Mineral and oxygen isotopic compositions in a profile through the altered lower oceanic crust, ODP Hole 176-735B

ODP Hole 735B located on the Southwest Indian Ridge at 57°E is an in situ sampled long, continuous section of lower oceanic crust. Oxygen isotope compositions of constituent minerals of Leg 176 gabbros have been measured by UV-laser oxygen isotope microprobe. Together with existing data from Leg 118, a complete oxygen isotope profile through the lower oceanic crust has been obtained. Most clinopyroxenes and olivines have normal mantle values of ~5.5 per mil and ~5.2 per mil, respectively, while plagioclases show slight d18O enrichment relative to its mantle value of 6.1per mil. Down-hole variations of Hole 735B gabbro indicate a downward decreasing d18O profile, with a kink at a depth of about 800 m below sea floor. Above this depth, gabbros are depleted in 18O relative to unaltered basalts, while below ~800 m they show nearly unmodified d18O values. Abundant seawater penetration appears to be limited to the upper part of the lower crust at ODP site 735 (~800 m into the gabbroic layer and ~2-2.5 km into the oceanic crust from the top of pillow basalts). Mass balance calculations show that the lower crust formed under this ultra-slow-spreading ridge has an average d18O value of 5.5 per mil. The whole crust at Site 735 has an overall 18O enrichment with d18O values of 6.0 per mil to 7.8 per mil, depending on the possible variation of the d18O values of the upper pillow basalts and sheeted dykes. The apparent difference in oxygen isotope compositions of ocean crusts formed with different spreading rates has important implications on the buffering of ocean water over geological time, as well as on the oxygen recycling between crust and mantle through subduction. The difference of seawater penetration between fast- and slow-spreading ridges could be related to their particular magmatic-tectonic history during the formation and aging of the crust. However, more analyses on continuous sections through oceanic and ophiolitic crust in different tectonic settings are required to derive any predictive models.

Chemical, isotope and mineral composition of hydrothermally altered upper oceanic crust drilled at ODP Site 129-801C

ODP Hole 801C penetrates >400 m into 170-Ma oceanic basement formed at a fast-spreading ridge. Most basalts are slightly (10-20%) recrystallized to saponite, calcite, minor celadonite and iron oxyhydroxides, and trace pyrite. Temperatures estimated from oxygen isotope data for secondary minerals are 5-100°C, increasing downward. At the earliest stage, dark celadonitic alteration halos formed along fractures and celadonite, and quartz and chalcedony formed in veins from low-temperature (<100°C) hydrothermal fluids. Iron oxyhydroxides subsequently formed in alteration halos along fractures where seawater circulated, and saponite and pyrite developed in the host rock and in zones of restricted seawater flow under more reducing conditions. Chemical changes include variably elevated K, Rb, Cs, and H2O; local increases in FeT, Ba, Th, and U; and local losses of Mg and Ni. Secondary carbonate veins have 87Sr/86Sr = 0.706337 - 0.707046, and a negative correlation with d18O results from seawater-basalt interaction. Carbonates could have formed at any time since the formation of Site 801 crust. Variable d13C values (-11.2? to 2.9?) reflect the incorporation of oxidized organic carbon from intercalated sediments and changes in the d13C of seawater over time. Compared to other oceanic basements, a major difference at Site 801 is the presence of two hydrothermal silica-iron deposits that formed from low-temperature hydrothermal fluids at the spreading axis. Basalts associated with these horizons are intensely altered (60-100%) to phyllosilicates, calcite, K-feldspar, and titanite; and exhibit large increases in K, Rb, Cs, Ba, H2O, and CO2, and losses of FeT, Mn, Mg, Ca, Na, and Sr. These effects may be common in crust formed at fast-spreading rates, but are not ubiquitous. A second important difference is that the abundance of brown oxidation halos along fractures at Site 801 is an order of magnitude less than at some other sites (2% vs. 20-30%). Relatively smooth basement topography (<100 m) and high sedimentation rate (8 m/Ma) probably restricted the access of oxygenated seawater. Basement lithostratigraphy and early low-temperature hydrothermal alteration and mineral precipitation in fractures at the spreading axis controlled permeability and limited later flow of oxygenated seawater to restricted depth intervals.

Alkali contents, Sr isotope and U-Th-Pb data for ocean crust vein minerals from DSDP Holes 27-261, 61-462A, and 72-516F

Cation exchange experiments (ammonium acetate and cation resin) on celadonite-smectite vein minerals from three DSDP holes demonstrate selective removal of common Sr relative to Rb and radiogenic Sr. This technique increases the Rb/Sr ratio by factors of 2.3 to 22 without significantly altering the age of the minerals, allowing easier and more precise dating of such vein minerals. The ages determined by this technique (Site 261 - 121.4+/-1.6 m.y.; Site 462A - 105.1+/-2.8 m.y.; Site 516F - 69.9+/-2.4 m.y.) are 34, 54 and 18 m.y. younger, respectively, than the age of crust formation at the site; in the case of site 462A, the young age is clearly related to off-ridge emplacement of a massive sill/flow complex. At the other sites, either the hydrothermal circulation systems persisted longer than for normal crust (10-15 m.y.), or were reactivated by off-ridge igneous activity. Celadonites show U and Pb contents and Pb isotopic compositions little changed from their basalt precursors, while Th contents are significantly lower. Celadonites thus have unusually high alkali/U,Th ratios and low Th/U ratios. If this celadonite alteration signature is significantly imprinted on oceanic crust as a whole, it will lead to very distinctive Pb isotope signatures for any hot spot magmas which contain a component of aged subducted recycled oceanic crust. Initial Sr isotope ratios of ocean crust vein minerals (smectite, celadonite, zeolite, calcite) are intermediate between primary basalt values and contemporary sea water values and indicate formation under seawaterdominated systems with effective water/rock ratios of 20-200.

Geochemistry of lavas and dikes from the upper oceanic crust of Hess Deep Rift, eastern Pacific Ocean

Strontium isotopes are useful tracers of fluid-rock interaction in marine hydrothermal systems and provide a potential way to quantify the amount of seawater that passes through these systems. We have determined the whole-rock Sr-isotopic compositions of a section of upper oceanic crust that formed at the fast-spreading East Pacific Rise, now exposed at Hess Deep. This dataset provides the first detailed comparison for the much-studied Ocean Drilling Program (ODP) drill core from Site 504B. Whole-rock and mineral Sr concentrations indicate that Sr-exchange between hydrothermal fluids and the oceanic crust is complex, being dependent on the mineralogical reactions occurring; in particular, epidote formation takes up Sr from the fluid increasing the 87Sr/86Sr of the bulk-rock. Calculating the fluid-flux required to shift the Sr-isotopic composition of the Hess Deep sheeted-dike complex, using the approach of Bickle and Teagle (1992, doi:10.1016/0012-821X(92)90221-G) gives a fluid-flux similar to that determined for ODP Hole 504B. This suggests that the level of isotopic exchange observed in these two regions is probably typical for modern oceanic crust. Unfortunately, uncertainties in the modeling approach do not allow us to determine a fluid-flux that is directly comparable to fluxes calculated by other methods.

Stable oxygen isotope ratios in zircons from oceanic crust

Lower ocean crust is primarily gabbroic, although 1-2% felsic igneous rocks that are referred to collectively as plagiogranites occur locally. Recent experimental evidence suggests that plagiogranite magmas can form by hydrous partial melting of gabbro triggered by seawater-derived fluids, and thus they may indicate early, high-temperature hydrothermal fluid circulation. To explore seawater-rock interaction prior to and during the genesis of plagiogranite and other late-stage magmas, oxygen-isotope ratios preserved in igneous zircon have been measured by ion microprobe. A total of 197 zircons from 43 plagiogranite, evolved gabbro, and hydrothermally altered fault rock samples have been analyzed. Samples originate primarily from drill core acquired during Ocean Drilling Program and Integrated Ocean Drilling Program operations near the Mid-Atlantic and Southwest Indian Ridges. With the exception of rare, distinctively luminescent rims, all zircons from ocean crust record remarkably uniform d18O with an average value of 5.2 ± 0.5 per mil (2SD). The average d18O(Zrc) would be in magmatic equilibrium with unaltered MORB [d18O(WR) ~5.6-5.7 per mil], and is consistent with the previously determined value for equilibrium with the mantle. The narrow range of measured d18O values is predicted for zircon crystallization from variable parent melt compositions and temperatures in a closed system, and provides no indication of any interactions between altered rocks or seawater and the evolved parent melts. If plagiogranite forms by hydrous partial melting, the uniform mantle-like d18O(Zrc) requires melting and zircon crystallization prior to significant amounts of water-rock interactions that alter the protolith d18O. Zircons from ocean crust have been proposed as a tectonic analog for >3.9 Ga detrital zircons from the earliest (Hadean) Earth by multiple workers. However, zircons from ocean crust are readily distinguished geochemically from zircons formed in continental crustal environments. Many of the >3.9 Ga zircons have mildly elevated d18O (6.0-7.5 per mil), but such values have not been identified in any zircons from the large sample suite examined here. The difference in d18O, in combination with newly acquired lithium concentrations and published trace element data, clearly shows that the >3.9 Ga detrital zircons did not originate by processes analogous to those in modern mid-ocean ridge settings.

Microfossils detected in a block of ancient dense clay coated with a ferromanganese crust, Clarion-Clipperton Province, East Equatorial Pacific

The area in study is characterized by a regional stratigraphic hiatus from Early Miocene to Quaternary. Deposits from Late Eocene to Early Miocene occur on the bottom surface or under a thin sedimentary cover. Ferromanganese nodules, mostly of Oligocene age, formed on surface layers of Tertiary or Quaternary sediments. A detailed micropaleontological study of a block of dense ancient clay coated with a ferromanganese crust was carried out. Composition of found radiolarian and diatomaceous complexes proved that the crust formed in Quaternary on an eroded surface of Late Oligocene clay. In Quaternary Neogene sediments were eroded and washed away by bottom currents. It is likely that the erosion began 0.9-0.7 Ma at the beginning of the "Glacial Pleistocene". The erosion could be initiated by loosening and resuspension of surface sediments resulting from seismic activity generated by strong earthquakes in the Central America subduction zone. The same vibration maintained residual nodules at the seafloor surface. Thus, for the area in study a common reason and a common Quaternary interval for formation of the following features is supposed: a regional stratigraphic hiatus, formation of residual nodule fields, and position of ancient nodules on the surface of Quaternary sediments.

Carbon chemistry of oceanic crust

Carbonate mineral precipitation in the upper oceanic crust during low-temperature, off-axis, hydrothermal circulation is investigated using new estimates of the bulk CO2 content of seven DSDP/ODP drill cores. In combination with previously published data these new data show: (i) the CO2 content of the upper ~ 300 m of the crust is substantially higher in Cretaceous than in Cenozoic crust and (ii) for any age of crust, there is substantially more CO2 in Atlantic (slow-spreading) than Pacific (intermediate- to fast-spreading) crust. Modelling the Sr-isotopic composition of the carbonates suggests that > 80% of carbonate mineral formation occurs within < 20 Myr of crust formation. This means that the higher CO2 content of Cretaceous crust reflects a secular change in the rate of CO2 uptake by the crust. Oxygen isotope derived estimates of carbonate mineral precipitation temperatures show that the average and minimum temperature of carbonate precipitation was ~10 °C higher temperatures in the Cretaceous than in the Cenozoic. This difference is consistent with previous estimates of secular change in bottom seawater temperature. Higher fluid temperature within the crust will have increased reaction rates potentially liberating more basaltic Ca and hence enhancing carbonate mineral precipitation. Additionally, if crustal fluid pH is controlled by fluid-rock reaction, the higher Ca content of the Cretaceous ocean will also have enhanced carbonate mineral precipitation. New estimates of the rate of CO2 uptake by the upper ocean crust during the Cenozoic are much lower than previous estimates.