Composite depth scales and splice tie points of ODP Sites 178-1095 and 178-1096

During Leg 178, multiple advanced piston corer holes were drilled at four sites (1095, 1096, 1098, and 1099). Cores from the holes were correlated on board to produce composite depths and optimal spliced sections, but the time limitations aboard ship caused these to be preliminary. Recomputed composite depths for Sites 1098 and 1099 in Palmer Deep are reported elsewhere in this volume (doi:10.2973/odp.proc.sr.178.2002). This paper reports recomputed composite depths and spliced sections for Sites 1095 and 1096, located on a sediment drift on the continental rise of the Pacific margin of the Antarctic Peninsula. Limits on the validity of the spliced sections arise from limited multiple coverage and possibly from the effects of ocean swell.

(Table 1) Snow and ice thickness and layering at observation points of the North Pole 34 drifting station

Variability of total alkalinity in sea ice of the high-latitudinal Arctic from November 2005 to May 2006 is considered. For the bulk of one- and two-year sea ice, alkalinity dependence on salinity is described as TA = k x Sal, where k is salinity/alkalinity ratio in under-ice water. The given relationship is valid within a wide range of salinity from 0.1 psu in desalinated fraction of two-year ice to 36 psu in snow on the young ice surface. Geochemically significant deviations from the relationship noted were observed exclusively in snow and the upper layer of one-year ice. In the upper layer of one-year ice, deficiency of alkalinity is observed ( delta TA ~= -0.07 mEq/kg, or -15%). In snow on the surface of the one-year ice, alkalinity excess is formed under desalination ( delta TA is as high as 1.3 mEq/kg, or 380%). Deviations registered are caused by possibility of carbonate precipitation in form of CaCO3 x 6H2O under seawater freezing. It is shown that ice formation and the following melting might cause losses of atmospheric CO2 of up to 3 x 10**12 gC/year.

Composite depth scales, ash layer correlations and splice tie points of ODP Site 186-1151

We present composite depth scales for the multiply cored intervals from Sites 1150 and 1151. These new depth scales place coeval strata recovered in cores from different holes at a single site into a common stratigraphic framework. At Site 1150, double coring between Holes 1150A and 1150B occurred over only a short interval between ~703 and 713 meters below seafloor (mbsf), but this is sufficient to tie the upper portion of the stratigraphic section cored in Hole 1150A to the lower portion cored in Hole 1150B. The upper ~100 m of the sedimentary section at Site 1151 was double cored with the advanced piston corer and partially cored with the rotary core barrel, resulting in the complete recovery of this interval. The composite depth scales were constructed using Splicer software to vertically adjust the relative depths of various cores from one hole to the depths from another hole so as to align distinct physical properties measured on cores. The magnetic susceptibility data was the physical property most easily correlated between holes, and therefore primarily used to create a composite depth scale and spliced stratigraphic section. The spliced section is a continuous stratigraphic section constructed from representative cored intervals from the holes at a site. Both the splice and the composite depth scale can be applied to other data sets from Site 1151 to provide a stratigraphically continuous and laterally consistent basis for interpreting lithologic features or data sets. The resulting composite scale showed a 30% improvement in correlation of the magnetic susceptibility data relative to the original mbsf depth scale, and comparable improvement when applied to the other data sets.