Behaviour of TiO(2)-SiMgO(x) hybrid composites on the solar photocatalytic degradation of polluted air


Autoria(s): SUAREZ, S.; HEWER, T. L. R.; PORTELA, R.; HERNANDEZ-ALONSO, M. D.; FREIRE, R. S.; SANCHEZ, B.
Contribuinte(s)

UNIVERSIDADE DE SÃO PAULO

Data(s)

20/10/2012

20/10/2012

2011

Resumo

The photocatalytic performance of TiO(2)-SiMgO(x) ceramic plates for trichloroethylene abatement in gas phase has been evaluated under sun irradiance conditions. A continuous flow Pyrex glass reactor fixed on the focus of a compound parabolic collector has been used. The performance of the hybrid photocatalyst has been evaluated as the variation of TCE conversion and reaction products formation with the solar irradiance at different total gas flow, TCE concentration, and water vapour content. SiMgO(x) not only provides adsorbent properties to the photocatalyst, but it also allows the effective use of the material during low solar irradiance conditions. The adsorption-desorption phenomena play a pivotal role in the behaviour of the system. Thus, TCE conversion curves present two different branches when the sun irradiance increases (sunrise) or decreases (sunset). CO(2), COCl(2) and DCAC were the most relevant products detected. Meanwhile CO(2) concentration was insensitive to the branch analysed, COCl(2) or DCAC were not indicating the ability of these compounds to be adsorbed on the composite. An increase of the UV irradiation at total TCE conversion promotes the CO(2) selectivity. The excess of energy arriving to the reactor favours the direct reaction pathway to produce CO(2). The photonic efficiency, calculated as a function of the rate of CO(2) formation, decreases linearly with the solar irradiance up to around 2 mW cm(-2), where it becomes constant. For decontamination systems high TCE conversion is pursuit and then high solar irradiance values are required, in spite of lower photonic efficiency values. The present photocatalyst configuration, with only 17% of the reactor volume filled with the photoactive material, allows total TCE conversion for 150 ppm and 1 L min(-1) in a wide sun irradiance window from 2 to 4 mW cm(-2). The incorporation of water vapour leads to an increase of the CO(2) selectivity keeping the TCE conversion around 90%, although significant amounts of COCl(2) were observed. (c) 2010 Elsevier B.V. All rights reserved.

Identificador

APPLIED CATALYSIS B-ENVIRONMENTAL, v.101, n.3/Abr, p.176-182, 2011

0926-3373

http://producao.usp.br/handle/BDPI/31421

10.1016/j.apcatb.2010.09.014

http://dx.doi.org/10.1016/j.apcatb.2010.09.014

Idioma(s)

eng

Publicador

ELSEVIER SCIENCE BV

Relação

Applied Catalysis B-environmental

Direitos

restrictedAccess

Copyright ELSEVIER SCIENCE BV

Palavras-Chave #TiO(2)-SiMgO(x) #Sepiolite #Hybrid photocatalysts #Trichloroethylene (TCE) #Adsorption #VOC #Compound parabolic collector (CPC) #Sunlight irradiance #Solar photocatalysis #Ceramic plates #WATER-TREATMENT #HETEROGENEOUS PHOTOCATALYSIS #TRICHLOROETHYLENE #COLLECTORS #TIO2 #DISINFECTION #OXIDATION #DECONTAMINATION #ENHANCEMENT #PRODUCTS #Chemistry, Physical #Engineering, Environmental #Engineering, Chemical
Tipo

article

original article

publishedVersion