Comportamento de cristalização de lipídios estruturados por interesterificação química de banha e óleo de soja

The aim of this study was to evaluate the crystallization behavior of binary mixtures of lard and soybean oil in different ratios and their respective structured lipids obtained by chemical interesterification. Crystallization kinetics and polarized light microscopy were used to analyze the mixtures before and after interesterification. The addition of soybean oil changed the lard crystallization, by the effect of the dilution. Crystal diameter increased, while the number of crystals decreased, as a function of temperature. Interesterification resulted in the formation of fewer crystals, with larger diameter in comparison with the original mixtures.

Metodologia analítica para quantificar o teor de biodiesel na mistura biodiesel: diesel utilizando espectroscopia na região do infravermelho

Considered the best substitute for diesel, biodiesel can be blended with diesel in any ratio, bringing lots of environmental, economic and social advantages. Brazilian law Nº 11097/2005, proposes the introduction of biodiesel in to the Brazilian energy matrix, mixed with diesel at a minimum percentage of 2%. For consumers and sellers to be sure that the commercialized mixture of biodiesel:diesel contains the correct percentage, it is necessary to develop analytical methodologies to quantify the amount of biodiesel added. This work presents a fast, low-cost and simple methodology to determine the biodiesel proportion in mixtures of biodiesel:diesel, based on infrared spectroscopy.

Stereoselective syntheses of (+)- isoretronecanol and (+)-5-epi-tashiromine via addition of chiral titanium (iv) enolates to cyclic n-acyliminium ions

The stereoselective addition of the titanium (IV) enolates derived from (S)-4-isopropyl-N-4-chlorobutyryl-1,3-thiazolidine-2-thione (8) and from (S)-4-isopropyl-N-4-chloropentanoyl-1,3-thiazolidine-2-thione (9) to N-Boc-2-methoxypyrrolidine (5b) afforded the addition products (+)-10 and (+)-11 in 84% yield in both cases, as 8.6:1 and 10:1 diastereoisomeric mixtures, respectively. A three-step sequence allowed to convert these adducts to (+)-isoretronecanol (1) and (+)-5-epi-tashiromine (2) in 43% and 49% overall yield, respectively.

The influence of crystallization conditions on the filtration characteristics of sulphathiazole suspensions

Cooling crystallization is one of the most important purification and separation techniques in the chemical and pharmaceutical industry. The product of the cooling crystallization process is always a suspension that contains both the mother liquor and the product crystals, and therefore the first process step following crystallization is usually solid-liquid separation. The properties of the produced crystals, such as their size and shape, can be affected by modifying the conditions during the crystallization process. The filtration characteristics of solid/liquid suspensions, on the other hand, are strongly influenced by the particle properties, as well as the properties of the liquid phase. It is thus obvious that the effect of the changes made to the crystallization parameters can also be seen in the course of the filtration process. Although the relationship between crystallization and filtration is widely recognized, the number of publications where these unit operations have been considered in the same context seems to be surprisingly small. This thesis explores the influence of different crystallization parameters in an unseeded batch cooling crystallization process on the external appearance of the product crystals and on the pressure filtration characteristics of the obtained product suspensions. Crystallization experiments are performed by crystallizing sulphathiazole (C9H9N3O2S2), which is a wellknown antibiotic agent, from different mixtures of water and n-propanol in an unseeded batch crystallizer. The different crystallization parameters that are studied are the composition of the solvent, the cooling rate during the crystallization experiments carried out by using a constant cooling rate throughout the whole batch, the cooling profile, as well as the mixing intensity during the batch. The obtained crystals are characterized by using an automated image analyzer and the crystals are separated from the solvent through constant pressure batch filtration experiments. Separation characteristics of the suspensions are described by means of average specific cake resistance and average filter cake porosity, and the compressibilities of the cakes are also determined. The results show that fairly large differences can be observed between the size and shape of the crystals, and it is also shown experimentally that the changes in the crystal size and shape have a direct impact on the pressure filtration characteristics of the crystal suspensions. The experimental results are utilized to create a procedure that can be used for estimating the filtration characteristics of solid-liquid suspensions according to the particle size and shape data obtained by image analysis. Multilinear partial least squares regression (N-PLS) models are created between the filtration parameters and the particle size and shape data, and the results presented in this thesis show that relatively obvious correlations can be detected with the obtained models.

Simultaneous spectrophotometric determination of ezetimibe and simvastatin in pharmaceutical preparations using chemometric techniques

Two spectrophotometric methods are described for the simultaneous determination of ezetimibe (EZE) and simvastatin (SIM) in pharmaceutical preparations. The obtained data was evaluated by using two different chemometric techniques, Principal Component Regression (PCR) and Partial Least-Squares (PLS-1). In these techniques, the concentration data matrix was prepared by using the mixtures containing these drugs in methanol. The absorbance data matrix corresponding to the concentration data matrix was obtained by the measurements of absorbances in the range of 240 - 300 nm in the intervals with Δλ = 1 nm at 61 wavelengths in their zero order spectra, then, calibration or regression was obtained by using the absorbance data matrix and concentration data matrix for the prediction of the unknown concentrations of EZE and SIM in their mixture. The procedure did not require any separation step. The linear range was found to be 5 - 20 µg mL-1 for EZE and SIM in both methods. The accuracy and precision of the methods were assessed. These methods were successfully applied to a pharmaceutical preparation, tablet; and the results were compared with each other.

Determinação espectroscópica multivariada de glucosamina e condroitina em formulações farmacêuticas

The objective of this study was to develop and validate an analytical method for quantification of glucosamine and chondroitin in pharmaceutical formulations. Multivariate calibration combined with infrared spectrophotometry allowed this analysis. 25 mixtures of glucosamine-6-sulphate and chondroitin-6-sulphate were used for calibration. Average errors found with this model during external validation were 1.37% for glucosamine sulphate and 1.30% for chondroitin sulphate. This method presented satisfactory results for assessed variables, what indicating that it is suitable for simultaneous quantification of glucosamine and chondroitin.

Quantificação simultânea de indicadores biológicos de exposição a solventes orgânicos por cromatografia líquida de alta eficiência

Biological monitoring is very important to guarantee health to workers. This method was developed for simultaneous determination of xylene, toluene, styrene and ethylbenzene metabolites. It involves only dilution and centrifugation of urine samples and improved chromatographic conditions. Analyses show recovery > 95%; r² > 0.99; intermediate precision CV% < 6% and % bias < ±10. Exposed subjects presented at least three metabolites in urine. The method proved to be feasible, reliable and important in biological monitoring, especially in exposure to organic solvent mixtures.

Triterpenes and antitubercular activity of Byrsonima crassa

We evaluated the potential antitubercular activity of triterpenes obtained from leaves and bark of Byrsonima crassa. From chloroform extracts of the leaves, by bioassay-guided fractionation, we obtained mixtures of known triterpenes: α-amyrin, β-amyrin and their acetates, lupeol, oleanolic acid, ursolic acid and α-amyrinone. Tested against Mycobacterium tuberculosis, the triterpenes exhibited minimum inhibitory concentrations (MICs) of 31.25 - 312.25 µg/mL. β-amyrin and friedelin, isolated from the chloroform extract of bark, showed MICs of 312.25 and 125 µg/mL respectively. This is the first report of the identification and determination of the activity of B. crassa triterpenes against M. tuberculosis.

Otto Redlich: chemist and gentleman from the "old school"

The name of Otto Redlich is generally remembered as co-author of one of most used equations of state for the calculation of volumetric and thermodynamic properties of pure substances and their mixtures. Nevertheless, he made also important contributions in different areas of chemistry and chemical engineering. Pursuits of race and religious order forced him and his family to leave his native Austria and emigrate to the United States. His professional career included both academic and industrial research achievements.

Síntese e avaliação da atividade fitotóxica de derivados da α-Santonina

Mixtures of α-Santonin and various solvents were irradiated by either high or low pressure mercury lamps. The photochemical reactions afforded lumisantonin (11) (76% in acetonitrile), (3S,3aS,9bS)-3,6,6-trimethyl-3,3a,4,5-tetrahydronafto[1,2-b]furan-2,7(6H,9bH)dione (12) (100% in acetonitrile), 10α-acetoxy-3-oxo-1,7αH,6,11βH-guaia-4-en-6,12-olide (8) (26% in acetic acid), 10α-hydroxy-3-oxo-1,7αH,6,11βH-guaia-4-en-6,12-olide (10) (32%) and (E)-3-((3S,3aS,7aS)-3-methyl-2-oxo-6-(propan-2-ylidene)hexahydrobenzofuran-7-(7aH)-ylidene)propanoic acid (9) (44%) (in water/ acetic acid 1:1, v/v). Lactone 12 was also prepared by irradiation of lumisantonin in diethyl ether. Lactones 8 and 10 were converted, respectively, into the 10α-acetoxy-3β-hydroxy-1,7αH,6,11βH-guaia-4-en-6,12-olide (13) (87%) and 3β,10α-dihydroxy-1,7αH,6,11βH-guaia-4-en-6,12-olide (14) (75%) by sodium borohydride reduction. The effects of the compounds on the development of radicle of Sorghum bicolor and Cucumis sativus were evaluated.

Cromatografia gasosa bidimensional abrangente (GC × GC)

This paper presents the fundamental principles, instrumentation and selected applications of comprehensive two-dimensional gas chromatography (GC × GC). In this technique, introduced in 1991, two capillary columns are coupled and proper modulating interfaces continuously collect the eluate from the first column, transferring it to the second column. The result is a geometric increment in the chromatographic resolution, ensuring separation of extremely complex mixtures in time periods shorter or comparable to those of analysis using conventional gas chromatography and with better detectabilities and sensitivities.

Evaluation of anti-Mycobacterium tuberculosis activity of Campomanesia adamantium (Myrtaceae)

The anti-Mycobacterium tuberculosis activity of Campomanesia adamantium fruits extracts were evaluated. Six compounds, identified as flavanones and chalcones were quantified by HPLC-DAD-UV. Promising antitubercular activity was observed with ethyl acetate extract (MIC 62.5 µg/mL) and their fractions (MIC values ranging from 39 to above 250 µg/mL). The better MIC result of 39 µg/mL was associated with two fractions that contain bigger amounts of 5,7-dihydroxy-6, 8-di-C-methylflavanone and 2',4'-dihydroxy-3',5'-dimethyl-6'-methoxychalcone. These compounds exhibited MICs >250 and 62.5 µg/mL, respectively, while their mixtures showed values ranging from 62.5 to 7.8 µg/mL, demonstrating a synergism between them.

Construção de um calorímetro isotérmico diferencial de alta sensibilidade e baixo custo

The high cost of sensitivity commercial calorimeters may represent an obstacle for many calorimetric research groups. This work describes the construction and calibration of a batch differential heat conduction calorimeter with sample cells volumes of about 400 μL. The calorimeter was built using two small high sensibility square Peltier thermoelectric sensors and the total cost was estimated to be about US$ 500. The calorimeter was used to study the excess enthalpy of solution of binary mixtures of liquids, as a function of composition, for the following binary systems of solvents: water + 1,4-dioxane or + dimethylsulfoxide at 298,2 ± 0,5 K.

Corrosão metálica associada ao uso de combustíveis minerais e biocombustíveis

Fuels and biofuels have a major importance in the transportation sector of any country, contributing to their economic development. The utilization of these fuels implies their closer contact to metallic materials, which comprise vehicle, storage, and transportation systems. Thus, metallic corrosion could be related to fuels and biofuels utilization. Specially, the corrosion associated to gasoline, ethanol, diesel, biodiesel, and their mixtures is discussed in this article. Briefly, the ethanol is the most corrosive and gasoline the least. Few investigations about the effect of biodiesel indicate that the corrosion is associated to their unsaturation degree and the corrosion of diesel is related to its acidity.

Caracterização da fusão peritética do cloreto de sódio di-hidratado por curvas de aquecimento

Binary mixture phase diagrams are normally obtained from thermal analysis involving freezing point curves. However, that approach is not always reliable and easy to follow to all kinds of mixtures in any proportion. In fact, even for a simple system, such as NaCl-H2O, this freezing methodology gives mixed results when one starts from a solid-solution system, due mostly to the formation of the NaCl.2H2O, which has an incongruent melting point, and the dependence of its solubility with the temperature. In this work we report a trustworthy, simple and cheap method involving heating curves to drawn the NaCl-H2O phase diagram.