All Inorganic Spin-Coated Nanoparticle-Based Capacitive Memory Devices

We demonstrate all inorganic, robust, cost-effective, spin-coated, two-terminal capacitive memory metal-oxide nanoparticle-oxide-semiconductor devices with cadmium telluride nanoparticles sandwiched between aluminum oxide phosphate layers to form the dielectric memory stack. Using a novel high-speed circuit to decouple reading and writing, experimentally measured memory windows, programming voltages, retention times, and endurance are comparable with or better than the two-terminal memory devices realized using other fabrication techniques.

Energy conversion in shape memory alloy heat engine - Part II: Simulation

In this paper, a theoretical model proposed in Part I (Zhu et al., 2001a) is used to simulate the behavior of a twin crank NiTi SMA spring based heat engine, which has been experimentally studied by Iwanaga et al. (1988). The simulation results are compared favorably with the measurements. It is found that (1) output torque and heat efficiency decrease as rotation speed increase; (2) both output torque and output power increase with the increase of hot water temperature; (3) at high rotation speed, higher water temperature improves the heat efficiency. On the contrary, at low rotation speed, lower water temperature is more efficient; (4) the effects of initial spring length may not be monotonic as reported. According to the simulation, output torque, output power and heat efficiency increase with the decrease of spring length only in the low rotation speed case. At high rotation speed, the result might be on the contrary.

A Study of Composite Beam with Shape Memory Alloy Arbitrarily Embedded under Thermal and Mechanical Loadings

The constitutive relations and kinematic assumptions on the composite beam with shape memory alloy (SMA) arbitrarily embedded are discussed and the results related to the different kinematic assumptions are compared. As the approach of mechanics of materials is to study the composite beam with the SMA layer embedded, the kinematic assumption is vital. In this paper, we systematically study the kinematic assumptions influence on the composite beam deflection and vibration characteristics. Based on the different kinematic assumptions, the equations of equilibrium/motion are different. Here three widely used kinematic assumptions are presented and the equations of equilibrium/motion are derived accordingly. As the three kinematic assumptions change from the simple to the complex one, the governing equations evolve from the linear to the nonlinear ones. For the nonlinear equations of equilibrium, the numerical solution is obtained by using Galerkin discretization method and Newton-Rhapson iteration method. The analysis on the numerical difficulty of using Galerkin method on the post-buckling analysis is presented. For the post-buckling analysis, finite element method is applied to avoid the difficulty due to the singularity occurred in Galerkin method. The natural frequencies of the composite beam with the nonlinear governing equation, which are obtained by directly linearizing the equations and locally linearizing the equations around each equilibrium, are compared. The influences of the SMA layer thickness and the shift from neutral axis on the deflection, buckling and post-buckling are also investigated. This paper presents a very general way to treat thermo-mechanical properties of the composite beam with SMA arbitrarily embedded. The governing equations for each kinematic assumption consist of a third order and a fourth order differential equation with a total of seven boundary conditions. Some previous studies on the SMA layer either ignore the thermal constraint effect or implicitly assume that the SMA is symmetrically embedded. The composite beam with the SMA layer asymmetrically embedded is studied here, in which symmetric embedding is a special case. Based on the different kinematic assumptions, the results are different depending on the deflection magnitude because of the nonlinear hardening effect due to the (large) deflection. And this difference is systematically compared for both the deflection and the natural frequencies. For simple kinematic assumption, the governing equations are linear and analytical solution is available. But as the deflection increases to the large magnitude, the simple kinematic assumption does not really reflect the structural deflection and the complex one must be used. During the systematic comparison of computational results due to the different kinematic assumptions, the application range of the simple kinematic assumption is also evaluated. Besides the equilibrium study of the composite laminate with SMA embedded, the buckling, post-buckling, free and forced vibrations of the composite beam with the different configurations are also studied and compared.

Depth dependence of nanohardness in a CuAlNi single crystal shape memory alloy

Instrumented nanoindentation was employed to study the depth dependence of nanohardness in a CuAlNi single crystal shape memory alloy that exhibits shape memory effect (SME). A Berkovich indenter and a cube comer indenter were used in this study, and the

A Discussion on Modeling Shape Memory Alloy Embedded in A Composite Laminate as Axial Force and Elastic Foundation

In this paper, the possible error sources of the composite natural frequencies due to modeling the shape memory alloy (SMA) wire as an axial force or an elastic foundation and anisotropy are discussed. The great benefit of modeling the SMA wire as an axial force and an elastic foundation is that the complex constitutive relation of SMA can be avoided. But as the SMA wire and graphite-epoxy are rigidly bonded together, such constraint causes the re-distribution of the stress in the composite. This, together with anisotropy, which also reduces the structural stiffness can cause the relatively large error between the experimental data and theoretical results.

A Thermodynamic Constitutive Model for Stress Induced Phase Transformation in Shape Memory Alloys

In this paper a thermodynamic constitutive model is developed for stress induced phase transformation in single crystalline and polycrystalline shape memory alloys (SMAs). Volume fractions of different martensite variants are chosen as internal variables to describe the evolution of microstructure state in the material. This model is then used in prediction the transformation behavior of a SMA (Cu-Al-Zn-Mn) under complex thermomechanical load (including complete and incomplete transformation in mechanical cycling, and proportional/non-proportional loading). (C) 2002 Elsevier Science Ltd. All rights reserved.

Energy Conversion in Shape Memory Alloy Heat Engine Part I: Theory

Shape Memory Alloy (SMA) can be easily deformed to a new shape by applying a small external load at low temperature, and then recovers its original configuration upon heating. This unique shape memory phenomenon has inspired many novel designs. SMA based heat engine is one among them. SMA heat engine is an environment-friendly alternative to extract mechanical energy from low-grade energies, for instance, warm wastewater, geothermal energy, solar thermal energy, etc. The aim of this paper is to present an applicable theoretical model for simulation of SMA-based heat engines. First, a micro-mechanical constitutive model is derived for SMAs. The volume fractions of austenite and martensite variants are chosen as internal variables to describe the evolution of microstructure in SMA upon phase transition. Subsequently, the energy equation is derived based on the first thermodynamic law and the previous SMA model. From Fourier’s law of heat conduction and Newton’s law of cooling, both differential and integral forms of energy conversion equation are obtained.

Tutela del patrimonio cultural : marco jurídico estatal

Más de mil "bienes" se habían incorporado hasta el mes de octubre del año 2013 al Registro que lleva la "Comisión Nacional de Museos y de Monumentos y Lugares Históricos", organismo estatal creado en 1940 y que tiene como misión –en sustancia– preservar, defender y acrecentar el patrimonio histórico y artístico de la Nación Argentina. La riqueza y variedad del elenco, que se amplía año a año, son datos que informan acerca del magnífico patrimonio cultural que ostenta el país. Algo más de una quinta parte del Registro, cuyo catálogo se agrupa en diferentes "tipologías", atañe a bienes de naturaleza "religiosa", en altísimo porcentaje concernientes a la Iglesia Católica. Sólo en orden a exhibir la diversidad del repertorio, que atraviesa todo el territorio de la Nación, cabe señalar que fueron declarados como "Monumento Histórico" la Catedral de la ciudad de Salta (Provincia de Salta), el Santuario de Nuestro Señor de los Milagros de Mailín (Provincia de Santiago del Estero), el Monumento al Cristo Redentor de los Andes (Provincia de Mendoza), el Cementerio de la Misión Salesiana (Provincia de Tierra del Fuego) y las Capillas de los Cementerios Británico y Alemán (Ciudad de Buenos Aires)...

Theory Of Phase Transformation And Reorientation In Single Crystalline Shape Memory Alloys

A constitutive model, based on an (n + 1)-phase mixture of the Mori-Tanaka average theory, has been developed for stress-induced martensitic transformation and reorientation in single crystalline shape memory alloys. Volume fractions of different martensite lattice correspondence variants are chosen as internal variables to describe microstructural evolution. Macroscopic Gibbs free energy for the phase transformation is derived with thermodynamics principles and the ensemble average method of micro-mechanics. The critical condition and the evolution equation are proposed for both the phase transition and reorientation. This model can also simulate interior hysteresis loops during loading/unloading by switching the critical driving forces when an opposite transition takes place.

Polibio, el mundo helenístico y la problemática cultural : algunas líneas de reflexión en los últimos veinte años

Resumen: Nuestro conocimiento de algunos aspectos de las Historias de Polibio se ha incrementado significativamente durante las dos últimas décadas. En ese sentido, ha habido ciertos desarrollos importantes con respecto a aspectos culturales de la obra, cuyo alcance ha ido permitiendo repensar durante estos años algunos presupuestos clásicos sobre la relación entre Polibio, Roma y el mundo helenístico. Proponemos aquí ofrecer un rápido análisis de las tres principales líneas de estudio propuestas por los estudiosos, cuyo alcance es considerado, en efecto, como un total reubicación del historiador aqueo al interior del universo cultural del mundo helenístico.

Una inflación de tipo “cultural”

"El problema de la inflación en la Argentina data de largas décadas, y el país es conocido en el mundo como un caso de estudio específico, tanto a partir de la persistente inflación registrada desde la década de 1840 hasta la actualidad, como por el proceso hiperinflacionario de 1989. Hoy, una vez más, como desde hace 60 años, la Argentina se enfrenta a una inflación persistente. También a una carrera dólar paralelo vs dólar oficial. Los errores del pasado no han servido como aprendizaje, y se repiten una y otra vez..."

El viaje omnipresente : su funcionalidad discursiva en los relatos culturales de la segunda modernidad

Número monográfico: El viaje y sus discursos

El aborto en la ley europea : derechos humanos, derechos sociales y la nueva tendencia cultural

Resumen: Este artículo se propone analizar: 1) si existe un verdadero “derecho al aborto” en la Convención Europea de Derechos Humanos, 2) si el aborto es una violación a los Derechos Sociales, 3) si la reciente tendencia en Europa frente a la restricción del aborto muestra que éste es un problema social y no un derecho o una libertad individual. Legisladores y organizaciones esperando proteger mejor a los niños y a las mujeres, del aborto, encontrarán críticas a la idea de la existencia de un derecho humano al aborto, así como el marco legal en el cual elaborar leyes protectorias.