Correlation of Static Ageing Effects on Automotive Catalysts

This study identifies and analyzes the effect that aging time and temperature have on the CO light-off activity of three-way catalyst samples, aged in a static air (oxidizing) atmosphere. The bench aging time (BAT) equation proposed by the Environmental Protection Agency (EPA), which describes aging as dependent upon time at temperature, was used to calculate a range of oven aging times and temperatures based on a RAT-A engine bench aging cycle.

CO light-off tests carried out on cores aged between 800 and 900 °C have shown that it is the aging temperature that has the greatest effect on catalyst deterioration for static aging testing, with aging time having little effect. These results were in contradiction to the BAT equation, an industry norm for the aging of catalysts. This demonstrates that static aging, whilst showing how temperature affects aging, gives little or no time effects. The results have shown that static aging is not representative of actual aging on a vehicle.

Progressive aging conducted at a temperature of 1000 °C was shown to cause a decrease in catalyst activity as the aging time increased. However, even in these extreme conditions, static aging gave a slower rate of aging with time when compared to engine aging as defined by the BAT equation. Overall, static aging in air has been shown to produce a greater increase in aging due to temperature than predicted by the BAT equation, but less aging due to aging time.

Compiler and Runtime Support for Hybrid Static/Dynamic Scheduling

One of the outstanding issues in parallel computing is the selection of task granularity. This work proposes a solution to the task granularity problem by lowering the overhead of the task scheduler and as such supporting very fine-grain tasks. Using a combination of static (compile-time) scheduling and dynamic (run-time) scheduling, we aim to make scheduling decisions as fast as with static scheduling while retaining the dynamic load- balancing properties of fully dynamic scheduling. We present an example application and discuss the requirements on the compiler and runtime system to realize hybrid static/dynamic scheduling.

Modelling Static and Dynamic FRP-Concrete Bond Behaviour Using a Local Concrete Damage Model

This paper presents a study on the bond behaviour of FRP-concrete bonded joints under static and dynamic loadings, by developing a meso-scale finite element model using the K&C concrete damage model in LS-DYNA. A significant number of single shear experiments under static pull-off loading were modelled with an extensive parametric study covering key factors in the K&C model, including the crack band width, the compressive fracture energy and the shear dilatation factor. It is demonstrated that the developed model can satisfactorily simulate the static debonding behaviour, in terms of mesh objectivity, the load-carrying capacity and the local bond-slip behaviour, provided that proper consideration is given to the selection of crack band width and shear dilatation factor. A preliminary study of the effect of the dynamic loading rate on the debonding behaviour was also conducted by considering a dynamic increase factor (DIF) for the concrete strength as a function of strain rate. It is shown that a higher loading rate leads to a higher load-carrying capacity, a longer effective bond length, and a larger damaged area of concrete in the single shear loading scenario.

Overexpression of the microRNA miR-433 promotes resistance to paclitaxel through the induction of cellular senescence in ovarian cancer cells

Annually, ovarian cancer (OC) affects 240,000 women worldwide and is the most lethal gynecological malignancy. High-grade serous OC (HGSOC) is the most common and aggressive OC subtype, characterized by widespread genome changes and chromosomal instability and is consequently poorly responsive to chemotherapy treatment. The objective of this study was to investigate the role of the microRNA miR-433 in the cellular response of OC cells to paclitaxel treatment. We show that stable miR-433 expression in A2780 OC cells results in the induction of cellular senescence demonstrated by morphological changes, downregulation of phosphorylated retinoblastoma (p-Rb), and an increase in β-galactosidase activity. Furthermore, in silico analysis identified four possible miR-433 target genes associated with cellular senescence: cyclin-dependent kinase 6 (CDK6), MAPK14, E2F3, and CDKN2A. Mechanistically, we demonstrate that downregulation of p-Rb is attributable to a miR-433-dependent downregulation of CDK6, establishing it as a novel miR-433 associated gene. Interestingly, we show that high miR-433 expressing cells release miR-433 into the growth media via exosomes which in turn can induce a senescence bystander effect. Furthermore, in relation to a chemotherapeutic response, quantitative real-time polymerase chain reaction (qRT-PCR) analysis revealed that only PEO1 and PEO4 OC cells with the highest miR-433 expression survive paclitaxel treatment. Our data highlight how the aberrant expression of miR-433 can adversely affect intracellular signaling to mediate chemoresistance in OC cells by driving cellular senescence.

MIR-433 Predicts poor response to chemotherapy in ovarian cancer patients by the induction of cellular senescence

Annually, ovarian cancer (OC) affects 240,000 women worldwide and is the most lethal gynaecological malignancy. Such mortality is predominantly associated with the development of an intrinsic and acquired resistance to chemotherapy, the lack of targeted therapies and the lack of biomarkers predicting response to standard treatment.

Our clinical data demonstrates that increased miR-433 expression in primary high grade serous OC (HGSOCs) is significantly associated with poor PFS (n=46, p=0.024). Interestingly, the IHC analysis of two miR-433 targets: MAD2 [1] and HDAC6 shows that low IHC levels of both proteins is also significantly associated with worse outcome (p=0.002 and 0.002 respectively; n=43). Additionally, the analysis of miR 433 in the publicly available TCGA dataset corroborates that high miR-433 is significantly correlated with worse OS for patients presenting with OC (n=558 and p=0.027). In vito, in a panel of OC cell lines, higher miR-433 and lower MAD2 and HDAC6 levels were associated with resistance to paclitaxel.

To further investigate the role of miR-433 in the cellular response to chemotherapy, we generated an OC cell line stably expressing miR-433 or miR-control. MTT viability assays and Western Blot analyses established that miR-433 cells were more resistant to paclitaxel treatment (50nM) compared to miR-controls. Importantly, we have shown for the first time that miR 433 induced senescence resulting in a chracteristic flattened morphology and down-regulation of phosphorylated Retinoblastoma (p Rb), a molecular marker of senescence. Surprisingly, miR 433 induced senescence was independent from two well recognised senescent drivers: namely p53/p21 and p16. To explore this further we performed an in silico analysis of seven microRNA platforms which indicated that miR 433 potentially targets Cyclin-dependent kinase CDK6, which promotes sustained phosphorylation of Rb and thus cell cycle progression. In vitro, the overexpression of pre-miR-433 resulted in diminished CDK6 expression demonstrating a novel interaction between miR-433 and CDK6.

In conclusion, this study demonstrates that high miR-433 expression predicts poor outcome in OC patients by putatively rendering OC cells resistant to paclitaxel treatment through the induction of cellular senescence identifying this microRNA as a potential marker of chemoresponse.

State detection of bond wires in IGBT modules using eddy current pulsed thermography

Insulated gate bipolar transistor (IGBT) modules are important safety critical components in electrical power systems. Bond wire lift-off, a plastic deformation between wire bond and adjacent layers of a device caused by repeated power/thermal cycles, is the most common failure mechanism in IGBT modules. For the early detection and characterization of such failures, it is important to constantly detect or monitor the health state of IGBT modules, and the state of bond wires in particular. This paper introduces eddy current pulsed thermography (ECPT), a nondestructive evaluation technique, for the state detection and characterization of bond wire lift-off in IGBT modules. After the introduction of the experimental ECPT system, numerical simulation work is reported. The presented simulations are based on the 3-D electromagnetic-thermal coupling finite-element method and analyze transient temperature distribution within the bond wires. This paper illustrates the thermal patterns of bond wires using inductive heating with different wire statuses (lifted-off or well bonded) under two excitation conditions: nonuniform and uniform magnetic field excitations. Experimental results show that uniform excitation of healthy bonding wires, using a Helmholtz coil, provides the same eddy currents on each, while different eddy currents are seen on faulty wires. Both experimental and numerical results show that ECPT can be used for the detection and characterization of bond wires in power semiconductors through the analysis of the transient heating patterns of the wires. The main impact of this paper is that it is the first time electromagnetic induction thermography, so-called ECPT, has been employed on power/electronic devices. Because of its capability of contactless inspection of multiple wires in a single pass, and as such it opens a wide field of investigation in power/electronic devices for failure detection, performance characterization, and health monitoring. 

Static and dynamic degradation of sintered calcium phosphate ceramics

The chemical compositions of calcium phosphate materials are similar to that of bone making them very attractive for use in the repair of critical size bone defects. The bioresorption of calcium phosphate occurs principally by dissolution. To determine the impact of composition and flow conditions on dissolution rates, calcium phosphate tablets were prepared by slip casting of ceramic slips with different ratios of hydroxyapatite (HA) and ß-tricalcium phosphate (ß-TCP). Dissolution was evaluated at pH4 using both a static and dynamic flow regime. Both the composition of the HA:ß-TCP tablet and flow regime noticeably influenced the rate of dissolution; the 50:50 HA:ß-TCP composition demonstrating the greatest level of dissolution, and, exposure of the ceramic specimens to dynamic conditions producing the highest rate of dissolution. Understanding the impact of phase composition and flow condition with respect to the dissolution of calcium phosphate will aid in the development and improvement of materials for bone substitution.

A randomised comparison of daunorubicin 90mg/m2 vs 60mg/m2 in AML induction: results from the UK NCRI AML17 trial in 1206 patients

Modifying induction therapy in AML may improve the remission rate and reduce the risk of relapse thereby improving survival. Escalation of the daunorubicin dose to 90mg/m(2) has shown benefit for some patient subgroups when compared with a dose of 45mg/m(2) and has been recommended as a standard of care. However 60mg/m(2) is widely used and has never been directly compared to 90mg/m(2). As part of the UK NCRI AML17 trial 1206 adults with untreated AML or high risk MDS, mostly under 60 years of age, were randomised to a first induction course of chemotherapy which delivered either 90mg/m(2) or 60mg/m(2) on days 1,3 and 5 combined with cytosine arabinoside. All patients then received a second course which included daunorubicin 50mg/m(2) on days 1,3 and 5. There was no overall difference in complete remission rate (CR) (73% vs 75%, OR1.07 (0.83-1.39), p=0.6) or in any recognised subgroup. The 60 day mortality was increased in the 90mg/m2 arm (10% vs 5% (HR 1.98(1.30-3.02) p=0.001)), which resulted in no difference in overall 2 year survival (59% vs 60%, HR 1.16(0.95-1.43), p=0.15). In exploratory subgroup analysis there was no subgroup which showed significant benefit, although there was a significant interaction by FLT3 ITD mutation. The trial is registered to www.isrctn.com as ISRCTN55675535.

Crush responses of composite cylinder under quasi-static and dynamic loading

Despite the abundance of studies investigating the performance of composite structures under crush loading, disagreement remains in the literature regarding the effect of increased strain rate on the crush response. This study reports an experimental investigation of the behaviour of a carbon-epoxy composite energy absorber under static and dynamic loading with a strain rate of up to 100s^-1. Consistent damage modes and measured force responses were obtained in samples tested under the same strain rate. The energy absorption was found to be independent of strain rate as the total energy absorption appeared to be largely associated with fibre-dominated fracture, which is independent of strain rate within the studied range. The results from this study are beneficial for the design of energy absorbing structures.

Fusion of Static and Temporal Information for Threat Evaluation in Sensor Networks

In many CCTV and sensor network based intelligent surveillance systems, a number of attributes or criteria are used to individually evaluate the degree of potential threat of a suspect. The outcomes for these attributes are in general from analytical algorithms where data are often pervaded with uncertainty and incompleteness. As a result, such individual threat evaluations are often inconsistent, and individual evaluations can change as time elapses. Therefore, integrating heterogeneous threat evaluations with temporal influence to obtain a better overall evaluation is a challenging issue. So far, this issue has rarely be considered by existing event reasoning frameworks under uncertainty in sensor network based surveillance. In this paper, we first propose a weighted aggregation operator based on a set of principles that constraints the fusion of individual threat evaluations. Then, we propose a method to integrate the temporal influence on threat evaluation changes. Finally, we demonstrate the usefulness of our system with a decision support event modeling framework using an airport security surveillance scenario.

Induction of the inflammatory regulator A20 by gibberellic acid in airway epithelial cells

BACKGROUND AND PURPOSE: NF-κB-driven inflammation is negatively regulated by the zinc finger protein A20. Gibberellic acid (GA3 ) is a plant-derived diterpenoid with documented anti-inflammatory activity, which is reported to induce A20-like zinc finger proteins in plants. Here, we sought to investigate the anti-inflammatory effect of GA3 in airway epithelial cells and determine if the anti-inflammatory action relates to A20 induction.

EXPERIMENTAL APPROACH: Primary nasal epithelial cells and a human bronchial epithelial cell line (16HBE14o-) were used. Cells were pre-incubated with GA3 , stimulated with Pseudomonas aeruginosa LPS; IL-6 and IL-8 release, A20, NF-κB and IκBα expression were then evaluated. To determine if any observed anti-inflammatory effect occurred via an A20-dependent mechanism, A20 was silenced using siRNA.

KEY RESULTS: Cells pre-incubated with GA3 had significantly increased levels of A20 mRNA (4 h) and protein (24 h), resulting in a significant reduction in IL-6 and IL-8 release. This effect was mediated via reduced IκBα degradation and reduced NF-κB (p65) expression. Furthermore, the anti-inflammatory action of GA3 was abolished in A20-silenced cells.

CONCLUSIONS AND IMPLICATIONS: We showed that A20 induction by GA3 attenuates inflammation in airway epithelial cells, at least in part through its effect on NF-κB and IκBα. GA3 or gibberellin-derived derivatives could potentially be developed into anti-inflammatory drugs for the treatment of chronic inflammatory diseases associated with A20 dysfunction.