941 resultados para ethyl cellulose
Resumo:
A rapid, sensitive and reliable thin-layer chromatography/spectrophotometry screening procedure was developed for quantitative determination of diuretics associated in pharmaceutical dosage forms. The chromatographic method employed microcrystalline cellulose and butanol : acetic acid : water (4:1:1) or amilic alcohol : ammonium hydroxide 25% (9:1) as mobile phases and detection by U.V. light. The drugs were extracted using a simple procedure and were quantified by U.V. spectrophotometry. Results varied from 97.5 to 102.5% and are similar to those obtained by conventional methods. This method of quantification of diuretics is promising for quality control of drugs.
Resumo:
This review reports the application of inorganic and organic polymeric materials for cation removal by using nitrogenated basic centers. The data demonstrate the importance of the desired groups when free or immobilized on natural or synthesized inorganic polymers through silanol groups. Thus, the most studied silica gel is followed by natural crysotile and talc polymers, and the synthesized mesopore silicas, talc-like, silicic acids, phosphates and phyllosilicates. The organic natural biopolymeric chitin and cellulose were chemically modified to improve the availability of the amine groups or the reactivity with desirable molecules to enlarge the content of basic centers. The cation removal takes place at the solid/liquid interface and some interactive effects have their thermodynamic data determined.
Resumo:
A new analytical method was developed to non-destructively determine pH and degree of polymerisation (DP) of cellulose in fibres in 19th 20th century painting canvases, and to identify the fibre type: cotton, linen, hemp, ramie or jute. The method is based on NIR spectroscopy and multivariate data analysis, while for calibration and validation a reference collection of 199 historical canvas samples was used. The reference collection was analysed destructively using microscopy and chemical analytical methods. Partial least squares regression was used to build quantitative methods to determine pH and DP, and linear discriminant analysis was used to determine the fibre type. To interpret the obtained chemical information, an expert assessment panel developed a categorisation system to discriminate between canvases that may not be fit to withstand excessive mechanical stress, e.g. transportation. The limiting DP for this category was found to be 600. With the new method and categorisation system, canvases of 12 Dalí paintings from the Fundació Gala-Salvador Dalí (Figueres, Spain) were non-destructively analysed for pH, DP and fibre type, and their fitness determined, which informs conservation recommendations. The study demonstrates that collection-wide canvas condition surveys can be performed efficiently and non-destructively, which could significantly improve collection management.
Resumo:
We have developed an easy method for the synthesis of thirteen compounds derived from 1,2,4-triazoles through a carboxylic acid and hydrazinophthalazine reaction, with a 75-85% yield mediated by the use of agents such as 1-ethyl-3-(3'-dimethylaminopropyl)-carbodiimide hydrochloride and 1-hydroxybenzotriazole. The operational simplicity of this method and the good yield of products make it valuable for the synthesis of new compounds with pharmacological activity.
Resumo:
This study describes the use of three (-)-alpha-pinene derivatives, one diol-1,2 [(-)-(1R, 2R, 3S, 5R)-2,6,6-trimethylbicyclo[3.1.1]heptane-2,3-diol 4] and two piridine-hydroxy derivatives [(+)-(1R,2S,3R,5S)-2,6,6-trimethyl-3-(2-pyridinylmethyl)bicyclo[3.1.1]heptan-3-ol 7 and (-)-(1R,2S,3R,5S)-2,6,6-trimethyl-3-[2-(2-pyridinyl) ethyl]bicyclo[3.1.1]heptan-3-ol 8]; one diol-1,3 [(-)-(1S,2R,5S)-2-(1-hydroxy-1-methylethyl)-5-methylcyclohexanol 5] derived from (+)-isopulegol 2 and one diol-1,3 [(+)-(1R,2R,5R)-2-(1-hydroxy-1-methylethyl)-5-methylcyclohexanol 6] derived from (+)-neo-isopulegol 3, as ligands in the asymmetric Reformatsky reaction. The best enantiomeric excess of beta-hydroxy ester obtained in the Reformatsky asymmetric reaction was 18% using ligand 6, and the chemical yield of the reactions was 65% on average.
Resumo:
The chloroform extract of aerial parts of Ipomoea subincana was submitted to different chromatographic procedures which afforded methyl caffeate, ethyl caffeate, methyl 3,4-dimethoxycinnamate, lupeol, alpha-amyrin, beta-amyrin, 3-beta-O-beta-D-glycopiranosyl-sitosterol, beta-sitosterol, stigmasterol, scopoletin, aromadendrane-4beta,10alpha-diol, n-docosyl-cis-p-coumarate and n-icosyl-trans-p-coumarate, vanilin, cinamic acid and vanillic acid. However, from the ethyl acetate extract besides quercetin and 3-O-beta-D-glycopiranosyl-quercetin were isolated methyl 4-O-E-feruloyl-5-O-E-caffeoyl-quinate, methyl 3,5-di-O-E-caffeoyl-quinate and methyl 4-O-E-caffeoyl-quinate. The structures of the compounds were established on the basis of spectral data.
Resumo:
In many industries, such as petroleum production, and the petrochemical, metal, food and cosmetics industries, wastewaters containing an emulsion of oil in water are often produced. The emulsions consist of water (up to 90%), oils (mineral, animal, vegetable and synthetic), surfactants and other contaminates. In view of its toxic nature and its deleterious effects on the surrounding environment (soil, water) such wastewater needs to be treated before release into natural water ways. Membrane-based processes have successfully been applied in industrial applications and are considered as possible candidates for the treatment of oily wastewaters. Easy operation, lower cost, and in some cases, the ability to reduce contaminants below existing pollution limits are the main advantages of these systems. The main drawback of membranes is flux decline due tofouling and concentration polarisation. The complexity of oil-containing systems demands complementary studies on issues related to the mitigation of fouling and concentration polarisation in membranebased ultrafiltration. In this thesis the effect of different operating conditions (factors) on ultrafiltration of oily water is studied. Important factors are normally correlated and, therefore, their effect should be studied simultaneously. This work uses a novel approach to study different operating conditions, like pressure, flow velocity, and temperature, and solution properties, like oil concentration (cutting oil, diesel, kerosene), pH, and salt concentration (CaCl2 and NaCl)) in the ultrafiltration of oily water, simultaneously and in a systematic way using an experimental design approach. A hypothesis is developed to describe the interaction between the oil drops, salt and the membrane surface. The optimum conditions for ultrafiltration and the contribution of each factor in the ultrafiltration of oily water are evaluated. It is found that the effect on permeate flux of the various factors studied strongly depended on the type of oil, the type of membrane and the amount of salts. The thesis demonstrates that a system containing oil is very complex, and that fouling and flux decline can be observed even at very low pressures. This means that only the weak form of the critical flux exists for such systems. The cleaning of the fouled membranes and the influence of different parameters (flow velocity, temperature, time, pressure, and chemical concentration (SDS, NaOH)) were evaluated in this study. It was observed that fouling, and consequently cleaning, behaved differently for the studied membranes. Of the membranes studied, the membrane with the lowest propensity for fouling and the most easily cleaned was the regenerated cellulose membrane (C100H). In order to get more information about the interaction between the membrane and the components of the emulsion, a streaming potential study was performed on the membrane. The experiments were carried out at different pH and oil concentration. It was seen that oily water changed the surface charge of the membrane significantly. The surface charge and the streaming potential during different stages of filtration were measured and analysed being a new method for fouling of oil in this thesis. The surface charge varied in different stages of filtration. It was found that the surface charge of a cleaned membrane was not the same as initially; however, the permeability was equal to that of a virgin membrane. The effect of filtration mode was studied by performing the filtration in both cross-flow and deadend mode. The effect of salt on performance was considered in both studies. It was found that salt decreased the permeate flux even at low concentration. To test the effect of hydrophilicity change, the commercial membranes used in this thesis were modified by grafting (PNIPAAm) on their surfaces. A new technique (corona treatment) was used for this modification. The effect of modification on permeate flux and retention was evaluated. The modified membranes changed their pore size around 33oC resulting in different retention and permeability. The obtained results in this thesis can be applied to optimise the operation of a membrane plant under normal or shock conditions or to modify the process such that it becomes more efficient or effective.
Resumo:
Reduction of five substituted octalones employing lithium tri-sec-butylborohydride (L-selectride®) in THF and ethyl ether led to allylic alcohols with moderate diastereoselectivity. The stereoselectivity of addition of bulky hydrides showed to be different from most examples in the literature and was strongly influenced by substitution on the octalone ring.
Resumo:
The specific consumption and carbon monoxide (CO) and nitrogen oxide (NO) emissions from gasolines formulated with ethanol, methyl tert-butyl ether (MTBE) and tert-amyl ethyl ether (TAEE) were evaluated in the rich, stoichiometric and lean-burn regions during the operation of an Otto-cycle engine. The use of ethanol as an additive presented high specific consumption, while gasoline formulated with TAEE showed low specific consumption with the engine operating under lean-burn conditions. The ethers evaluated here presented a low percentage of CO in the rich-burn region when compared with ethanol.
Resumo:
The selective ion monitoring acquisition mode in mass spectrometry was applied to identify, in the diesel complex matrix, the raw materials (vegetable oil and alcohol) that originate biodiesel. Biodiesel samples obtained from babassu, castor, palm and soybean vegetable oils and pure fatty acid methyl and ethyl esters were used to develop this method, using specific fragments in mass spectrometry and the "window system" in gas chromatography. The commercial Brazilian B2 samples were found to be produced with soybean oil, transesterified with methanol.
Resumo:
Phytochemical studies of ethyl acetate extracts from the roots and aerial parts of Gypsophila trichotoma revealed the presence of stigmast-7-en-3-ol, stigmasta-7,22-dien-3-ol (spinasterol), ergost-7-en-3-ol, stigmasta-3,5dien7-one, β-sitosterol, 22,23-dihydrospinasterone, vitexin, orientin, homoorientin and hyperoside. The structures of the compounds were determined by GC/MS and HPLC analyses.
Resumo:
The crude methanol extract and hexane, ethyl acetate, chloroform and methanol fractions from leaves of S. garckeana were examined in vitro for their antiproliferative activity on MCF-7, NCI-ADR, NCI-460, UACC-62, 786-0, OVCAR-03, PCO-3 and HT-29 human cancer cell lines. Among the assayed fractions, the ethyl acetate fraction showed to be cytotoxic against 786-0, UACC-62, OVCAR-03 and NCI-ADR cell lines with IC50 values of 12 µg/mL, 42 µg/mL, 53 µg/mL and 51 µg/mL, respectively. Through fractionation and isolation procedures compound (1) was obtained from the EtOAc fraction and its structure was elucidated by spectral techniques.
Resumo:
Alkaline salts of the palmitic acid were synthesized and characterized from aqueous and ethanolic medium. The salts were characterized by elemental analysis (EA) and infrared spectroscopy (IR). EA and IR, being its synthesis comproved, also characterized the ethyl palmitate. All the salts and the ester were submitted to thermal analysis using thermogravimetry (TG), and differential thermal analysis (DTA) in the temperature ranging from room to 700 ºC under air dynamic atmosphere. Differential scanning calorimetry (DSC) measurements were taken from -90 ºC up to temperatures close to the starting of the decomposition temperature, determined by thermogravimetry, using heating and cooling cycles.
Resumo:
This paper describes the isolation of five phytoconstituents from Marlierea tomentosa. The triterpenes α-amyrin (1) and β-amyrin (2), and the flavonoids quercitrin (3) and isoquercetin (4), were isolated from the leaves. The branches afforded the triterpene arjunolic acid (5). The antinociceptive activity of crude extract, fractions and compound 5 were tested using the writhing and formalin tests in mice. The crude extract, some fractions, particularly dichloromethane and butanol (leaves), ethyl acetate (branches) and arjunolic acid (5) (81.2% inhibition) were more active against the writhing test than the two reference drugs, acetylsalicylic acid and indomethacin.
Resumo:
A simple, specific and sensitive GC-MS procedure with ion m/z 62 was validated for the determination of ethyl carbamate (EC) in spirits. It exhibited linearity over the concentration of 30 to 600 μg/L with 30 μg/L limit of quantification. EC was detected in 70 of the 71 samples analyzed with levels from 33 to 2609 μg/L (mean level = 893 μg/L). 35% of the samples contained 500 to 1000 μg/L and 23% contained 150 to 500 and 1000 to 1500 μg/L. No significant correlation was found between EC and the levels of copper, pH and alcohol content of the samples.