Effect of offset web holes on web crippling strength of cold-formed steel channel sections under end-two-flange loading condition

A combination of experiments and non-linear finite element analyses are used to investigate the effect of offset web holes on the web crippling strength of cold-formed steel channel sections under the end-two-flange (ETF) loading condition; the cases of both flanges fastened and unfastened to the support are considered. The web holes are located at the mid-depth of the sections, with a horizontal clear distance of the web holes to the near edge of the bearing plate. Finite element analysis results are compared against the laboratory test results; good agreement was obtained in terms of both strength and failure modes. A parametric study was then undertaken to investigate both the effect of the position of holes in the web and the cross-section sizes on the web crippling strength of the channel sections. It was demonstrated that the main factors influencing the web crippling strength are the ratio of the hole depth to the depth of the web, and the ratio of the distance from the edge of the bearing to the flat depth of the web. Design recommendations in the form of web crippling strength reduction factors are proposed in this study.

Exploring Virtual-Channel architecture in FPGA based Networks-on-Chip

A novel Networks-on-Chip (NoC) router architecture specified for FPGA based implementation with configurable Virtual-Channel (VC) is presented. Each pipeline stage of the proposed architecture has been optimized so that low packet propagation latency and reduced hardware overhead can be achieved. The proposed architecture enables high performance and cost effective VC NoC based on-chip system interconnects to be deployed on FPGA.

Body-centric ultra-wideband multi-channel characterisation and spatial diversity in the indoor environment

This study presents the findings of an empirical channel characterisation for an ultra-wideband off-body optic fibre-fed multiple-antenna array within an office and corridor environment. The results show that for received power experiments, the office and corridor were best modelled by lognormal and Rician distributions, respectively [for both line of sight (LOS) and non-LOS (NLOS) scenarios]. In the office, LOS measurements for t and tRMS were both described by the Normal distribution for all channels, whereas NLOS measurements for t and t were Nakagami and Weibull distributed, respectively. For the corridor measurements, LOS for t and t were either Nakagami or normally distributed for all channels, with NLOS measurements for t and t being Nakagami and normally distributed, respectively. This work also shows that achievable diversity gain was influenced by both mutual coupling and cross-correlation co-efficients. Although the best diversity gains were 1.8 dB for three-channel selective diversity combining, the authors present recommendations for improving these results. © The Institution of Engineering and Technology 2013.

Body shadowing mitigation using differentiated LOS/NLOS channel models for RSSI-based Monte Carlo personnel localization

Research into localization has produced a wealth of algorithms and techniques to estimate the location of wireless network nodes, however the majority of these schemes do not explicitly account for non-line of sight conditions. Disregarding this common situation reduces their accuracy and their potential for exploitation in real world applications. This is a particular problem for personnel tracking where the user's body itself will inherently cause time-varying blocking according to their movements. Using empirical data, this paper demonstrates that, by accounting for non-line of sight conditions and using received signal strength based Monte Carlo localization, meter scale accuracy can be achieved for a wrist-worn personnel tracking tag in a 120 m indoor office environment. © 2012 IEEE.