Structural characterization of Botryosphaeran: a (1 -> 3;1 -> 6)-beta-D-glucan produced by the ascomyceteous fungus, Botryosphaeria sp.

The exopolysaccharide, Botryosphaeran, produced by the ligninolytic, ascomycetcous fungus Botryosphaeria sp., was isolated from the extracellular fluid by precipitation with ethanol, and purified by gel permeation chromatography to yield a carbohydrate-rich fraction (96%) composed mainly of glucose (98%). Infra-red and C-13 NMR spectroscopy showed that all the glucosidic linkages were in the beta-configuration. Data from methylation analysis and Smith degradation indicated that Botryosphaeran was a (1 --> 3)-beta-(D)-glucan with approx 22% side branching at C-6. The products obtained from partial acid hydrolysis demonstrated that the side branches consisted of single (1 --> 6)-beta-linked glucosyl, and (1 --> 6)-beta-linked gentiobiosyl residues.[GRAPHICS](C) 2003 Elsevier Ltd. All rights reserved.

Atividade antifúngica de extratos de Momordica charantia L. sobre Colletotrichum musae

Os objetivos do presente trabalho foram avaliar os efeitos de extratos de Momordica charantia sobre o crescimento micelial e a germinação de conídios de Colletotrichum musae, e a eficiência destes extratos no controle da antracnose, causada por C. musae, em bananas. Extratos aquoso e hidroetanólico, obtidos de folhas e ramos, na concentração de 50% em relação ao volume adicionado, em meio sólido, proporcionaram 71 e 65% de inibição do crescimento micelial, respectivamente, enquanto que em meio líquido, a inibição do crescimento micelial foi de 86 e 81%, respectivamente. Somente o extrato aquoso e o tiofanato metílico, nas concentrações de 50% e 1000 µg mL-1 respectivamente, proporcionaram 100% de inibição da germinação de esporos de C. musae. Os extratos metanólico e aquoso inibiram em 80 e 70%, respectivamente, o desenvolvimento das lesões em bananas, quando aplicados até dois dias antes da inoculação do fungo. Estes resultados foram semelhantes ao tratamento com tiofanato metílico, que inibiu 80% do desenvolvimento das lesões. Confirma-se a presença de substância antifúngica nos extratos de M. charantia e outros estudos devem ser realizados para viabilizar seu uso no controle da antracnose da banana.

Efeitos da interação dipolar na nucleação de vórtices em nano-cilindros magnéticos

The effect of confinement on the magnetic structure of vortices of dipolar coupled ferromagnetic nanoelements is an issue of current interest, not only for academic reasons, but also for the potential impact in a number of promising applications. Most applications, such as nano-oscillators for wireless data transmission, benefit from the possibility of tailoring the vortex core magnetic pattern. We report a theoretical study of vortex nucleation in pairs of coaxial iron and Permalloy cylinders, with diameters ranging from 21nm to 150nm, and 12nm and 21nm thicknesses, separated by a non-magnetic layer. 12nm thick iron and Permalloy isolated (single) cylinders do not hold a vortex, and 21nm isolated cylinders hold a vortex. Our results indicate that one may tailor the magnetic structure of the vortices, and the relative chirality, by selecting the thickness of the non-magnetic spacer and the values of the cylinders diameters and thicknesses. Also, the dipolar interaction may induce vortex formation in pairs of 12nm thick nanocylinders and inhibit the formation of vortices in pairs of 21nm thick nanocylinders. These new phases are formed according to the value of the distance between the cylinderes. Furthermore, we show that the preparation route may control relative chirality and polarity of the vortex pair. For instance: by saturating a pair of Fe 81nm diameter, 21nm thickness cylinders, along the crystalline anisotropy direction, a pair of 36nm core diameter vortices, with same chirality and polarity is prepared. By saturating along the perpendicular direction, one prepares a 30nm diameter core vortex pair, with opposite chirality and opposite polarity. We also present a theoretical discussion of the impact of vortices on the thermal hysteresis of a pair of interface biased elliptical iron nanoelements, separated by an ultrathin nonmagnetic insulating layer. We have found that iron nanoelements exchange coupled to a noncompensated NiO substrate, display thermal hysteresis at room temperature, well below the iron Curie temperature. The thermal hysteresis consists in different sequences of magnetic states in the heating and cooling branches of a thermal loop, and originates in the thermal reduction of the interface field, and on the rearrangements of the magnetic structure at high temperatures, 5 produce by the strong dipolar coupling. The width of the thermal hysteresis varies from 500 K to 100 K for lateral dimensions of 125 nm x 65 nm and 145 nm x 65 nm. We focus on the thermal effects on two particular states: the antiparallel state, which has, at low temperatures, the interface biased nanoelement with the magnetization aligned with the interface field and the second nanoelement aligned opposite to the interface field; and in the parallel state, which has both nanoelements with the magnetization aligned with the interface field at low temperatures. We show that the dipolar interaction leads to enhanced thermal stability of the antiparallel state, and reduces the thermal stability of the parallel state. These states are the key phases in the application of pairs of ferromagnetic nanoelements, separated by a thin insulating layer, for tunneling magnetic memory cells. We have found that for a pair of 125nm x 65nm nanoelements, separated by 1.1nm, and low temperature interface field strength of 5.88kOe, the low temperature state (T = 100K) consists of a pair of nearly parallel buckle-states. This low temperature phase is kept with minor changes up to T= 249 K when the magnetization is reduced to 50% of the low temperature value due to nucleation of a vortex centered around the middle of the free surface nanoelement. By further increasing the temperature, there is another small change in the magnetization due to vortex motion. Apart from minor changes in the vortex position, the high temperature vortex state remains stable, in the cooling branch, down to low temperatures. We note that wide loop thermal hysteresis may pose limits on the design of tunneling magnetic memory cells

Mercury emissions from forest burning in southern Amazon

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Corrosion behavior of Ti-6Al-4V alloy treated by plasma immersion ion implantation process

Ti-6Al-4V alloy is one of the most frequently used Ti alloys with diverse applications in aerospace and biomedical areas due to its favorable mechanical properties, corrosion resistance and biocompatibility. Meanwhile, its surface can stiffer intense corrosion caused by wear processes due to its poor tribological properties. Thus in the present study, PIII processing of Ti-6Al-4V alloy was carried out to evaluate its corrosion resistance in 3.5% NaCl solution. Two different sets of Ti-6Al-4V samples were PIII treated, varying the plasma gases and the treatment time. The corrosion behavior is correlated with the surface morphology, and the nitrogen content. SEM micrographs of the untreated sample reveal a typical two-phase structure. PIII processing promotes surface sputtering and the surface morphology is completely different for samples treated with N-2/H-2 mixture and N-2 only. The highest penetration of nitrogen (similar to 88 nm), corresponding to 33% of N-2 was obtained for the sample treated with N-2/H-2 mixture for 1:30 h. The corrosion behavior of the samples was investigated by a potentiodynamic polarization method. A large passive region of the polarization curves (similar to 1.5 V), associated with the formation of a protective film, was observed for all samples. The passive current density (similar to 3 x 10(-6) A cm(-2)) of the PIII-treated Ti-6Al-4V samples is about 10 times higher than for the untreated sample. This current value is still rather low and maintains good corrosion resistance. The anodic branches of the polarization curves for all treated Ti-6Al-4V samples demonstrate also that the oxide films break down at approximately 1.6 V, forming an active region. Although the sample treated by N-2/H-2 mixture for 1.30 It has thicker nitrogen enriched layer, better corrosion resistance is obtained for the PIII process performed with N, gas only. (c) 2007 Elsevier B.V. All rights reserved.

Enhanced corrosion resistance of AISI H13 steel treated by nitrogen plasma immersion ion implantation

Electrochemical corrosion measurements of AISI H13 steel treated by Pill process in 3.5% (wt) NaCl solution were investigated. So far the corrosion behavior of AISI H 13 steel by Pill has not been studied. The electrochemical results are correlated with the surface morphology, nitrogen content and hardness of the nitride layer. Ion implantation of nitrogen into H 13 steel was carried out by Pill technique. SEM examination revealed a generalized corrosion and porosity over all analyzed sample surfaces. Penetration of nitrogen reaching more than 20 gm was achieved at 450 degrees C and hardness as high as 1340 HV (factor of 2.7 enhancement over standard tempered and annealed H 13) was reached by a high power, 9 h Pill treatment. The corrosion behavior of the samples was studied by potentiodynamic polarization method. The noblest corrosion behavior was observed for the samples treated by PIII at 450 degrees C, during 9 h. Anodic branches of polarization curves of PIII processed samples show a passive region associated with the formation of a protective film. The passive region current density of PIII treated H13 samples (3.5 x 10(-6) A/cm(2)) is about 270 times lower than the one of untreated specimens, which demonstrates the higher corrosion resistance for the Pill treated H 13 samples. (c) 2007 Elsevier B.V. All rights reserved.

Self-Organizing Maps as a New Tool for Classification of Plants at Lower Hierarchical Levels

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Beam Search Algorithms for Minimizing Tool Switches on a Flexible Manufacturing System

In the minimization of tool switches problem we seek a sequence to process a set of jobs so that the number of tool switches required is minimized. In this work different variations of a heuristic based on partial ordered job sequences are implemented and evaluated. All variations adopt a depth first strategy of the enumeration tree. The computational test results indicate that good results can be obtained by a variation which keeps the best three branches at each node of the enumeration tree, and randomly choose, among all active nodes, the next node to branch when backtracking.

Contribuição ao estudo da vascularização arterial do testículo de búfalos da raça Murrah

Estudamos o comportamento da artéria testicular, o número e a distribuição dos vasos penetrantes em 30 pares de testículos de búfalos da raça Murrah (Bubalus bubalis), com idade entre 8 meses e 5 anos, procedentes da região de Ilha Solteira, no Estado de São Paulo, mediante a análise de moldes obtidos pela injeção de vinil, na artéria testicular e em seguida corrosão do órgão em ácido sulfúrico a 30%. Encontramos mais freqüentemente (68,4%) a artéria testicular cedendo dois ramos, o cranial e o caudal, com participação equivalente de ambos os ramos na vascularização do órgão (35,0%), ou com predominância do ramo cranial (21,7%) ou do ramo caudal (11,7%). em outros arranjos, a artéria testicular cede três ramos: o cranial, o médio e o caudal (20,0%) ou ainda número variável de ramos craniais (4 a 7) e caudais (3 a 5) (11,6%) para a vascularização arterial do testículo.

Matéria seca e produção de grãos de Crotalaria juncea L. submetida à poda e adubação fosfatada

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Allocation of protective devices in distribution circuits using nonlinear programming models and genetic algorithms

The optimized allocation of protective devices in strategic points of the circuit improves the quality of the energy supply and the system reliability index. This paper presents a nonlinear integer programming (NLIP) model with binary variables, to deal with the problem of protective device allocation in the main feeder and all branches of an overhead distribution circuit, to improve the reliability index and to provide customers with service of high quality and reliability. The constraints considered in the problem take into account technical and economical limitations, such as coordination problems of serial protective devices, available equipment, the importance of the feeder and the circuit topology. The use of genetic algorithms (GAs) is proposed to solve this problem, using a binary representation that does (1) or does not (0) show allocation of protective devices (reclosers, sectionalizers and fuses) in predefined points of the circuit. Results are presented for a real circuit (134 busses), with the possibility of protective device allocation in 29 points. Also the ability of the algorithm in finding good solutions while improving significantly the indicators of reliability is shown. (C) 2003 Elsevier B.V. All rights reserved.

Algoritmos evolutivos dedicados à reconfiguração de redes radiais de distribuição sob demandas fixas e variáveis: estudo dos operadores genéticos e parâmetros de controle

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Preferência de oviposição de Grapholita molesta (busck) (lepidoptera: tortricidae) em cultivares de pessegueiro

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

EFEITO do ETHEPHON em VIDEIRA 'RUBI' (Vitis vinifera L.), CULTIVADA NA REGIÃO NOROESTE do ESTADO DE SÃO PAULO

O experimento foi conduzido em vinhedo comercial da cv. Rubi, localizado na região Noroeste do Estado de São Paulo. Teve, como objetivo, verificar o efeito do ethephon, aplicado antes da poda de produção, na porcentagem de desfolhamento, tempo de realização da poda, brotação dos ramos, produção da videira, tentando reduzir os custos, melhorando a produtividade e a qualidade. Concluiu-se que a aplicação de 7500ppm de ethephon, 20 dias antes da poda, foi o tratamento que proporcionou maior porcentagem de desfolhamento, menor tempo de realização da poda, maior porcentagem de gemas brotadas e maior produção.

Aumento da produtividade de soja com a aplicação de bioestimulantes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)