989 resultados para Anti-reflection coating (ARC)


Relevância:

20.00% 20.00%

Publicador:

Resumo:

HR212, a recombinant protein expressed in Escherichia coli, has been previously reported to inhibit HIV-1 membrane fusion at low nanomolar level. Here we report that HR212 is effective in blocking laboratory strain HIV-1IIIB entry and replication with EC50 values of 3.92±0.62 and 6.59±1.74 nM, respectively, and inhibiting infection by clinic isolate HIV-1KM018 with EC50 values of 44.44±10.20 nM, as well as suppressing HIV-1- induced cytopathic effect with an EC50 value of 3.04±1.20 nM. It also inhibited HIV-2ROD and HIV-2CBL-20 entry and replication in the μM range. Notably, HR212 was highly effective against T20-resistant strains with EC50 values ranging from 5.09 to 7.75 nM. Unlike T20, HR212 showed stability sufficient to inhibit syncytia formation in a time-of-addition assay, and was insensitive to proteinase K digestion. These results suggest that HR212 has great potential to be further developed as novel HIV-1 fusion inhibitor for treatment of HIV/ AIDS patients, particularly for those infected by T20-resistant variants.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Polycrystalline silicon (poly-Si) films(similar to 10 mu m) were grown from dichlorosilane by a rapid thermal chemical vapor deposition (RTCVD) technique, with a growth rate up to 100 Angstrom/s at the substrate temperature (T-s) of 1030 degrees C. The average grain size and carrier mobility of the films were found to be dependent on the substrate temperature and material. By using the poly-Si films, the first model pn(+) junction solar cell without anti-reflecting (AR) coating has been prepared on an unpolished heavily phosphorus-doped Si wafer, with an energy conversion efficiency of 4.54% (AM 1.5, 100 mW/cm(2), 1 cm(2)).

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The asymmetric Fabry-Perot (ASFP) mode position with the thickness of different index coating layer is calculated. The reason for the blue shift of the ASFP mode with the increasing thickness of low index coating layer is analyzed and this phenomenon is observed in experiments. With the wet-etching method, the ASFP mode can be tuned to the desired wavelength and thus the deviation of growth can be compensated. This method is used to improve the contrast ratio of modulators. With the ASFP mode located at different positions relative to the unbiased e-hh peak, different modulation characteristics are demonstrated.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Magnetic multilayers [NixFe100-x/Mo-30] grown by dc-magnetron sputtering were investigated by x-ray small-angle reflection and high-angle diffraction. Structural parameters of the multilayers such as the superlattice periods, the interfacial roughness, and interplane distance were obtained. It was found that for our NixFe100-x/Mo system, the Mo layer has bcc structure with [110] preferential orientation, while the preferential orientation of the NixFe100-x layer changes from a fee structure with [111] preferential orientation to a bcc structure with [110] preferential orientation with decreasing values of x. An intermixing layer located in the interlayer region between the NixFe100-x and Mo layers exists in the multilayers, and its thickness is almost invariant with respect to an increase of Mo layer thickness and/or a decrease of x in the region of x greater than or equal to 39. The thickness of the intermixing layer falls to zero when x less than or equal to 23.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Two semiconductor saturable absorber mirrors (SESAMs), of which one is coated with 50% reflection film on the top and the other is not, were contrastively studied in passively mode-locked solid-state lasers which were pumped by low output power laser diode (LD). Experiments have shown that reducing the modulation depth of SESAM by coating partial reflection film, whose reflectivity is higher than that between SESAM and air interface, is an effective method to get continuous wave (CW) mode-locking instead of Q-switched mode-locking (QML) in low power pumped solid-state lasers. A simple Nd:YVO4 laser pumped by low power LD, in which no water-cooling system was used, could obtain CW mode-locking by the 50% reflector coated SESAM with average output power of ~ 20 mW

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The different resonant Raman scattering process of single-walled carbon nanotubes (SWNTs) has been found between the Stokes and anti-Stokes sides of the radial breathing modes (RBMs), and this provides strong evidence that Raman spectra of some special diametric SWNTs are in resonance with their electronic transitions between the singularities in the one-dimensional electronic density of states in the valence and conduction bands, and other SWNTs axe beyond the resonant condition. Because of the coexistence of resonant and non-resonant Raman scattering processes for different diametric SWNTs, the relative intensity of each RBM does not reflect the proportion of a particular SWNT.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

以PCR技术从金黄色葡萄球菌基因组DNA中首次克隆编码成熟SECZ蛋白的全基因sec2。该基因共717bp,编码239个氨基酸,Genbank Accession number:AY450554。构建了SEC2的表达载体pET-28a-sec2,并在大肠杆菌BL21(DE3)中高效表达可溶性rSEC2蛋白。经亲和层析纯化,其纯度在95%以上,平均回收量为每升培养物40mg。纯化的rSEcZ保持了与野生型相当的生物学活性。以限制性核酸内切酶连接技术分别将两个抗人表皮生长因子受体HER-2单链抗体基因通过DNA Linker与sec2融合,构建融合基因b-l-sec2和ml小sec2,并以两种方式表达纯化。以pET-32a表达载体在E,coliAD494(DE3)中以氨基端融合大肠杆菌硫氧还蛋白(TrxA)形式高效表达融合蛋白TRX-B-L-SEC2和TRX-ML-L-SEC2,经亲和层析纯化,并以肠激酶切割得到成熟融合免疫毒素B-L-SEC2和ML-L-SEC2,其纯度在95%以上,平均回收量为每升培养物smg;以构建的新型表达载体pASK-75-EX在E.coliBL21(ED3)中以不溶性包涵体形式表达融合免疫毒素蛋白,经变性、纯化和复性后得到具有生物学活性的融合免疫毒素,其纯度在95%以上,平均回收量为每升培养物30mg。以两种方式制备的融合免疫毒素都保持了SECZ蛋白的免疫原性,都能有效刺激人外周血单个核细胞的增殖,并且都显示出在体外与HER-2过表达的乳腺癌细胞SK-Br-3特异性结合能力,具有显著的靶向性抑瘤作用。用PcR方法扩增了编码TrxA蛋白的基因trxA并克隆至表达载体pET-28a启动子上游,构建了一种在单质粒中利用两个相同的启动子游离共表达硫氧还蛋白与目的蛋白的表达载体。利用该载体可使TrxA与外源蛋白在大肠杆菌BL21(DE3)中以非融合形式高效共表达。共表达的TrxA可明显促进外源蛋白单链抗体ML3.9(scFv-ML)、3一轻基苯甲酸-6-单加氧酶(3HBA)的可溶性表达;并明显减少肠毒素C2(SEC2)、结核杆菌螺旋酶A亚基(GYRA)的包涵体表达。