(Table 1) Age and depth of reflectors of the 3.5-kHz and airgun seismic record and their corresponding depth of ash layers, carbonate peaks, and transition zones from DSDP Hole 83-504B

DSDP cores from areas of low (Site 505) and high heat flow (Site 504 B) near the Costa Rica Rift, together with seismic profiles from the Panama Basin, have been studied to determine the relationship between: (1) carbonate content and physical and acoustic properties; and (2) carbonate content, carbonate diagenesis and acoustic stratigraphy. Except for ash and chert layers, bulk density correlates strongly and linearly with carbonate content. Velocity is uniform downcore and only small variations at a small scale are measured. Thus an abrupt change in carbonate content will cause abrupt changes in acoustic impedance and should cause reflectors that can be detected acoustically. A comparison of seismic profiler reflection records with physical properties, carbonate content and reflection coefficients indicates that the main reflectors can be identified with ash layers, diagenetic boundaries, and carbonate content variations. Diagenesis of carbonate sediments is present at Site 504B in a 260 m-thick ooze-chalk-limestone/chert sequence. These diagenetic sequences occur in areas of higher heat flow (200 mW/m**2). Seismic profiler records can be used to map the extent and depth of these diagenetic boundaries.

Geochemistry of marine sediments of the world's major subduction zones

This paper presents new major and trace-element data and Lu-Hf and Sm-Nd isotopic compositions for representative suites of marine sediment samples from 14 drill sites outboard of the world's major subduction zones. These suites and samples were chosen to represent the global range in lithology, Lu/Hf ratios, and sediment flux in subducting sediments worldwide. The data reported here represent the most comprehensive data set on subducting sediments and define the Hf-Nd isotopic variations that occur in oceanic sediments and constrain the processes that caused them. Using new marine sediment data presented here, in conjunction with published data, we derive a new Terrestrial Array given by the equation, epsilon-Hf = 1.55 * epsiolon-Nd + 1.21. This array was calculated using >3400 present-day Hf and Nd isotope values. The steeper slope and smaller y-intercept of this array, compared to the original expression (epsilon-Hf = 1.36 * epsilonNd + 2.89; Vervoort et al., 1999, doi:10.1016/S0012-821X(99)00047-3) reflects the use of present day values and the unradiogenic Hf of old continental samples included in the array. In order to examine the Hf-Nd isotopic variations in marine sediments, we have classified our samples into 5 groups based on lithology and major and trace-element geochemical compositions: turbidites, terrigenous clays, and volcaniclastic, hydrothermal and hydrogenetic sediments. Compositions along the Terrestrial Array are largely controlled by terrigenous material derived from the continents and delivered to the ocean basins via turbidites, volcaniclastic sediments, and volcanic inputs from magmatic arcs. Compositions below the Terrestrial Array derive from unradiogenic Hf in zircon-rich turbidites. The anomalous compositions above the Terrestrial Array largely reflect the decoupled behavior of Hf and Nd during continental weathering and delivery to the ocean. Both terrigenous and hydrogenetic clays possess anomalously radiogenic Hf, reflecting terrestrial sedimentary and weathering processes on the one hand and marine inheritance on the other. This probably occurs during complementary processes involving preferential retention of unradiogenic Hf on the continents in the form of zircon and release of radiogenic Hf from the breakdown of easily weathered, high Lu-Hf phases such as apatite.

Massic magnetic susceptibility and CaCO3 content at the P. ohmi and T. hugii zones from the Rio Argos X.Ag-1 section, southeastern Spain

An orbital floating time scale of the Hauterivian-Barremian transition (Early Cretaceous) is proposed using high-resolution magnetic susceptibility measurements. Orbital tuning was performed on the Río Argos section (southeast Spain), the candidate for a Global boundary Stratotype Section and Point (GSSP) for the Hauterivian-Barremian transition. Spectral analyses of MS variations, coupled with the frequency ratio method, allow the recognition of precession, obliquity and eccentricity frequency bands. Orbitally-tuned magnetic susceptibility provides minimum durations for ammonite biozones. The durations of well-constrained ammonite zones are assessed at 0.78 myr for Pseudothurmannia ohmi (Late Hauterivian) and 0.57 myr for Taveraidiscus hugii (Early Barremian). These results are consistent with previous estimates from the other reference section (Angles, southeast France) and tend to show that the Río Argos section displays a complete succession for this time interval. They differ significantly from those proposed in the Geologic Time Scale 2008 and may help to improve the next compilation. The Faraoni Oceanic Anoxic Event, a key Early Cretaceous oceanographic perturbation occurring at the P. ohmi/P. catulloi subzone boundary has a duration estimated at 0.10-0.15 myr, which is similar to previous assessments.

Chemical composition of plagioclase from DSDP Legs 45 and 46, Atlantic Ocean

Phyric basalts recovered from DSDP Legs 45 and 46 contain abundant plagioclase phenocrysts which occur as either discrete single grains (megacrysts) or aggregates (glomerocrysts) and which are too abundant and too anorthitic to have crystallized from a liquid with the observed bulk rock composition. Almost all the plagioclase crystals are complexly zoned. In most cases two abrupt and relatively large compositional changes associated with continuous internal morphologic boundaries divide the plagioclase crystals into three parts: core, mantle and rim. The cores exhibit two major types of morphology: tabular, with a euhedral to slightly rounded outline; or a skeletal inner core wrapped by a slightly rounded homogeneous outer core. The mantle region is characterized by a zoning pattern composed of one to several spikes/plateaus superimposed on a gently zoned base line, with one large plateau always at the outside of the mantle, and by, in most cases, a rounded internal morphology. The inner rim is typically oscillatory zoned. The width of the outer rim can be correlated with the position of the individual crystal in the basalt pillow. The presence of a skeletal inner core and the concentration of glass inclusions in low-An zones in the mantle region suggest that the liquid in which these parts of the crystals were growing was undercooled some amount. The resorption features at the outer margins of low-An zones indicate superheating of the liquid with respect to the crystal. It is proposed that the plagioclase cores formed during injection of primitive magma into a previously existing magma chamber, that the mantle formed during mixing of a partially mixed magma and the remaining magma already in the chamber, and that the inner rim formed when the mixed magma was in a sheeted dike system. The large plateau at the outside of the mantle may have formed during the injection of the next batch of primitive magma into the main chamber, which may trigger an eruption. This model is consistent with fluid dynamic calculations and geochemically based magma mixing models, and is suggested to be the major mechanism for generating the disequilibrium conditions in the magma.

Evaluation of traffic control devices for rural high-speed maintenance work zones.

Texas Department of Transportation, Research and Technology Transfer Office, Austin

Protection of personnel in maintenance and construction zones. Interim report.

Texas State Department of Highways and Public Transportation, Transportation Planning Division, Austin

Traffic capacity through work zones on urban freeways. Interim report.

Texas State Department of Highways and Public Transportation, Transportation Planning Division, Austin

Alternative sign sequences for work zones on rural highways. Executive summary. Final report.

Federal Highway Administration, Office of Research and Development, Washington, D.C.

Comparison of signs and markings for passing/no-passing zones. Executive summary.

Federal Highway Administration, Office of Research, Washington, D.C.

Sight distance requirements at lane closure work zones on urban freeways. Interim report.

Texas State Department of Highways and Public Transportation, Transportation Planning Division, Austin

Vehicle accidents in highway work zones. Final report.

Federal Highway Administration, Washington, D.C.