Commissioning of a new commercial plastic scintillator system for radiotherapy

Introduction Since 1992 there have been several articles published on research on plastic scintillators for use in radiotherapy. Plastic scintillators are said to be tissue equivalent, temperature independent and dose rate independent [1]. Although their properties were found to be promising for measurements in megavoltage X-ray beams there were some technical difficulties with regards to its commercialisation. Standard Imaging has produced the first commercial system which is now available for use in a clinical setting. The Exradin W1 scintillator device uses a dual fibre system where one fibre is connected to the Plastic Scintillator and the other fibre only measures Cerenkov radiation [2]. This paper presents results obtained during commissioning of this dosimeter system. Methods All tests were performed on a Novalis Tx linear accelerator equipped with a 6 MV SRS photon beam and conventional 6 and 18 MV X-ray beams. The following measurements were performed in a Virtual Water phantom at a depth of dose maximum. Linearity: The dose delivered was varied between 0.2 and 3.0 Gy for the same field conditions. Dose rate dependence: For this test the repetition rate of the linac was varied between 100 and 1,000 MU/min. A nominal dose of 1.0 Gy was delivered for each rate. Reproducibility: A total of five irradiations for the same setup. Results The W1 detector gave a highly linear relationship between dose and the number of Monitor Units delivered for a 10 9 10 cm2 field size at a SSD of 100 cm. The linearity was within 1 % for the high dose end and about 2 % for the very low dose end. For the dose rate dependence, the dose measured as a function of repetition the rate (100–1,000 MU/min) gave a maximum deviation of 0.9 %. The reproducibility was found to be better than 0.5 %. Discussion and conclusions The results for this system look promising so far being a new dosimetry system available for clinical use. However, further investigation is needed to produce a full characterisation prior to use in megavoltage X-ray beams.

Exploring potential factors leading to effective training : an exclusive study on commercial banks in Cambodia

Purpose A previous study found that the quality of education in Cambodia is poor compared to other developing countries. However, the working performance of commercial banks in Cambodia is high. It was speculated that effective training was the main factor underlying this contradiction. Therefore, the main purpose of this article is to explore the elements of training conducted by commercial banks in Cambodia and to examine their relationship with training effectiveness. Design/methodology/approach The research focuses on six factors: training needs assessment; training program; flexibility of training; self-efficacy; social support; and transfer of knowledge. The data came in the form of questionnaires and desk research. A descriptive analytical approach is then used to describe these six factors. Findings The banking industry in Cambodia offers very effective training to its employees. It is also worth noting that more than 80 percent of employees are satisfied with the training, despite few attempts on the part of management to elicit opinions from employees on what training methods should be employed. Research limitations/implications As research studies involving Cambodia are relatively rare, it was difficult for to gather primary data. Because of this limitation and the purpose of this study, descriptive data interpretation was employed. Practical implications – Even though training can make up for poor education, it is only a short-term solution. In the long term, education needs to be enhanced to increase working performance. Originality/value This research provides a good framework for commercial banks in other developing countries to compare. A cross-cultural study is also proposed for future research.

Beyond Bilbao : rethinking flagship cultural development and planning in three California cities

Since the widely publicized revitalization success story of the Guggenheim Museum Bilbao, local governments have been scrambling to create their own flagship cultural projects. Because of the broad public sponsorship of such projects, urban planners need a full understanding of the associated potentials and problems. However, little research specifically examines the localized complexities of the flagship cultural strategy. Examining projects in Los Angeles, San Francisco, and San Jose, California, the article illustrates that much more than impressive architecture influences their catalytic ability. Flagship cultural projects are highly dependent on a variety of contextual factors and, therefore, should be positioned to build on existing arts and related commercial activity rather than gamble that they will generate new development from scratch.

The Construction and Performance of Commercial Contracts

This book analyses the principles underlying the construction and application of a number of boilerplate and other clauses commonly included in commercial contracts. The first Part of the work deals with general principles of interpretation. It then considers clauses which allocate commercial risk; clauses relating to performance; clauses introducing new parties by way of assignment, novation or nomination; clauses such as guarantees and indemnities which create liabilities in third parties; and dispute resolution clauses including governing law. The authors highlight common issues surrounding the application of these clauses in practice and, where appropriate, make drafting recommendations based on their analysis of case law and the operation of relevant statutes. This is a very accessible resource for all commercial practitioners.

Changes to commercial service provision among sex workers from Queensland, Australia

Introduction: The role of commercial sex in facilitating infection transmission is a subject of ongoing empirical enquiry, with little attention to the variety and extent of ‘non-traditional’ commercial services that pose a lesser risk of infection. This study sought to examine the supply and demand of a wide range of traditional and non-traditional commercial sexual services among sex workers and their clients from Queensland, Australia. Methods: Cross-sectional convenience sampling was used to compare female sex workers in 1991 (n=200, aged 16-46 years) and 2003 (n=247, aged 18-57 years) and from male clients in 2003. The client sample comprised 160 male clients aged between 19 and 72 years. Results: Over the comparison period there was a significant increase in the provision of ‘exotic’ or non-traditional sexual services. In 2003, the availability of bondage and discipline, submission, fantasy, use of sex toys, golden showers, fisting and lesbian double acts had increased dramatically, while ‘traditional’ services had mostly remained at similar levels. Moreover, the proportion of sex workers in some industry sectors providing ‘exotic’ commercial services seem to have risen over time. Conclusion: Undoubtedly, the sex industry has professionalised and now includes more sophisticated and specialized suppliers. As with any commercial business, the diversification of services is largely driven with client demand, with the ‘menu’ being generally broader than the majority of client preferences. However, although clients demands for particular commercial sexual services seems to have been met, with regard to anal sex and anal play, supply has failed to meet client demand. Disclosure of Interest Statement: Funding for the 2003 study was provided by the Prostitution Licensing Authority. Acknowledgement and sincere thanks to the men and women who participated in this study.

Dosimetry of cone-defined stereotactic radiosurgery fields with a commercial synthetic diamond detector

Purpose Small field x-ray beam dosimetry is difficult due to a lack of lateral electronic equilibrium, source occlusion, high dose gradients and detector volume averaging. Currently there is no single definitive detector recommended for small field dosimetry. The objective of this work was to evaluate the performance of a new commercial synthetic diamond detector, namely the PTW 60019 microDiamond, for the dosimetry of small x-ray fields as used in stereotactic radiosurgery (SRS). Methods Small field sizes were defined by BrainLAB circular cones (4 – 30 mm diameter) on a Novalis Trilogy linear accelerator and using the 6 MV SRS x-ray beam mode for all measurements. Percentage depth doses were measured and compared to an IBA SFD and a PTW 60012 E diode. Cross profiles were measured and compared to an IBA SFD diode. Field factors, Ω_(Q_clin,Q_msr)^(f_clin,f_msr ), were calculated by Monte Carlo methods using BEAMnrc and correction factors, k_(Q_clin,Q_msr)^(f_clin,f_msr ), were derived for the PTW 60019 microDiamond detector. Results For the small fields of 4 to 30 mm diameter, there were dose differences in the PDDs of up to 1.5% when compared to an IBA SFD and PTW 60012 E diode detector. For the cross profile measurements the penumbra values varied, depending upon the orientation of the detector. The field factors, Ω_(Q_clin,Q_msr)^(f_clin,f_msr ), were calculated for these field diameters at a depth of 1.4 cm in water and they were within 2.7% of published values for a similar linear accelerator. The corrections factors, k_(Q_clin,Q_msr)^(f_clin,f_msr ), were derived for the PTW 60019 microDiamond detector. Conclusions We conclude that the new PTW 60019 microDiamond detector is generally suitable for relative dosimetry in small 6 MV SRS beams for a Novalis Trilogy linear equipped with circular cones.

Commercial Leases in Australia [7th ed.]

Commercial Leases in Australia is a comprehensive guide to understanding and drafting commercial leases agreements in Australia and to managing disputes when they arise.

Design and experimental testing of air slab caps which convert commercial electron diodes into dual purpose, correction-free diodes for small field dosimetry

Purpose Two diodes which do not require correction factors for small field relative output measurements are designed and validated using experimental methodology. This was achieved by adding an air layer above the active volume of the diode detectors, which canceled out the increase in response of the diodes in small fields relative to standard field sizes. Methods Due to the increased density of silicon and other components within a diode, additional electrons are created. In very small fields, a very small air gap acts as an effective filter of electrons with a high angle of incidence. The aim was to design a diode that balanced these perturbations to give a response similar to a water-only geometry. Three thicknesses of air were placed at the proximal end of a PTW 60017 electron diode (PTWe) using an adjustable “air cap”. A set of output ratios (ORfclin Det ) for square field sizes of side length down to 5 mm was measured using each air thickness and compared to ORfclin Det measured using an IBA stereotactic field diode (SFD). k fclin, f msr Qclin,Qmsr was transferred from the SFD to the PTWe diode and plotted as a function of air gap thickness for each field size. This enabled the optimal air gap thickness to be obtained by observing which thickness of air was required such that k fclin, f msr Qclin,Qmsr was equal to 1.00 at all field sizes. A similar procedure was used to find the optimal air thickness required to make a modified Sun Nuclear EDGE detector (EDGEe) which s “correction-free” in small field relative dosimetry. In addition, the feasibility of experimentally transferring k fclin, f msr Qclin,Qmsr values from the SFD to unknown diodes was tested by comparing the experimentally transferred k fclin, f msr Qclin,Qmsr values for unmodified PTWe and EDGEe diodes to Monte Carlo simulated values. Results 1.0 mm of air was required to make the PTWe diode correction-free. This modified diode (PTWeair) produced output factors equivalent to those in water at all field sizes (5–50 mm). The optimal air thickness required for the EDGEe diode was found to be 0.6 mm. The modified diode (EDGEeair) produced output factors equivalent to those in water, except at field sizes of 8 and 10 mm where it measured approximately 2% greater than the relative dose to water. The experimentally calculated k fclin, f msr Qclin,Qmsr for both the PTWe and the EDGEe diodes (without air) matched Monte Carlo simulated results, thus proving that it is feasible to transfer k fclin, f msr Qclin,Qmsr from one commercially available detector to another using experimental methods and the recommended experimental setup. Conclusions It is possible to create a diode which does not require corrections for small field output factor measurements. This has been performed and verified experimentally. The ability of a detector to be “correction-free” depends strongly on its design and composition. A nonwater-equivalent detector can only be “correction-free” if competing perturbations of the beam cancel out at all field sizes. This should not be confused with true water equivalency of a detector.

Commercial friendships between gay salesmen and straight female customers

Perhaps it is now sacrosanct in marketing to contemplate that many service encounters, especially those in retail settings, are social encounters in which bonds between and among customers and employees are critical drivers of consumption (Beatty et al., 1996; Rosenbaum, 2006). Indeed, within retail settings, it is often possible for salespeople and customers to form so-called “commercial friendships” (Price and Arnould, 1999). These friendships result in both salespeople and their customers having social interactions that are close to those experienced in personal friendships (Swan et al., 2001), and which are extremely satisfying for all parties. Outside of marketing, the social science literature (Grigoriou, 2004; Rumens, 2008; Russell, DelPriore, Butterfield, and Hill, 2013) and popular press (de la Cruz and Dolby, 2007; Hopcke and Rafaty, 1999; Tilmann-Healy, 2001, Whitney, 1990) is replete with knowledge regarding the “absolutely fabulous” friendships (Hopcke and Rafaty, 1999) that often form between gay men and straight women. In fact, Western culture regularly highlights the compatibility of gay men and straight women in film, television, and writing, to the extent that they have now influenced popular thinking on the topic, so that gay men and straight females are viewed as sharing common plights and interests (Rumens, 2008). Yet, thus far, marketing researchers have looked askance at the effect of friendships between gay male employees and heterosexual female customers in consumption settings, such as retail stores and boutiques. Indeed, with the exception of Peretz’s (1995) participant observation regarding how young and outwardly gay salesmen use their ambiguous gender to sell women’s clothing, in a Paris-based luxury boutique, any theoretical explorations regarding retail-based commercial friendships between gay salesmen and female customers are non-existent—until now. This research addresses this apparent chasm in the literature by putting forth an original framework that shows how the emotional closeness between gay salesmen and female customers, due to the absence of sexual interest and inter-female competition, results in an intense emotional closeness, that facilitates pleasurable retail transactions, customer satisfaction, loyalty, and positive word-of-mouth. In doing so, this work extends the commercial friendship paradigm by considering retail-based, commercial friendships between an under-researched marketplace dyad; gay men and straight females. It is worth noting here that some straight women may find the idea of commercial friendships with gay salesmen as undesirable, due to the very notion of having relationships with retail organizations or employees (Noble and Phillips, 2004), or a personal disdain for homosexuality.

Design & performance of a networked ad-hoc acoustic communications system using inexpensive commercial CDMA modems

We present a new approach for creating and implementing an ad-hoc underwater acoustic sensor network based on connecting a small processor to the serial port of a commercial CDMA acoustic modem. The processor acts as a "node controller" providing the networking layer that the modems lack. The ad-hoc networking protocol is based on a modified dynamic source routing (DSR) approach and can be configured for maximising information throughput or minimising energy expenditure. The system was developed in simulation and then evaluated during field trials using a 10 node deployment. Experimental results show reliable multi-hop networking under a variety of network configurations, with the added ability to determine internode ranges to within 1.5 m for localisation.

Automation of underground LHD and truck haulage

This paper reviews the state-of-the-art in the automation of underground mining vehicles and reports on the development of an autonomous navigation system under development through the CMTE with sponsorship arranged by AMIRA. Past attempts at automating LHDs and haul trucks are described and their particular strengths and weaknesses are discussed. The auto-guidance system being developed overcomes some of the limitations of state-of-the-art prototype æcommercialÆ systems. It can be retrofitted to existing remote controlled vehicles, uses minimum installed infrastructure and is flexible enough for rapid relocation to alternate routes. The navigation techniques use data fusion of two separate sets of sensors combining natural feature recognition, nodal maps and inertial navigation techniques. Collision detection is incorporated and people and other traffic are excluded from the tramming area. This paper describes the work being done by the group with regard to auto-tramming and also outlines the future goals.