Optical and dielectric relaxor behaviour of Ba(Zr(0.25)Ti(0.75))O(3) ceramic explained by means of distorted clusters

In this work, Ba(Zr(0.25)Ti(0.75))O(3) ceramic was prepared by solid-state reaction. This material was characterized by x-ray diffraction and Fourier transform Raman spectroscopy. The temperature dependent dielectric properties were investigated in the frequency range from 1 kHz to 1 MHz. The dielectric measurements indicated a diffuse phase transition. The broadening of the dielectric permittivity in the frequency range as well as its shifting at higher temperatures indicated a relaxor-like behaviour for this material. The diffusivity and the relaxation strength were estimated using the modified Curie-Weiss law. The optical properties were analysed by ultraviolet-visible (UV-vis) absorption spectroscopy and photoluminescence (PL) measurements at room temperature. The UV-vis spectrum indicated that the Ba(Zr(0.25)Ti(0.75))O(3) ceramic has an optical band gap of 2.98 eV. A blue PL emission was observed for this compound when excited with 350 nm wavelength. The polarity as well as the PL property of this material was attributed to the presence of polar [TiO(6)] distorted clusters into a globally cubic matrix.

Rock magnetism in soils of the Pampean plain. Buenos Aires province, Argentina. Linking climate and magnetic behaviour

Results of the study of Argiudolls in two localities (Zarate and Veronica) of the Pampean plain, Argentina, are presented in this contribution. This is a typical area covered by loess. The magnetic studies carried out allowed to determine the presence of detrital magnetite and titanomagnetite, as well as maghemite, pedogenic goethite and superparamagnetic particles (SP). In Veronica soils, a depletion of ferromagnetic minerals is recorded The dominant process in these soils has been the reductive loss of detrital magnetite and titanomagnetite. This is associated with a greater degree of evolution of the soil, which is determined by the concentration and type of detected clays. The higher clay concentration in these soils facilitated reducing conditions and a greater loss of detrital magnetic particles. The loss is reinforced under poor drainage conditions. In the poorly drained soil of Zarate, a concentration of magnetic particles is observed in the Bt horizon, which is associated with an illuviation process. The well drained soil of the same locality shows neoformation of SP particles. These particles would have an ephemeral life until a new wet period in the annual cycle occurs. Although some characteristics of the magnetic signal appear reinforced by the conditions of drainage, this aspect does not seem to be too significant, at least in the Pampean region with low topographic gradients.

Short-time behaviour of demand and price viewed through an exactly solvable model for heterogeneous interacting market agents

We introduce a stochastic heterogeneous interacting-agent model for the short-time non-equilibrium evolution of excess demand and price in a stylized asset market. We consider a combination of social interaction within peer groups and individually heterogeneous fundamentalist trading decisions which take into account the market price and the perceived fundamental value of the asset. The resulting excess demand is coupled to the market price. Rigorous analysis reveals that this feedback may lead to price oscillations, a single bounce, or monotonic price behaviour. The model is a rare example of an analytically tractable interacting-agent model which allows LIS to deduce in detail the origin of these different collective patterns. For a natural choice of initial distribution, the results are independent of the graph structure that models the peer network of agents whose decisions influence each other. (C) 2009 Elsevier B.V. All rights reserved.

Behaviour of TiO(2)-SiMgO(x) hybrid composites on the solar photocatalytic degradation of polluted air

The photocatalytic performance of TiO(2)-SiMgO(x) ceramic plates for trichloroethylene abatement in gas phase has been evaluated under sun irradiance conditions. A continuous flow Pyrex glass reactor fixed on the focus of a compound parabolic collector has been used. The performance of the hybrid photocatalyst has been evaluated as the variation of TCE conversion and reaction products formation with the solar irradiance at different total gas flow, TCE concentration, and water vapour content. SiMgO(x) not only provides adsorbent properties to the photocatalyst, but it also allows the effective use of the material during low solar irradiance conditions. The adsorption-desorption phenomena play a pivotal role in the behaviour of the system. Thus, TCE conversion curves present two different branches when the sun irradiance increases (sunrise) or decreases (sunset). CO(2), COCl(2) and DCAC were the most relevant products detected. Meanwhile CO(2) concentration was insensitive to the branch analysed, COCl(2) or DCAC were not indicating the ability of these compounds to be adsorbed on the composite. An increase of the UV irradiation at total TCE conversion promotes the CO(2) selectivity. The excess of energy arriving to the reactor favours the direct reaction pathway to produce CO(2). The photonic efficiency, calculated as a function of the rate of CO(2) formation, decreases linearly with the solar irradiance up to around 2 mW cm(-2), where it becomes constant. For decontamination systems high TCE conversion is pursuit and then high solar irradiance values are required, in spite of lower photonic efficiency values. The present photocatalyst configuration, with only 17% of the reactor volume filled with the photoactive material, allows total TCE conversion for 150 ppm and 1 L min(-1) in a wide sun irradiance window from 2 to 4 mW cm(-2). The incorporation of water vapour leads to an increase of the CO(2) selectivity keeping the TCE conversion around 90%, although significant amounts of COCl(2) were observed. (c) 2010 Elsevier B.V. All rights reserved.

Electrochemical Behaviour of the AA2024 Aluminium Alloy Modified with Self-Assembled Monolayers/Polyaniline Double Films

The electrochemical characteristics of the AA2024 aluminium alloy modified with octadecyltrimethoxysilane (ODTMS) + polyaniline (PANi) and propiltrimethoxysilane (PTMS) + (PANi) were studied in the present work. The results show that the different protective coatings shift the values of corrosion and pit potentials to more positive values making the system nobler and indicate that the double film ODTMS + PANi present the best protection against corrosion characteristics, that is probably due to the two contributions: anodic protection associated with the barrier effect.

Pupils' Interaction with the Exhibits According to the Learning Behaviour Model

Science centres are one of the best opportunities for informal study of natural science. There are many advantages to learn in the science centres compared with the traditional methods: it is possible to motivate and supply visitors with the social experience, to improve people’s understandings and attitudes, thereby bringing on and attaching wider interest towards natural science. In the science centres, pupils show interest, enthusiasm, motivation, self-confidence, sensitiveness and also they are more open and eager to learn. Traditional school-classes however mostly do not favour these capabilities. This research presents the qualitative study in the science centre. Data was gathered from observations and interviews at Science North science centre in Canada. Pupils’ learning behaviours were studied at different exhibits in the science centre. Learning behaviours are classified as follows: labels reading, experimenting with the exhibits, observing others or exhibit, using guide, repeating the activity, positive emotional response, acknowledged relevance, seeking and sharing information. In this research, it became clear that in general pupils do not read labels; in most cases pupils do not use the guides help; pupils prefer exhibits that enable high level of interactivity; pupils display more learning behaviours at exhibits that enable a high level of interactivity.

Vad påverkar föräldrars sätt att tillgodose barns behov av regelbundet umgänge? : En applikation på Theory of Planned Behaviour

Föreliggande undersökning var en attitydundersökning baserad på Theory of Planned Behaviour där attityd, subjektiv norm, upplevd kontroll samt intention anses kunna predicera beteende. Syftet med undersökningen är försöka ta reda på vilka faktorer som påverkar hur mycket tid man som förälder umgås med sina barn efter en separation eller skilsmässa eftersom många barn i den situationen förlorar kontakten med den ena föräldern. 36 försöksdeltagare besvarade ett frågeformulär bestående av 31 frågor och påståenden gällande umgänge. Resultaten visar att tiden man som förälder umgås med sina barn efter en skilsmässa beror på intention och upplevd kontroll. Intentionen förklaras av upplevd kontroll och dom förväntningar man upplever från omgivningen. Attityden hade endast liten betydelse i modellen.

Behaviour of Surface Defects in Wire Rod Rolling

Defects are often present in rolled products, such as wire rod. The markets demand for wire rod without any defects has increased. In the final wire rod products, defects originating from the steel making, casting, pre-rolling of billets and during the wire rod rolling can appear. In this work, artificial V-shaped longitudinal surface cracks has been analysed experimentally and by means of FEM. The results indicate that the experiments and FEM calculations show the same tendency except in two cases, where instability due to a fairly “round” false round bars disturbed the experiment. FE studies in combination with practical experiments are necessary in order to understand the behaviour of the material flows in the groove and to explain whether the crack will open up as a V-shape or if it will be closed as an I-shape.

To what extent are CO2 emissions from intra-urban shopping trips by cars affected by drivers’ travel behaviour and store location?

Transportation is seen as one of the major sources of CO2 pollutants nowadays. The impact of increased transport in retailing should not be underestimated. Most previous studies have focused on transportation and underlying trips, in general, while very few studies have addressed the specific affects that, for instance, intra-city shopping trips generate. Furthermore, most of the existing methods used to estimate emission are based on macro-data designed to generate national or regional inventory projections. There is a lack of studies using micro-data based methods that are able to distinguish between driver behaviour and the locational effects induced by shopping trips, which is an important precondition for energy efficient urban planning. The aim of this study is to implement a micro-data method to estimate and compare CO2 emission induced by intra-urban car travelling to a retail destination of durable goods (DG), and non-durable goods (NDG). We estimate the emissions from aspects of travel behaviour and store location. The study is conducted by means of a case study in the city of Borlänge, where GPS tracking data on intra-urban car travel is collected from 250 households. We find that a behavioural change during a trip towards a CO2 optimal travelling by car has the potential to decrease emission to 36% (DG), and to 25% (NDG) of the emissions induced by car-travelling shopping trips today. There is also a potential of reducing CO2 emissions induced by intra-urban shopping trips due to poor location by 54%, and if the consumer selected the closest of 8 existing stores, the CO2 emissions would be reduced by 37% of the current emission induced by NDG shopping trips.

Depicting the interplay between organisational tiers in the use of a national quality registry to develop quality of care in Sweden

BACKGROUND: With a pending need to identify potential means to improved quality of care, national quality registries (NQRs) are identified as a promising route. Yet, there is limited evidence with regards to what hinders and facilitates the NQR innovation, what signifies the contexts in which NQRs are applied and drive quality improvement. Supposedly, barriers and facilitators to NQR-driven quality improvement may be found in the healthcare context, in the politico-administrative context, as well as with an NQR itself. In this study, we investigated the potential variation with regards to if and how an NQR was applied by decision-makers and users in regions and clinical settings. The aim was to depict the interplay between the clinical and the politico-administrative tiers in the use of NQRs to develop quality of care, examining an established registry on stroke care as a case study. METHODS: We interviewed 44 individuals representing the clinical and the politico-administrative settings of 4 out of 21 regions strategically chosen for including stroke units representing a variety of outcomes in the NQR on stroke (Riksstroke) and a variety of settings. The transcribed interviews were analysed by applying The Consolidated Framework for Implementation Research (CFIR). RESULTS: In two regions, decision-makers and/or administrators had initiated healthcare process projects for stroke, engaging the health professionals in the local stroke units who contributed with, for example, local data from Riksstroke. The Riksstroke data was used for identifying improvement issues, for setting goals, and asserting that the stroke units achieved an equivalent standard of care and a certain level of quality of stroke care. Meanwhile, one region had more recently initiated such a project and the fourth region had no similar collaboration across tiers. Apart from these projects, there was limited joint communication across tiers and none that included all individuals and functions engaged in quality improvement with regards to stroke care. CONCLUSIONS: If NQRs are to provide for quality improvement and learning opportunities, advances must be made in the links between the structures and processes across all organisational tiers, including decision-makers, administrators and health professionals engaged in a particular healthcare process.

Trust-By-Contract: Modelling, Analysing and Predicting Behaviour in Software Architectures

Architecture description languages (ADLs) are used to specify high-level, compositional views of a software application. ADL research focuses on software composed of prefabricated parts, so-called software components. ADLs usually come equipped with rigorous state-transition style semantics, facilitating verification and analysis of specifications. Consequently, ADLs are well suited to configuring distributed and event-based systems. However, additional expressive power is required for the description of enterprise software architectures – in particular, those built upon newer middleware, such as implementations of Java’s EJB specification, or Microsoft’s COM+/.NET. The enterprise requires distributed software solutions that are scalable, business-oriented and mission-critical. We can make progress toward attaining these qualities at various stages of the software development process. In particular, progress at the architectural level can be leveraged through use of an ADL that incorporates trust and dependability analysis. Also, current industry approaches to enterprise development do not address several important architectural design issues. The TrustME ADL is designed to meet these requirements, through combining approaches to software architecture specification with rigorous design-by-contract ideas. In this paper, we focus on several aspects of TrustME that facilitate specification and analysis of middleware-based architectures for trusted enterprise computing systems.