Contactless and replaceable modularized battery energy storage system for electric vehicles

A novel replaceable, modularized energy storage system with wireless interface is proposed for a battery operated electric vehicle (EV). The operation of the proposed system is explained and analyzed with an equivalent circuit and an averaged state-space model. A non-linear feedback linearization based controller is developed and implemented to regulate the DC link voltage by modulating the phase shift ratio. The working and control of the proposed system is verified through simulation and some preliminary results are presented.

A matrix converter based Inductive Power Transfer system

Typical Inductive Power Transfer (IPT) systems employ two power conversion stages to generate a high frequency current from low frequency utility supply. This paper proposes a matrix converter based IPT system that facilitates the generation of high frequency current through a single power conversion stage. The proposed matrix converter topology transforms a 3-phase low frequency voltage system to a high frequency single phase voltage which in turn powers a series compensated IPT system. A comprehensive mathematical model is developed to investigate the behavior of the proposed IPT topology. Theoretical results are presented in comparison to simulations, which are performed in Matlab/ Simulink, to demonstrate the applicability of the proposed concept and the validity of the developed model.

A Tobit model for analyzing speed limit compliance in work zones

Poor compliance with speed limits is a serious safety concern in work zones. Most studies of work zone speeds have focused on descriptive analyses and statistical testing without systematically capturing the effects of vehicle and traffic characteristics. Consequently, little is known about how the characteristics of surrounding traffic and platoons influence speeds. This paper develops a Tobit regression technique for innovatively modeling the probability and the magnitude of non-compliance with speed limits at various locations in work zones. Speed data is transformed into two groups—continuous for non-compliant and left-censored for compliant drivers—to model in a Tobit model framework. The modeling technique is illustrated using speed data from three long-term highway work zones in Queensland, Australia. Consistent and plausible model estimates across the three work zones support the appropriateness and validity of the technique. The results show that the probability and magnitude of speeding was higher for leaders of platoons with larger front gaps, during late afternoon and early morning, when traffic volumes were higher, and when higher proportions of surrounding vehicles were non-compliant. Light vehicles and their followers were also more likely to speed than others. Speeding was more common and greater in magnitude upstream than in the activity area, with higher compliance rates close to the end of the activity area and close to stop/slow traffic controllers. The modeling technique and results have great potential to assist in deployment of appropriate countermeasures by better identifying the traffic characteristics associated with speeding and the locations of lower compliance.

Implementing a new genre of eHealth system in a reticent environment

This tutorial primarily focuses on the social aspects of implementing a novel eHealth systems called Accountable-eHealth (AeH) systems. The main focus of AeH systems is mitigating information privacy concerns whilst facilitating appropriate access to information for users, and is based on the principles of information accountability (IA).

Mathematical modelling and experimental validation of solar assisted heat pump system

Singapore is located at the equator, with abundant supply of solar radiation, relatively high ambient temperature and relative humidity throughout the year. The meteorological conditions of Singapore are favourable for efficient operation of solar energy based systems. Solar assisted heat pump systems are built on the roof-top of National University of Singapore’s Faculty of Engineering. The objectives of this study include the design and performance evaluation of a solar assisted heat-pump system for water desalination, water heating and drying of clothes. Using MATLAB programming language, a 2-dimensional simulation model has been developed to conduct parametric studies on the system. The system shows good prospect to be implemented in both industrial and residential applications and would give new opportunities in replacing conventional energy sources with green renewable energy.

Grid-side cascade inverter system as an interface for wind energy storage

Additional converters that are used to interface energy storage devices incur power losses as well as increased system cost and complexity. The need for additional converters can be eliminated if the grid side inverter can itself be effectively used as the interface for energy storage. This paper therefore proposes a technique whereby the grid side inverter can also be used as an interface to connect a supercapacitor energy storage for wind energy conversion systems. The proposed grid side inverter is formed by cascading a 3-level inverter and a 2-level inverter through a coupling transformer. The three-level inverter is the main inverter and it is powered by the rectified output of the wind turbine coupled AC generator while the 2-level auxiliary inverter is connected to the super capacitor bank that is used to compensate short term power fluctuations. Novel modulation and control techniques are proposed to address the problems associated with non-integer and dynamically-changing dc-link voltage ratio, which is caused by the random nature of wind. Simulation results are presented to verify the efficacy of the proposed system in suppressing short term wind power fluctuations.

Mathematical Models of Tumor-Immune System Dynamics

"This collection of papers offers a broad synopsis of state-of-the-art mathematical methods used in modeling the interaction between tumors and the immune system. These papers were presented at the four-day workshop on Mathematical Models of Tumor-Immune System Dynamics held in Sydney, Australia from January 7th to January 10th, 2013. The workshop brought together applied mathematicians, biologists, and clinicians actively working in the field of cancer immunology to share their current research and to increase awareness of the innovative mathematical tools that are applicable to the growing field of cancer immunology. Recent progress in cancer immunology and advances in immunotherapy suggest that the immune system plays a fundamental role in host defense against tumors and could be utilized to prevent or cure cancer. Although theoretical and experimental studies of tumor-immune system dynamics have a long history, there are still many unanswered questions about the mechanisms that govern the interaction between the immune system and a growing tumor. The multidimensional nature of these complex interactions requires a cross-disciplinary approach to capture more realistic dynamics of the essential biology. The papers presented in this volume explore these issues and the results will be of interest to graduate students and researchers in a variety of fields within mathematical and biological sciences."--Publisher website

Modelling of a magnetocaloric system for cooling in the kilowatt range

A numerical time-dependent model of an active magnetic regenerator (AMR) was developed for cooling in the kilowatt range. Earlier numerical models have been mostly developed for cooling power in the 0.4 kW range. In contrast, this paper reports the applicability of magnetic refrigeration to the 50 kW range. A packed bed active magnetic regenerator was modelled and the influence of parameters such as geometry and operating parameters were studied for different geometries. The pressure drop for AMR bed length and particle diameter was also studied. High cooling power and coefficient of performance (COP) were achieved by optimization of the diameter of the magnetocaloric powder particles and operating frequency. The optimum operating conditions of the AMR for a cooling capacity of 50 kW was determined for a temperature span of 15 K. The predicted coefficient of performance (COP) was found to be ∼6, making it an attractive alternative to vapour compression systems.

Efficiency optimization for bidirectional IPT system

Compared with unidirectional inductive power transfer (UIPT) systems which are suitable for passive loads, bidirectional IPT (BIPT) systems can be used for active loads with power regenerative capability. There are numerous BIPT systems that have been proposed previously to achieve improved performance. However, typical BIPT systems are controlled through modulation of phase-shift of each converter while keeping the relative phase angle between voltages produced by two converters at ± 90 degrees. This paper presents theoretical analysis to show that there is a unique phase shift for each converter at which the inductive coils losses of the system is minimized for a given load. Simulated results of a BIPT system, compensated by CLCL resonant networks, are presented to demonstrate the applicability of the proposed concept and the validity of the mathematical model.

Cascaded multilevel converter based bidirectional inductive power transfer (BIPT) system

A typical low power IPT system employs an H-Bridge converter with a simple control strategy to generate a high frequency current from DC power supply. This paper proposes a cascaded multilevel converter for bidirectional IPT (BIPT) systems, which is suitable for low to medium power applications as well as for situations such as PV cells where several individual DC sources are to be utilized. A novel modulation strategy is proposed for the multilevel converter with the aim of minimizing switching losses. Series - Series (SS) compensation circuit is adopted for the IPT system and a mathematical model is presented to minimize the coil losses of the system under varying output power. Theoretical results presented in comparison to the simulations to demonstrate the applicability of the proposed concept and the validity of the developed model. The experimental results show the feasibility of the proposed phase shift modulation.

My System of Career Influences MSCI (Adult) Facilitator's Guide

Career development in the 21st century presents many challenges and opportunities to adults. They must now navigate a complex and rapidly changing world of work influenced by technology, globalisation and fluctuating economic conditions. The My System of Career Influences (MSCI) (Adult) is a qualitative career assessment tool based on the constructivist theory from cognitive psychology. Acknowledged as the third wave in cognitive science after psychoanalysis and behaviourism, constructivism emphasises the individual in the assessment and counselling process. Individuals actively participate in the construction of their own reality and are encouraged to respond to and deal with both anticipated and unanticipated events that influence their careers. The tool comprises a facilitator guide and participant workbooks. The guide describes the Systems Theory Framework of career development that provides the theoretical background to the MSCI as well as a step-by-step user guide to conducting the MSCI (Adult) process with individuals and groups. Each participant uses the accompanying MSCI (Adult) Workbook (sold separately) which they can complete and keep for later reference. With its attention to an holistic and storied approach to career intervention My System of Career Influences (MSCI) (Adult) is an essential resource for all career practitioners working with adults in today's workplaces.

My System of Career Influences MSCI (Adult) Workbook

NOTE: This client booklet is to be used in conjunction with the MSCI (Adult) Facilitators Guide. Career development in the 21st century presents many challenges and opportunities. Throughout your life you will make countless decisions and experience numerous transitions. Each decision may be subject to a range of influences, for example people we know may give us an opinion, we may be attracted to a particular place or a particular salary, or we may simply want a change. No two people will have the same pattern of influences. The My System of Career Influences MSCI (Adult) is a qualitative career assessment reflection process based on recent developments in theory and practice. It uses a constructivist view and encourages a narrative and story-based approach to your career development. It has been used successfully with employees by career development practitioners working in a range of businesses and organisations from large to small and in one-on-one career counselling sessions as well as in a group setting.

A Tradable Permit System in an Intertemporal Economy

It is known that in an intertemporal competitive economy, a tradable permit system may not achieve efficiency without setting appropriate permit interest rates (i.e., rewards for holding permits). To find the rates, however, we need to know in advance the path of efficient permit prices, which is difficult to obtain. This study intends to solve this problem in two ways. First, we analyze a special case in which the permit interest rates are given by a simple rule. For example, if the marginal abatement cost of pollution emission is constant, then the appropriate rate is to equal the monetary interest rate. As is the case for global warming, if the damage is caused in the future far beyond the planning period of the environmental program, the appropriate rate coincides with the marginal self-recovery of environmental stock under certain conditions. As a second approach, we propose a tradable permit system with a permit bank, as a mechanism by which the permit interest rates are generated endogenously without governmental intervention other than the issuance of permits. However, we also show that this approach raises the problem of indeterminacy of the equilibrium. © 2013 Springer Science+Business Media Dordrecht.

Use of the biolistic particle delivery system to transform fungal genomes

Biolistic delivery of transforming DNA into fungal genomes, especially when performed on uninucleate haploid conidia, has proven successful in bypassing the time-consuming repetitive purification of protoplasts used for the widely applied polyethylene glycol-mediated method. Biolistic transformation is also relatively quick compared to other available methods and provides a high percentage of stable transformants.

Environmental information provision, market valuation, and firm incentives: An empirical study of the Japanese PRTR system

The environmental performance of a listed firm could affect its level of investment in pollution prevention and its access to financial markets. Previous studies using Tobin's q that explore market response to environmental performance do not distinguish between the impact of performance on investment and market response, which may mislead conclusions. To overcome this problem, we simultaneously estimate the functions of the intangible asset, the replacement cost, and the toxic chemical risk. We find that the Japanese financial market does not value risk associated with toxic chemical releases. Nevertheless, even without market valuation, firms increase investment to reduce pollution. © 2010 by the Board of Regents of the University of Wisconsin System.