Análise e extração das expectativas dos agentes de mercado em torno da data do COPOM

Este trabalho explora um importante conceito desenvolvido por Breeden & Litzenberger para extrair informações contidas nas opções de juros no mercado brasileiro (Opção Sobre IDI), no âmbito da Bolsa de Valores, Mercadorias e Futuros de São Paulo (BM&FBOVESPA) dias antes e após a decisão do COPOM sobre a taxa Selic. O método consiste em determinar a distribuição de probabilidade através dos preços das opções sobre IDI, após o cálculo da superfície de volatilidade implícita, utilizando duas técnicas difundidas no mercado: Interpolação Cúbica (Spline Cubic) e Modelo de Black (1976). Serão analisados os quatro primeiros momentos da distribuição: valor esperado, variância, assimetria e curtose, assim como suas respectivas variações.

Fundamentos em processamento de linguagem natural: uma proposta para extração de bigramas

É senso comum que o texto escrito é uma importante forma de registrar as informações e que atualmente grande parte desse conteúdo informacional está disponível em meio digital. Entretanto, de maneira geral, os computadores lidam com o texto como sendo uma cadeia de caracteres que não têm nenhum significado. A área de Processamento de Linguagem Natural (PLN) vem se empenhando em extrair significados do texto. Nesse sentido este trabalho apresenta uma revisão desse tema e propõe um método automatizado que utiliza uma heurística determinística denominada Heudet que visa extrair bigramas do texto. A meta é extrair o significado do texto através de um conjunto de expressões multipalavras identificadas. Os resultados obtidos foram melhores se comparados com aqueles que utilizam-se das técnicas de medidas de associação estatística obtidas pelo software Ngram Statistics Package (NSP).

Extração, caracterização estrutural e atividades farmacológicas do olginato obtido da alga marrom Lobophora variegata (Lamouroux) Oliveira Filho, 1977

The alginic acid or alginates are acidic polysaccharides found in brown seaweed widely used in food, cosmetic, medical and pharmaceutical industry. This paper proposes the extraction, chemical characterization and verification of the pharmacological activities of brown seaweed variegata Lobophora . The alginate was extracted from the seaweed Lobophora variegata and part was sulphated for comparative purposes. The native extract showed 42% total sugar, 65% uronic acid, 0,36 % protein and 0% of sulfate, while the sulfate showed 39% , 60%, 0.36% and 27,92 % respectively. The presence of a sulfate group may be observed by the metachromasia with toluidine blue in electrophoresis system and characteristic vibration 1262,34 cm-1 in infrared spectroscopy connections assigned to S = O. We observed the formation of films and beads of native alginate, where more concentrated solution 6% resulted in a thicker and more consistent film. Native alginate showed proliferative activity at concentrations (25 and 50 mcg), (50 mg) and (100 mg) in 3T3 cell line in 24h, 48h and 72h, respectively , as the sulfated (100 mg) in 24 . Also showed antiproliferative or cytotoxic activity in HeLa cells of strain, (25 and 100 mg), (25 and 100 mg) and (25, 50 and 100 mg), to native, now for the sulfate concentrations (100 mg) in 24 (25, 50 and 100 mg) in 48 hours, and (50 and 100 mg ) 72h. For their antioxidant activity, the sulfated alginates have better total antioxidant activity reaching 29 % of the native activity while 7.5 % of activity . For the hydroxyl radical AS showed high inhibition ( between 77-83 % ) in concentrations, but the AN surpassed these numbers in the order of 78-92 % inhibition. The reducing power of AN and AS ranged between 39-82 % . In the method of ferric chelation NA reached 100 % chelating while the AS remained at a plateau oscillating 6.5%. However, in this study , we found alginates with promising pharmacological activities, to use in various industries as an antioxidant / anti-tumor compound

Estudo da adição do resíduo proveniente da extração de minério de ferro em argilas do Rio Grande do Norte

The mining industry is responsible for the generation of waste from their natural process of extraction. The mining impacts in urban areas are of special importance due to the high urban occupation, which are exacerbated due to the proximity of the mined areas and populated areas. Some solutions to wastedisposal have the potential to significantly reduce the environmental risks and liabilities, but represent higher costs in the stages of deployment and operation. The addition of mining waste as raw material in the development of commercial products reduces the environmental impacts, transforming the waste into a positive element in the generation of employment and income. This thesis studies the incorporation of waste iron ore in two clays, one from the ceramic industry of the City of Natal and the other from the ceramic industry of the Seridó Region, both in the State of Rio Grande do Norte, Brazil. Percentages of iron ore waste of 5%, 10% , 15%, 20%, 25% and 30% were used in the tested ceramic matrix. The two clays and the iron ore waste used as part of this investigation were characterized by X-ray diffraction tests, X-ray fluorescence tests, differential thermal analysis, thermogravimetric analysis and dilatometric analysis. The samples were sintered under temperatures of 850 °C, 950 °C and 1050°C at a heating rate of 5 °C/min with isotherms of two hours. The following tests were performed with the samples: linear shrinkage, water absorption, apparent porosity, apparent density, mass loss in fire and bending resistance in order to obtain their physical and mechanical properties. An amount of 5% of waste iron ore in the matrix clay at a temperature of 850 0C resulted in na increase of about 65% in the tensile strength of the clay samples from the Natal ceramic industry. A linear shrinkage of only 0.12% was observed for the samples, which indicates that the physical properties of the final product were not influenced by the addition of the waste

Extração de boro de água produzida sintética por sistema microemulsionado

Boron is a semi-metal present in certain types of soils and natural waters. It is essential to the healthy development of plants and non-toxic to humans, depending on its concentration. It is used in various industries and it s present in water production coming from oil production. More specifically in Rio Grande do Norte, one of the largest oil producers on shore of Brazil, the relationship water/oil in some fields becomes more than 90%. The most common destination of this produced water is disposal in open sea after processing to meet the legal specification. In this context, this research proposes to study the extraction of boron in water produced by microemulsion systems for industrial utilization. It was taken into account the efficiency of extraction of boron related to surfactant (DDA and OCS, both characterized by FT-IR), cosurfactant (butanol and isoamyl alcohol), organic phase (kerosene and heptanes) and aqueous phase (solution of boron 3.6 ppm in alkaline pH). The ratio cosurfactant/ surfactant used was four and the percentage of organic phases for all points of study was set at 5%. It was chosen points with the highest percentage of aqueous phase. Each system was designed for three points of different compositions in relation to the constituents of a pseudoternary diagram. These points were chosen according to studies of phase behavior in pseudoternary diagrams made in previous studies. For this research, points were chosen in the Winsor II region. The excess aqueous solution obtained in these systems was separated and analyzed by ICP OES. For the data set obtained, the better efficiency in the extraction of boron was obtained using the system with DAC, isoamyl alcohol and heptanes, which extracted 49% in a single step. OCS was not viable to the extraction of boron by microemulsion system in the conditions defined in this study

Extração de metais (K, Mg, Ba, Ca, Cr, Mn, Li, Fe) de água produzida utilizando sistema microemulsionado

The produced water is a byproduct formed due to production of petroleum and carries with it a high amount of contaminants such as oil particles in suspension, organic compounds and metals. Thus, these latter pollutants are very difficult to treat because of its high solubility in water. The objective of this work is to use and evaluate a microemulsioned system to remove metals ( K , Mg , Ba , Ca , Cr , Mn , Li , Fe ) of synthetic produced water. For the extraction of metals, it was used a pseudoternary diagram containing the following phases: synthetic produced water as the aqueous phase (AP), hexane as organic phase (OP), and a cosurfactant/surfactant ratio equal to four (C/S = 4) as the third phase, where the OCS (saponified coconut oil) was used as surfactant and n-butanol as cosurfactant. The synthetic produced water was prepared in a bench scale and the region of interest in the diagram for the removal of metals was determined by experimental design called. Ten points located in the phase Winsor II were selected in an area with a large amount of water and small amounts of reagents. The samples were analyzed in atomic absorption spectrometer, and the results were evaluated through a statistical assesment, allowing the efficiency analysis of the effects and their interactions. The results showed percentages of extraction above 90% for the metals manganese, iron, chromium, calcium, barium and magnesium, and around 45% for metals lithium and potassium. The optimal point for the simultaneous removal of metals was calculated using statistical artifact multiple response function (MR). This calculation showed that the point of greatest extraction of metals occurs was the J point, with the composition [72% AP, 9% OP, 19% C/S], obtaining a global extraction percentage about 80%. Considering the aspects analyzed, the microemulsioned system has shown itself to be an effective alternative in the extraction of metals on synthetic produced water remediation

Eosinófilos sanguíneos e fecais em crianças infectadas por helmintos e protozoários

Conselho Nacional de Desenvolvimento Científico e Tecnológico

Extração e pré-tratamento químico de frutanos de Yacon, Polymnia sonchifolia

O processo de desintegração de tubérculos de yacon promove a incorporação de oxigênio que favorece a oxidação de compostos fenólicos e decorrente contaminação do extrato aquoso com cores e odores objetáveis que prejudicam a sua utilização. Este estudo buscou verificar uma metodologia simplificada de extração dos carboidratos presentes nos tubérculos de yacon e efetuar uma primeira remoção de resíduos e compostos originários das cores e odores indesejáveis, utilizando processos de coagulação e precipitação, aplicando tecnologias de baixo custo. Após a etapa de trituração e remoção dos restos celulares, o extrato teve seu pH aumentado para 9,5 e a temperatura para 90ºC, seguido de sedimentação. A remoção deste precipitado foi realizada por filtração em papel após a coagulação com diferentes concentrações de sulfato de alumínio comercial. Verificou-se que a melhor concentração de coagulante no extrato foi de 100ppm, removendo 90,6% dos compostos coloridos. O balanço de massa mostrou uma recuperação de 47,5% dos sólidos totais sendo que 35,6% estão na forma de carboidratos, verificado através da concentrção de carbono orgânico. O processo de pré-tratamento químico causou hidrólise nos oligofrutanos, detectado por um aumento na concentração de açúcares redutores totais, diretamente proporcional à concentração de sulfato de alumínio utilizado no tratamento de coagulação. Análises cromatográficas indicaram o perfil dos açúcares no hidrolisado e a extensão desta hidrólise que foi considerada pequena. A metodologia aplicada mostrou-se fácil, de baixo custo, eficiente e aplicável em agroindústrias nas zonas produtoras desta espécie de raiz tropical.

Estudo de polimorfismos em genes relacionados ao metabolismo do ácido fólico e sua associação com o desenvolvimento de fendas orais não-sindrômicas

The congenital facial clefts are characterized by incomplete formation of the structures that separate the oral and nasal cavity. It is known that several environmental and genetic factors are involved in its development, among these, polymorphisms associated with folic acid metabolism have been investigated. In this sense, the objective was to observe the frequency of polymorphisms C677T and A1298C methylenetetrahydrofolate reductase gene (MTHFR), methionine synthase A2756G of (MTR), A66G of methionine synthase reductase (MTRR) A80G and the reduced folate carrier (RFC1) in patients with non-syndromic oral clefts, trying to match them with their development. Methods: We studied 140 patients with non-syndromic oral clefts and their mothers and 175 control subjects with their mothers, who underwent a questionnaire to obtain family information. Were collecting blood for DNA extraction from patients and their mothers to identify the genotypes of both by PCRRFLP, in addition to carrying out the determination of glucose, AST, ALT and serum creatinine, folic acid and vitamin B12 Serum and plasma homocysteine, and the hemogram. Results: Most patients have cleft lip and palate (55.8%), followed by isolated cleft palate (24.2%) and cleft lip (20%). Regarding gender, 62% of patients were male and 48% female and, after subdivision of the type of screwdriver according to sex was found a prevalence of males in the cracks of the type lip and palate (69 %) and lip (69.2%) and in the case of cleft palate was a female predominance (59%). The average concentration of serum folate in the group of mothers of cleft patients was significantly lower (13.8 ± 2.4 ng / mL) compared with the group of mothers of control subjects (18.8 ± 3.4 ng / mL) This was also observed for the group of cleft children as compared to controls, the dosage of folic acid had a significant difference with values of 15.6 ± 0.6 (ng / mL) and 17.9 ± 0.6 (ng / mL), respectively. For the biochemical measurements of glucose, AST, ALT and creatinine were not statistically different, nor was observed for haematological parameters performed. In assessing the frequency of polymorphisms C677T and A1298C MTHFR, A2756G MTR, MTRR A66G and A80G of the RFC1 there was no statistically significant difference in genotype distribution between cases and controls both for mothers and in the cleft. Conclusion: Although not observed association of polymorphisms with the development of cracks, the decrease in serum folate in the group of cleft patients and their mothers may reflect a disturbance in the metabolism of this metabolite, necessitating further studies such as studies methylation and expression to further elucidate the involvement of folate in the development of oral clefts