Characterisation of organoclays and adsorption of p-nitrophenol : environmental application

Organoclays were synthesised through ion exchange of a single surfactant for sodium ions, and characterised by a range of method including X-ray diffraction (XRD), BET, X-ray photoelectron spectroscopy (XPS), thermogravimetric analysis (TGA), Fourier transform infrared spectroscopy (FT-IR), and transmission electron microscopy (TEM). The change in surface properties of montmorillonite and organoclays intercalated with the surfactant, tetradecyltrimethylammonium bromide (TDTMA) were determined using XRD through the change in basal spacing and the expansion occurred by the adsorbed p-nitrophenol. The changes of interlayer spacing were observed in TEM. In addition, the surface measurement such as specific surface area and pore volume was measured and calculated using BET method, this suggested the loaded surfactant is highly important to determine the sorption mechanism onto organoclays. The collected results of XPS provided the chemical composition of montmorillonite and organoclays, and the high-resolution XPS spectra offered the chemical states of prepared organoclays with binding energy. Using TGA and FT-IR, the confirmation of intercalated surfactant was investigated. The collected data from various techniques enable an understanding of the changes in structure and surface properties. This study is of importance to provide mechanisms for the adsorption of organic molecules, especially in contaminated environmental sites and polluted waters.

Transition from n- to p-type of spray pyrolysis deposited Cu doped ZnO thin films for NO2 sensing

The structural, optical, and gas-sensing properties of spray pyrolysis deposited Cu doped ZnO thin films were investigated. Gas response of the undoped and doped films to N02 (oxidizing) gas shows an increase and decrease in resistance, respectively, indicating p-type conduction in doped samples. The UV-Vis spectra of the films show decrease in the bandgap with increasing Cu concentration in ZnO. The observed p-type conductivity is attributed to the holes generated by incorporated Cu atoms on Zn sites in ZnO thin films. The X-ray diffraction spectra showed that samples are polycrystalline with the hexagonal wurtzite structure and increasing the concentration of Cu caused a decrease in the intensity of the dominant (002) peak. The surface morphology of films was studied by scanning electron microscopy and the presence of Cu was also confirmed by X-ray photoelectron spectroscopy. Seebeck effect measurements were utilized to confirm the p-type conduction of Cu doped ZnO thin films. Copyright © 2009 American Scientific Publishers All rights reserved.

[P,P-Di-tert-butyl-N-trimethylsilyl- P-(trimethylsilylamino)phosphineimidato-N,N]bis(pyridine-N)- lithium(I)

In the title compound, [Li(C14H36N2PSi2)(C5H5N)2], the bulky chelating monoanionic P,P-di-tert-butyl-N-trimethylsilyl-P-(trimethylsilylamino)phosphine imidate ligand and two pyridine ligands bind to Li in a pseudo-tetrahedral arrangement with twofold symmetry. The Li-N [phosphine]distance is 2.048 (5) Å, while the LiP distance is 2.520 (6) Å

An epistemic community as influencer and implementer in local government accounting in Australia

This paper adopts an epistemic community framework to explicate the dual role of epistemic communities as influencers of accounting policy within regulatory space and as implementers who effect change within the domain of accounting. The context is the adoption and implementation of fair value accounting within local government in New South Wales (NSW). The roles and functions of Australian local government are extensive, and include the development and maintenance of infrastructure, provision of recreational facilities, certain health and community services, buildings, cultural facilities, and in some cases, water and sewerage (Australian Local Government Association, 2009). The NSW state Department of Local Government (DLG) is responsible for legislation and policy development to ensure that local councils are able to deliver ‘quality services to their communities in a sustainable manner’ (DLG, 2008c). These local councils receive revenue from various sources including property rates, government grants and user-pays service provision. In July 2006 the DLG issued Circular 06-453 to councils (DLG, 2006c), mandating the staged adoption of fair value measurement of infrastructure assets. This directive followed the policy of NSW State Treasury (NSW Treasury, 2007),4 and an independent inquiry into the financial sustainability of local councils (LGSA, 2006). It was an attempt to resolve the inconsistency in public sector asset valuation in NSW Local Governments, and to provide greater usefulness and comparability of financial statements.5 The focus of this study is the mobilization of accounting change by the DLG within this wider political context. When a regulatory problem arises, those with political power seek advice from professionals with relevant skill and expertise (Potter, 2005). This paper explores the way in which professionals diffuse accounting ‘problems’ and the associated accounting solutions ‘across time and space’ (Potter, 2005, p. 277). The DLG’s fair value accounting policy emanated from a ‘regulatory space’ (Hancher and Moran, 1989)6 as a result of negotiations between many parties, including accounting and finance professionals. Operating within the local government sector, these professionals were identified by the DLG as being capable of providing helpful input. They were also responsible for the implementation of the new olicy within local councils. Accordingly they have been dentified as an pistemic community with the ability to ranslate regulatory power by changing he domain of ccounting (Potter, 2005, p. 278).7 The paper is organised as follows. The background to the LG’s decision to require the introduction of fair value accounting for infrastructure assets is explored. Following this, the method of the study is described, and the epistemic community framework outlined. In the next sections, evidence of the influencing and implementing roles of epistemic groups is provided. Finally, conclusions are drawn about the significance of these groups both within regulatory space in developing accounting regulation, and in embedding change within the domain of accounting.

The effect of simulated astigmatic refractive error on reading performance

Background: Few studies have specifically investigated the functional effects of uncorrected astigmatism on measures of reading fluency. This information is important to provide evidence for the development of clinical guidelines for the correction of astigmatism. Methods: Participants included 30 visually normal, young adults (mean age 21.7 ± 3.4 years). Distance and near visual acuity and reading fluency were assessed with optimal spectacle correction (baseline) and for two levels of astigmatism, 1.00DC and 2.00DC, at two axes (90° and 180°) to induce both against-the-rule (ATR) and with-the-rule (WTR) astigmatism. Reading and eye movement fluency were assessed using standardized clinical measures including the test of Discrete Reading Rate (DRR), the Developmental Eye Movement (DEM) test and by recording eye movement patterns with the Visagraph (III) during reading for comprehension. Results: Both distance and near acuity were significantly decreased compared to baseline for all of the astigmatic lens conditions (p < 0.001). Reading speed with the DRR for N16 print size was significantly reduced for the 2.00DC ATR condition (a reduction of 10%), while for smaller text sizes reading speed was reduced by up to 24% for the 1.00DC ATR and 2.00DC condition in both axis directions (p<0.05). For the DEM, sub-test completion speeds were significantly impaired, with the 2.00DC condition affecting both vertical and horizontal times and the 1.00DC ATR condition affecting only horizontal times (p<0.05). Visagraph reading eye movements were not significantly affected by the induced astigmatism. Conclusions: Induced astigmatism impaired performance on selected tests of reading fluency, with ATR astigmatism having significantly greater effects on performance than did WTR, even for relatively small amounts of astigmatic blur of 1.00DC. These findings have implications for the minimal prescribing criteria for astigmatic refractive errors.

Arc voltage behavior in GMAW-P under different drop transfer modes

Purpose: Experimental measurements have been made to investigate meaning of the change in voltage for the pulse gas metal arc welding (GMAW-P) process operating under different drop transfer modes. Design/methodology/approach: Welding experiments with different values of pulsing parameter and simultaneous recording of high speed camera pictures and welding signals (such as current and voltage) were used to identify different drop transfer modes in GMAW-P. The investigation is based on the synchronization of welding signals and high speed camera to study the behaviour of voltage signal under different drop transfer modes. Findings: The results reveal that the welding arc is significantly affected by the molten droplet detachment. In fact, results indicate that sudden increase and drop in voltage just before and after the drop detachment can be used to characterize the voltage behaviour of different drop transfer mode in GMAW-P. Research limitations/implications: The results show that voltage signal carry rich information about different drop transfer occurring in GMAW-P. Hence it’s possible to detect different drop transfer modes. Future work should concentrate on development of filters for detection of different drop transfer modes. Originality/value: Determination of drop transfer mode with GMAW-P is crucial for the appropriate selection of pulse welding parameters. As change in drop transfer mode results in poor weld quality in GMAW-P, so in order to estimate the working parameters and ensure stable GMAW-P understanding the voltage behaviour of different drop transfer modes in GMAW-P will be useful. However, in case of GMAW-P hardly any attempt is made to analyse the behaviour of voltage signal for different drop transfer modes. This paper analyses the voltage signal behaviour of different drop transfer modes for GMAW-P.

Review: "Information and Communication Technologies in Tourism 2003" edited by Frew, A.J., Hitz, M., & O’Connor, P.

"This volume represents the proceedings of the 10th ENTER conference, held in Helsinki, Finland during January 2003. The conference theme was ‘technology on the move’, and the 476pp. proceedings offer 50 papers by 108 authors. The editors advise all papers were subject to a double blind peer review. The research has been categorised into 18 broad headings, which reflects the diversity of topics addressed. This reviewer has adopted the approach of succinctly summarising each of the papers, in the order they appear, to assist readers of Tourism Management in judging the potential value of the content for their own work..." -- publisher website

Hydrogen-bonding in cyclic imides and amide carboxylic acid derivatives from the facile reaction of cis-cyclohexane-1,2-carboxylic anhydride with o- and p-anisidine and m- and p-aminobenzoic acids

The structures of the open chain amide carboxylic acid rac-cis-[2-(2-methoxyphenyl)carbamoyl]cyclohexane-1-carboxylic acid, C15H19NO4, (I) and the cyclic imides rac-cis-2-(4-methoxyphenyl)-3a,4,5,6,7,7-hexahydroisoindole-1,3-dione,C15H17NO3, (II), chiral cis-2-(3-carboxyphenyl)-3a,4,5,6,7,7a-hexahydroisoindole-1,3-dione, C15H15NO4,(III) and rac-cis-2-(4-carboxyphenyl)- 3a,4,5,6,7,7a-hexahydroisoindole-1,3-dione monohydrate, C15H15NO4. H2O) (IV), are reported. In the amide acid (I), the phenylcarbamoyl group is essentially planar [maximum deviation from the least-squares plane = 0.060(1)Ang. for the amide O atom], the molecules form discrete centrosymmetric dimers through intermolecular cyclic carboxy-carboxy O-H...O hydrogen-bonding interactions [graph set notation R2/2(8)]. The cyclic imides (II)--(IV) are conformationally similar, with comparable phenyl ring rotations about the imide N-C(aromatic) bond [dihedral angles between the benzene and isoindole rings = 51.55(7)deg. in (II), 59.22(12)deg. in (III) and 51.99(14)deg. in (IV). Unlike (II) in which only weak intermolecular C-H...O(imide) hydrogen bonding is present, the crystal packing of imides (III) and (IV) shows strong intermolecular carboxylic acid O-H...O hydrogen-bonding associations. With (III), these involve imide O-atom acceptors, giving one-dimensional zigzag chains [graph set C(9)], while with the monohydrate (IV), the hydrogen bond involves the partially disordered water molecule which also bridges molecules through both imide and carboxyl O-atom acceptors in a cyclic R4/4(12) association, giving a two-dimensional sheet structure. The structures reported here expand the structural data base for compounds of this series formed from the facile reaction of cis-cyclohexane-1,2-dicarboxylic anhydride with substituted anilines, in which there is a much larger incidence of cyclic imides compared to amide carboxylic acids.

Drugs, labels and (p)ill-fitting boxes : ADHD and children who are hard to teach

In offering a critical review of the problem we call “ADHD” this paper progresses in three stages. The first two parts juxtapose the dominant voices emanating from the literature in medicine and psychology, highlighting some interdependency between these otherwise competing interest groups. In part three, the nature of the relationship between these groups and the institution of the school is considered, as is the role that the school may play in the psycho-pathologisation of fidgety, distractible, active children who prove hard to teach. In so doing, the author provides an insight as to why the problem we call “ADHD” has achieved celebrity status in Australia and what the effects of that may be for children who come to be described in these ways.

Adsorption of p-nitrophenol on organoclays

In this study, organoclays were prepared through ion exchange of a single cationic surfactant, hexadecyltrimethylammonium bromide and characterised by a range of methods including X-ray diffraction (XRD) and thermogravimetric analysis. Changes in the surface properties of montmorillonite and the organoclays were observed and the basal spacings of organoclays with and without p-nitrophenol were determined using XRD. The thermal stability of both organoclays were measured using thermogravimetry. As the surfactant loading increased, the expanded basal spacings were observed, and different molecular configurations of surfactant were identified. When the surfactant loading exceeded 1.0 CEC, surfactant molecules tend to adsorb strongly on the clay surface and this resulted in increased affinity to organic compounds. The adsorbed p-nitrophenol and the surfactant decomposed simultaneously. Hence, the surfactant molecules and adsorbed p-nitrophenol are important in determining the thermal stabilities of organoclays. This study enhances the understanding of the structure and adsorption properties of organoclays and has further implications for the application of organoclays as filter materials for the removal of organic pollutants in aqueous solutions.

Who drives E&P innovation?

Few would argue that the upstream oil and gas industry has become more technology- intensive over the years. At the same time, the increasing costs and complexity of today’s exploration and production (E&P) technologies are making it increasingly difficult for any one company to support an aggressive research and development (R&D) agenda single handedly. The coming together of these two evolutionary forces gives rise to important questions. How does innovation happen in the E&P industry? Specifically, what ideas and inputs flow from which parts of the industry’s value network, and where do these inputs go? And how do firms and organizations from different countries contribute differently to this process? This survey was designed to shed light on these issues.