Grain size distribution and percentiles of the sand component from sediments obtained in the southern Great Belt, Baltic Sea

Im Sedimentationsraum der südwestlichen Ostsee verdient der nordöstliche Teil der Kieler Bucht besonderes Interesse. Dort öffnet sich die wichtigste Verbindung zwischen Ostsee und Nordsee. Von den Austauschvorgängen, durch welche diese Meeresräume aufeinander Einfluß nehmen, ist gerade jenes Gebiet entscheidend betroffen. Die Beobachtung der Dynamik des Austausches, die Beobachtung der Transportlast, welche von den Wassermassen bewegt wird, und schließlich auch die Beobachtung der Beziehungen, welche sich zwischen dem Zusammentreffen von Wassermassen unterschiedlicher physikalischer Eigenschaften und der Sedimentbildung ergeben, läßt deshalb vor allem dort wesentliche Hinweise zum Verständnis der Sedimentationsvorgänge in der südlichen Ostsee erhoffen. In der vorliegenden Arbeit wurden an 49 Durchschnittsproben die Korngrößenverteilungen und Schwermineralgehalte von Sedimenten aus dem Südausgang des Großen Beltes untersucht. 1. Es wurden sechs in sich morphologisch etwa gleichwertige Gebiete ausgegliedert, die jeweils durch Sedimente mit ähnlichen Korngrößenverteilungen ausgezeichnet sind. Nach Lage, Typ und genetischer Ausdeutbarkeit fügen sich diese Gebiete dem von O. PRATJE (1939, 1948) gegebenen Modell der Sedimentationszonen gut ein. 2. Innerhalb dieser Gebiete ergibt sich für Sande in mehr als 20 m Wassertiefe südwärts gerichteter Transport. Oberhalb dieser Tiefe läßt sich stellenweise nordwärts gerichteter Transport nachweisen. 3. Der Schwermineralgehalt der Sedimente bleibt immer unter zwei Prozent. Die höchsten Anteile (1,7 bzw. 1,9%) werden in den Sedimenten der Tiefen Rinne und der ufernahen Bereiche des Großen Beltes angetroffen. 4. Die Korngrößenverteilungen der Sedimente werden nach der Lage der Modi in bis zu drei (Kies-, Sand-, Silt-) Komponenten zerlegt. Die Beteiligung der Silt-Komponente wird entscheidend von der Salzgehaltssprungschicht beeinflußt. 5. Es bestehen offensichtlich Zusammenhänge zwischen der Schlicksedimentation und der Salzgehaltsschichtung auch in der weiteren südlichen Ostsee.

Temperature tolerance of western Baltic Sea Fucus vesiculosus - growth, photosynthesis and survival

Fucus vesiculosus L. (Phaeophyceae) is the most abundant and hence ecologically most important primary producer, carbon sink and habitat provider in the western Baltic Sea. All F. vesiculosus L. specimens were collected on 23 April 2014 from a depth of 0.2-1 m in the non-tidal Kiel Fjord, western Baltic Sea (54°27'N; 10°12'E), where this species forms dense and almost monospecific stands on stones. After sampling the algal thalli were stored in a refrigerator box with water from the sampling site, transported to Bremerhaven and stored at 10 °C for one day in filtered seawater. Experiments were conducted with vegetative apical tips (6.7±0.5 cm length), the actively growing region of F. vesiculosus, which were randomly selected and cut from 144 different individuals prior to the experiments. These tips were acclimated to laboratory conditions for three days in filtered seawater at 10 °C before the start of the experiment. Furthermore, 30 additional vegetative apices were freeze-dried to document the initial biochemical status of F. vesiculosus in its native habitat. A temperature gradient was installed in a walk-in constant cooling chamber (15 °C) in nine water baths (5, 10, 15, 20, 24, 26, 27, 28 and 29 °C ± 0.1 °C) which were tempered by thermostats (5, 10 and 15 °C: Huber Variostat CC + Pilot ONE, Peter Huber Kältemaschinen GmbH, Offenburg, Germany; 20 and 28 °C: Haake DC3, Thermo Fisher Scientific Inc., Waltham, USA; 24, 26, 27 and 29 °C: Haake DC10). Every temperature treatment consisted of four 2 L glass beakers (n = 4). In each beaker four F. vesiculosus apices were grown in 2 µm-filtered North Sea water diluted with demineralized water in a ratio of 1:1 and enriched with nutrients after Provasoli (1968; 1/10 enrichment), leading to a salinity of about 15.6 which equaled habitat conditions. The algae were exposed to an irradiance of 130 µmol photons m-2 s-1 ±10 % (Powerstar HGI-TS 150 W, OSRAM GmbH, Bad Homburg, Germany) measured at the top of the beaker under a 16:8 h L:D cycle. The media in the beakers was changed every third or fourth day and aerated with artificial air containing 380 ppm CO2 (gas mixing device; HTK Hamburg GmbH, Hamburg, Germany). Before the experiment, the algae were acclimated to the final temperatures in steps of 5 °C for 2 days each, beginning at 10 °C. After 21 days exposure time, three out of four samples per replicate were freeze-dried for further biochemical analyses, and afterwards the thermostats were turned off to reduce the temperature to 16±0.4 °C for another 10 days permitting growth under post-culture conditions.

Secchi depth maps for the Baltic Sea, 2003-2012, with links to GeoTIFs

Secchi depth is a measure of water transparency. In the Baltic Sea region, Secchi depth maps are used to assess eutrophication and as input for habitat models. Due to their spatial and temporal coverage, satellite data would be the most suitable data source for such maps. But the Baltic Sea's optical properties are so different from the open ocean that globally calibrated standard models suffer from large errors. Regional predictive models that take the Baltic Sea's special optical properties into account are thus needed. This paper tests how accurately generalized linear models (GLMs) and generalized additive models (GAMs) with MODIS/Aqua and auxiliary data as inputs can predict Secchi depth at a regional scale. It uses cross-validation to test the prediction accuracy of hundreds of GAMs and GLMs with up to 5 input variables. A GAM with 3 input variables (chlorophyll a, remote sensing reflectance at 678 nm, and long-term mean salinity) made the most accurate predictions. Tested against field observations not used for model selection and calibration, the best model's mean absolute error (MAE) for daily predictions was 1.07 m (22%), more than 50% lower than for other publicly available Baltic Sea Secchi depth maps. The MAE for predicting monthly averages was 0.86 m (15%). Thus, the proposed model selection process was able to find a regional model with good prediction accuracy. It could be useful to find predictive models for environmental variables other than Secchi depth, using data from other satellite sensors, and for other regions where non-standard remote sensing models are needed for prediction and mapping. Annual and monthly mean Secchi depth maps for 2003-2012 come with this paper as Supplementary materials.

Pedology, geochronology, palynology and macrofossils of soil profiles in the Altdarss area, german Baltic Sea coast

A new site with Lateglacial palaeosols covered by 0.8 - 2.4 m thick aeolian sands is presented. The buried soils were subjected to multidisciplinary analyses (pedology, micromorphology, geochronology, dendrology, palynology, macrofossils). The buried soil cover comprises a catena from relatively dry ('Nano'-Podzol, Arenosol) via moist (Histic Gleysol, Gleysol) to wet conditions (Histosol). Dry soils are similar to the so-called Usselo soil, as described from sites in NW Europe and central Poland. The buried soil surface covers ca. 3.4 km**2. Pollen analyses date this surface into the late Aller0d. Due to a possible contamination by younger carbon, radiocarbon dates are too young. OSL dates indicate that the covering by aeolian sands most probably occurred during the Younger Dryas. Botanical analyses enables the reconstruction of a vegetation pattern typical for the late Allerod. Large wooden remains of pine and birch were recorded.

137Cs concentrations in the southeastern Baltic Sea in 1997-2000

Variations of 137Cs concentration in the southeastern Baltic Sea were investigated over the period 1997-2000, i.e. in 11-14 years after the Chernobyl Nuclear Power Plant accident. Rate of "self-cleaning" proved to be very slow. Some results obtained in 1999 were almost the same as those measured after the accident, in 1986. Calculated results showed that "Chernobyl" caesium-137 would be "cleaned" in the Baltic Sea by 2020-2022. In 2000 average concentration had to be about 50-60 Bq/m**3. Sometimes mentioned concentrations were observed. In some cases higher concentrations averaging from 67 to 80 Bq/m**3 were registered in the southeastern Baltic Sea in 1999; and in some samples 137Cs concentrations were very high. They varied from 110 to 212 Bq/m**3. No steady correlation was observed between 137Cs concentration, salinity and temperature in surface water of the area. Distribution of radionuclide concentration sometimes depends on direction of water mass transport. Abnormally high concentrations of 137Cs in the southeastern Baltic Sea may result from additional radioactive waste discharge.

(Table 1) Sea level during storm surges at various sites along the german Baltic Sea coast

A seawall was constructed in 1897 along the steep coast of Streckelsberg, Usedom Island to stop the cliff retreat. It was destroyed several times by storm induced sea floods, reconstructed and gradually extended to a length of 450 m. After the severe storm event of 1/2.3.1949, no more repair work was implemented. The ruins were no longer capable of preventing further erosion of the Streckelsberg cliff. A new protective structure became a necessity against ongoing erosion, and to check the lowering of the abrasion platform. The construction of three breakwaters began in 1995. A severe storm occurred on 3/4.11.1995 before their completion. Coastal bottom sediment mapping using a sidescan-sonar carried out two days later showed that a channel system down to a depth of 1.5 m was cut into the sand layer covering the sea floor on both sides of the Koserow Bank. The bottom of these channels was paved with gravel and boulders. This layer was encountered in the whole surveyed area below a mobile sand layer. Discharged bodies of fine sand half a meter high and erosional cavities several m2 in diameter around boulders led to the conclusion that an intensive sediment movement down to a depth of 11 m had taken place during the storm. A storm related direction of sediment discharge could not be identified. The existing section of the breakwaters withstood the severe storm.

Mesozooplankton investigations in Bornholm Basin, Baltic Sea

Mesozooplankton production was estimated by using a new sampling technique and two alternative calculation methods. In essence, production estimates are based on significantly higher abundances. The contribution of juvenile stages to copepod and fish dynamics was generally low, so that the omission of juvenile stages in budgets will result in a small error. The situations reported in this study present a unique food web szenario, which in detail, however, was strongly dependent on methodology. Furthermore relations between trophic levels were considered with respect to vertical distribution.

X-ray fotos of 10 sediment cores from the Baltic Sea

Various types of trace fossils have been studied on radiographs of sediment cores from the Western Baltic since the early nineteen sixties. lnvestigations on the endo- und epifauna including their habitats and population densities carried out independently by biologists helped to identify the processes of their formation and classify the structures. Biogenic traces are ubiquitous in both sandy and muddy sediments of the Great Belt, where the bottom waters are weil oxygenated through inflows from the North Sea (through Kattegat-Skagerrak). Almost all types of bioturbation structures encountered in the Kiel Bay are also observed in a variety of shapes and forms, and can be considered as representative for the Western Baltic area. Polychaetes, bivalves and echinoderms were recorded at the sediment surface of the cores, and also in living positions in the sediment. The different types of burrows having distint outlines ('trace fossis'), and those having indistinct outlines ('biodeformational strctures'), and their varying abundance encountered in the area have been linked, wherever possible, to the sediment type, and to the macro-benthos.

Maps and acoustic profiles of free gas distribution, Western Baltic Sea and Kattgat-Skagerrak area

A shallow gas depth-contour map covering the Skagerrak-western Baltic Sea region has been constructed using a relatively dense grid of existing shallow seismic lines. The digital map is stored as an ESRI shape file in order to facilitate comparison with other data from the region. Free gas usually occurs in mud and sandy mud but is observed only when sediment thickness exceeds a certain threshold value, depending on the water depth of the area in question. Gassy sediments exist at all water depths from approx. 20 m in the coastal waters of the Kattegat to 360 m in the Skagerrak. In spite of the large difference in water depths, the depth of free gas below seabed varies only little within the region, indicating a relatively fast movement of methane in the gas phase towards the seabed compared to the rate of diffusion of dissolved methane. Seeps of old microbial methane occur in the northern Kattegat where a relatively thin cover of sandy sediments exists over shallow, glacially deformed Pleistocene marine sediments. Previous estimates of total methane escape from the area may be correct but the extrapolation of local methane seepage rate data to much larger areas on the continental shelf is probably not justified. Preliminary data on porewater chemistry were compared with the free gas depth contours in the Aarhus Bay area, which occasionally suffers from oxygen deficiency, in order to examine if acoustic gas mapping may be used for monitoring the condition of the bay.

Composition of organic matter in suspended matter and bottom sediments of the southeastern Baltic Sea

Data on contents and compositions of hydrocarbons (HCs)-aliphatic (AHCs) and polycyclic aromatic (PAHs) are provided in comparison with contents of total organic carbon (Corg), lipids in suspended matter, and Corg in bottom sediments. Particular attention is paid to distribution of HCs in the area of the Kravtsov oil field. It is established that concentrations of AHCs in water are governed by concentrations of suspended matter and elevated AHC concentrations are confined to coastal areas. In the area of D-6 platform sandy bottom sediments are notable for great variability of HC concentrations, both laterally and from year to year. In summer of 2010 average content of AHCs was 40 ppm (19% of Corg) and that of PAHs was 0.023 ppm. Natural seepage from sediment mass is considered to be a source of HCs along with oil contamination.