Does tobacco-control mass media campaign exposure prevent relapse among recent quitters?

OBJECTIVE: To determine whether greater mass media campaign exposure may assist recent quitters to avoid relapse. METHOD: Using date of data collection and postcode, media market estimates of televised tobacco-control advertising exposure measured by gross ratings points (GRPs) were merged with a replenished cohort study of 443 Australians who had quit in the past year. Participants' demographic and smoking characteristics prior to quitting, and advertising exposure in the period after quitting, were used to predict relapse 1 year later. RESULTS: In multivariate analysis, each increase in exposure of 100 GRPs (i.e., 1 anti-smoking advertisement) in the three-month period after the baseline quit was associated with a 5% increase in the odds of not smoking at follow-up (OR = 1.05, 95% CI 1.02-1.07, p < 0.001). This relationship was linear and unmodified by length of time quit prior to the baseline interview. At the mean value of 1081 GRPs in the 3 months after the baseline-quit interview, the predicted probability of being quit at follow-up was 52%, whereas it was 41% for the minimum (0) and 74% for the maximum (3,541) GRPs. CONCLUSION: Greater exposure to tobacco-control mass media campaigns may reduce the likelihood of relapse among recent quitters.

Primary voltage control of a single-phase inverter using linear quadratic regulator with integrator

This paper proposes a linear quadratic regulator with integral action, ensuring fast dynamic response and resisting capability of voltage deviation from instantaneous reference grid voltage, to control the inverter voltage that can also be used in a microgrid. The proposed control strategy is based on a linear quadratic regulator, minimizing the cost function of the system, with integral action used to impede voltage degradation from a reference voltage for outside disturbances of the system, such as abrupt load change. The combined integral term assists to recover the voltage difference between grid and reference grid voltage. The validity of the proposed controller has been tested with linear and non-linear loads under various conditions. In both cases, the effectiveness of the controller has been proved. The result of the proposed controller is good to track the instantaneous reference grid voltage.

Joint dynamic probabilistic constraints with projected linear decision rules

We consider multistage stochastic linear optimization problems combining joint dynamic probabilistic constraints with hard constraints. We develop a method for projecting decision rules onto hard constraints of wait-and-see type. We establish the relation between the original (in nite dimensional) problem and approximating problems working with projections from di erent subclasses of decision policies. Considering the subclass of linear decision rules and a generalized linear model for the underlying stochastic process with noises that are Gaussian or truncated Gaussian, we show that the value and gradient of the objective and constraint functions of the approximating problems can be computed analytically.

H-infinity control design for time-delay linear systems: a rational transfer function based approach

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Métodos numéricos para resolução de equações diferenciais ordinárias lineares baseados em interpolação por spline

In this work we have elaborated a spline-based method of solution of inicial value problems involving ordinary differential equations, with emphasis on linear equations. The method can be seen as an alternative for the traditional solvers such as Runge-Kutta, and avoids root calculations in the linear time invariant case. The method is then applied on a central problem of control theory, namely, the step response problem for linear EDOs with possibly varying coefficients, where root calculations do not apply. We have implemented an efficient algorithm which uses exclusively matrix-vector operations. The working interval (till the settling time) was determined through a calculation of the least stable mode using a modified power method. Several variants of the method have been compared by simulation. For general linear problems with fine grid, the proposed method compares favorably with the Euler method. In the time invariant case, where the alternative is root calculation, we have indications that the proposed method is competitive for equations of sifficiently high order.

Reactive power dispatch and planning using a non-linear branch-and-bound algorithm

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Robust state-derivative pole placement LMI-based designs for linear systems

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Design of a control system using linear matrix inequalities for the active vibration control of a plate

The study of algorithms for active vibration control in smart structures is an area of interest, mainly due to the demand for better performance of mechanical systems, such as aircraft and aerospace structures. Smart structures, formed using actuators and sensors, can improve the dynamic performance with the application of several kinds of controllers. This article describes the application of a technique based on linear matrix inequalities (LMI) to design an active control system. The positioning of the actuators, the design of a robust state feedback controller and the design of an observer are all achieved using LMI. The following are considered in the controller design: limited actuator input, bounded output (energy) and robustness to parametric uncertainties. Active vibration control of a flat plate is chosen as an application example. The model is identified using experimental data by an eigensystem realization algorithm (ERA) and the placement of the two piezoelectric actuators and single sensor is determined using a finite element model (FEM) and an optimization procedure. A robust controller for active damping is designed using an LMI framework, and a reduced model with observation and control spillover effects is implemented using a computer. The simulation results demonstrate the efficacy of the approach, and show that the control system increases the damping in some of the modes.

NUMERICAL SIMULATION of CONVECTION-DIFFUSION PROBLEMS BY THE CONTROL-VOLUME-BASED FINITE-ELEMENT METHOD

This work presents a numerical study of the tri-dimensional convection-diffusion equation by the control-volume-based on finite-element method using quadratic hexahedral elements. Considering that the equation governing this problem in its main variable may represent several properties, including temperature, turbulent kinetic energy, viscous dissipation rate of the turbulent kinetic energy, specific dissipation rate of the turbulent kinetic energy, or even the concentration of a contaminant in a given medium, among others, the wide applicability of this problem is thus evidenced. Three cases of temperature distributions will be studied specifically in this work, in addition to one case of pollutant dispersion upon analysis of the concentration of a contaminant in a fixed flow point. Some comparisons will be carried out against works found in the open literature, while others will be done according to each phenomenon characteristics.

Experimental Active Vibration Control in Truss Structures Considering Uncertainties in System Parameters

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Prevalência de incontinência urinária e fatores associados em idosos institucionalizados

Urinary incontinence (UI) is a geriatric syndrome that is especially prevalent in institutionalized individuals, and that causes economic and social impacts derived from treatment costs and overload of caregiver. UI also entails physical consequences to the health of the elderly, such as urinary tract infections or pressure ulcers, among other health problems. However, the existing national research on this condition is still scarce and comprises serious methodological biases. Therefore, the objective of this study is to determine the prevalence of urinary incontinence and associated factors in institutionalized elderly. A cross-sectional study is presented herein, conducted between October and December, 2013 and carried out in 10 nursing homes in the city of Natal (Northeast Brazil). UI was verified through the program Minimum Data Set version 3.0, which was also used to assess fecal incontinence, urinary devices and UI control programs. Data collection included sociodemographic information, UI characterization, as well as variables related to the institution itself and to health conditions (comorbidities, medication, pelvic floor surgery, Barthel Index for functional capacity and Pfeiffer test for cognitive status). Bivariate analysis was performed using the Chi-Square Test (or Fisher‟s Exact Test) and the Linear Chi-Square Test, calculating the prevalence ratio with 95% confidence interval. Variables with p value under 0.20 were included in the multivariate analysis, which was performed using the Stepwise Forward logistic regression. The inclusion of variables in the final model depended on the likelihood ratio test, absence of multicollinearity and on the Hosmer-Lemeshow test. A statistical significance level of 0.05 was considered. Six (1.8%) hospitalized elderly, one individual in palliative care (0.3%) and one (0.3%) individual under the age of 60 were excluded from the study. The final sample consisted of 321 elderly, mostly females, with a mean age of 81.5 years. The prevalence of UI was 59.43% and the final model revealed statistically a significant association between UI and white race, physical inactivity, stroke, mobility constraints and cognitive decline. The most frequent UI type was functional UI due to physical or cognitive disability, and incontinence control measures were applied only to a minority of residents (approximately 8%). It is concluded that UI is a health issue that affects more than half of the institutionalized elderly, and is associated with white race, physical inactivity, stroke and other geriatric syndromes such as immobility and cognitive disability. Most of these associated factors are modifiable and therefore the findings of this study highlight the importance of UI prevention and treatment in nursing homes, which include general measures, such as physical and psychosocial activities, and specific measures, such as prompted voiding

Dynamic stationary response of reinforced plates by the boundary element method

A direct version of the boundary element method (BEM) is developed to model the stationary dynamic response of reinforced plate structures, such as reinforced panels in buildings, automobiles, and airplanes. The dynamic stationary fundamental solutions of thin plates and plane stress state are used to transform the governing partial differential equations into boundary integral equations (BIEs). Two sets of uncoupled BIEs are formulated, respectively, for the in-plane state ( membrane) and for the out-of-plane state ( bending). These uncoupled systems are joined to formamacro-element, in which membrane and bending effects are present. The association of these macro-elements is able to simulate thin-walled structures, including reinforced plate structures. In the present formulation, the BIE is discretized by continuous and/or discontinuous linear elements. Four displacement integral equations are written for every boundary node. Modal data, that is, natural frequencies and the corresponding mode shapes of reinforced plates, are obtained from information contained in the frequency response functions (FRFs). A specific example is presented to illustrate the versatility of the proposed methodology. Different configurations of the reinforcements are used to simulate simply supported and clamped boundary conditions for the plate structures. The procedure is validated by comparison with results determined by the finite element method (FEM).