Effects of Fin Parameters on Gas-Side Heat Transfer Performance of H-Type Finned Tube Bundle in a Waste Heat Recovery Boiler

Alfa Laval Aalborg Oy designs and manufactures waste heat recovery systems utilizing extended surfaces. The waste heat recovery boiler considered in this thesis is a water-tube boiler where exhaust gas is used as the convective heat transfer medium and water or steam flowing inside the tubes is subject to cross-flow. This thesis aims to contribute to the design of waste heat recovery boiler unit by developing a numerical model of the H-type finned tube bundle currently used by Alfa Laval Aalborg Oy to evaluate the gas-side heat transfer performance. The main objective is to identify weaknesses and potential areas of development in the current H-type finned tube design. In addition, numerical simulations for a total of 15 cases with varying geometric parameters are conducted to investigate the heat transfer and pressure drop performance dependent on H-type fin geometry. The investigated geometric parameters include fin width and height, fin spacing, and fin thickness. Comparison between single and double tube type configuration is also conducted. Based on the simulation results, the local heat transfer and flow behaviour of the H-type finned tube is presented including boundary layer development between the fins, the formation of recirculation zone behind the tubes, and the local variations of flow velocity and temperature within the tube bundle and on the fin surface. Moreover, an evaluation of the effects of various fin parameters on heat transfer and pressure drop performance of H-type finned tube bundle has been provided. It was concluded that from the studied parameters fin spacing and fin width had the most significant effect on tube bundle performance and the effect of fin thickness was the least important. Furthermore, the results suggested that the heat transfer performance would increase due to enhanced turbulence if the current double tube configuration is replaced with single tube configuration, but further investigation and experimental measurements are required in order to validate the results.

Sustainable Development – the Key to Competitiveness CSR as an added value to Alstom’s corporate performance

Corporate social responsibility or CSR is today a widely recognized concept which is receiving in- creasing popularity extremely rapidly, especially in the business world. The pressure on companies to carry out their business practices in ethical manners, which promote the wellbeing of the environment and society, is coming from all directions and all stakeholders. Alstom, a French multinational conglomerate operating in the rail transport and energy industry, is no exception to this norm. This company, which will be used as the case example in this thesis, is being brought to bay in terms of engaging in CSR practices and practicing business with high ethics. It is surely not a negatively conceived phenomenon that CSR is being put on a pedestal – quite the opposite. Instead of corporations practicing CSR only to meet their stakeholder requirements through practicing window dressing, many corporations actually strive to benefit from the practice of corporate social business. In addition to bringing benefit to externals a corporation such as Alstom itself can benefit from being involved in CSR. The purpose of this thesis is to evaluate the current strategic values and the future perspectives of CSR at Alstom and moreover the added value which the practice of CSR could bring Alstom as a business. A set of perspectives from a futures studies viewpoint is looked at, with critical examination of the company’s current corporate practices as well as the CSR related studies and theories written for corporations. Through this, some solutions and practices will be suggested to Alstom in order for it to fully utilize the potential of corporate social business and the value it can bring in the most probable futures that the company is expected to face. By utilizing the Soft Systems Methodology (SSM), a method mainly used in organizations to solve problematic issues in management and policy contexts, a process is developed to see what improvements could be of help in improving Alstom and its way towards involving CSR in its business practices even more than it currently does. Alstom is already deeply involved in the practicing of CSR and its vision has a strong emphasis on this popular concept of today. In order to stay in the game and to use CSR as a competitive advantage to the company, Alstom ought to embed corporate social practices even deeper in its organizational culture by using them as a tool to reduce risk and costs, increasing employee commitment and customer loyalty and to attract socially responsible investors, just to name a few. CSR as a concept is seen to have great potential in the future, an opportunity Alstom will not miss.

Isolation and recovery of glycomacropeptide from milk whey by means of thermal treatment

During enzymatic process of cheese manufacturing, rennin cleaves κ-casein releasing two fractions: para-κ-casein and glycomacropeptide (GMP), which remains soluble in milk whey. GMP is a peptide with structural particularities such as chain carbohydrates linked to specific threonine residues, to which a great variety of biological activities is attributed. Worldwide cheese production has increased generating high volumes of milk whey that could be efficiently used as an alternative source of high quality peptide or protein in foodstuff formulations. In order to evaluate isolation and recovery on whey GMP by means of thermal treatment (90 °C), 18 samples (2 L each) of sweet whey, resuspended commercial whey (positive control) and acid whey (negative control) were processed. Indirect presence of GMP was verified using chemical tests and PAGE-SDS 15%. At 90 °C treated sweet whey, 14, 20 and 41 kDa bands were observed. These bands may correspond to olygomers of GMP. Peptide recovery showed an average of 1.5 g/L (34.08%). The results indicate that industrial scale GMP production is feasible; however, further research must be carried out for the biological and nutritional evaluation of GMP's incorporation to foodstuff as a supplement.

Early initiation of dialysis: mortality and renal function recovery in acute kidney injury patients

INTRODUCTION: The decision of when to start dialysis in Acute Kidney Injury (AKI) patients with overt uremia is strongly established, however, when blood urea nitrogen (BUN) levels is < 100 mg/dL the timing of initiation of dialysis remains uncertain. Purpose: The aim of this study was to assess mortality and renal function recovery AKI patients started on dialysis at different BUN levels. METHODS: This was a retrospective study performed at Medical School Hospital, São Paulo, Brazil, enrolling 86 patients underwent to dialysis. RESULTS: Dialysis was started when BUN < 75 mg/dl in 23 patients (Group I) and BUN > 75 mg/dl in 63 patients (Group II). Hypervolemia and mortality were higher in Group I than in Group II (65.2% vs. 14.3% - p < 0.05, 39.1% vs. 68.9%- p < 0.05, respectively). Among survivors, the rate of renal function recovery was higher in Group I (71.4% and 36.8%, respectively - p < 0.05). Multivariate analysis showed that sepsis, age > 60 years, peritoneal dialysis and BUN > 75 mg/dl at dialysis initiation were independently related with mortality. CONCLUSIONS: Lower mortality and higher renal function recovery rates were associated with early dialysis initiated at lower BUN leves in AKI patients.

Recovery and purification of anthocyanins from purple-blue potato

The aim of this work was to study techniques to extract and purify of anthocyanins from purple-blue potato. This topic was determined as a master’s thesis and it was done in collaboration with the Food Chemistry and Food Development Department of University of Turku and Department of Chemical and Process Engineering at Lappeenranta University of Technology. At first, purple-blue potatoes were pretreated in four types of boiled, raw, freeze-dried and dried boiled potato for extraction. They were mixed with aqueous acidified ethanol (ethanol:water:acetic acid 40%:53%:7% v/v) for conventional extraction. Boiled potato was selected as a best pretreated potato. Different ethanol concentration and extraction time were examined and the mixture of 80% in 24 h resulted in maximum anthocyanin content (132.23 mg/L). As conventional extraction method of anthocyanins was non-selective, some of impurities such as free sugars might accelerate anthocyanin degradation. Therefore, to obtain anthocyanins in purified form, adsorption as a promising selective method was used to recovery and isolate anthocyanins. It was carried out with six adsorbents. Among those, Amberlite XAD-7HP, a nonionic acrylic ester adsorbent, was found to have the best performance. In an adsorption column, flow rate of 3 mL/min was selected as the loading flow rate among four tested flow rates. Eluent volume and flow rate were 3 BV of aqueous acidified ethanol (75%, v/v) and 1 mL/min for desorption. The quantification of the total anthocyanin contents was performed by pH-differential method using UV-vis spectrophotometer. The resulting anthocyanin solution after purification was almost free from free sugars which were the major cause for degradation of anthocyanins. The average anthocyanin concentration in the purified and concentrated sample was obtained 1752.89 mg/L.

Reputational Risk Management as a key element for business continuity and value maximization

This thesis reveals the topic of reputational risk management as a key element for business continuity and value maximization. The purpose of the work is to investigate reputational risk from the side of its definition, management (including legal requirements on this risk category) and measurement and to analyse reputational risk’s impact on business continuity and value maximization. To be able to do this, different respective articles, reports of financial institutions are gathered and constructive summaries and analysis are made. In order to deeply investigate the impact of reputational risk on business continuity and value maximization, it was chosen to study it from three aspects: 1) check the impact of stock valuation of 7 companies that experienced reputational catastrophe / risk, 2) analyse a case study on disagreements in management of reputational risk among case companies and impact on their respective performance, and 3) conduct a survey of financial sector companies in Liechtenstein to see how reputational risk management works in practice. The findings of the research showed a significant impact of reputation decadence on company’s value and trading volume, and showed crucial importance of post-crisis management for the company’s financial performance. The results of the qualitative research based on survey proved that companies consider reputational risk management as a one of the key elements for their business continuity and value maximization.

Enhancement of ultrafiltration process by pretreatment in recovery of hemicelluloses from wood extracts

Hemicelluloses are potential raw material for several items produced in future wood-based biorefineries. One possible method for recovering hemicelluloses from wood extracts is ultrafiltration (UF). However, low filtration capacities and severe fouling restrict the use of tight UF membranes in the treatment of wood extracts. The lack of suitable commercial membranes creates a need for pretreatment which would decrease fouling and increase the filtration capacity. This thesis focuses on the evaluation of the possibility to improve the filtration capacity and decrease fouling with the pretreatment of wood extracts. Methods which remove harmful compounds and methods which degrade them are studied, as well as combinations of the methods. The tested pretreatments have an influence on both the concentration of different compounds and the molecular mass distribution of the compounds in the extract. This study revealed that in addition to which kind of compounds were removed, also the change in molecular size distribution affected the filtration capacity significantly. It was shown that the most harmful compounds for the filtration capacity of the hydrophobic 5 kDa membrane were the ones capable of permeating the membrane and fouling also the inner membrane structure. Naturally, the size of the most harmful compounds depends on the used UF membrane and is thus case-specific. However, in the choice of the pretreatment method, the focus should be on the removal of harmful compound sizes rather than merely on the total amount of removed foulants. The results proved that filtration capacity can be increased with both adsorptive and oxidative pretreatments even by hundreds of per cents. For instance, the use of XAD7 and XAD16 adsorbents increased the average flux in the UF of a birch extract from nearly zero to 107 kg/(m2h) and 175 kg/(m2h), respectively. In the treatment of a spruce extract, oxidation by pulsed corona discharge (PCD) increased the flux in UF from 46 kg/(m2h) to 158 kg/(m2h). Moreover, when a birch extract batch was treated with laccase enzyme, the flux in UF increased from 15 kg/(m2h) to 36 kg/(m2h). However, fouling was decreased only by adsorptive pretreatment while oxidative methods had a negligible or even negative impact on it. This demonstrates that filtration capacity and fouling are affected by different compounds and mechanisms. The results of this thesis show that filtration capacity can be improved and fouling decreased through appropriate pretreatment. However, the choice of the best possible pretreatment is case-specific and depends on the wood extract and the membrane used. Finding the best option requires information on the extract content and membrane characteristics as well as on the filtration performance of the membrane in the prevailing conditions and a multivariate approach. On the basis of this study, it can be roughly concluded that adsorptive pretreatment improves the filtration capacity and decreases fouling rather reliably, but it may lead to significant hemicellulose losses. Oxidation reduces the loss of valuable hemicelluloses and could improve the filtration capacity, but fouling challenges may remain. Combining oxidation with adsorptive pretreatment was not a solution for avoiding hemicellulose losses in the tested cases.

Key factors in U.S. Government support of business internationalization in Finland Case: U.S. Embassy in Helsinki

This study discusses the importance of government intervention for companies and the expansion of national innovation systems. The purpose of the study is to examine the impact which the U.S. Embassy in Helsinki can have on Finnish businesses through their business support programs and events. The embassy has shifted focus in recent years with the creation of an innovation center and increased business services. The study has sub-objectives to discover the critical factors for producing impact, host and home based factor interaction, and effects produced by these initiatives. The theoretical background of the study consists of literature relating to the concepts of national innovation systems and government intervention. The empirical research conduct for this study is based on interviews with experts from the environment surrounding the U.S. Embassy in Helsinki, Finland and participation in embassy events. The data was collected between March 2014 and September 2015. Seven interviews were conducted; five with representatives of the U.S. Embassy and two with related organizations. Thematic analysis was used to categorize and interpret interview and observation data. The use of an impact radar was implemented as a basis for analysis. This study finds that the internationalization of national innovation systems provides interesting opportunities and challenges for national governments. The opportunity to provide services to foreign companies by an embassy in a stable environment opens the possibility to create positive notice and relations with the host country. The increased connections and inputs to the national innovation system of the home country have the potential to increase knowledge absorption and create positive growth. The most effective way for governments to encourage businesses is to create incentives and reduce barriers. The services are best aimed at small to medium sized companies in the early stages of development. The findings of this report suggest that the most critical factors for producing impact on companies are the ability to disseminate information effectively, the ability to create a positive image of the country, the ability to foster effective networks between the two countries, and the ability to facilitate the internationalization of companies. In the best cases, the embassy is able to create incentives to internationalize to the United States and reduce barriers which are encountered by companies. Future research is necessary to fully understand the impact of business services provided by an embassy can have on the political and economic relations of countries, and on particular industry sectors. The institutional setting provided by the embassy’s focus on business relations provides a rich environment for further study in a number of areas.

Potential of energy and nutrient recovery from biodegradable waste by co-treatment in Lithuania

Biodegradable waste quantities in Lithuania and their potential for the co-treatment in renewable energy and organic fertilizer production are investigated. Two scenarios are formulated to study the differences of the amounts of obtainable energy and fertilizers between different ways of utilization. In the first scenario, only digestion is used, and in the second scenario, other materials than straw are digested, and straw and the solid fraction of sewage sludge digestate are combusted. As a result, the amounts of heat and electricity, as well as the fertilizer amounts in the counties are obtained for both scenarios. Based on this study, the share of renewable energy in Lithuania could be doubled by the co-treatment of different biodegradable materials.