Asymptomatic carriers of Plasmodium spp. as infection source for malaria vector mosquitoes in the Brazilian Amazon

We have described the existence of asymptomatic carriers of Plasmodium vivax and Plasmodium falciparum infections in native Amazon populations. Most of them had low parasitemias, detected only by polymerase chain reaction (PCR). Because they remain symptomless and untreated, we wanted to determine whether they could infect Anopheles darlingi Root, the main Brazilian vector, and act as disease reservoirs. Fifteen adult asymptomatic patients (PCR positive only) were selected, and experimental infections of mosquitoes were performed by direct feeding and by a membrane-feeding system. Seventeen adult symptomatic patients with high parasitemias were used as controls. We found an infection rate in An. darlingi of 1.2% for the asymptomatic carriers and 22% for the symptomatic carriers. Although the asymptomatic group infected mosquitoes at a much lower rate, these patients remain infective longer than treated, symptomatic patients. Also, the prevalence of asymptomatic infections is 4 to 5 times higher than symptomatic infections among natives. These results have implications for the malaria control program in Brazil, which focuses essentially on the treatment of symptomatic patients. © 2005 Entomological Society of America.

Influence of light curing source on microhardness of composite resins of different shades

Introduction: The evolution of light curing units can be noticed by the different systems recently introduced. The technology of LED units promises longer lifetime, without heating and with production of specific light for activation of camphorquinone. However, further studies are still required to check the real curing effectiveness of these units. Purpose: This study evaluated the microhardness of 4 shades (B-0.5, B-1, B-2 and B-3) of composite resin Filtek Z-250 (3M ESPE) after light curing with 4 light sources, being one halogen (Ultralux - Dabi Atlante) and three LED (Ultraled - Dabi Atlante, Ultrablue - DMC and Elipar Freelight - 3M ESPE). Methods: 192 specimens were distributed into 16 groups, and materials were inserted in a single increment in cylindrical templates measuring 4mm x 4mm and light cured as recommended by the manufacturer. Then, they were submitted to microhardness test on the top and bottom aspects of the cylinders. Results: The hardness values achieved were submitted to analysis of variance and to Tukey test at 5% confidence level. It was observed that microhardness of specimens varied according to the shade of the material and light sources employed. The LED appliance emitting greater light intensity provided the highest hardness values with shade B-0.5, allowing the best curing. On the other hand, appliances with low light intensity were the least effective. It was also observed that the bottom of specimens was more sensitive to changes in shade. Conclusion: Light intensity of LED light curing units is fundamental for their good functioning, especially when applied in resins with darker shades.

Vernonia polyanthes as a new source of antiulcer drugs

Methanolic (VPME) and chloroformic (VPCL) extracts, obtained from the aerial parts of Vernonia polyanthes, were investigated for its antiulcerogenic properties. Administration of VPME (250 mg/kg) and VPCL (50 mg/kg) significantly inhibited the gastric mucosa damage (64% and 90%, respectively) caused by absolute ethanol (p.o.). Otherwise, in NSAID-induced gastric damage, their gastroprotective effects have decreased. Since the VPCL extract resulted to be more effective than the VPME we focused our efforts over VPCL action mechanism of action. © 2007 Elsevier B.V. All rights reserved.

Voltammetry of mercury (II) based on an organo-clay modified graphite electrode

Organo-clay complex of ligand-hexadecyltrimethylammonium with montmorillonite was made for the purpose of application as a preconcentration agent in a chemically modified carbon paste electrode for determination of mercury (II) in aqueous solution. It was found out that the adsorption of Hg(II) by organo-clay complex is independent of the pH of the solution. It was also found out that the adsorption of the remaining metals Cd(II), Ps(II), Cu(II), Zn(II), and Ni(II) was dependent on the changes in pH solutions and increased when it varies from 1 to 8. The resultant material was characterized by cyclic and differential pulse anodic voltammetry using a modified graphite paste electrode in different supporting electrolytes. The mercury response was evaluated with respect to pH, electrode composition, preconcentration time, mercury concentration, possible interferences and other variables.

Paisagem natural paleógena da bacia sedimentar de São Paulo no município de guarulhos, estado de São Paulo

Paleogene sediments of this region represent a significant source of water for urban, industrial and agricultural activities. This basin is part of the Southeastern Brazilian Continental Rift, which occupies a large portion of this geographical area. This study aims to present the evolution of the natural Paleogene landscape, through an analysis of its stratigraphic intcrops and underground portions based on the concept of facies and facies associations. A total of nine clastic and separate lithofacies were recognized and grouped into two main facies associations. These data suggest the existence of two depositional interdigitated systems: fluvial braided fans, which were predominant in parts of the northern and central area, and another composed of lacustrine sediments found in its central-south region. The paleogeography herein outlined will help considerably in the detection of new areas for mineral and water resources prospection, as well as in urban planning projects of this region.

Economic efficiency of free and open source software in the public sector: the example of Chile

Includes bibliography

Mexico's incorporation into the new industrial order: foreign investment as a source of international competitiveness

Includes bibliography

Determination of copper at wide range concentrations using instrumental features of high-resolution continuum source flame atomic absorption spectrometry

This work describes a method to determine Cu at wide range concentrations in a single run without need of further dilutions employing high-resolution continuum source flame atomic absorption spectrometry. Different atomic lines for Cu at 324. 754 nm, 327. 396 nm, 222. 570 nm, 249. 215 nm and 224. 426 nm were evaluated and main figures of merit established. Absorbance measurements at 324. 754 nm, 249. 215 nm and 224. 426 nm allows the determination of Cu in the 0. 07-5. 0 mg L -1, 5. 0-100 mg L -1 and 100-800 mg L -1 concentration intervals respectively with linear correlation coefficients better than 0. 998. Limits of detection were 21 μg L -1, 310 μg L -1 and 1400 μg L -1 for 324. 754 nm, 249. 215 nm and 224. 426 nm, respectively and relative standard deviations (n = 12) were ≤ 2. 7%. The proposed method was applied to water samples spiked with Cu and the results were in agreement at a 95% of confidence level (paired t-test) with those obtained by line-source flame atomic absorption spectrometry.

Change and opportunity: corporate social responsibility as a source of competitiveness in small and medium enterprises in Latin America and the Caribbean

Includes bibliography

Reactive power support pricing of distributed generators with primary energy source uncertainty

In this paper, a novel methodology to price the reactive power support ancillary service of Distributed Generators (DGs) with primary energy source uncertainty is shown. The proposed methodology provides the service pricing based on the Loss of Opportunity Costs (LOC) calculation. An algorithm is proposed to reduce the uncertainty present in these generators using Multiobjective Power Flows (MOPFs) implemented in multiple probabilistic scenarios through Monte Carlo Simulations (MCS), and modeling the time series associated with the generation of active power from DGs through Markov Chains (MC). © 2011 IEEE.

Dinâmica de cátions na raiz e folhas de berinjela cultivada sobre doses crescentes de potássio oriundas de duas fontes

This study was conducted at the Department of Plant Production, Sector Horticulture, UNESP - Botucatu, SP, Brazil, in order to assess the dynamics of cationic nutrients in roots and leaves and effects on dry matter production of roots and shoots in eggplant grown on conditions of increasing doses of potassium from two distinct sources (KCl and K 2SO 4). The experiment was arranged in randomized blocks in factorial 2 × 4 (two sources of potassium, KCl and K 2SO 4 and four doses of each source equivalent, 250, 500, 750 and 1000 kg ha -1 K 2O) comprising eight treatments with three replicates. For the experiment we used Oxisol medium texture (615 g of sand, silt 45 g and 340 g clay per kg soil). The characteristics evaluated were: soil electrical conductivity, mass of shoot and root material, content and ratio of K +, Ca 2+ and Mg 2+ in roots and leaves of eggplant. We conclude that excessive doses of sources of K 2O affected the production of dry matter of roots and shoots, as well as electrical conductivity. The accumulation and the relationship of Ca2+/K+, Mg 2+/K + were affected by increased K + concentration; K 2SO 4 was the fertilizer that was less damaging.

Single-phase current-source-boost inverter for renewable energy sources

This paper presents a new methodology for the operation and control of a single-phase current-source (CS) Boost Inverter, considering that the conventional CS boost inverter has a right-half-plane (RHP) zero in its control-to-output transfer function, and this RHP zero causes the known non-minimum-phase effects. In this context, a special design with low boost inductance and a multi-loop control is developed in order to assure stable and very fast dynamics. Furthermore, the proposed inverter presents output voltage with very low total harmonic distortion (THD), reduced components and high power density. Therefore, this paper presents the inverter operation, the proposed control technique, the main simulation results and a prototype in order to demonstrate the feasibility of the proposal. © 2011 IEEE.

Integrating open source codes for solid modeling and automatic mesh generation in FEM applications

The applications of the Finite Element Method (FEM) for three-dimensional domains are already well documented in the framework of Computational Electromagnetics. However, despite the power and reliability of this technique for solving partial differential equations, there are only a few examples of open source codes available and dedicated to the solid modeling and automatic constrained tetrahedralization, which are the most time consuming steps in a typical three-dimensional FEM simulation. Besides, these open source codes are usually developed separately by distinct software teams, and even under conflicting specifications. In this paper, we describe an experiment of open source code integration for solid modeling and automatic mesh generation. The integration strategy and techniques are discussed, and examples and performance results are given, specially for complicated and irregular volumes which are not simply connected. © 2011 IEEE.

On nonlinear dynamics in a free fluid surface of a tank excited by a non-ideal power source

We investigate the nonlinear oscillations in a free surface of a fluid in a cylinder tank excited by non-ideal power source, an electric motor with limited power supply. We study the possibility of parametric resonance in this system, showing that the excitation mechanism can generate chaotic response. Additionally, the dynamics of parametrically excited surface waves in the tank can reveal new characteristics of the system. The fluid-dynamic system is modeled in such way as to obtain a nonlinear differential equation system. Numerical experiments are carried out to find the regions of chaotic solutions. Simulation results are presented as phase-portrait diagrams characterizing the resonant vibrations of free fluid surface and the existence of several types of regular and chaotic attractors. We also describe the energy transfer in the interaction process between the hydrodynamic system and the electric motor. Copyright © 2011 by ASME.

3-D Space Vector PWM implementation for Four-Leg Voltage Source Inverter

The Space Vector PWM implementation and operation for a Four-leg Voltage Source Inverter (VSI) is detailed and discussed in this paper. Although less common, four-leg VSIs are a viable solution for situations where neutral connection is necessary, including Active Power Filter applications. This topology presents advantages regarding the VSI DC link and capacitance, which make it useful for high power devices. Theory, implementation and simulations are also discussed in this paper. © 2011 IEEE.