Summary of physical properties on cores used for petrofabric analyses triaxial experiments at DSDP Leg 67 Holes

Deformation features within the cores are studied with a view towards elucidating the structure of the Middle America Trench along the transect drilled during Leg 67. Where possible, inferences are made as to the physical environment of deformation. Extensional tectonics prevails in the area of the seaward slope and trench. Fracturing and one well-preserved normal fault are found mostly within the lower Miocene chalks, at the base of the sedimentary section. These chalks have high porosities (40%-60%) and water content (30%-190%, based on % dry wt.). Experimental triaxial compression tests conducted on both dry and water-saturated samples of chalk from Holes 495 and 499B show that only in the saturated samples is more brittle behavior observed. Brittle failure of the chalks is greatly facilitated by pore fluid pressures that lead to low effective pressures. Additional embrittlement (weakening) can take place as a result of the imposed extensional stress resulting from bending of a subducting elastic oceanic plate. The chalks exhibit, in a landward direction, an increase in density and mechanical strength and a decrease in water content. These changes are attributed to mechanical compaction that may have resulted from tectonic horizontal compression. The structure of the landward slope is not well understood because the slope sites had to be abandoned due to the presence of gas hydrate. The relationship of the chaotic, brittle deformation (observed in the cores from Hole 494A) at the base of the landward slope to tectonic processes remains unclear. The deformation observed on the slope sites (Holes 496 and 497) is mostly fracturing and near-vertical sigmoidal veinlets. These are interpreted as being the result of gas/fluid overpressurization due to the decomposition of the gas hydrate, and not due to tectonic loading of accreted sediments. Aside from four small displacement (less than 1cm) reverse faults observed in the lower Miocene chalks (which may be the product of soft-sediment deformation), there is a noticeable absence of structures reflecting a dominance of horizontal (tectonic) compression along the transect drilled. The absence of such features, the lack of continuity of sediment types across the trench-landward slope, and the normal stratigraphic sequence in Hole 494A do not support any known accretionary model.

Measurements of velocity-dependent and slip-dependent frictional strength in laboratory friction experiments on natural samples from IODP Expedition 316 and ODP Hole 190-1174B

Slowslip forms part of the spectrum of fault behaviour between stable creep and destructive earthquakes. Slow slip occurs near the boundaries of large earthquake rupture zones and may sometimes trigger fast earthquakes. It is thought to occur in faults comprised of rocks that strengthen under fast slip rates, preventing rupture as a normal earthquake, or on faults that have elevated pore-fluid pressures. However, the processes that control slow rupture and the relationship between slow and normal earthquakes are enigmatic. Here we use laboratory experiments to simulate faulting in natural rock samples taken from shallow parts of the Nankai subduction zone, Japan, where very low-frequency earthquakes - a form of slow slip - have been observed.We find that the fault rocks exhibit decreasing strength over millimetre-scale slip distances rather than weakening due to increasing velocity. However, the sizes of the slip nucleation patches in our laboratory simulations are similar to those expected for the very lowfrequency earthquakes observed in Nankai. We therefore suggest that this type of fault-weakening behaviour may generate slow earthquakes. Owing to the similarity between the expected behaviour of slow earthquakes based on our data, and that of normal earthquakes during nucleation, we suggest that some types of slow slip may represent prematurely arrested earthquakes.

Seawater carbonate chemistry, calcification and respiration duirng experiments with a pteropod Creseis acicula, 2010

Among marine calcifiers, shelled pteropods are expected to be particularly sensitive to ocean acidification, generated by the uptake of anthropogenic CO2 by the ocean, and the associated decrease of the seawater saturation state with respect to aragonite (omega aragonite). The few available studies have mostly focused on polar species although pteropods are also important components of temperate and tropical ecosystems. It is also unknown which parameter of the carbonate system controls calcification. Specimens of the temperate Mediterranean species Creseis acicula were maintained under seven different conditions of the carbonate chemistry, obtained by manipulating pH and total alkalinity, with the goal to disentangle the effects of pH and omega aragonite. Respiration, excretion as well as rates of net and gross calcification were not directly affected by a decrease in pH but decreased significantly with a decrease of omega aragonite. The decrease of gross calcification rates is consistent with that reported for polar species. Although the organisms were apparently able to maintain gross calcification rates under slightly undersaturated aragonite conditions, the clear net dissolution signal observed below saturation suggests that they are not able to build a shell in seawater corrosive to aragonite. The decrease in respiration and excretion, and the low O:N molar ratio, could be due to the short time that the organisms were allowed to acclimatize to their new environment.

Tracer release experiments in the tropical North Atlantic

Lateral diffusivity is computed from a tracer release experiment in the northeastern tropical Atlantic thermocline. The uncertainties of the estimates are inferred from a synthetic particle release using a high-resolution ocean circulation model. The main method employed to compute zonal and meridional components of lateral diffusivity is the growth of the second moment of a cloud of tracer. The application of an areal comparison method for estimating tracer-based diffusivity in the field experiments is also discussed. The best estimate of meridional eddy diffusivity in the Guinea Upwelling region at about 300 m depth is estimated to be inline image m2 s-1. The zonal component of lateral diffusivity is estimated to be inline image m2 s-1, while areal comparison method yields areal equivalent zonal diffusivity component of inline image m2 s?1. In comparison to Ky, Kx is about twice larger, resulting from the tracer patch stretching by zonal jets. Employed conceptual jet model indicates that zonal jet velocities of about inline image m s?1 are required to explain the enhancement of the zonal eddy diffusivity component. Finally, different sampling strategies are tested on synthetic tracer release experiments. They indicate that the best sampling strategy is a sparse regular sampling grid covering most of the tracer patch.

Growth rates and biometric measurements of coccolithophores (Coccolithus pelagicus, Coccolithus braarudii, Emiliania huxleyi) during experiments

Coccolithophores, a diverse group of phytoplankton, make important contributions to pelagic calcite production and export, yet the comparative biogeochemical role of species other than the ubiquitous Emiliania huxleyi is poorly understood. Here we examined the relative importance of E. huxleyi and two Coccolithus species (Coccolithus pelagicus and Coccolithus braarudii), in terms of daily calcite production, by culturing E. huxleyi and Coccolithus in parallel, and comparing growth rates and biometrically determined cellular carbon calcite quotas. Biometric measurements of Coccolithus species, and E. huxleyi cell diameters, were performed using polarised light microscopy. Scanning electron microscopy was used for all other biometric measurements of E. huxleyi.