and analysis of web services, including those of commercial logistic systems (Fedex), are used to validate the algorithms and open up further insights into service interface synthesis.

Discovering behavioural interfaces for overloaded web services

The growth of APIs and Web services on the Internet, especially through larger enterprise systems increasingly being leveraged for Cloud and software-as-a-service opportuni- ties, poses challenges to improving the efficiency of integration with these services. Interfaces of enterprise systems are typically larger, more complex and overloaded, with single operation having multiple data entities and parameter sets, supporting varying requests, and reflecting versioning across different system releases, compared to fine-grained operations of contemporary interfaces. We propose a technique to support the refactoring of service interfaces by deriving business entities and their relationships. In this paper, we focus on the behavioural aspects of service interfaces, aiming to discover the sequential dependencies of operations (otherwise known as protocol extraction) based on the entities and relationships derived. Specifically, we propose heuristics according to these relationships, and in turn, deriving permissible orders in which operations are invoked. As a result of this, service operations can be refactored on business entity CRUD lines, with explicit behavioural protocols as part of an interface definition. This supports flexible service discovery, composition and integration. A prototypical implementation and analysis of existing Web services, including those of commercial logistic systems (Fedex), are used to validate the algorithms proposed through the paper.

Surface modes of coated semiconductor spheres

The frequencies of the two modes of surface plasmon oscillations exhibited by coated semiconductor spheres can either decrease or increase with the size of the particle depending upon the ratio ωh1/ωh2, ε∞1 and ε∞2. When ωh1 = ωh2, the soft mode frequency becomes independent of the size of the sphere.

Pressure-induced first-order transition in layered crystalline semiconductor GeSe to a metallic phase

The electrical resistivity of layerd crystalline GeSe has been investigated up to a pressure of 100 kbar and down to liquid-nitrogen temperature by use of a Bridgman anvil device. A pressure-induced first-order phase transition has been observed in single-crystal GeSe near 6 GPa. The high-pressure phase is found to be quenchable and an x-ray diffraction study of the quenched material reveals that it has the face-centered-cubic structure. Resistivity measurements as a function of pressure and temperature suggest that the high-pressure phase is metallic.

Metal-insulator-semiconductor capacitors with bismuth oxide as insulator

Metal-insulator-semiconductor capacitors using aluminum Bi2O3 and silicon have been studied for varactor applications. Reactively sputtered Bi2O3 films which under suitable proportions of oxygen and argon and had high resistivity suitable for device applications showed a dielectric constant of 25. Journal of Applied Physics is copyrighted by The American Institute of Physics.

Specifying Reuse Interfaces for Task-Oriented Framework Specialization

Reuse of existing carefully designed and tested software improves the quality of new software systems and reduces their development costs. Object-oriented frameworks provide an established means for software reuse on the levels of both architectural design and concrete implementation. Unfortunately, due to frame-works complexity that typically results from their flexibility and overall abstract nature, there are severe problems in using frameworks. Patterns are generally accepted as a convenient way of documenting frameworks and their reuse interfaces. In this thesis it is argued, however, that mere static documentation is not enough to solve the problems related to framework usage. Instead, proper interactive assistance tools are needed in order to enable system-atic framework-based software production. This thesis shows how patterns that document a framework s reuse interface can be represented as dependency graphs, and how dynamic lists of programming tasks can be generated from those graphs to assist the process of using a framework to build an application. This approach to framework specialization combines the ideas of framework cookbooks and task-oriented user interfaces. Tasks provide assistance in (1) cre-ating new code that complies with the framework reuse interface specification, (2) assuring the consistency between existing code and the specification, and (3) adjusting existing code to meet the terms of the specification. Besides illustrating how task-orientation can be applied in the context of using frameworks, this thesis describes a systematic methodology for modeling any framework reuse interface in terms of software patterns based on dependency graphs. The methodology shows how framework-specific reuse interface specifi-cations can be derived from a library of existing reusable pattern hierarchies. Since the methodology focuses on reusing patterns, it also alleviates the recog-nized problem of framework reuse interface specification becoming complicated and unmanageable for frameworks of realistic size. The ideas and methods proposed in this thesis have been tested through imple-menting a framework specialization tool called JavaFrames. JavaFrames uses role-based patterns that specify a reuse interface of a framework to guide frame-work specialization in a task-oriented manner. This thesis reports the results of cases studies in which JavaFrames and the hierarchical framework reuse inter-face modeling methodology were applied to the Struts web application frame-work and the JHotDraw drawing editor framework.

Crystal structure and semiconductor-metal transition of the quasi-two-dimensional transition metal oxide, La2NiO4

Abstract is not available.

A noticeboard in "both worlds" unsurprising interfaces supporting easy bi-cultural content publication

We describe the design of a digital noticeboard to support communication within a remote Aboriginal community whose aspiration is to live in "both worlds", nurturing and extending their Aboriginal culture and actively participating in Western society and economy. Three bi-cultural aspects have emerged and are presented here: the need for a bi-lingual noticeboard to span both oral and written language traditions, the tension between perfunctory information exchange and social, embodied protocols of telling in person and the different ways in which time is represented in both cultures. The design approach, developed iteratively through consultation, demonstration and testing led to an "unsurprising interface", aimed at maximizing use and appropriation across cultures by unifying visual, text and spoken contents in both passive and interactive displays in a modeless manner.

Social NUI: Social perspectives in natural user interfaces

Natural User Interfaces (NUI) offer rich ways for interacting with the digital world that make innovative use of existing human capabilities. They include and often combine different input modalities such as voice, gesture, eye gaze, body interactions, touch and touchless interactions. However much of the focus of NUI research and development has been on enhancing the experience of individuals interacting with technology. Effective NUIs must also acknowledge our innately social characteristics, and support how we communicate with each other, play together, learn together and collaboratively work together. This workshop concerns the social aspects of NUI. The workshop seeks to better understand the social uses and applications of these new NUI technologies -- how we design these technologies for new social practices and how we understand the use of these technologies in key social contexts.