Cross voltage control with inner hysteresis current control for multi-output boost converter

Multi-output boost (MOB) converter is a novel DC-DC converter unlike the regular boost converter, has the ability to share its total output voltage and to have different series output voltage from a given duty cycle for low and high power applications. In this paper, discrete voltage control with inner hysteresis current control loop has been proposed to keep the simplicity of the control law for the double-output MOB converter, which can be implemented by a combination of analogue and logical ICs or simple microcontroller to constrain the output voltages of MOB converter at their reference voltages against variation in load or input voltage. The salient features of the proposed control strategy are simplicity of implementation and ease to extend to multiple outputs in the MOB converter. Simulation and experimental results are presented to show the validity of control strategy.

Droop control of converter interfaced micro sources in rural distributed generation

This paper proposes new droop control methods for load sharing in a rural area with distributed generation. Highly resistive lines, typical of rural low voltage networks, always create a big challenge for conventional droop control. To overcome the conflict between higher feedback gain for better power sharing and system stability in angle droop, two control methods have been proposed. The first method considers no communication among the distributed generators (DGs) and regulates the converter output voltage and angle ensuring proper sharing of load in a system having strong coupling between real and reactive power due to high line resistance. The second method, based on a smattering of communication, modifies the reference output volt-age angle of the DGs depending on the active and reactive power flow in the lines connected to point of common coupling (PCC). It is shown that with the second proposed control method, an economical and minimum communication system can achieve significant improvement in load sharing. The difference in error margin between proposed control schemes and a more costly high bandwidth communication system is small and the later may not be justified considering the increase in cost. The proposed control shows stable operation of the system for a range of operating conditions while ensuring satisfactory load sharing.

From Sydney and Shanghai : Australian and Chinese women writing modernism

In the 1930s and 1940s, Australian women writers published novels, poems, and short stories that pushed the boundaries of their national literary culture. From their position in the Pacific, they entered into a dialogue with a European modernism that they reworked to invigorate their own writing and to make cross-continental connections. My interest in the work of Australian women prose writers of this period stems from an appreciation of the extent of their engagement with interwar modernism (an engagement that is generally under-acknowledged) and the realization that there are commonalities of approach with the ways in which contemporaneous Chinese authors negotiated this transnational cultural traffic. China and Australia, it has been argued, share an imaginative and literal association of many centuries, and this psychic history produces a situation in which ‘Australians feel drawn towards China: they cannot leave it alone.’1 Equally, Chinese exploration of the great southern land began in the fifteenth century, prior to European contact. In recent times, the intensity of Australia’s cultural and commercial connections with Asia has led to a repositioning of the Australian sense of regionalism in general and, in particular, has activated yet another stage in the history of its relationship with China. In this context, the association of Australian and Chinese writing is instructive because the commonalities of approach and areas of interest between certain authors indicate that Australian writers were not alone in either the content or style of their response to European modernism. This recognition, in turn, advances discussions of modernism in Australia and reveals an alternative way of looking at the world from the Pacific Rim through literature. The intent is to examine selective Australian and Chinese authors who are part of this continuous history and whose writing demonstrates common thematic and stylistic features via the vector of modernism. I focus on the 1930s and 1940s because these are the decades in which Australia and China experienced wideranging conflict in the Pacific, and it is significant that war, both forthcoming and actual, features as an ominous soundtrack in the writing of Chinese and Australian women. I argue that, given the immensity of cultural difference between Australia and China, there is an especially interesting juncture in the ways in which the authors interrogate modernist practices and the challenge of modernism. The process in which writing from the Pacific Rim jointly negotiates the twin desires of engaging with European literary form and representing one’s own culture may be seen as what Jessica Berman identifies as a geomodernism, one of the ‘new possible geographies’ of modernism.2 My discussion centres on the work of the Australian women, to which the Chinese material serves as a point of reference, albeit a critical one. The Chinese writing examined here is restricted to authors who wrote at least some material in English and whose work is available in translation.

Respecting contractual intentions : balancing consumer expectations with the sanctity of contract in the context of standard form insurance contracts

It is the purpose of this article to examine the means curently available to judges to achieve a workable balance between providing appropriate consumer protection to signatories of standard form contractors while still retaining adequate respect for the sanctity of contract, and, based on this analysis, to determine whether a significantly greater scope of contract (re)construction is likely to become the norm in most common law jurisdictions in the coming decades.

The rate-limiting mechanism for the heterogeneous burning of cylindrical iron rods

This paper presents the findings of an investigation into the rate-limiting mechanism for the heterogeneous burning in oxygen under normal gravity and microgravity of cylindrical iron rods. The original objective of the work was to determine why the observed melting rate for burning 3.2-mm diameter iron rods is significantly higher in microgravity than in normal gravity. This work, however, also provided fundamental insight into the rate-limiting mechanism for heterogeneous burning. The paper includes a summary of normal-gravity and microgravity experimental results, heat transfer analysis and post-test microanalysis of quenched samples. These results are then used to show that heat transfer across the solid/liquid interface is the rate-limiting mechanism for melting and burning, limited by the interfacial surface area between the molten drop and solid rod. In normal gravity, the work improves the understanding of trends reported during standard flammability testing for metallic materials, such as variations in melting rates between test specimens with the same cross-sectional area but different crosssectional shape. The work also provides insight into the effects of configuration and orientation, leading to an improved application of standard test results in the design of oxygen system components. For microgravity applications, the work enables the development of improved methods for lower cost metallic material flammability testing programs. In these ways, the work provides fundamental insight into the heterogeneous burning process and contributes to improved fire safety for oxygen systems in applications involving both normal-gravity and microgravity environments.

Disclosure in insurance law : contemporary and historical economic considerations

This article examines the importance of accurate classification and identification of risk with particular reference to the problem of adverse selection. It is argued that, historically, this concern was the paramount consideration influencing standard form contract formation and disclosure laws. The scope of its relevance today however is less apparent in that contemporary insurance contracting is conducted in a vastly different environment from that which prevailed at the time Lloyd's was better known as a coffee house. Accordingly, the second part of this article looks at the contemporary framework of information disclosure and those dynamics within it designed to elicit information weighing on risk forecasting : specifically, (a) direct inquiry and testing requirements; (b) signaling - or incentive based structuring of insurance contractual and (c) bargaining in the shadow of the utmost good faith doctrine. Finally, certain conclusions arising out of contemporary and historical economic considerations underpinning disclosure in insurance law are outlined.

Technical note : modelling a complex micro-multileaf collimator using the standard BEAMnrc distribution

Purpose: The component modules in the standard BEAMnrc distribution may appear to be insufficient to model micro-multileaf collimators that have tri-faceted leaf ends and complex leaf profiles. This note indicates, however, that accurate Monte Carlo simulations of radiotherapy beams defined by a complex collimation device can be completed using BEAMnrc's standard VARMLC component module.---------- Methods: That this simple collimator model can produce spatially and dosimetrically accurate micro-collimated fields is illustrated using comparisons with ion chamber and film measurements of the dose deposited by square and irregular fields incident on planar, homogeneous water phantoms.---------- Results: Monte Carlo dose calculations for on- and off-axis fields are shown to produce good agreement with experimental values, even upon close examination of the penumbrae.--------- Conclusions: The use of a VARMLC model of the micro-multileaf collimator, along with a commissioned model of the associated linear accelerator, is therefore recommended as an alternative to the development or use of in-house or third-party component modules for simulating stereotactic radiotherapy and radiosurgery treatments. Simulation parameters for the VARMLC model are provided which should allow other researchers to adapt and use this model to study clinical stereotactic radiotherapy treatments.

Disclosure under the prescribed insurance contracts regime : Section 35 of the Insurance Contracts Act 1984 and consumer protection revisited

Section 35 of the Insurance Contracts Act 1984 requires insurers offering insurance policies in six prescribed areas "to clearly inform" prospective insureds of any departure their policies may constitute from the standard covers established by the Act and its accompanying Regulations. This prescribed insurance contracts regime was designed to remedy comprehension problems generated by the length and complexity of insurance documents and to alleviate misunderstanding over the terms and conditions of individual policies. This article examines the rationale underpinning s 35 and the prescribed insurance contracts regime and looks at the operation of the legislation with particular reference to home contents insurance in Australia. It is argued that the means whereby disclosure of derogation from standard cover may be effected largely negates the thrust of the prescribed insurance contract reform. Recommendations to address these operational deficiencies are made.

Experimental tests on structural members fabricated from high strength steel materials

Typical high strength steels (HSS) have exceptional high strengths with improved weldability making the material attractive in modern steel constructions. However, due to lack of understanding, most of the current steel design standards are limited to conventional low strength steels (LSS, i.e. fy ≤ 450 MPa). This paper presents the details of full-scale experimental tests on short beams fabricated from BISPLATE80 HSS materials (nominal fy = 690 MPa). The various slenderness ratios of the plate elements in the test specimens were chosen in the range near the current yield limit (AS4100-1998, etc.). The experimental studies presented in this paper have produced a better understanding of the structural behaviour of HSS members subjected to local instabilities. Comparisons have also presented in the paper regarding to the design predictions from the current steel standards (AS4100-1998). This study has enabled to provide a series of proposals for proper assessment of plate slenderness limits for structural members made of representative HSS materials. This research work also enables the inclusion of further versions in the steel design specifications for typical HSS materials to be used in buildings and bridges. This paper also presents a distribution model of residual stresses in the longitudinal direction for typical HSS I-sections.

On the use of different spatial reference frames for movement control

Previous work has shown that amplitude and direction are two independently controlled parameters of aimed arm movements, and performance, therefore, suffers when they must be decomposed into Cartesian coordinates. We now compare decomposition into different coordinate systems. Subjects pointed at visual targets in 2-D with a cursor, using a two-axis joystick or two single-axis joysticks. In the latter case, joystick axes were aligned with the subjects’ body axes, were rotated by –45°, or were oblique (i.e., one axis was in an egocentric frame and the other was rotated by –45°). Cursor direction always corresponded to joystick direction. We found that compared with the two-axis joystick, responses with single-axis joysticks were slower and less accurate when the axes were oriented egocentrically; the deficit was even more pronounced when the axes were rotated and was most pronounced when they were oblique. This confirms that decomposition of motor commands is computationally demanding and documents that this demand is lowest for egocentric, higher for rotated, and highest for oblique coordinates. We conclude that most current vehicles use computationally demanding man–machine interfaces.

High Court changes position on standard of care of learner drivers

Since the High Court decision of Cook v Cook (1986) 162 CLR 376, a person who voluntarily undertakes to instruct a learner driver of a motor vehicle is owed a lower standard of care than that owed to other road users. The standard of care was still expressed to be objective; however, it took into account the inexperience of the learner driver. Therefore, a person instructing a learner driver was owed a duty of care the standard being that of a reasonable learner driver. This ‘special relationship’ was said to exist because of the passenger’s knowledge of the driver’s inexperience and lack of skill. On 28 August 2008 the High Court handed down its decision in Imbree v McNeilly [2008] HCA 40, overruling Cook v Cook.

Narratives of mitigation : sentencing Indigenous criminal defendants in South Australia’s Higher Courts

In their statistical analyses of higher court sentencing in South Australia, Jeffries and Bond (2009) found evidence that Indigenous offenders were treated more leniently than non-Indigenous offenders, when they appeared before the court under similar numerical circumstances. Using a sample of narratives for criminal defendants convicted in South Australia’s higher courts, the current article extends Jeffries and Bond’s (2009) prior statistical work by drawing on the ‘focal concerns’ approach to establish whether, and in what ways, Indigeneity comes to exert a mitigating influence over sentencing. Results show that the sentencing stories of Indigenous and non-Indigenous offenders differed in ways that may have reduced assessments of blameworthiness and risk for Indigenous defendants. In addition, judges highlighted a number of Indigenous-specific constraints that potentially could result in imprisonment being construed as an overly harsh and costly sentence for Indigenous offenders.

The core role of the nurse practitioner: practice, professionalism and clinical leadership.

AIM: To draw on empirical evidence to illustrate the core role of nurse practitioners in Australia and New Zealand. BACKGROUND: Enacted legislation provides for mutual recognition of qualifications, including nursing, between New Zealand and Australia. As the nurse practitioner role is relatively new in both countries, there is no consistency in role expectation and hence mutual recognition has not yet been applied to nurse practitioners. A study jointly commissioned by both countries' Regulatory Boards developed information on the core role of the nurse practitioner, to develop shared competency and educational standards. Reporting on this study's process and outcomes provides insights that are relevant both locally and internationally. METHOD: This interpretive study used multiple data sources, including published and grey literature, policy documents, nurse practitioner program curricula and interviews with 15 nurse practitioners from the two countries. Data were analysed according to the appropriate standard for each data type and included both deductive and inductive methods. The data were aggregated thematically according to patterns within and across the interview and material data. FINDINGS: The core role of the nurse practitioner was identified as having three components: dynamic practice, professional efficacy and clinical leadership. Nurse practitioner practice is dynamic and involves the application of high level clinical knowledge and skills in a wide range of contexts. The nurse practitioner demonstrates professional efficacy, enhanced by an extended range of autonomy that includes legislated privileges. The nurse practitioner is a clinical leader with a readiness and an obligation to advocate for their client base and their profession at the systems level of health care. CONCLUSION: A clearly articulated and research informed description of the core role of the nurse practitioner provides the basis for development of educational and practice competency standards. These research findings provide new perspectives to inform the international debate about this extended level of nursing practice. RELEVANCE TO CLINICAL PRACTICE: The findings from this research have the potential to achieve a standardised approach and internationally consistent nomenclature for the nurse practitioner role.