Modes of occurrence and geochemistry at DSDP Holes 69-505A and 69-505B

The compositions of chrome spinels of Costa Rica Rift basalts from Deep Sea Drilling Project Site 505 vary depending on their occurrences as (1) inclusions in olivine crystals, (2) inclusions in Plagioclase crystals, and (3) isolated crystals in variolitic or glassy samples. The variations are a consequence of (1) changes of melt compositions as crystallization proceeds, and (2) contrasting behavior of olivine and Plagioclase in competition with spinels for Al and Mg. Some spinels have skeletal rims compositionally less magnesian than mineral cores; however, the cores do not appear to be xenocrysts, unlike some texturally similar spinels in Mid-Atlantic Ridge basalts.

Chemical composition and solubility of ocean phosphatized rocks in seawater

In order to elucidate possibility of limestone phosphatization during contact with seawater two sets of experiments were carried out: that of solubility of natural phosphates in seawater and that of deposition of phosphorus onto calcareous phase. Concentration of phosphorus in seawater used for solubility experiments varied from 39 to 338 µ/l, temperature was 5.5-17.5°C and pH 7.8-7.9. The lowest solubility was characteristic of ancient crystallized samples. The deposition experiments showed that in case when concentration of dissolved phosphate in seawater reaches 3 mg/l it might be sorbed on solid CaCO3 phase without forming its own mineral. The latter is able to form rapidly but only if magnesium is not present in solution. In magnesium-free water calcium phosphates precipitate when concentration of dissolved phosphorus is higher than 0.9-1.2 mg/l. These results show that phosphatization of limestones in marine environment takes place during their contact with pore water but not with marine bottom water.

Description and geochemistry of DSDP Leg 55 Holes

One of the objectives of Leg 55 was to investigate the Tertiary history of sedimentation and environment on the Emperor Seamounts after their volcanic activity. For the three first sites, 430, 431, and 432, drilled on Ojin, Nintoku, and Yömei Seamounts, the Neogene sedimentary deposits are not well represented and are not typical pelagic sediments. Except for two holes (430A and 432), where we found calcareous oozes, the sediments are heterogeneous sands, gravels, and pebbly mudstones with a wide range in grain size and composition. Two phenomena characterize these deposits: the inheritance of volcaniclastic material and its alteration, and the authigenesis of secondary minerals including silicates, phosphates, and ferromanganese oxides formed under volcanic influence in a marine environment.

Geochemistry and lithology of clayey nannofossil ooze turbidites and hemipelagites at ODP Holes 135-834A and 135-835A

The western Lau Basin, between the Central and Eastern Lau Spreading Centers and the Lau Ridge, contains several small, elongate, fault-bounded, partially sediment-filled sub-basins. Sites 834 and 835 were drilled in the oldest part of the Lau Basin in two of these small extensional basins close to the Lau Ridge, formed on late Miocene to early Pliocene oceanic crust. Both sites show a similar sediment sequence that consists of clayey nannofossil oozes and mixed sediments interbedded with epiclastic vitric sands and silts. The vitric sands and silts are largely restricted to the deeper part of the sediment column (early Pliocene-late Pliocene), and the upper part of the sediment column at both sites consists of a distinctive sequence of brown clayey nannofossil ooze, stained by iron and manganese oxyhydroxides (late Pliocene-Holocene). However, the clayey nannofossil ooze sequence at Site 835 is anomalously thick and contains several medium- to very thick beds of matrix-supported, mud-clast conglomerate (interpreted as muddy debris-flow deposits), together with large amounts of redeposited clayey nannofossil ooze and coherent rafted blocks of older hemipelagic material. Redeposited clayey nannofossil oozes can be distinguished from hemipelagic nannofossil oozes using several sedimentological criteria. These include variation in color hue and chroma, presence or absence of bioturbation, presence or absence of scattered foraminifers, grain-size characteristics, variability in calcium carbonate content, presence or absence of pumice clasts, and micropaleontology. Clayey nannofossil ooze turbidites and hemipelagites are also geochemically distinct, with the turbidites being commonly enriched in Mn, Ni, Pb, Zn, Cr, and P. The sediment sequence at Site 835 is dominated by allochthonous sediments, either muddy debris-flow deposits, coherent rafted blocks, or thick clayey nannofossil ooze turbidites. Since 2.9 Ma, only 25% of the 133 m of sediments deposited represents hemipelagic deposition, with an average sedimentation rate of 1.5 cm/k.y.. Allochthonous sediments were the main sediment type deposited during the Brunhes geomagnetic Epoch and make up 80% of the thickness of sediment deposited during this period. Short intervals of mainly hemipelagic deposition occurred from 0.4 to 0.9 Ma, 1.0 to 1.4 Ma, and 1.7 to 2.1 Ma. However, allochthonous sediments were again the dominant sediment type deposited between 2.1 and 2.5 Ma, with a large slide complex emplaced around 2.5 Ma. We conclude that the adjacent high ground, surrounding the basin in which Site 835 was drilled, was affected by marked instability throughout the late Pliocene and Pleistocene. In contrast, sedimentation at Site 834 during this period has been dominated by hemipelagic deposition, with redeposited sediments making up slightly less than 17% of the total thickness of sediment deposited since 2.3 Ma. However, there was a marked increase in frequency and magnitude of redeposited sediments at around 0.2 Ma at Site 834, which broadly corresponds to the onset of a major episode of turbidite and debris-flow emplacement beginning about 0.4 Ma at Site 835. This episode of instability at both sites may be the effect of the approach and passing of the Central Lau propagator at the latitude of Sites 834 and 835 at about 0.5 Ma.

Pleistocene rhyolithic tephra of ODP Leg 181 sites

Taupo Volcanic Zone (TVZ), in the North Island, New Zealand, is arguably the most active Quaternary rhyolitic system in the world. Numerous and widespread rhyolitic tephra layers, sourced from the TVZ, form valuable chronostratigraphic markers in onshore and offshore sedimentary sequences. In deep-sea cores from Ocean Drilling Program (ODP) Leg 181 Sites 1125, 1124, 1123 and 1122, located east of New Zealand, ca 100 tephra beds are recognised post-dating the Plio-Pleistocene boundary at 1.81 Ma. These tephras have been dated by a combination of magnetostratigraphy, orbitally tuned stable-isotope data and isothermal plateau fission track ages. The widespread occurrence of ash offshore to the east of New Zealand is favoured by the small size of New Zealand, the explosivity of the mainly plinian and ignimbritic eruptions and the prevailing westerly wind field. Although some tephras can be directly attributed to known TVZ eruptions, there are many more tephras represented within ODP-cores that have yet to be recognised in near-source on-land sequences. This is due to proximal source area erosion and/or deep burial as well as the adverse effect of vapour phase alteration and devitrification within near-source welded ignimbrites. Despite these difficulties, a number of key deep-sea tephras can be reliably correlated to equivalent-aged tephra exposed in uplifted marine back-arc successions of Wanganui Basin where an excellent chronology has been developed based on magnetostratigraphy, orbitally calibrated sedimentary cycles and isothermal plateau fission track ages on tephra. Significant Pleistocene tephra markers include: the Kawakawa, Omataroa, Rangitawa/Onepuhi, Kaukatea, Kidnappers-B, Potaka, Unit D/Ahuroa, Ongatiti, Rewa, Sub-Rewa, Pakihikura, Ototoka and Table Flat Tephras. Six other tephra layers are correlated between ODP-core sites but have yet to be recognised within onshore records. The identification of Pleistocene TVZ-sourced tephras within the ODP record, and their correlation to Wanganui Basin and other onshore sites is a significant advance as it provides: (1) an even more detailed history of the TVZ than can be currently achieved from the near-source record, (2) a high-resolution tephrochronologic framework for future onshore-offshore paleoenvironmental reconstructions, and (3) well-dated tephra beds correlated from the offshore ODP sites with astronomically tuned timescales provide an opportunity to critically evaluate the chronostratigraphic framework for onshore Plio-Pleistocene sedimentary sequences (e.g. Wanganui Basin, cf. Naish et al. (1998, doi:10.1016/S0277-3791(97)00075-9).

Chemical composition of zeolites in sandstones at DSDP Sites 445 and 446

Andesitic volcaniclastic sandstones of Middle Eocene age recovered from DSDP Sites 445 and 446, a back-arc basin, contain clinoptilolite, heulandite and analcite as a pore-filling cement. Clinoptilolite and heulandite at Sites 445 and 446 contain different chemical composition from other deep-sea clinoptilolites and heulandites. The dominant cation of both clinoptilolite and heulandite is Na+ ion activity in pore water was greater at the time of their formation. Volcanic glass has acted as a precursor for both clinoptilolite and heulandite at Sites 445 and 446. Biogenic silica is also suggested as a precursor. High Na+ ion activity in pore water also helped to transform clinoptilolite and heulandite to analcite downhole. The necessary Na+ ions for this clinoptilolite, heulandite and analcite at Sites 445 and 446 might have been provided by hydrothermal circulation of seawater through more permeable sandstones deposited during early stages of back-arc basin rifting.

Sample descriptions, d-spacing and geochemistry at DSDP Holes 68-501 and 69-504B

Mössbauer analyses were conducted on a sample of saponite selected from DSDP Leg 69 basalt core. The sample was initially placed within a nitrogen-purged container on-board Glomar Challenger approximately three hours after recovery, where it remained until analysis. The Mössbauer data revealed an original, in situ Fe2O3/FeO ratio of 0.46, with both Fe**2+ and Fe**3+ in octahedral coordination. With controlled exposure to air under ambient laboratory storage conditions, the proportion of Fe**3+ increased from an original 30% to 51% over a period of about 11.5 months. The Fe**3+ thus produced remained in octahedral coordination, and no observable changes occurred in the physical appearance of the sample.