Synthesis, properties and crystal structure of a heteropoly compound containing titanium

K4H2CoW12O40. 2Ti02 . 9H(2)O crystallizes from an aqueous solution of Na2WO4, Co(OAc)(2) and Ti(SO4)(2). The compound has very similar i.r. and u.v. spectra to those of [CoW12O40](6-) and [CoW11TiO40](8-) but its polarographic behaviour is different from that of [CoW11TiO40](8-) and exhibits only reduction of tungsten(VI). A single crystal structural analysis indicates that this compound consists of the heteropolyanion [CoW12O40](6-), titanium-oxygen chain, potassium ions and water molecules.

The origin of nonlinearities in K[B5O6(OH)(4)]center dot 2H(2)O crystal

In this paper the origin of nonlinearities of the K[B5O6(OH)(4)].2H(2)O(KB5) crystal has been investigated from a comprehensive view-point by using the bond-valence theory of complex crystals. The results of the calculation (d(31) = -1.18 X 10(-10) esu, d(32) = 0.20 X 10(-10) and d(33) = -1.03 X 10(-9) esu) are in good agreement with experimental data. For the first time we pointed out that its nonlinearities come from the H(2)-O(2) bonds and the [B5O6(OH)(4)](-) group, and estimated its larger nonlinear optical (NLO) coefficient d(33).

K+ sensors based on supported alkanethiol/phospholipid bilayers

A novel kind of K+ sensor with valinomycin-incorporated bilayers supported on a gold electrode consisting of self-assembled alkanethiol monolayers (SAMs) and a lipid monolayer has been fabricated successfully. The lipid monolayer is deposited on the alkylated surface of the first alkanethiol monolayer through three different methods, such as the Langmuir-Blodgett (LB) technique, painted method and painted-frozen method. The response of K + sensors produced by a painted or painted-frozen lipid monolayer on an alkanethiol alkylated gold electrode is larger than that by the LB method, which is due to the difference in fluidity of the three kinds of bilayers. Selectivity coefficients KK+, Na+, KK+, Li+, KK+, Ca2+ and KK+, Mg2+ are 10(-4), 10(-4), 2 x 10(-5) and 3 x 10(-5) respectively, and there is no obvious difference among different fabricating methods. A linear response toward the potassium ion was found in the range from 10(-1) M to 10(-5) M with the detection limit of 10(-6) M. The sensor has a slope of 60 mV per decade. Meanwhile, the longevity of the sensor was improved obviously for at least two months at about -10 degrees C. The higher stability shows the possibility to fabricate a practical biosensor.

Study of cupric hexacyanoferrate-modified platinum electrodes using probe beam deflection and electrochemical quartz crystal microbalance techniques

The ion exchange mechanism accompanying the oxidation/reduction processes of cupric hexacyanoferrate-modified platinum electrodes in different aqueous electrolyte solutions has been studied by means of in situ probe beam deflection and the electrochemical quartz crystal microbalance technique. The results demonstrate that the charge neutrality of the film during the reoxidation/reduction process is accomplished predominantly by the movement of cations, but anions and/or solvent are also participator(s). Moreover, in KHC8H4O4 (potassium biphthalate) solution, the EQCM data obtained from chronoamperometry experiment are more complicated than those in KCl and K2SO4 solutions. (C) 1997 Elsevier Science Ltd.

Novel polyaryletherketones containing various pendant groups .1. Synthesis and characterization

Novel high glass transition temperature polyaryletherketones, containing pendant amido, alkyl, and carboxyl groups with reduced viscosity above 0.54 dL/g, were synthesized via solution nucleophilic polycondensation reaction of phenolphthalin, 2',2 ''-diisopropyl-5',5 ''-dimethylphenolphthalin, and 3,3'-bis(4-hydroxyphenyl)isobenzopyrrolidone with bis(4-nitrophenyl)ketone in the presence of potassium carbonate. By ion exchange with Na+ and K+, four ionomers were also prepared. A new monomer simultaneously containing carboxyl and algyl substituents was synthesized by reduction reaction of 2',2 ''-diisopropyl-5',5 ''-dimethyl-phenolphthalein. The resulting polymers were soluble in a few polar aprotic solvents; transparent, colorless, and tough films could easily be cast from DMF or DMSO solution. The mechanical properties of the films were excellent; and their tensile strength, elongation at break, and tensile moduli were in the range of 67.1-97.1 MPa, 7.8-165%, and 1.47-2.27 GPa, respectively. The prepared polymers showed fairly good thermal stability and resonably high glass transition temperatures above 210 degrees C. (C) 1997 John Wiley & Sons, Inc.

A new method for the preparation of fullerol

Reaction of C-60 with excessive potassium in toluene at refluxing temperature results in black precipitate KaC60 with high conversion, which can completely be hydrolyzed to prepare the fullerol. Investigations including FT-IR. H-1 NMR C-13 NMR, UV-Vis and FABMS of the product were reported.

Synthesis and crystal structure of [(C8H8)(3)(C6H5CH2C5H4)Nd2K(THF)3]

NdCl3 reacted with C6H5CH2C5H4Na in the ratio 1:1 at -78 degrees C giving [C6H5 CH2C5H4NdCl2 . nTHF], which then was reacted with C8H8K2/THF to yield the title complex [(C8H8)(3)(C6H5CH2C5H4)Nd2K(THF)(3)] (C6H5CH2C5H4 = benzylcyclopentadienyl). The crystal structure of the Nd complex was determined by X-ray diffraction and revealed that the benzyl group is coordinated to the potassium atom to form a new type of trinuclear complex [(eta(8)-C8H8)Nd(mu(2)-eta(8)-C8H8K(THF) (eta(3)-C6H5CH2-mu(2)-eta(5)-C5H4)Nd (THF)(2)(eta(8)-C8H8)]. Copyright (C) 1996 Elsevier Science Ltd.

W-183 NMR characterization of rare earth heteropolymetalates in aqueous solution

W-183 NMR spectra were obtained for [La(AsW11O39)(2)](11-), [La(As2W17O61)(2)](17-), [La(SiW9Mo2O39)(2)](13-), [LaSb9W21O86](16-), [LaAs4W40O140](25-) and alpha-, beta-[(CeO)(3) . (SiW9O34)(2)](14-) complexes, Tungsten NMR studies showed that the C-s symmetry of the square antiprism for [La(ASW(11)O(39))(2)](11-) and [La(As2W17O61)(2)](17-) anions keep constant in aqueous solution; the lanthanide accupied the central S-1 site in [LnSb(9)W(21)O(86)](16-) and [LnAs(4)W(40)O(140)](25-) complexes, respectively, and lanthanide metal cations gave [(CeO)(3) . (SiW9O34)(3)](14-) type of complexes with SiW9O3410-.

Convenient preparation and properties of C-60(OH)(x)

In this paper, we introduce a very convenient method to produce water soluble C-60 derivatives- fullerols by the reaction of C-60 with potassium in toluene solution, FT-IR, H-1 NMR and FABMS proved the multi-hydroxyl and C-60 cage structures of the products, The properties of unstability to light, heat, basicity of aqueous solution and the solubility in some common polar solvents were also described.

SYNTHESIS AND PHOTOCHROMISM IN SOLUTION OF PHENOXYNAPHTHACENEQUINONE DERIVATIVES

Two new phenoxynaphthacenequinone derivatives, 6-[4-(2-(4-hydroxyphenyl)isopropyl)phenoxy] -5,12-naphthacenequinone (7) and 6-[4-(potassium sulfophenylazo)phenoxy]-5,12-naphthacenequinone (8), were synthesized, and their photochromism in solution was investigated and compared with that of 6-phenoxy-5,12-naphthacenequinone (1). On the basis of the spectral data and the selective irreversible reaction of ammonia with the colored phenoxy-ana-naphthacenequinone, the concentrations of the ana forms at the photostationary state (PSS), achieved by 365 nm UV irradiation, and the molar extinction coefficients of the pure ana forms at 481-482 nm of compounds 1, 7 and 8 in dimethylsulfoxide (DMSO) were found to be 83 mol.% and 1.70x10(4) mol(-1) dm(3) cm(-1), 82 mol.% and 1.62x10(4) mol(-1) dm(3) cm(-1) and 16 mol.% and approximately 1.34x10(4) mol(-1) dm(3) cm(-1) respectively; the absorption spectra of the colored ana forms of 7 and 1 in DMSO were estimated; the rate;constants of photoconversion induced by 365 nm light were obtained. The results show the strong effect of the structure of the phenoxynaphthacenequinones on their photochromism in solution. In addition to DMSO solution, compound 7 exhibited normal photochromism in toluene, benzene, chloroform and a DMSO-ethanol mixed solvent, but not in dimethylformamide (DMF) in which a photoinduced reaction occurred between 7 and DMF or impurities.

SYNTHESES AND CRYSTAL-STRUCTURES OF (ETA-5-C5H5)3LN(THF) (LN=CE, ER)

Brown crystalline tricyclopentadienyl cerium tetrahydrofuranate (THF) complex (eta5-C5H5)3Ce(THF) was prepared by the reaction of (NH4)2Ce(NO3)6 with sodium cyclopentadienide (C5H5Na) in THF at molar ratio of 1:6. ErCl3.4THF reacts with potassium cyclooct

CALCULATIONS FOR THE VIBRATION FREQUENCIES OF THE O-H...O BOND IN KH2PO4 BY A SEMIEMPIRICAL METHOD

The frequencies of the stretching vibration and the bending vibration of the 0-H ... 0 bond in potassium dihydrogen phosphate have been calculated by means of two semiempirical formulae with three parameters. The calculated results can give satisfactory explanation for the experimental spectra of the potassium dihydrogen phosphate crystal. The parameters used in the calculations may be related to the chemical bonding and the charge distribution about the two oxygen atoms of the 0-H ... 0 bond system.

WATER-SOLUBLE AND AMPHIPHILIC POLYMERS .11. GRAFT-POLYMERIZATION OF ACRYLIC-ACID ON POLY(VINYL ALCOHOL)

The graft polymerization of acrylic acid(AA) on poly(vinyl alcohol) (PVAL) has been investigated by using either potassium persulfate (KPS) or ceric ammonium nitrate(CAN) as an initiator. In the case of KPS initiation, the formation of the graft polymer always lags behind the homopolymer formation. The graft polymer is separated by acetone, and the increase of reaction temperature favors the homopolymer formation at the early stage. In the case of CAN initiation, graft polymers with a high PAA content can hardly be obtained when the polymerization is performed under nitrogen and at < 0.06 mol/L HNO3 concentration. It has been found that incorporation of a small amount of oxygen in a protective nitrogen gas accelerates markedly the graft polymerization, and that the resulting graft polymers can not be separated by acetone precipitation technique in most cases. The Dalian nitrogen(containing 0.7% oxygen) is a good protective gas for CAN-initiated PVAL-AA graft polymerization.

AMPEROMETRIC FLOW-INJECTION ANALYSIS OF HYDRAZINE BY ELECTROCATALYTIC OXIDATION AT COBALT TETRAPHENYLPORPHYRIN MODIFIED ELECTRODE WITH HEAT-TREATMENT

Chemically modified electrodes prepared by treating the cobalt tetraphenylporphyrin modified glassy-carbon electrode at 750-degrees (HCME) are shown to catalyze the electrooxidation of hydrazine. The oxidation occurred at +0.63 V vs. Ag/AgCl (saturated potassium chloride) in pH 2.5 media. The catalytic response is evaluated with respect to solution pH, potential scan-rate, concentration dependence and flow-rate. The catalytic stability of the HCME is compared with that of the cobalt tetraphenylporphyrin adsorbed glassy-carbon electrode. The stability of the HCME was excellent in acidic solution and even in solutions containing organic solvent (50% CH3OH). When used as the sensing electrode in amperometric detection in flow-injection analysis, the HCME permitted sensitive detection of hydrazine at 0.5 V. The limit of detection was 0.1 ng. The linear range was from 50 ng to 2.4-mu-g. The method is very sensitive and selective.

CYCLIC VOLTAMMETRIC AND SPECTROELECTROCHEMICAL STUDIES OF COPPER IN ALKALINE-SOLUTION

The behaviour of the electroplated copper film electrode on tin oxide/glass or glassy carbon surface was studied in potassium hydroxide medium by cyclic voltammetry and in situ transmission spectroelectrochemistry. The results indicate that the electroplated copper film electrode is similar to a copper electrode and cyclic voltammetry with this electrode affords more resolution. The anodic peaks were found to correspond successively to the adsorption of oxygen, the formation of a surface layer of Cu2O, the formation of a surface layer of Cu(OH)2 or CuO and formation of a thick multilayer film of CuO. This is the first time it has been proposed that a surface layer of Cu(OH)2 or CuO is formed from the oxidation of the surface layer of Cu2O. Similarly, a clear interpretation is presented that the cathodic peaks correspond successively to the reduction of CuO to Cu2O, the reductions of Cu2O to Cu and the soluble Cu(II) species to Cu. On the other hand, a shoulder peak related to the chemical transformation of Cu(OH)2 to CuO was first observed.