Type 20 Design B Starboard Side; SS Deep Water

Print No:80.

Type 20 Design B Port Side; SS Deep Water

Print No:66.

Type 20 Design C Port Side; SS Deep Water

Print No:66.

Type 20 Design D Starboard Side; SS Deep Water

Print No: 80.; Initials Lower Left: WH; Initials Lower Left: LY; Initials Lower Left: RN

Type 20 Design D Port Side; SS Deep Water

Print No: 66 (stamped on).; Initials Lower Left: WH; Initials Lower Left: LY; Initials Lower Left: RN

Are deep-sea cephalopods really common preys for oceanic seabirds?

Uma análise de dados publicados sobre dietas de aves marinhas oceânicas mostra a predominância de cefalópodes musculares e de distribuição mais superficial nas camadas oceânicas, mas também são importantes as espécies gelatinosas e amoniacais restritas a camadas abaixo dos 300 m da superfície. A princípio, não deveria se esperar que cefalópodes de profundidade fossem considerados presas comuns de aves marinhas oceânicas como reportados por muitos autores. É proposto neste estudo que uma fonte indireta, importante e de fácil obtenção, surgiu com o início das atividades dos barcos atuneiros que operam com espinhel. O hábito de ingerir restos de vísceras de peixes capturados em barcos espinheleiros pode explicar as prováveis conclusões equivocadas de que cefalópodes de profundidade são presas naturais de aves marinhas oceânicas.

Frequência de Lettuce big-vein associated virus e Mirafiori lettuce big-vein virus em Plantas de alface no Estado de São Paulo e transmissão através de extrato vegetal e solo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A dense GNSS meteorological network for observing deep convection in the Amazon

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of pH of colloidal suspension on crystallization and activation energy of deep levels in SnO2 thin films obtained via sol-gel

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

A Comparison of Deep Drawing and Ironing of Metal Alloy Strip Produced conventionally and Non-conventionally via Semi Solid Material Processing

A semi solid thin strip continuous casting process was used to obtain 50%wt Pb/50%wtSn strip by single and twin roll processing at speed of 15 m/min. A 50%wt Pb/50%wtSn plate ingot was also cast for rolling conventionally into strips of 1.4 mm thickness and 45 mm width for comparison with those achieved non-conventionally. This hypoeutectic alloy has a solidification interval and fusion temperature of approximately 31 degrees C and 215 degrees C respectively. The casting alloy temperature was around 280 degrees C as measured by a type K immersion thermocouple prior to pouring into a tundish designed to maintain a constant melt flow on the cooling slope during semi solid material production. A nozzle with a weir ensures that the semi solid material is dragged smoothly by the lower roll, producing strip with minimum contamination of slag/oxide. The temperatures of the cooling slope and the lower roll were also monitored using K type thermocouples. The coiled semi solid strip, which has a thickness of 1.5 mm and 45 mm width, was rolled conventionally in order to obtain 1.2 mm thick strip. The coiled thixorolled strip had a thickness of 1.2 mm and achieved practically the same width as the conventional strips. Blanks of 40 mm diameter were cut from the strips in a mechanical press, ready for deep drawing and ironing for mechanical characterization. All the strips achieved from non-conventional processing had the same mechanical performance as those achieved conventionally. The limiting drawing ratio (LDR) achieved was approximately 2.0 for all strips. Microscopy examination was made in order to observe phase segregation during processing.

Revegetation and Soil Management Effects on Chemical Properties of a Saprolite Resulting from Deep Soil Removal

During the building of a hydroelectrical power plant at Ilha Solteira in the Parana River (Brazil), materials of a highly weathered soil Oxisol were extracted from a depth between 5 and 8 m for engineering works. This resulted in an abandoned depression area. The topsoil was not salvaged and the open pit was not backfilled, and as result vegetation hardly or not at all recovered. on the residual saprolite materials, an experimental field was established to assess different soil rehabilitation treatments. Field experiments were initiated in 1992. After soil tillage, two different crops and three different liming strategies were compared, giving six combinations. In addition, two uncropped control treatments, tilled and no-tilled, were established so that a total of eight treatments were assessed. The experimental design consisted of four randomized experimental blocks, which included a total of 32 plots with a plot area of 100 m(2). This experiment was used to study the effectiveness of the soil-reclamation treatments after a 9-year period. Soil samples were taken at three different depths (0-10, 10-20, and 20-40 cm), and they were analyzed routinely for pH, organic-matter content, and cation exchange capacity (CEC). Revegetation of the abandoned saprolite material increased soil organic-matter content and cation exchange capacity (CEC), and to some extent small differences between treatments were evidenced. Exchangeable calcium (Ca) and magnesium (Mg) recovered faster than organic-matter content. A significant linear relationship was found between organic-matter content and CEC, suggesting continued addition of organic material will further approach the value of these parameters to those levels corresponding to natural soils under "Cerrado" vegetation.

Combinations of low doses of unfractionated heparin and of low-molecular-weight heparin prevent experimental venous thrombosis

Synergism between low-molecular-weight heparin and low doses of unfractionated heparin (UH) enhancing anti-factor Xa activity and the release of tissue factor pathway inhibitor was observed. The aim of this study was to verify whether this association is effective in preventing experimental venous thrombosis. Seventy rats were allocated into 7 groups: the control group treated with distilled water, the H-350 group treated with UH 350 IU/kg, the E-2 group treated with enoxaparin 2 mg/kg, the H-175 group treated with UH 175 IU/kg, the E-1 group treated with enoxaparin 1 mg/kg, the H-175 + E-1 group treated with UH 175 IU/kg plus enoxaparin 1 mg/kg, and the H-100 + E-0.5 group treated with UH 100 IU/kg plus enoxaparin 0.5 mg/kg. Forty minutes after subcutaneous injection, thrombosis was induced in vena cava. Three hours later, if present, thrombi were withdrawn and weighed. Bleeding time, activated partial thromboplastin time, thrombin time (TT), and anti-factor Xa were measured at the beginning and end of the experiment. Fortyeight other animals were treated, but without inducing thrombus, and tests were performed 40 min after injection. Thrombus developed in 90.9% of control animals, 20% of the H-350 group, 22.2% of the E-2 group, 10% of the H-175 + E-1 group, and 30% of the H-100 + E-0.5 group; there was a difference between group C and the other groups. Only in the H-350 and H-175 + E-1 groups were TT and activated partial thromboplastin time prolonged in relation to control at the end of the experiment. Forty minutes after injection, TT was prolonged in the H-350 and H-175 + E-1 groups. In conclusion, combinations of low doses of low-molecular-weight heparin and low doses of UH were as effective as high doses of each one used alone in preventing thrombus development in rat vena cava. Copyright (c) 2005 S. Karger AG, Basel.

Correlation between the intensity of venous reflux in the saphenofemoral junction and morphological changes of the great saphenous vein by duplex scanning in patients with primary varicosis

Aim. One of the major causes of chronic venous disease is venous reflux, the identification and quantification of which are important for diagnosis. Duplex scanning allows for the detection and quantification of reflux in individual veins. Evaluation of the great saphenous vein in primary varicosis is necessary for its preservation. Objective of the study is to evaluate a possible correlation between the intensity of reflux at the saphenofemoral junction, diameter alterations of the incompetent great saphenous vein and the practical effect of such correlation. Also to compare the clinical severity of the CEAP classification with such parameters.Methods. Three hundred limbs were submitted to duplex evaluation of their insufficient saphenous veins. Vein diameter was measured on five different points. Velocity and flow at reflux peak and reflux time were determined. The saphenous vein's diameters were correlated with velocity, flow and time. The three latter parameters and diameters were compared with clinical severity according to CEAP.Results. Correlation was found between the saphenous vein's diameters, velocity and flow. No correlation was observed between time and diameter in the thigh's upper and middle thirds. When comparing diameter, velocity and flow with CEAP clinical severity classification, an association was observed. The correlation between reflux time with clinical severity was weak.Conclusion. Reflux time is a good parameter for identifying the presence of reflux, but not for quantifying it. Velocity and peak flow were better parameters for evaluating reflux intensity as they were correlated with great saphenous vein alterations, and were associated with the disease's clinical severity. [Int Angiol 2010;29:323-30]