TOF-SIMS analysis using C60. Effect of impact energy on yield and damage

C₆₀ has been shown to give increased sputter yields and, hence, secondary ions when used as a primary particle in SIMS analysis. In addition, for many samples, there is also a reduction in damage accumulation following continued bombardment with the ion beam. In this paper, we report a study of the impact energy (up to 120 keV) of C₆₀ on the secondary ion yield from a number of samples with consideration of any variation in yield response over mass ranges up to m/z 2000. Although increased impact energy is expected to produce a corresponding increase in sputter yield/rate, it is important to investigate any increase in sample damage with increasing energy and, hence, efficiency of the ion beams. On our test samples including a metal, along with organic samples, there is a general increase in secondary ion yield of high-mass species with increasing impact energy. A corresponding reduction in the formation of low-mass fragments is also observed. Depth profiling of organic samples demonstrates that when using C₆₀, there does not appear to be any increase in damage evident in the mass spectra as the impact energy is increased.

Guided wave propagation and spectral element method for debonding damage assessment in RC structures

A concrete–steel interface spectral element is developed to study the guided wave propagation along the steel rebar in the concrete. Scalar damage parameters characterizing changes in the interface (debonding damage) are incorporated into the formulation of the spectral finite element that is used for damage detection of reinforced concrete structures. Experimental tests are carried out on a reinforced concrete beam with embedded piezoelectric elements to verify the performance of the proposed model and algorithm. Parametric studies are performed to evaluate the effect of different damage scenarios on wave propagation in the reinforced concrete structures. Numerical simulations and experimental results show that the method is effective to model wave propagation along the steel rebar in concrete and promising to detect damage in the concrete–steel interface.

An artificial intelligence examination of the influence of geological conditions and changes in climate on damage to light structures in Victoria

Damage to light structures in the state of Victoria can be caused by movements of expansive soils. The presentation will present the results of an examination of reports of increasing complaints of house damage in Victoria and particularly in the Melbourne area. The examination analyses the influence of geology and change in climate using Neural Network and Genetic Algorithm approaches and assesses their relative importance in contributing to the cause of the damage.

Compressive deformation and damage of Mg-based metallic glass interpenetrating phase composite containing 30-70 vol% titanium

Mg-based metallic glass interpenetrating phase composites (IPCs) containing 30-70 vol% titanium was fabricated in this study. The effects of reinforced phase volume fraction and interspace on the mechanical properties were investigated systematically. With increasing the volume fraction of titanium, the fracture strength and strain increased up to 1860 MPa and 44%, respectively. The results showed that the critical volume fraction (around 40%) of Ti metal should be required for significantly improving plasticity of IPC. Decreasing the interspace of the titanium phase could lead to enhancement of yield and fracture strength. The deformation behavior and strengthening mechanisms were discussed in detail.