New Modified Dipping Method Using 4-hexylresorcinol for Preventing Blackspot Formation in Prawns.

Industry acceptance of alternative sulphite treatments for preventing blackspot in prawns is limited. This study demonstrated that dipping prawns (Penaeus monodon and Fenneropenaeus merguiensis) in a less concentrated solution for longer times provides better control of blackspot formation than the recommended 2 minute dip in 50 mg/L 4-hexylresorcinol. Protection improved as modified dipping times and solution concentrations increased. Blackspot protection provided by most of the modified dip methods was more effective than a 1 minute dip in 1% sodium metabisulphite. The recommended 2 minute dip method should be limited to 125 kg when used on consecutive 25-kg batches of prawns. Yields increased by less than 10% even after 72-hour exposure in the modified dip. The new dipping method meets most international residue standards when applying the modified treatments evaluated.

Electrode kinetics of a nickel/cadmium cell and failure-mode prediction. Estimation of equivalent resistance of an internal short

A quantitative expression has been obtained for the equivalent resistance of an internal short in rechargeable cells under constant voltage charging.

Adsorption of CO and N2 on modified transition-metal surfaces

Electron spectroscopic studies clearly demonstrate that modification of the surfaces of Mn, Fe and Ni metals by chlorine significantly decreases the strength of interaction between the metal and adsorbed molecules such as CO and N2. This is in contrast to the effect of electropositive additives such as Ba and Al which increase the adsorption bond strength significantly.

Solubilities of solids in supercritical fluids using dimensionally consistent modified solvate complex models

New dimensionally consistent modified solvate complex models are derived to correlate solubilities of solids in supercritical fluids both in the presence and absence of entrainers (cosolvents). These models are compared against the standard solvate complex models [J.Chrastil, J. Phys. Chem. 86 (1982) 3016-3021; J.C. Gonzalez, M.R.Vieytes, A.M. Botana, J.M. Vieites, L.M. Botana, J. Chromatogr. A 910 (2001) 119-125; Y. Adachi, B.C.Y. Lu, Fluid Phase Equilb. 14 (1983) 47-156; J.M. del Valle, J.M. Aguilera, Ind. Eng. Chem. Res. 27 (1988) 1551-1553] by correlating the solubilities of 13 binary and 12 ternary systems. Though the newly derived models are not significantly better than the standard models in predicting the solubilities, they are dimensionally consistent. (C) 2009 Elsevier B.V. All rights reserved.

A Modified Heffron-Phillip's Model for The Design of Power System Stabilizers

In this paper a modified Heffron-Phillip's (K-constant) model is derived for the design of power system stabilizers. A knowledge of external system parameters, such as equivalent infinite bus voltage and external impedances or their equivalent estimated values is required for designing a conventional power system stabilizer. In the proposed method, information available at the secondary bus of the step-up transformer is used to set up a modified Heffron-Phillip's (ModHP) model. The PSS design based on this model utilizes signals available within the generating station. The efficacy of the proposed design technique and the performance of the stabilizer has been evaluated over a range of operating and system conditions. The simulation results have shown that the performance of the proposed stabilizer is comparable to that could be obtained by conventional design but without the need for the estimation and computation of external system parameters. The proposed design is thus well suited for practical applications to power system stabilization, including possibly the multi-machine applications where accurate system information is not readily available.

Feasibility of a stepped wedge cluster RCT and concurrent observational sub-study to evaluate the effects of modified ward night lighting on inpatient fall rates and sleep quality: A protocol for a pilot trial

Background: Falls among hospitalised patients impose a considerable burden on health systems globally and prevention is a priority. Some patient-level interventions have been effective in reducing falls, but others have not. An alternative and promising approach to reducing inpatient falls is through the modification of the hospital physical environment and the night lighting of hospital wards is a leading candidate for investigation. In this pilot trial, we will determine the feasibility of conducting a main trial to evaluate the effects of modified night lighting on inpatient ward level fall rates. We will test also the feasibility of collecting novel forms of patient level data through a concurrent observational sub-study. Methods/design: A stepped wedge, cluster randomised controlled trial will be conducted in six inpatient wards over 14 months in a metropolitan teaching hospital in Brisbane (Australia). The intervention will consist of supplementary night lighting installed across all patient rooms within study wards. The planned placement of luminaires, configurations and spectral characteristics are based on prior published research and pre-trial testing and modification. We will collect data on rates of falls on study wards (falls per 1000 patient days), the proportion of patients who fall once or more, and average length of stay. We will recruit two patients per ward per month to a concurrent observational sub-study aimed at understanding potential impacts on a range of patient sleep and mobility behaviour. The effect on the environment will be monitored with sensors to detect variation in light levels and night-time room activity. We will also collect data on possible patient-level confounders including demographics, pre-admission sleep quality, reported vision, hearing impairment and functional status. Discussion: This pragmatic pilot trial will assess the feasibility of conducting a main trial to investigate the effects of modified night lighting on inpatient fall rates using several new methods previously untested in the context of environmental modifications and patient safety. Pilot data collected through both parts of the trial will be utilised to inform sample size calculations, trial design and final data collection methods for a subsequent main trial.

Modified current source inverter fed induction motor drive with reduced torque pulsations

A new technique for reducing the torque pulsations in a conventional current source inverter fed induction motor drive is presented. This does not attempt to improve the current waveforms, but modifies the airgap MMF directly. This is based on the use of a motor with two sets of balanced phase windings, with a 30 electrical degree phase difference between them, and each set being fed from a conventional current source inverter. The two inverters are further connected in series so that they can operate from the same current source. As a consequence of this arrangement, the voltage rating of the components of each inverter is reduced, along with reduced torque ripple. This scheme has been experimentally verified and compared with the performance of a conventional scheme.

Correlation between NIRS generated and chemically measured feed quality data in barley (Hordeum vulgare), and potential use in QTL analysis identification

A study was performed to investigate the value of near infrared reflectance spectroscopy (NIRS) as an alternate method to analytical techniques for identifying QTL associated with feed quality traits. Milled samples from an F6-derived recombinant inbred Tallon/Scarlett population were incubated in the rumen of fistulated cattle, recovered, washed and dried to determine the in-situ dry matter digestibility (DMD). Both pre- and post-digestion samples were analysed using NIRS to quantify key quality components relating to acid detergent fibre, starch and protein. This phenotypic data was used to identify trait associated QTL and compare them to previously identified QTL. Though a number of genetic correlations were identified between the phenotypic data sets, the only correlation of most interest was between DMD and starch digested (r = -0.382). The significance of this genetic correlation was that the NIRS data set identified a putative QTL on chromosomes 7H (LOD = 3.3) associated with starch digested. A QTL for DMD occurred in the same region of chromosome 7H, with flanking markers fAG/CAT63 and bPb-0758. The significant correlation and identification of this putative QTL, highlights the potential of technologies like NIRS in QTL analysis.

Metabolism of structurally modified acyclic monoterpenes by Pseudomonas incognita

The ability of Pseudomonas incognita to metabolize some structurally modified acyclic monoterpenes was tested. The 6,7 double bond was found essential for these compounds to serve as a substrate for this organism, whereas the same was not true with the 1,2 double bond. Metabolism of dihydrolinalyl acetate by this strain yielded dihydrolinalool, dihydrolinalool-8-carboxylic acid, dihydrolinalyl acetate-8-carboxylic acid, and 4-acetoxy-4-methyl hexanoic acid. A cell-free extract prepared from dihydrolinalyl acetate grown cells transformed dihydrolinalyl acetate into dihydrolinalool and dihydrolinalool-8-carboxylic acid. Based on the identification of various metabolites isolated from the culture medium, and on growth and manometric studies carried out with the isolated metabolites as well as with related synthetic analogs, probable pathways for the biodegradation of dihydrolinalyl acetate are presented.

2-O-methyl-1-methyl adenosine: A new modified nucleoside in ragi (eleusine coracana ) tRNA

A new modified nucleoside 2-²-O-methyl-l-methyl adenosine has been found to be present in the tRNA of (eleusine coracana ) (ragi) seedlings. The sequence of the dinucleotide of which this modified nucleoside is a part suggests its presence in phenylalanine-tRNA. The structural implications of the presence of this new modification are discussed.

Electrotransformation of Haemophilus parasuis with in vitro modified DNA based on a novel shuttle vector

The objective of the present study was to establish a valid transformation method of Haemophilus parasuis, the causative agent of Glasser's disease in pigs, using a novel H. parasuis-Escherichia coli shuttle vector. A 4.2 kb endogenous plasmid pYC93 was extracted from an H. parasuis field isolate and completely sequenced. Analysis of pYC93 revealed a region approximately 800 bp showing high homology with the defined replication origin oriV of pLS88, a native plasmid identified in Haemophilus ducreyi. Based on the origin region of pYC93, E. coli cloning vector pBluescript SK(+) and the Tn903 derived kanamycin cassette, a shuttle vector pSHK4 was constructed by overlapping PCR strategy. When electroporation of the 15 H. parasuis serovar reference strains and one clinical isolate SH0165 with pSHK4 was performed, only one of these strains yielded transformants with an efficiency of 8.5 x 10(2) CFUhlg of DNA. Transformation efficiency was notably increased (1.3 x 10(5) CFU/mu g of DNA) with vector DNA reisolated from the homologous transformants. This demonstrated that restriction-modification systems were involved in the barrier to transformation of H. parasuis. By utilizing an in vitro DNA modification method with cell-free extracts of the host H. parasuis strains, 15 out of 16 strains were transformable. The novel shuttle vector pSHK4 and the established electrotransformation method constitute useful tools for the genetic manipulation of H. parasuis to gain a better understanding of the pathogen. (C) 2011 Elsevier B.V. All rights reserved.

Modified Lu-Lee cryptosystem

A modified Lu-Lee cryptosystem is proposed which appears to be resistant to the cryptanalytic attacks on the original Lu-Lee scheme. The data expansion due to encryption is moderate, and the size of the public key is also quite small.

An alternative approach to selective sea water oxidation for hydrogen production

Sea water electrolysis is one of the promising ways to produce hydrogen since it is available in plentiful supply on the earth. However, in sea water electrolysis toxic chlorine evolution is the preferred reaction over oxygen evolution at the anode. In this work, research has been focused on the development of electrode materials with a high selectivity for oxygen evolution over chlorine evolution. Selective oxidation in sea water electrolysis has been demonstrated by using a cation-selective polymer. We have used a perm-selective membrane (Nafion®), which electrostatically repels chloride ions (Cl−) to the electrode surface and thereby enhances oxygen evolution at the anode. The efficiency and behaviour of the electrode have been characterized by means of anode current efficiency and polarization studies. The surface morphology of the electrode has been characterized by using a scanning electron microscope (SEM). The results suggest that nearly 100% oxygen evolution efficiency could be achieved when using an IrO2/Ti electrode surface-modified by a perm-selective polymer.

Mechanism of adsorption effects on electrode kinetics: Part I: Selection rules in the case of low coverage by molecular surfactants

It is shown that the effect of adsorption of inert molecules on electrode reaction rates is completely accounted for, by introducing into the rate equation, adsorption-induced changes in both the effective electrode area as well as in the electrostatic potential at the reaction site with an additional term for the noncoulombic interaction between the reactant and the adsorbate. The electrostatic potential at the reaction site due to the adsorbed layer is calculated using a model of discretely-distributed molecules in parallel orientation when adsorbed on the electrode with an allowance for thermal agitation. The resulting expression, which is valid for the limiting case of low coverages, is used to predict the types of molecular surfactants that are most likely to be useful for acceleration and inhibition of electrode reactions.