Regio- and stereo-selective dioxygenase-catalysed cis-dihydroxylation of fjord-region polycyclic arenes

Bacterial dioxygenase-catalysed cis-dihydroxylation of the tetracyclic arenes benzo[c]phenanthrene 2, and the isosteric compounds benzo[b]naphtho[1,2-d]furan 8, and benzo[b]naphtho[1,2-d]thiophene 9, has been found to occur exclusively at fjord-region bonds. The resulting cis-dihydrodiols 7, 10 and 11 were found to be enantiopure and of similar absolute configuration. cis-Dihydroxylation was also observed in the pseudo-fjord region of the 8,9,10,11-tetrahydro-precursors (12 and 13) of benzo[b]naphtho[1,2-d]furan 8, and benzo[b]naphtho[1,2-d]thiophene 9, to yield the corresponding enantiopure hexahydro cis-diols 14 and 15. A novel tandem cis-dihydroxylation and bis-desaturation of the tetrahydro-substrate, tetrahydrobenzo[b]naphtho[1,2-d]thiophene 13, catalysed by biphenyl dioxygenase, was found to yield the fjord-region cis-dihydrodiol 17 of benzo[b]naphtho[1,2-d]thiophene 9.

Improving f(MAX)/f(T) ratio in FinFETs using source/drain extension region engineering

A design methodology to optimise the ratio of maximum oscillation frequency to cutoff frequency, f(MAX)/f(T), in 60 nm FinFETs is presented. Results show that 25 to 60% improvement in f(MAX)/f(T) at drain currents of 20-300 mu A/mu m can be achieved in a non-overlap gate-source/drain architecture. The reported work provides new insights into the design and optimisation of nanoscale FinFETs for RF applications.

Source/drain extension region engineering in nanoscale double gate SOI MOSFETs: Novel design methodology for low-voltage analog applications

The present paper proposes for the first time, a novel design methodology based on the optimization of source/drain extension (SDE) regions to significantly improve the trade-off between intrinsic voltage gain (A(vo)) and cut-off frequency (f(T)) in nanoscale double gate (DG) devices. Our results show that an optimally designed 25 nm gate length SDE region engineered DG MOSFET operating at drain current of 10 mu A/mu m, exhibits up to 65% improvement in intrinsic voltage gain and 85% in cut-off frequency over devices designed with abrupt SIDE regions. The influence of spacer width, lateral source/drain doping gradient and symmetric as well as asymmetrically designed SDE regions on key analog figures of merit (FOM) such as transconductance (g(m)), transconductance-to-current ratio (g(m)/I-ds), Early voltage (V-EA), output conductance (g(ds)) and gate capacitances are examined in detail. The present work provides new opportunities for realizing future low-voltage/low-power analog circuits with nanoscale SDE engineered DG MOSFETs. (C) 2007 Elsevier B.V. All rights reserved.

Source/drain extension region engineering in FinFETs for low-voltage analog applications

In this letter, we propose a novel design methodology for engineering source/drain extension (SDE) regions to simultaneously improve intrinsic dc gain (A(vo)) and cutoff frequency (f(T)) of 25-nm gate-length FinFETs operated at low drain-current (I-ds = 10 mu A/mu m). SDE region optimization in 25-nm FinFETs results in exceptionally high values of Avo (similar to 45 dB) and f(T) (similar to 70 GHz), which is nearly 2.5 times greater when compared to devices designed with abrupt SDE regions. The influence of spacer width, lateral source/drain doping gradient, and the spacer-to-gradient ratio on key analog figures of merit is examined in detail. This letter provides new opportunities for realizing future low-voltage/low-power analog design with nanoscale SDE-engineered FinFETs.

Further assessment of the complement component 2 and factor B region associated with age-related macular degeneration

PURPOSE. Polymorphic variation in genes involved in regulation of the complement system has been implicated as a major cause of genetic risk, in addition to the LOC387715/HTRA1 locus and other environmental influences. Previous studies have identified polymorphisms in the complement component 2 (CC2) and factor B (CFB) genes, as potential functional variants associated with AMD, in particular CFB R32Q and CC2 rs547154, both of which share strong linkage disequilibrium (LD). METHODS. Data derived from the HapMap Project were used to select 18 haplotype-tagging SNPs across the extended CC2/ CFB region for genotyping, to measure the strength of LD in 318 patients with neovascular AMD and 243 age-matched control subjects to identify additional potential functional variants in addition to those originally reported. RESULTS. Strong LD was measured across this region as far as the superkiller viralicidic activity 2-like gene (SKIV2L). Nine SNPs were identified to be significantly associated with the genetic effect observed at this locus. Of these, a nonsynonymous coding variant SKIV2L R151Q (rs438999; OR, 0.48; 95% confidence interval [CI], 0.31- 0.74; P < 0.001), was in strong LD with CFB R32Q, rs641153 (r2 = 0.95) and may exert a functional effect. When assessed within a logistic regression model measuring the effects of genetic variation at the CFH and LOC387715/HTRA1 loci and smoking, the effect remained significant (OR, 0.38; 95% CI, 0.22- 0.65; P < 0.001). Additional variation identified within this region may also confer a weaker but independent effect and implicate additional genes within the pathogenesis of AMD. CONCLUSIONS. Because of the high level of LD within the extended CC2/CFB region, variation within SKIV2L may exert a functional effect in AMD. Copyright © Association for Research in Vision and Ophthalmology.

Emission lines of Fe X in active region spectra obtained with the Solar Extreme-ultraviolet Research Telescope and Spectrograph

Fully relativistic calculations of radiative rates and electron impact excitation cross-sections for Fe X are used to derive theoretical emission-line ratios involving transitions in the 174-366 angstrom wavelength range. A comparison of these with solar active region observations obtained during the 1989 and 1995 flights of the Solar Extreme-ultraviolet Research Telescope and Spectrograph (SERTS) reveals generally very good agreement between theory and experiment. Several Fe X emission features are detected for the first time in SERTS spectra, while the 3s(2)3p(5) P-2(3/2)-3s(2)3p(4)(S-1)3d D-2(3/2) transition at 195.32 angstrom is identified for the first time (to our knowledge) in an astronomical source. The most useful Fe X electron density (N-e) diagnostic line ratios are assessed to be 175.27/174.53 and 175.27/177.24, which both involve lines close in wavelength and free from blends, vary by factors of 13 between N-e = 10(8) and 10(11) cm(-3), and yet show little temperature sensitivity. Should these lines not be available, then the 257.25/345.74 ratio may be employed to determine N-e, although this requires an accurate evaluation of the instrument intensity calibration over a relatively large wavelength range. However, if the weak 324.73 angstrom line of Fe X is reliably detected, the use of 324.73/345.74 or 257.25/324.73 is recommended over 257.25/345.74. Electron densities deduced from 175.27/174.53 and 175.27/177.24 for the stars Procyon and alpha Cen, using observations from the Extreme-Ultraviolet Explorer (EUVE) satellite, are found to be consistent and in agreement with the values of N-e determined from other diagnostic ratios in the EUVE spectra. A comparison of several theoretical extreme-ultraviolet Fe X line ratios with experimental values for a theta-pinch, for which the plasma parameters have been independently determined, reveals reasonable agreement between theory and observation, providing some independent support for the accuracy of the adopted atomic data.

Plasma diagnostics of active-region evolution and implications for coronal heating

A detailed study is presented of the decaying solar-active region NOAA 10103 observed with the Coronal Diagnostic Spectrometer (CDS), the Michelson Doppler Imager (MDI) and the Extreme-ultraviolet Imaging Telescope (EIT) onboard the Solar and Heliospheric Observatory (SOHO). Electron-density maps formed using Si x (356.03 angstrom/347.41 angstrom) show that the density varies from similar to 10(10) cm(-3) in the active-region core to similar to 7 x 108 cm-3 at the region boundaries. Over the 5 d of observations, the average electron density fell by similar to 30 per cent. Temperature maps formed using Fe XVI (335.41 angstrom)/Fe XIV (334.18 angstrom) show electron temperatures of similar to 2.34 x 10(6) K in the active-region core and similar to 2.10 x 10(6) K at the region boundaries. Similarly to the electron density, there was a small decrease in the average electron temperature over the 5-d period. The radiative, conductive and mass-flow losses were calculated and used to determine the resultant heating rate (P-H). Radiative losses were found to dominate the active-region cooling process. As the region decayed, the heating rate decreased by almost a factor of 5 between the first and last day of observations. The heating rate was then compared to the total unsigned magnetic flux (Phi(tot) = integral dA vertical bar B-z vertical bar), yielding a power law of the form P-H similar to Phi(0.81 +/- 0.32)(tot) This result suggests that waves rather than nanoflares may be the dominant heating mechanism in this active region.

SiO in G34.26: Outflows and shocks in a high mass star forming region

We have looked for SiO emission as evidence of shocks in the high mass star formation region G34.26+0.15. JCMT, VLA and FCRAO observations show that SiO emission is widespread across the region. The SiO emission highlights a massive, collimated out ow and other regions where stellar winds are interacting with molecular clumps. As in other star forming regions, there is also SiO at ambient velocities which is related to the out ow activity. No strong SiO abundance enhancement was measured in either the out ow or the low velocity gas, though abundances up to 10(-8) are possible if the SiO is locally enhanced in clumps and optically thick. SiO emission is not detected from the hot core itself, indicating either that SiO is not strongly enhanced in the hot core or that column densities in the region where grain mantle evaporation has taken place are low. In line of sight spiral arm clouds, we measure a SiO abundance of 0.4-2 x 10(-10), consistent with previous estimates for quiescent clouds.

The role of the supply chain in developing a 'lagging' region's manufacturing industry. How important are links with suppliers and customers?

This paper investigates the use of supply chains as a source of knowledge transfer to manufacturing businesses in South Yorkshire and the effect this can have on improving economic performance. It also looks at where assistance originates from, what factors influence who gets the assistance, and what the benefits are.