Treatment of hazardous shipyard wastewater using dolomitic sorbents

Hazardous shipyard wastewater is a worldwide problem, arising from ship repair. In this study an experimental programme was undertaken to establish the suitability of dolomite and dolomitic sorbent materials to remove contaminants from wastewater arising from a commercial shipyard. Experimental data indicate that dolomite and dolomitic sorbents have the ability to significantly reduce the COD concentration of the shipyard effluent (98% reduction). The data gained from trials at a shipyard indicated that the dolomite treatment process could be undertaken in a 8000 L pilot scale reaction vessel. Analysis of the wastewater using ICP-MS during the pilot trial indicated that the dolomite significantly reduced the concentrations of metallic impurities. The concentration of Sn ions, which is indicative of organo-tin complexes commonly found in shipyard wastewater, was reduced by 80% from its initial concentration in the pilot trial. The mechanism for the removal process using dolomite has been ascribed to a metal complexation/sorption process.

Down-regulation of beta1,4-galactosyltransferase V is a critical part of etoposide-induced apoptotic process and could be mediated by decreasing Sp1 levels in human glioma cells.

beta1,4-Galactosyltransferase V (beta1,4GalT V; EC 2.4.1.38) is considered to be very important in glioma for expressing transformation-related highly branched N-glycans. Recently, we have characterized beta1,4GalT V as a positive growth regulator in several glioma cell lines. However, the role of beta1,4GalT V in glioma therapy has not been clearly reported. In this study, interfering with the expression of beta1,4GalT V by its antisense cDNA in SHG44 human glioma cells markedly promoted apoptosis induced by etoposide and the activation of caspases as well as processing of Bid and expression of Bax and Bak. Conversely, the ectopic expression of beta1,4GalT V attenuated the apoptotic effect of etoposide on SHG44 cells. In addition, both the beta1,4GalT V transcription and the binding of total or membrane glycoprotein with Ricinus communis agglutinin-I (RCA-I) were partially reduced in etoposide-treated SHG44 cells, correlated well with a decreased level of Sp1 that has been identified as an activator of beta1,4GalT V transcription. Collectively, our results suggest that the down-regulation of beta1,4GalT V expression plays an important role in etoposide-induced apoptosis and could be mediated by a decreasing level of Sp1 in SHG44 cells, indicating that inhibitors of beta1,4GalT V may enhance the therapeutic efficiency of etoposide for malignant glioma.

Liquid source misted chemical deposition process of three-dimensional nano-ferroelectrics with substrate heating

A modification of liquid source misted chemical deposition process (LSMCD) with heating mist and substrate has developed, and this enabled to control mist penetrability and fluidity on sidewalls of three-dimensional structures and ensure step coverage. A modified LSMCD process allowed a combinatorial approach of Pb(Zr,Ti)O-3 (PZT) thin films and carbon nanotubes (CNTs) toward ultrahigh integration density of ferroelectric random access memories (FeRAMs). The CNTs templates were survived during the crystallization process of deposited PZT film onto CNTs annealed at 650 degrees C in oxygen ambient due to a matter of minute process, so that the thermal budget is quite small. The modified LSMCD process opens up the possibility to realize the nanoscale capacitor structure of ferroelectric PZT film with CNTs electrodes toward ultrahigh integration density FeRAMs.

Improved Process Monitoring Using Nonlinear Principal Component Models

This paper presents two new approaches for use in complete process monitoring. The firstconcerns the identification of nonlinear principal component models. This involves the application of linear
principal component analysis (PCA), prior to the identification of a modified autoassociative neural network (AAN) as the required nonlinear PCA (NLPCA) model. The benefits are that (i) the number of the reduced set of linear principal components (PCs) is smaller than the number of recorded process variables, and (ii) the set of PCs is better conditioned as redundant information is removed. The result is a new set of input data for a modified neural representation, referred to as a T2T network. The T2T NLPCA model is then used for complete process monitoring, involving fault detection, identification and isolation. The second approach introduces a new variable reconstruction algorithm, developed from the T2T NLPCA model. Variable reconstruction can enhance the findings of the contribution charts still widely used in industry by reconstructing the outputs from faulty sensors to produce more accurate fault isolation. These ideas are illustrated using recorded industrial data relating to developing cracks in an industrial glass melter process. A comparison of linear and nonlinear models, together with the combined use of contribution charts and variable reconstruction, is presented.

A transposase-independent mechanism gives rise to precise excision of IS256 from insertion sites in Staphylococcus epidermidis.

The mobile element IS256 causes phase variation of biofilm formation in Staphylococcus epidermidis by insertion and precise excision from the icaADBC operon. Precise excision, i.e., removal of the target site duplications (TSDs) and restoration of the original DNA sequence, occurs rarely but independently of functional transposase. Instead, the integrity of the TSDs is crucial for precise excision. Excision increased significantly when the TSDs were brought into closer spatial proximity, suggesting that excision is a host-driven process that might involve most likely illegitimate recombination.

Process monitoring approach using fast moving window PCA

This paper introduces a fast algorithm for moving window principal component analysis (MWPCA) which will adapt a principal component model. This incorporates the concept of recursive adaptation within a moving window to (i) adapt the mean and variance of the process variables, (ii) adapt the correlation matrix, and (iii) adjust the PCA model by recomputing the decomposition. This paper shows that the new algorithm is computationally faster than conventional moving window techniques, if the window size exceeds 3 times the number of variables, and is not affected by the window size. A further contribution is the introduction of an N-step-ahead horizon into the process monitoring. This implies that the PCA model, identified N-steps earlier, is used to analyze the current observation. For monitoring complex chemical systems, this work shows that the use of the horizon improves the ability to detect slowly developing drifts.

Modulating the selectivity for CO and butane oxidation over heterogeneous catalysis through amorphous catalyst coatings

The preparation of porous films directly deposited onto the surface of catalyst particles is attracting increasing attention. We report here for the first time a method that can be carried out at ambient pressure for the preparation of porous films deposited over 3 mm diameter catalyst particles of silica-supported Pt-Fe. Characterization of the sample prepared at ambient pressure (i.e., open air, OA) and its main structural differences as compared with a Na-A (LTA) coated catalyst made using an autoclave-based method are presented. The OA-coated material predominantly exhibited an amorphous film over the catalyst surface with between 4 and 13% of crystallinity as compared with fully crystallized LTA zeolite crystals. This coated sample was highly selective for CO oxidation in the presence of butane with no butane oxidation observed up to 350 degrees C. This indicates, for the first time, that the presence of a crystalline membrane is not necessary for the difference in light off temperature between CO and butane to be achieved and that amorphous films may also produce this effect. An examination of the space velocity dependence and adsorption of Na+ on the catalysts indicates that the variation in CO and butane oxidation activity is not caused by site blocking predominantly, although the Pt activity was lowered by contact with this alkali.

Effect of the carburization of MoO3-based catalysts on the activity for butane hydroisomerization

Catalysts based on molybdena (MoO3) reduced at mild temperatures are highly active and selective for the hydroisomerization of alkanes: however, further catalyst development has been hampered by the structural complexity of the material and the controversy regarding the nature of the active phase. The present work is aimed at determining the relationship between the content of carbon present in an oxycarbide phase and the activity for n-butane hydroisomerization. A series of temperature-programmed oxidation (TPO) and temporal analysis of product (TAP) data showed that the oxycarbidic carbon content is not related to the activity of the sample for the isomerization of n-butane to isobutane. The formation of a carbon-containing phase is, therefore, not crucial to obtain an active catalyst. This study also highlights the capability of the multi-pulse TAP technique to investigate structure-activity relationships over materials with readily variable atomic composition. (C) 2008 Elsevier B.V. All rights reserved.

The application of calcined natural dolomitic rock as a solid base catalyst in triglyceride transesterification for biodiesel synthesis

Natural dolomitic rock has been investigated in the transesterification of C-4 and C-8 triglycerides and olive oil with a view to determining its viability as a solid base catalyst for use in biodiesel synthesis. XRD reveals that the dolomitic rock comprised 77% dolomite and 23% magnesian calcite. The generation of basic sites requires calcination at 900 degrees C, which increases the surface area and transforms the mineral into MgO nanocrystallites dispersed over CaO particles. Calcined dolomitic rock exhibits high activity towards the liquid phase transesterification of glyceryl tributyrate and trioctanoate, and even olive oil, with methanol for biodiesel production.

Hydrogenation/hydrogenolysis of disulfides using sulfided Ni/Mo catalysts

The mechanism of the hydrogenation/hydrogenolysis of dinitrodiphenyldisulfides using sulfided NiMo/ gamma Al2O3 catalysts has been examined in detail. Although two routes are possible, the major pathway involves an initial S-S bond cleavage followed by reduction of the nitro group. Importantly, the disulfide hydrogenolysis occurs in the absence of the catalyst with the role of the catalyst thought to be to activate the hydrogen and trap the cleaved intermediate as well as facilitate the reduction of the nitro group. Monitoring the mass balance throughout the reaction demonstrates the difficulty in measuring intrinsic kinetics for gas-liquid-solid reactions. Although the mass balance is restored at the end of the reaction, up to 45% of the substrate/products is found to be adsorbed on the catalyst during the reaction. (c) 2008 Elsevier B.V. All rights reserved.

Supported and liquid phase task specific ionic liquids for base catalysed Knoevenagel reactions

A series of Hunig's base tethered ammonium ionic liquids have been used to catalyse the Knoevenagel condensation of aldehydes/ketones with malononitrile and ethyl cyanoacetate. The reactions were performed under homogeneous and under biphasic, liquid-liquid and liquid-silica supported ionic liquid, conditions with the biphasic systems employing cyclohexene as the second phase. By increasing the distance between the ammonium head group and Hunig's base the activity of the catalyst was found to increase. Higher activity, in general, was found under homogeneous reaction conditions; however, the recyclability of the catalyst was improved by supporting the BIL under biphasic conditions. (c) 2007 Elsevier B.V. All rights reserved.