Tripodal Bile Acid Architectures Based on a Triarylphosphine Oxide Core Obtained by Copper-Catalysed 1,3]-Dipolar Cycloaddition: Synthesis and Preliminary Aggregation Studies

We report the synthesis and aggregation behaviour of new water-soluble, bile acid derived tripodal architectures based on a core derived from triphenylphosphine oxide. We employed the well-established copper-catalysed 1,3]-dipolar cycloaddition (CuAAC) for the construction of these tripodal molecules. The aggregation behaviour of these molecules in aqueous media was studied by different analytical methods such as dye solubilisation, dynamic light scattering, NMR and AFM. These molecular architectures also offer an additional advantage in aiding understanding of the influence of the nature of the bile acid backbone and of the configuration at the steroid C-3 position in these architectures; to the best of our knowledge this has not been reported in the literature. The unique gelation properties of the -derivatives were explained through molecular modelling studies and the mechanical behaviour of these gels was studied by rheology experiments.

Nanostructuring of p- and n-type skutterudites reaching figures of merit of approximately 1.3 and 1.6, respectively

Thermoelectric (TE) conversion of waste heat into useful electricity demands optimized thermal and electrical transport in the leg material over a wide temperature range. In order to gain a reasonably high figure of merit (ZT) as well as high thermal electric conversion efficiency, various conditions of the starting material were studied: industrially produced skutterudite powders of p-type DDy(Fe1-xCox)(4)Sb-12 (DD: didymium) and n-type (Mm, Sm)(y)Co4Sb12 (Mm: mischmetal) were used. After a rather fast reaction-melting technique, the bulk was crushed and sieved with various strainers in order to obtain particles below the respective mesh sizes, followed by ball-milling under three different conditions. The dependence of the TE properties (after hot pressing) on the micro/nanosized particles, grains and crystallites was investigated. Optimized conditions resulted in an increase of ZT for bulk material to current record-high values: from ZT similar to 1.1 to ZT similar to 1.3 at 775 K for p-type and from ZT similar to 1.0 to ZT similar to 1.6 at 800 K for n-type, resulting in respective efficiencies (300-850 K) of eta > 13% and eta similar to 16%. (C) 2014 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Synthesis of novel beta-aryl-beta-(methylthio)acroleins via Vilsmeier-Haack protocol as potential 1,3-dielectrophilic three-carbon building blocks

A new general route for the synthesis of novel beta-aryl-beta-(methylthio)acroleins, a class of stable potential 1,3-dielectrophilic synthons, has been reported. The overall protocol involves treatment of either beta-chloroacroleins or their precursor iminium salts (generated in situ from the corresponding active methylene ketones under Vilsmeier-Haack reaction conditions) with S,S-dimethyldithiocarbonates (DDC)/aqueous KOH in either a one-pot or two-step process. The dimethyldithiocarbonate (DDC)/30% aqueous KOH has been shown to be an excellent source of methylthiolate anion. (C) 2014 Elsevier Ltd. All rights reserved.

Synthesis of 5,6-dihydro-4H-1,3-thiazine containing peptide mimics from N-(3-hydroxypropyl)thioamides and epimerization studies

The first synthesis of 1,3-thiazine fused peptide mimics is described from N-(3-hydroxypropyl)thioamides under MsCl/NEt3 conditions. The method is amenable to oligopeptidomimics with polar and apolar side chains. Substantial epimerization occurs at chiral C(2) exo methines in non-Pro fused mimics even under neutral conditions. H-1 NMR and crystal structure analyses indicate that the Thi analogues primarily associate with each other through intermolecular hydrogen bonds, involving the nitrogen of 1,3-thiazine and the N-H of the fused residue, which may be the basis for enamination-racemization process in these peptide mimics. (C) 2014 Elsevier Ltd. All rights reserved.

2-(4-Chlorobenzyl)-6-arylimidazo2,1-b]1,3,4]thiadiazoles: Synthesis, cytotoxic activity and mechanism of action

The cytotoxic activity of a new series of 2-(4'-chlorobenzyl)-5,6-disubstituted imidazo2,1-b]1,3,4]wthiadiazoles against different human and murine cancer cell lines is reported. Among the tested compounds, two derivatives namely 2-(4-chlorobenzyl)-6-(2-oxo-2H-chromen-3-yl)imidazo2,1-1)]1,3,4]th iadiazole-5-carbaldehyde 4i and 2-(4-chlorobenzyl)-6-(2-oxo-2H-chromen-3-ypimidazo2,1-1)]1,3,4]thi adiazol-5-yl thiocyanate 5i emerged as the most potent against all the cell lines. To investigate the mechanism of action, we selected compounds 4i for cell cycle study, analysis of mitochondrial membrane potential and Annexin V-FITC flow cytometric analysis and DNA fragmentation assay. Results showed that 4i induced cytotoxicity by inducing apoptosis without arresting the cell cycle. (C) 2014 Elsevier Masson SAS. All rights reserved.

Synthesis and antiproliferative activity of imidazo2,1-b]1,3,4]thiadiazole derivatives

A series of 2,5,6-substituted imidazo2,1-b]1,3,4]thiadiazole derivatives have been prepared and were tested for antiproliferative activity on cancer cells at the National Cancer Institute. Results showed that molecules with a benzyl group at position 2, exhibited an increase in activity for the introduction of a formyl group at the 5 position. The compound 2-benzyl-5-formyl-6-(4-bromophenyl)imidazo 2,1-b]1,3,4]thiadiazole 22 has been chosen for understanding the mechanism of action by various molecular and cellular biology studies. Results obtained from cell cycle evaluation analysis, analysis of mitochondrial membrane potential and Annexin V-FITC by flow cytometric analysis, ROS production and expression of apoptotic and DNA-repair proteins suggested that compound 22 induced cytotoxicity by activating extrinsic pathway of apoptosis, however, without affecting cell cycle progression. (C) 2014 Elsevier Ltd. All rights reserved.

Hydrochalcogenation of Symmetrical and Unsymmetrical Buta-1,3-diynes with Diaryl Dichalcogenides: Facile Entry to (Z)-1-(Organylchalcogeno)but-1-en-3-yne Derivatives

This work describes an efficient and stereoselective method for the hydrothiolation and -selenation of buta-1,3-diyne derivatives using diaryl disulfides or diselenides, respectively. In the presence of rongalite (HOCH2SO2Na) and potassium carbonate, buta-1,3-diynes undergo stereoselective addition of the thiolate or selenide anion generated in situ from diaryl disulfides or diselenides to afford the corresponding (Z)-1-sulfanyl-or (Z)-1-selanylalk-1-en-3-yne derivatives, respectively. The reaction of buta-1,3-diynes with diaryl disulfides or diselenides at higher temperature (70 degrees C) gave a mixture of monothiolation/selenation and bisthiolation/selenation products in moderate to good yields.

Regioselective Synthesis of Nitrofuran Containing Novel Spiropyrrolidine Library through 1,3-Dipolar Cycloaddition Reactions

A novel series of nitrofuran containing spiropyrrolidines has been synthesized with high regioselectivity in moderate to excellent yields via 1,3-dipolar cycloaddition reaction of azomethine ylides with various substituted chalcones.

Strongly minimal triangulations of (S (3) x S (1))(#3) and (S (3) x S (1))(#3)

A triangulated d-manifold K, satisfies the inequality for da parts per thousand yen3. The triangulated d-manifolds that meet the bound with equality are called tight neighbourly. In this paper, we present tight neighbourly triangulations of 4-manifolds on 15 vertices with as an automorphism group. One such example was constructed by Bagchi and Datta (Discrete Math. 311 (citeyearbd102011) 986-995). We show that there are exactly 12 such triangulations up to isomorphism, 10 of which are orientable.

Synthesis and evaluation of 2,5-di(4-aryloylaryloxymethyl)-1,3,4-oxadiazoles as anti-cancer agents

A series of 2,5-di(4-aryloylaryloxymethyl)-1,3,4-oxadiazoles 9a-j were obtained via multistep synthesis from hydroxybenzophenones 4a-e. The cytotoxicity of compounds 9a-j was evaluated against human leukemia cell lilies (K562 and CEM). The compounds exhibited moderate to good anti-cancer activity with compounds 9b and 9i having a chloro group exhibiting the best activity (IC50 = 10 mu M). Compound 9i exhibited activity against both the cell lines and 9b only exhibited activity against CEM. Further, a lactate dehydrogenase (LDH) assay and DNA fragmentation studies of the compounds 9a-j were also performed. (C) 2013 Elsevier Masson SAS. All rights reserved.

Halogen Bonding and Chalcogen Bonding in 4,7-Dibromo-5, 6-dinitro-2,1,3-benzothiadiazole

An organic solid, 4,7-dibromo-5,6-dinitro-2,1,3-benzothiadiazole, has been designed to serve as an illustrative example to quantitatively evaluate the relative merits of halogen and chalcogen bonding in terms of charge density features. The compound displays two polymorphic modifications, one crystallizing in a non-centrosymmetric space group (Z' = 1) and the other in a centrosymmetric space group with two molecules in the asymmetric unit (Z' = 2). Topological analysis based on QTAIM clearly brings out the dominance of the chalcogen bond over the halogen bond along with an indication that halogen bonds are more directional compared to chalcogen bonds. The cohesive energies calculated with the absence of both strong and weak hydrogen bonds as well as stacking interaction are indicative of the stabilities associated with the polymorphic forms.

Synthesis of Optically Active 2-Amino-1,3,4-oxadiazoles and their Hybrid Peptides

Synthesis of 2-amino-1,3,4-oxadiazole derivatives of N-Cbz(benzyloxycarbonyl)/Boc-protected amino/peptide acids under sonication is described. The conditions involved in the present protocol are simple, mild, and racemization free. The utility of 2-amino group in the substituted oxadiazoles for the incorporation of peptide and ureido bonds to obtain hybrid peptidomimetics is also delineated. The 2-amino-1,3,4-oxadiazole 3b was obtained as a single crystal, and its molecular structure has been confirmed through X-ray crystallographic study.

An Efficient Tertiary Azidation of 1,3-Dicarbonyl Compounds in Water Catalyzed by Tetrabutylammonium Iodide

An efficient azidation of 1,3-dicarbonyl compounds led to tertiary azides in the presence of tetrabutylammonium iodide (TBAI). TBAI is used as a pre-catalyst along with aq. tert-butyl hydroperoxide (TBHP) as an oxidant in aqueous medium. This operationally simple, practical, mild and green method provides an opportunity to synthesize a variety of azidated -keto esters, amides, and ketones in good yields.