Alpha decay half-lives of new superheavy elements through quasimolecular shapes

The lifetimes of alpha decays of the recently produced isotopes of the elements 112, 114, 116 and the element (294)118 and of some decay products have been calculated theoretically within the Wentzel-Kramers-Brillouin approximation. The alpha decay barriers have been determined in the quasimolecular shape path within a generalized liquid drop model including the proximity effects between nuclei in a neck, the mass and charge asymmetry and the precise nuclear radius. These calculations provide reasonable estimated for the observed alpha decay lifetimes. The calculated results have been compared with the results of the density-dependent M3Y effective interaction and the experimental data. It is indicated that the theoretical foundation of the generalized liquid drop model is as good as that of the microscopic DDM3Y model, at least in the sense of predicting the T-1/2 values as long as one uses a correct alpha decay energy. The half lives of these new nuclei are well tested from the consistence of the macroscopic, the microscopic and the experimental data.

Properties of alpha-decay to ground and excited states of heavy nuclei

Branching ratios and half-lives of alpha-decay to the ground-state rotational bands as well as the high-lying excited states of even-even nuclei have been calculated in the framework of the generalized liquid drop model (GLDM) and Royer's formula that we improved very recently. The calculation covers the isotopic chains from Ra to No in the mass regions 222 <= A <= 252 and 88 <= Z <= 102. The agreement between the calculated results and the experimental data indicates the reliability of investigating the properties of the unfavored alpha-decay with our method, especially the improved Royer's formula, which is very valuable for the analysis of experimental data. In addition, the dependence of half-lives on excitation energies of daughter nuclei has been investigated. It is shown that the influence on half-lives becomes stronger and stronger with the increase of the excitation energies.

Fine structure of alpha decay to rotational states of heavy nuclei

To gain a better insight into alpha-decay fine structure, we calculate the relative intensities of alpha decay to 2(+) and 4(+) rotational states in the framework of the generalized liquid drop model (GLDM) and improved Royer's formula. The calculated relative intensities of a decay to 2(+) states are in good agreement with the experimental data. For the relative intensities of alpha decay to 4(+) states, a good agreement with experimental data is achieved for Th and U isotopes. The formula we obtain is useful for the analysis of experimental data of alpha-decay fine structure. In addition, some predicted relative intensities which are still not measured are provided for future experiments.

Alpha-decay for heavy nuclei in the ground and isomeric states

The alpha-decay half-lives of nuclei in the ground states and Isomeric states have been calculated within the WKB approximation and Royer's formulas. The barrier in the quasimolecular shape path is determined within a generalized liquid drop model (GLDM). in which the centrifugal potential energy has been introduced to study the unfavored a-decay The agreement between the calculated results and experimental data indicates the reliability of studying alpha-decay of isomeric states with the generalized liquid drop model We find that their is no significant difference of preformation probability between Isomeric states and the corresponding ground states generally in favored alpha-decay Additionally. we extended Royer's formulas by taking account of the role of centrifugal harrier to study the unfavored alpha-decay, and some predicts oil the a decay half-lives of Isomers are made Finally. the effects of angular momontum transfer and Q(alpha) on alpha-decay half-life have been discussed Crown Copyright (C) 2009 Published by Elsevier B.V. All rights reserved

Improvement of a Fission-Like Model for Nuclear alpha Decay

The alpha decay constant is the product of the penetrability P and assault frequency nu(0) in the fission-like model. An effective assault frequency P-nu replacing the previous assault frequency nu(0) is introduced for improvement of a fission-like model named the generalized liquid drop model (GLDM) to describe the nuclear alpha decay process more accurately. Two analytical formulae are proposed for the effective assault frequency due to experimental data within the GLDM. The improved model can be used to give accurate calculations for alpha decay half-lives.

PROPERTIES OF ALPHA DECAY TO ROTATIONAL BANDS OF HEAVY NUCLEI

In the framework of the generalized liquid drop model (GLDM) and improved Royer's formula, we investigate the branching ratios and half-lives of alpha-decay to the members of the ground-state rotational bands of heavy even-even Fm and No isotopes. The calculated results are in good agreement with the available experimental data and some useful predictions are provided for future experiments.

Pressure drops of single and two-phase flows through T-type microchannel mixers

In this paper, preliminary experimental results are presented on pressure drop characteristics of single and two-phase flows through two T-type rectangular microchannel mixers with hydraulic diameters of 528 and 333 mum, respectively. It is shown that both N-2 and water single-phase laminar flows in microchannels, with consideration of experimental uncertainties, are consistent with classic theory, if additional effects, such as entrance effects that will interfere with the interpretation of experimental results, are eliminated by carefully designing the experiments. The obtained pressure drop data of N-2-water two-phase flow in micromixers are analyzed and compared with existing flow pattern-independent models. It is found that the Lockhart-Martinelli method generally underpredicts the frictional pressure drop. Thereafter, a modified correlation of C value in the Chisholm's equation based on linear regression of experimental data is proposed to provide a better prediction of the two-phase frictional pressure drop. Also among the homogeneous flow models investigated, the viscosity correlation of McAdams indicates the best performance in correlating the frictional pressure drop data (mean deviations within +/-20% for two micromixers both). Finally it is suggested that systematic studies are still required to accurately predict two-phase frictional performance in microchannels. (C) 2004 Elsevier B.V. All rights reserved.

Nafion/PTFE composite membranes for fuel cell applications

Porous polytetrafluoroethylene (PTFE) membranes were used as support material for Nafion((R))/PTFE composite membranes. The composite membranes were synthesized by impregnating porous PTFE membranes with a self-made Nafion solution. The resulting composite membranes were mechanically durable and quite thin relative to traditional perfluorosulfonated ionomer membranes (PFSI); we expect the composite membranes to be of low resistance and cost. In this study, we used three kinds of porous PTFE films to prepare Nafion/PTFE composite membranes of different thickness. Scanning electron micrographs and oxygen permeabilities showed that Nafion resin is distributed uniformly in the composite membrane and completely plug the micropores, there is a continuous thin Nation film present on the PTFE surface. The variation in water content of the composite and Nafion 115 membranes with temperature was determined. At the same temperature, water content of the composite membranes was smaller than that of the Nafion 115. In both dry and wet conditions, maximum strength and break strength of C-325(#) and C-345(#) were larger than those of Nafion 112 due to the reinforcing effect of the porous PTFE films. And the PEMFC performances and the lifetime of the composite membranes were also tested on the self-made apparatus. Results showed that the bigger the porosity of the substrate PTFE films, the better the fuel cell performance; the fuel cell performances of the thin composite membranes were superior to that of Nation 115 membrane; and after 180 h stability test at 500 mA/cm(2), the cell voltage showed no obvious drop. (C) 2002 Published by Elsevier Science B.V.

In situ IR spectroscopic studies on molybdenum nitride catalysts: active sites and surface reactions

Recent IR spectroscopic studies on the surface properties of fresh Mo2N/gamma-Al2O3 catalyst are presented in this paper. The surface sites of fresh Mo2N/gamma-Al2O3, both Modelta+ (0<δ<2) and N sites, are probed by CO adsorption. Two characteristic IR bands were observed at 2045 and 2200 cm(-1), due to linearly adsorbed CO on Mo and N sites, respectively. The surface N sites are highly reactive and can react with adsorbed CO to form NCO species. Unlike adsorbed CO on reduced passivated one, the adsorbed CO on fresh Mo2N/gamma-Al2O3 behaves similarly to that of group VIII metals, suggesting that fresh nitride resembles noble metals. It is found that the surface of Mo nitrides slowly transformed into sulfide under hydrotreating conditions, which could be the main reason for the activity drop of molybdenum nitride catalysts in the presence of sulfur-containing species. Some surface reactions, such as selective hydrogenation of 1,3-butadiene, isomerization of 1-butene, and hydrodesulfurization of thiophene, were studied on both fresh and reduced passivated Mo2N/gammaAl(2)O(3) catalysts using IR spectroscopy. The mechanisms of these reactions are proposed. The adsorption and reaction behaviors of these molecules on fresh molybdenum nitride also resemble those on noble metals, manifesting the unique properties of fresh molybdenum nitride catalysts. Mo and N sites are found to play different roles in the adsorption and catalytic reactions on the fresh Mo2N/gammaAl(2)O(3) catalyst. Generally, Mo sites are the main active sites for the adsorption and reactions of adsorbates; N sites are not directly involved in catalytic reactions but they modify the electronic properties of Mo sites.

SbOx/SiO2 catalysts for the selective oxidation of methane to formaldehyde using molecular oxygen as oxidant

SbOx and SbOx/SiO2 catalysts were prepared and investigated for methane selective oxidation to HCHO. HCHO selectivity up to 41% can be obtained on Sb2O5/SiO2 catalyst at 873 K and just drop gently to 18% with temperature up to 923 K. HCHO selectivity for SbOx/SiO2 catalysts decreases gently with reaction temperature, so considerable value of HCHO selectivity can still be obtained at high temperatures.

Automated voltammetric system for shipboard determination of metal speciation in sea water

An automated and semi-intelligent voltammetric system is described for trace metal analysis. The system consists of a voltammeter interfaced with a personal computer, a sample changer, 2 peristaltic pumps, a motor burette and a hanging mercury drop electrode. The system carries out fully automatically approximately 5 metal determinations per hour (including at least 3 repetitive scans and calibration by standard addition) at trace levels encountered in clean sea water. The computer program decides what level of standard addition to use and evaluates the data prior to switching to the next sample. Alternatively, the system can be used to carry out complexing ligand titration with copper whilst recording the labile copper concentration; in this mode up to 8 full titrations are carried out per day. Depth profiles for chromium speciation in the Mediterranean Sea and a profile for copper complexing ligand concentrations in the North Atlantic Ocean measured on board-ship with the system are presented. The chromium speciation was determined using a new method to differentiate between Cr(III) and Cr(VI) utilizing adsorption of Cr(III) on silica particles.

Nontoxic electrodes of solid amalgams

This is a review of electrodes based on nontoxic solid amalgams (MeSAE) (prepared by amalgamation of soft metal powders) in connection with some other kinds of voltammetric electrodes is given. Information is summarized on various types of MeSAEs (esp. AgSAE, CuSAE, AuSAE), pretreatment of their surfaces, their hydrogen overvoltage in aqueous solutions, conditions for their testing, electroanalytical parameters and use, in compared with the hanging mercury drop electrode (HMDE). Although the solid amalgam electrodes do not reach the quality of the HMDE, in many cases they represent its possible alternative. The broad range of voltammetric applications of the MeSAEs, especially of the AgSAEs, their good mechanical stability, simple handling, and new aspects of their use in electrochemical techniques are documented by numerous examples.

水分处理对油菜叶位光合速率、蒸腾速率及水分利用效率的影响

通过对不同水分处理下油菜不同叶位叶片光合速率(Pn)、蒸腾速率(E)和水分利用效率(WUE)的测定表明,油菜主茎叶片的光合速率、蒸腾速率和水分利用效率随叶位的降低而降低;干旱胁迫下油菜水分利用效率显著提高,光合速率变化不明显,但上部、下部叶间光合速率差异大。充分供水时叶片的蒸腾速率提高,水分利用效率则降低,从上到下叶片水分利用效率、光合速率降低不剧烈,而蒸腾速率表现为上部和下部叶高,而中部叶低。据测定,干旱处理下油菜单株生物量为37.45g,充分供水时为38.76g,干旱导致油菜生物量降低;水分胁迫能提高作物水分利用效率;在充分供水条件下叶片蒸腾速率较高,这可能是气孔行为的结果。

不同林龄植被培肥改良土壤效益研究

在黄土丘陵沟壑区森林植被能够明显改善生态环境 ,防止土地退化 ,提高土壤中有机质、速效氮和速效钾的含量 ,降低土壤pH和容重 ;快速显著地增加土体中 >0 .2 5mm水稳性团聚体和 >5 0 μm微团粒的数量 ,使土壤结构改善 ,协调供应养分和水分的能力提高 ;能促进黏粒形成 ,坚实度增加 ,土壤的抗蚀性和抗冲性提高 ,有效地减少水土流失。植被对土壤的培肥改良是一种正向持续反馈机制 ,时间越长 ,效益越显著

Controlled synthesis of organic-inorganic hybrid nanofibers by a wet-chemical route

Organic-inorganic hybrid nanofibers are successfully synthesized by incorporating 3,3 ',5,5 '-tetramethylbenzidine (TMB) and H2PtCl6 at room temperature. The morphology and size can be simply controlled by tuning the molar ratio and initial concentration of reactants. A possible formation mechanism was suggested on the basis of the experimental results. The optical properties were investigated and the as-obtained product displays a strong fluorescence emission at room temperature that may be promising for applications in the fabrication of photoelectric materials. (C) 2008 Elsevier B.V. All rights reserved.