Observation of annular electron beam transport in multi-TeraWatt laser-solid interactions

Electron energy transport experiments conducted on the Vulcan 100 TW laser facility with large area foil targets are described. For plastic targets it is shown, by the plasma expansion observed in shadowgrams taken after the interaction, that there is a transition between the collimated electron flow previously reported at the 10 TW power level to an annular electron flow pattern with a 20 degrees divergence angle for peak powers of 68 TW. Intermediate powers show that both the central collimated flow pattern and the surrounding annular-shaped heated region can co-exist. The measurements are consistent with the Davies rigid beam model for fast electron flow (Davies 2003 Phys. Rev. E 68 056404) and LSP modelling provides additional insight into the observed results.

Observation of ion temperatures exceeding background electron temperatures in petawatt laser-solid experiments

Neutron time of flight signals have been observed with a high resolution neutron spectrometer using the petawatt arm of the Vulcan laser facility at Rutherford Appleton Laboratory from plastic sandwich targets containing a deuterated layer. The neutron spectra have two elements: a high-energy component generated by beam-fusion reactions and a thermal component around 2.45 MeV. The ion temperatures calculated from the neutron signal width clearly demonstrate a dependence on the front layer thickness and are significantly higher than electron temperatures measured under similar conditions. The ion heating process is intensity dependent and is not observed with laser intensities on target below 10(20) W cm(-2). The measurements are consistent with an ion instability driven by electron perturbations.

Characterization of Li-7(p,n)Be-7 neutron yields from laser produced ion beams for fast neutron radiography

Investigations of Li-7(p,n)Be-7 reactions using Cu and CH primary and LiF secondary targets were performed using the VULCAN laser [C.N. Danson , J. Mod. Opt. 45, 1653 (1997)] with intensities up to 3x10(19) W cm(-2). The neutron yield was measured using CR-39 plastic track detector and the yield was up to 3x10(8) sr(-1) for CH primary targets and up to 2x10(8) sr(-1) for Cu primary targets. The angular distribution of neutrons was measured at various angles and revealed a relatively anisotropic neutron distribution over 180degrees that was greater than the error of measurement. It may be possible to exploit such reactions on high repetition, table-top lasers for neutron radiography. (C) 2004 American Institute of Physics.

Target charging effects on proton acceleration during high-intensity short-pulse laser-solid interactions

We report results from experiments performed at the Rutherford Appleton Laboratory using the VULCAN laser facility (I>5x10(19) W cm(-2)). Single wire targets were used, and on some shots additional objects were placed near the target. These were positioned so that they were not irradiated by the laser. Proton emission from single wire targets was observed as radially symmetric structures (

‘What Adult Worker Model? A Critical Look at Recent Social Policy Reform in Europe from a Gender and Family Perspective

Analyses regularly feature claims that European welfare states are in the process of creating an adult worker model. The theoretical and empirical basis of this argument is examined here by looking first at the conceptual foundations of the adult worker model formulation and then at the extent to which social policy reform in western Europe fits with the argument. It is suggested that the adult worker formulation is under-specified. A framework incorporating four dimensions—the treatment of individuals vis-à-vis their family role and status for the purposes of social rights, the treatment of care, the treatment of the family as a social institution, and the extent to which gender inequality is problematized—is developed and then applied. The empirical analysis reveals a strong move towards individualization as social policy promotes and valorizes individual agency and self-sufficiency and shifts some childcare from the family. Yet evidence is also found of continued (albeit changed) familism. Rather than an unequivocal move to an individualized worker model then, a dual earner, gender-specialized, family arrangement is being promoted. The latter is the middle way between the old dependencies and the new “independence.” This makes for complexity and even ambiguity in policy, a manifestation of which is that reform within countries involves concurrent moves in several directions.

A probabilistic modelling scheme for analysis of long-term failure of cemented femoral joint replacements

Reliable prediction of long-term medical device performance using computer simulation requires consideration of variability in surgical procedure, as well as patient-specific factors. However, even deterministic simulation of long-term failure processes for such devices is time and resource consuming so that including variability can lead to excessive time to achieve useful predictions. This study investigates the use of an accelerated probabilistic framework for predicting the likely performance envelope of a device and applies it to femoral prosthesis loosening in cemented hip arthroplasty.
A creep and fatigue damage failure model for bone cement, in conjunction with an interfacial fatigue model for the implant–cement interface, was used to simulate loosening of a prosthesis within a cement mantle. A deterministic set of trial simulations was used to account for variability of a set of surgical and patient factors, and a response surface method was used to perform and accelerate a Monte Carlo simulation to achieve an estimate of the likely range of prosthesis loosening. The proposed framework was used to conceptually investigate the influence of prosthesis selection and surgical placement on prosthesis migration.
Results demonstrate that the response surface method is capable of dramatically reducing the time to achieve convergence in mean and variance of predicted response variables. A critical requirement for realistic predictions is the size and quality of the initial training dataset used to generate the response surface and further work is required to determine the recommendations for a minimum number of initial trials. Results of this conceptual application predicted that loosening was sensitive to the implant size and femoral width. Furthermore, different rankings of implant performance were predicted when only individual simulations (e.g. an average condition) were used to rank implants, compared with when stochastic simulations were used. In conclusion, the proposed framework provides a viable approach to predicting realistic ranges of loosening behaviour for orthopaedic implants in reduced timeframes compared with conventional Monte Carlo simulations.

Buckling/post-buckling strength of friction stir welded aircraft stiffened panels

Assembling aircraft stiffened panels using friction stir welding offers potential to reduce fabrication time in comparison to current mechanical fastener assembly, making it economically feasible to select structurally desirable stiffener pitching and novel panel configurations. With such a departure from the traditional fabrication process, much research has been conducted on producing strong reliable welds, with less examination of the impact of welding process residual effects on panel structural behaviour and the development of appropriate design methods. This article significantly expands the available panel level compressive strength knowledge, demonstrating the strength potential of a welded aircraft panel with multiple lateral and longitudinal stiffener bays. An accompanying computational study has determined the most significant process residual effects that influence panel strength and the potential extent of panel degradation. The experimental results have also been used to validate a previously published design method, suggesting accurate predictions can be made if the conventional aerospace design methods are modified to acknowledge the welding altered panel properties.

The use of interactive video in teaching teachers: an evaluation of a link with a primary school

This paper presents an evaluation of the use of videoconferencing in learning and teaching in a United Kingdom higher education institution involved in initial teacher education. Students had the opportunity to observe naturalistic teaching practices without physically being present in the classroom. The study consisted of semi-structured interviews with the co-ordinator of the link, the head of ICT services in Stranmillis University College and the teacher of the classroom being observed. Students were invited to complete an online questionnaire. The views of the students, the co-ordinator of the link, the teacher of the classroom being observed and the head of ICT services in Stranmillis University College were then triangulated to gain an overall view of the effectiveness of the videoconferencing link. Interviews suggested students benefited in terms of pedagogy. In the early stages of the project, the teacher thought it acted as a form of classroom control. Technical problems were encountered initially and camera control was modified in the light of these. The online questionnaire suggested that students viewed this experience in a positive way and were impressed with the content, technical quality, and potential benefits of the use of this example of new technologies.

Information disclosure and depositor discipline in the Chinese banking sector

We investigate the relationship between information disclosure and depositor behaviour in the Chinese banking sector. Specifically, we enquire whether enhanced information disclosure enables investors to more effectively infer a banking institution's risk profile, thereby influencing their deposit decisions. Utilising an unbalanced panel, incorporating financial data from 169 Chinese banks over the 1998–2009 period, we employ generalised-method-of-moments (GMM) estimation procedures to control for potential endogeneity, unobserved heterogeneity, and persistence in the dependent variable. We uncover evidence that: (i) the growth rate of deposits is sensitive to bank fundamentals after controlling for macroeconomic factors, diversity in ownership structure, and government intervention; (ii) a bank publicly disclosing more transparent information in its financial reports, is more likely to experience growth in its deposit base; and (iii) banks characterised by high information transparency, well-capitalised and adopted international accounting standards, are more able to attract funds by offering higher interest rates.

Keeping it real! Enhancing realism in standardised patient OSCE stations

Background: Objective structured clinical examinations (OSCEs) are a
commonly used method of assessing clinical competency in healthcare education. They can providean opportunity to observe candidates interacting with patients.
There are many challenges in using real patients in OSCEs, and increasingly standardised patients are being used as a preference. However, by using standardised patients there is a risk of making the encounter arti?cial and removed from actual clinical practice.
Context: Efforts made in terms of cognitive, auditory, visual, tactile, psychological and emotional cues can minimise the differences between a simulated
and real clinical scenario. However, a number of factors, including feasibility, cost and usability, need to be considered if such techniques are to be practicable
within an OSCE framework.
Innovation: This article describes a series of techniques that have been used in our institution to enhance the realism of a standardised patient encounter in an
OSCE. Efforts in preparing standardised patient roles, and how they portray these roles, will be considered. A wide variety of equipment can also be used in
combination with a patient and the surrounding environment, which can further enhance the authenticity of the simulated scenario.
Implications: By enhancing the realism in simulated patient OSCE encounters, there is potential to trigger more authentic conscious responses from candidates and implicit reactions that the candidates themselves may be less
aware of. Furthermore, using such techniques may allow faculty members to select scenarios that were previously not thought possible in an OSCE

Optimal proportional-integral-derivative control of shape memory alloy actuators using genetic algorithm and the Preisach model

Shape memory alloy (SMA) actuators, which have the ability to return to a predetermined shape when heated, have many potential applications in aeronautics, surgical tools, robotics, and so on. Although the number of applications is increasing, there has been limited success in precise motion control owing to the hysteresis effect of these smart actuators. The present paper proposes an optimization of the proportional-integral-derivative (PID) control method for SMA actuators by using genetic algorithm and the Preisach hysteresis model.

A normative approach to the criminalisation of cartel activity

Although cartel behaviour is almost universally (and rightly) condemned, it is not clear why cartel participants deserve the full wrath of the criminal law and its associated punishment. To fill this void, I develop a normative (or principled) justification for the criminalisation of conduct characteristic of ‘hard core’ cartels. The paper opens with a brief consideration of the rhetoric commonly used to denounce cartel activity, eg that it ‘steals from’ or ‘robs’ consumers. To put the discussion in context, a brief definition of ‘hard core’ cartel behaviour is provided and the harms associated with this activity are identified. These are: welfare losses in the form of appropriation (from consumer to producer) of consumer surplus, the creation of deadweight loss to the economy, the creation of productive inefficiency (hindering innovation of both products and processes), and the creation of so-called X-inefficiency. As not all activities which cause harm ought to be criminalised, a theory as to why certain harms in a liberal society can be criminalised is developed. It is based on JS Mill's harm to others principle (as refined by Feinberg) and on a choice of social institutions using Rawls's ‘veil of ignorance.’ The theory is centred on the value of individual choice in securing one's own well-being, with the market as an indispensable instrument for this. But as applied to the harm associated with cartel conduct, this theory shows that none of the earlier mentioned problems associated with this activity provide sufficient justification for criminalisation. However, as the harm from hard core cartel activity strikes at an important institution which permits an individual's ability to secure their own well-being in a liberal society, criminalisation of hard core cartel behaviour can have its normative justification on this basis.