Analysis of the process of inspection in recreational craft in Spain. Suggestions for safety improvement

Inspections of pleasure boats in Spain can be carried out by collaborating entities of inspection, entities that must be authorized by the Maritime Administration. This authorization allows to perform effective inspections and technical controls of recreational crafts. Recreational crafts are subjected to surveys that are based on the registration list and on the material used in the hull. In addition, required safety equipment of the recreational boat depends on the distance that the recreational boat is authorized to navigate. Following data obtained from inspections of recreational craft, this paper aims to analyze information about hulls within dry and afloat conditions, about the equipment for rescue and safety, and about other nautical equipment; as well as to perform and improve different verifications during the inspections. All this information points to several aspects relevant for the optimization of the inspection process, the ultimate target being increasing efficiency and effectiveness, and ensuring more safety in recreational craft.

The forced adoption of a fast-track appraisal process for a breast cancer treatment in UK

Trastuzumab (Herceptin ®, Roche) is approved in UK for the treatment of the metastatic breast cancer since 2001. As of 2005, concomitantly with the publication of 3 studies that showed it produces a 50% reduction of the recurrence rates of breast cancer, trastuzumab started to be prescribed in the earlt adjuvant treatrnent of this disease. Und June 2006, trastuzumab did not have both: 1) regulatory approval and 2) NICE [National Institute for Health and Clinical Excellence] recommendation for the use in early stages of breast cancer. During the period until June 2006, the trastuzumab use in those patients was not reimbursed and because the cost of trastuzumab is equal with the yearly UK average income, most of patients could not self fund their treatrnent. Before the publication of the final NICE guidance, the new data of trastuzumab in early breast cancer raised enormous patient and professional interest and expectations. A great volume of public and professional pressure was generated to transcend a system by which Primary Care Trusts can reimburse a treatment only after a formal guidance was issued. This paper draw on a case study depicting and analyzing the process by which regulatory approval and NICE recommendations were achieved in a record time and how trastuzumab became a standard treatment on early adjuvant breast cancer. According to the data we gathered in this work we were witnessing one of the fastest processes of adoption of a health care technology since the creation of NICE, in 1999. This study addresses the following research question: How and why does the adoption pattern of trastuzumab differ from the rational decision-making model of the reimbursement process in UK? [Author, p. 4]

To analyse a trace or not? Evaluating the decision-making process in the criminal investigation

In order to broaden our knowledge and understanding of the decision steps in the criminal investigation process, we started by evaluating the decision to analyse a trace and the factors involved in this decision step. This decision step is embedded in the complete criminal investigation process, involving multiple decision and triaging steps. Considering robbery cases occurring in a geographic region during a 2-year-period, we have studied the factors influencing the decision to submit biological traces, directly sampled on the scene of the robbery or on collected objects, for analysis. The factors were categorised into five knowledge dimensions: strategic, immediate, physical, criminal and utility and decision tree analysis was carried out. Factors in each category played a role in the decision to analyse a biological trace. Interestingly, factors involving information available prior to the analysis are of importance, such as the fact that a positive result (a profile suitable for comparison) is already available in the case, or that a suspect has been identified through traditional police work before analysis. One factor that was taken into account, but was not significant, is the matrix of the trace. Hence, the decision to analyse a trace is not influenced by this variable. The decision to analyse a trace first is very complex and many of the tested variables were taken into account. The decisions are often made on a case-by-case basis.

The role of mentoring in facilitating the process of repurposing OER

This paper presents the initial data analysis of a research that is work in progress. It discusses the role of mentoring and peer support in facilitating the process of repurposing open educational resources (OER). It also reports on the lessons so far learned from the analysis of two distinct but related case studies on working with learners to use and disseminate OER.

A Game to Promote Understanding about UCD Methods and Process

The User-centered design (UCD) game is a tool forhuman-computer interaction practitioners to demonstrate the key user-centered design methodsand how they interrelate in the design process in an interactive and participatory manner. The target audiences are departments and institutions unfamiliar with UCD but whose work is related to the definition, creation, and update of a product or service.

Fostering Collaborative Knowledge Building by the Effective Provision of Knowledge about the Discussion Process

Peer-reviewed

Unsaturated Oxazolopiperidone Lactams: an Unexpected Domino-type Double Conjugate Additioncyclization Process

Reactions of 2-acetylindole enolate with unsaturated oxazolopiperidones 3, 4 and 10 unexpectedly gives pentacyclic dilactams 6, 7 and 11, respectively, resulting from a domino-type process involving two successive conjugate additions and a final cyclization.

Radiative Heat Transfer in Boiler Furnaces

Better models are needed for radiative heat transfer in boiler furnaces. If the process is known better, combustion in the furnace can be optimized to produce low emissions. It makes the process to be environmental friendly. Furthermore, if there is a better model of the furnace it can more fully explain what is happening inside the furnace. Using of the model one can quickly and easily analyze how it operates with bio fuels, moist fuels or difficult fuels and improve the operation. Models helps with better estimation of furnace dimensions and result in more accurate understanding of operation. Key component lacking in these models is radiative heat transfer in particle laden gases. If there are no particles than radiative heat transfer can be calculated approximately. There are two problems with current models when used with flow modeling. The first one is a need to account for a particle laden gas and the second one is an absence of a fast algorithm. Fast calculation is needed if radiative heat transfer calculation is done for a large CDF model. Computations slow down if time is required for calculating radiative properties over and over again. This thesis presents a band model for radiative heat transfer in boiler furnaces. Advantage is a quickness of calculation and account of particles in the process.

The experience of identity transformation process for people living with tetraplegia and paraplegia = El proceso de reconstrucción de la identidad de las personas afectadas de una paraplejia o tetraplejia

A spinal cord injury (SCI) is perceived as a source of biographical disruption, not only at a physical level but also in terms of people’s life stories, their motivation and their self-esteem. The aim of this study is to explore the factors that people with spinal cord injuries perceive as contributing to rebuilding their sense of self. Two focus groups were established from the SCIcommunity, one of which was made up of 14 people with paraplegia and the other of 9 people with tetraplegia. In addition, four individual interviews were conducted with the participants. The results of content analysis show that the two most prominent factors in the process of identity renegotiation are the partial transformation of the subject’s identity followed by a coming to terms with that new identity. To rebuild self-worth, the importance of finding a balance between change and continuity was identified. Renegotiation of identity after a spinal cord injury is a complex phenomenon that greatly influences the SCI individual’s quality of life perceptions. Reaching a balance between the changes experienced due to the injury and finding a sense of continuity can be either facilitated or obstructed by the economic, political, legal, architectural, and social context

Ilmaan johdettavien epäpuhtauksien päästökartoitus Porvoon öljynjalostamolla

Työn tarkoituksena oli laatia suunnitelma ilmaan johdettavien epäpuhtauksien päästökartoitukselle Porvoon öljynjalostamolla. Raskasmetallien, metaanin, fluorivetyhapon, rikkivedyn ja ammoniakin merkittävät päästöpaikat ja -tarkkailumenetelmät kartoitettaisiin tulevaa päästöraportointia varten. Tarkkailun alaisten komponenttien muodostuminen, kulkeutuminen ja merkittävät päästöpaikat Porvoon jalostamolla selvitettiin kirjallisuuslähteiden, jalostamon toimintajärjestelmän ohjeiden sekä työntekijöiden haastattelujen perusteella. Merkittäviä häiriöpäästötilanteita kartoitettiin ja arvioitiin jalostamon poikkeamatilastojen ja haastattelujen avulla. Normaalitoiminnan aikana tarkkailun alaisista epäpuhtauksista vapautuu ilmaan merkittäviä määriä ainoastaan metaania ja raskasmetalleja. Metaania vapautuu ilmaan polttoprosesseissa sekä hajapäästönä. Raskasmetallipäästöjä syntyy pohjaöljyn poltossa energialaitoksella sekä leijukatalyyttisessä krakkauksessa. Rikkilaitosten häiriötilanteista aiheutuu rikkivety- ja ammoniakkipäästöjä pääasiassa soihtujärjestelmän kautta. Alkylointiyksikön vuodoissa voi vapautua fluorivetyhappoa ilmaan. Päästömääriä arvioidaan pääosin laskennallisesti. Päästökartoitussuunnitelma on kokonaisuudessaan tämän työn liitteenä. Näyttäisi siltä, että TRS-yhdisteiden, ammoniakin ja fluorivetyhapon ilmapäästöt eivät ole merkittäviä Porvoon öljynjalostamolla. Uuden pohjaöljy-yksikön käyttöönotto on vähentänyt myös raskasmetallipäästöjä energialaitoksella. Metaanipäästö vaikuttaa kartoitukseen sisällytettävistä epäpuhtauksista merkityksellisimmältä Porvoon öljynjalostamolla.

Kierrätyspolttoaineen käyttö leijupetikattilan konseptiin

Diplomityö tehtiin Rautjärven kunnassa sijaitsevalle M-real Simpeleen tehtaan voimalaitokselle. Voimalaitoksella on leijupetikattila ja se tuottaa prosessilämmön ja höyryn kartonki- ja paperikoneelle. Vuotuinen energiantuotanto on noin 115 GWh. Diplomityön tavoitteena oli tutkia kierrätyspolttoaineen käyttöä osana voimalaitoksen polttoainekonseptista. Voimalaitoksen biokattila on leijupetikattila, jossa poltetaan tehtaalta tulevaa kuorta ja lietettä sekä tehtaan ulkopuolisia puuperäisiä biopolttoaineita ja turvetta. Yksi työn päätavoitteista oli laatia voimassa olevan ympäristöluvan muutoshakemus, jotta kierrätyspolttoaineen käytölle saataisiin lupa. Suurten polttolaitosten päästöjen tarkkailu- ja raportointivaatimukset ovat uudistuneet viime vuosina paljon. Suurimpia muutosten aiheuttajia ovat Valtioneuvoston asetukset 1017/2002 ja 362/2003. Tässä työssä kuvataan uusien asetusten tuomia vaatimuksia itse kattilalle ja polttoaineen syötölle, jatkuvatoimisille mittalaitteille ja muille suoritettaville mittauksille. Uutena asiana on myös ilmapäästöjen seurantamittaukset ja -tapa, jolla tulokset ilmoitetaan. Mahdollisimman pieniin leijupetikattilamuutoksiin uskotaan pääsevän korvaamalla kierrätyspolttoaine REF1:llä 5 – 10 % turpeesta tai puupolttoaineista.

Process variability-aware proactive reconfiguration technique for mitigating aging effects in nanos scale SRAM lifetime

Postprint (published version)