The influence of topography and land use on water quality of Xiangxi River in Three Gorges Reservoir region

A self-organizing map (SOM) was used to cluster the water quality data of Xiangxi River in the Three Gorges Reservoir region. The results showed that 81 sampling sites could be divided into several groups representing different land use types. The forest dominated region had low concentrations of most nutrient variables except COD, whereas the agricultural region had high concentrations of NO3N, TN, Alkalinity, and Hardness. The sites downstream of an urban area were high in NH3N, NO2N, PO4P and TP. Redundancy analysis was used to identify the individual effects of topography and land use on river water quality. The results revealed that the watershed factors accounted for 61.7% variations of water quality in the Xiangxi River. Specifically, topographical characteristics explained 26.0% variations of water quality, land use explained 10.2%, and topography and land use together explained 25.5%. More than 50% of the variation in most water quality variables was explained by watershed characteristics. However, water quality variables which are strongly influenced by urban and industrial point source pollution (NH3N, NO2N, PO4P and TP) were not as well correlated with watershed characteristics.

Distribution of the macroinvertebrate communities in the Xiangxi River system and relationships with environmental factors

Surveys of macroinvertebrates were carried out in the Xiangxi River system during July of 2001. Among the 121 taxa collected, Ephemeroptera, Trichoptera, and Diptera dominated (41.7, 26.0, and 24.5% of the total relative abundance, respectively). Two-way indictor species analysis and detrended correspondence analysis divided the 49 sites into four groups based on species composition and relative abundance. Canonical correspondence analysis indicated that elevation, SiO2, pH, conductivity, hardness, and NO2-N were significant environmental factors affecting the distribution of macroinvertebrates.

Benthic algae of the Xiangxi River, China

From June 2000 to June 2002, four sites on the mainstem of the Xiangxi River and one site on each of its major tributaries were sampled 16 times each for benthic algae. All total, 223 taxa (most to species and variety levels) were found (193 Bacillariophyta, 20 Chlorophyta, nine Cyanophyta and one Xanthophyta). The diatoms Cocconeis placentula, Achnanthes linearis, and Diatoma vulgare dominated the system, with relative abundance of 33.3%, 18.8%, and 6.4%, respectively. The abundances of all the other taxa were under 5%, and 210 taxa collectively contributed less than 1% of the total abundance. Taxa diversity peaked in winter and reached a minimum in summer. Species richness varied considerably but was not significantly different over time. Maximum algal density occurred in later winter/spring (1.4 x 10(9) ind./m(2)) but was not significantly different from the minimum density, which occurred in August. Chlorophyll a showed similar seasonal fluctuation but also was not significantly different over time. Canonical correspondence analysis demonstrated that water hardness, depth, conductivity, and alkalinity had important influences on variation of epilithic algae in the Xiangxi River system.

Toxicity of cypermethrin to Daphnia magna HB

The acute toxic effect of the pesticide cypermethrin to Daphnia magna HB was examined. D. magna HB was exposed to cypermethrin at concentrations of 0, 1, 3, 5, 7, and 9 mg/L for 24 In. Data showed that the 24 h-LC50 of cypermthrin on D. magna HB was 4.81 mg/L. In contrast, the 24 h-LC50 of K2Cr2O7 (the national standard toxicant) to Daphnia magna was 0.38 mg/L in the current study. Results indicated that the Daphnia magna was very sensitive to pesticides. In addition, the effects of the culture condition(such as hardness, temperature and DO etc.) on Daphnia magna HB was also studied.

Structure of macrozoobenthos of the East Dongting nature reserve, with emphasis on relationships with environmental variables

Ecological survey of macrozoobenthos assemblages was carried out at 32 sites in the East Dongting Nature Reserve, located in the northern region of the East Dongting Lake in the middle basin of the Yangtze River, China. All total 51 taxa including 18 oligochaetes, 15 mollusks, 14 insects and four other animals were recorded. Mollusks composed the dominant group and accounted for more than 70% of the total abundance. Assemblages were composed mainly of scrapers (66.7%) and collector-gatherers (nearly 20%), and to a lesser extent collector-filterers (roughly 12%), predators (ca. 7%), and shredders (ca. 6%). Two-way indicator species analysis, detrended correspondence, and canonical correspondence analysis (CCA) were employed to identify the relationships between macrozoobenthos assemblages and environmental variables. Thirty-two sites were separated into four site groups based on composition and relative abundance of benthic macroinvertebrates. CCA detected that water depth, pH, conductivity, SiO2, total nitrogen, total phosphorus, alkalinity, hardness, and Ca2+, were significant environmental factors influencing the pattern of macozoobenthos. In this minimal subset, water depth, pH, alkalinity and hardness were the most influential variables.

First-principles study of ground-state properties and high pressure behavior of ThO2

The mechanical properties, electronic structure and phonon dispersion of ground state ThO2 as well as the structure behavior up to 240 GPa are studied using first-principles density-functional theory. Our calculated elastic constants indicate that both the ground-state fluorite structure and high pressure cotunnite structure of ThO2 are mechanically stable. The bulk modulus, shear modulus, and Young's modulus of cotunnite ThO2 are all smaller by approximately 25% compared with those of fluorite ThO2. The Poisson's ratios of both structures are approximately equal to 0.3 and the hardness of fluorite ThO2 is 22.4 GPa. The electronic structure and bonding nature of fluorite ThO2 are fully analyzed, and show that the Th-O bond displays a mixed ionic/covalent character. The phase transition from the fluorite to cotunnite structure is calculated to occur at the pressure of 26.5 GPa, consistent with recent experimental measurement by ldiri et al. [1]. For the cotunnite phase it is further predicted that an isostructural transition takes place in the pressure region of 80-130 GPa.

Mechanical Deformation Behavior of Nonpolar GaN Thick Films by Berkovich Nanoindentation

In this study, the deformation mechanisms of nonpolar GaN thick films grown on m-sapphire by hydride vapor phase epitaxy (HVPE) are investigated using nanoindentation with a Berkovich indenter, cathodoluminescence (CL), and Raman microscopy. Results show that nonpolar GaN is more susceptible to plastic deformation and has lower hardness than c-plane GaN. After indentation, lateral cracks emerge on the nonpolar GaN surface and preferentially propagate parallel to the < 11 (2) over bar0 > orientation due to anisotropic defect-related stresses. Moreover, the quenching of CL luminescence can be observed to extend exclusively out from the center of the indentations along the < 11 (2) over bar0 > orientation, a trend which is consistent with the evolution of cracks. The recrystallization process happens in the indented regions for the load of 500 mN. Raman area mapping indicates that the distribution of strain field coincides well with the profile of defect-expanded dark regions, while the enhanced compressive stress mainly concentrates in the facets of the indentation.

Effect of counterpart on the tribological behavior and tribo-induced phase transformation of Si

The tribological behaviors and phase transformation of single crystal silicon against Si3N4, Ruby and steel were investigated in this study. It was found that the strong chemical action between silicon and Fe was the key factor to the tribological behavior of silicon as slid against steel. SEM and Raman spectroscopy indicated that phase transformation of single crystal silicon occurred during the running-in period at low sliding velocity as slid against Si3N4 and Ruby. and gave birth to single or a mixture phase of Si-III, Si-XII and amorphous silicon. The high hardness of counterpart and the absence of chemical action between silicon and counterpart facilitated the phase transformation of single crystal silicon. (C) 2008 Elsevier Ltd. All rights reserved.

Structural phase transformations of ZnS nanocrystalline under high pressure

In-situ energy dispersive x-ray diffraction on ZnS nanocrystalline was carried out under high pressure by using a diamond anvil cell. Phase transition of wurtzite of 10 nm ZnS to rocksalt occurred at 16.0 GPa, which was higher than that of the bulk materials. The structures of ZnS nanocrystalline at different pressures were built by using materials studio and the bulk modulus, and the pressure derivative of ZnS nanocrystalline were derived by fitting the equation of Birch-Murnaghan. The resulting modulus was higher than that of the corresponding bulk material, which indicates that the nanomaterial has higher hardness than its bulk materials.

Effect of implantation of nitrogen into SIMOX buried oxide on its fixed positive charge density

In order to obtain greater radiation hardness for SIMOX (separation by implanted oxygen) materials, nitrogen was implanted into SIMOX BOX (buried oxide). However, it has been found by the C-V technique employed in this work that there is an obvious increase of the fixed positive charge density in the nitrogen-implanted BOX with a 150 out thickness and 4 x 10(15) cm(-2) nitrogen implantation dose, compared with that unimplanted with nitrogen. On the other hand, for the BOX layers with a 375 nm thickness and implanted with 2 x 10(15) and 3 x 10(15) cm(-2) nitrogen doses respectively, the increase of the fixed positive charge density induced by implanted nitrogen has not been observed. The post-implantation annealing conditions are identical for all the nitrogen-implanted samples. The increase in fixed positive charge density in the nitrogen-implanted 150 nm BOX is ascribed to the accumulation of implanted nitrogen near the BOX/Si interface due to the post-implantation annealing process according to SIMS results. In addition, it has also been found that the fixed positive charge density in initial BOX is very small. This means SIMOX BOX has a much lower oxide charge density than thermal SiO2 which contains a lot of oxide charges in most cases.

Study on mechanical properties of GaN epitaxy films grown on sapphire by MOCVD

GaN epitaxy films were grown on (0001) oriented sapphire substrate by metal-organic vapor deposition(MOCVD). AFM and SEM were used to analyze the surface morphology of GaN films. Hardness and critical load of GaN films were measured by an nano-indentation tester, friction coefficient by reciprocating UMT-2MT tribometer. It is found that the surface of GaN film is smooth and the epitaxial growth mechanism is in two-dimension mode, GaN epitaxy films also belong to ultra-hardness materials, whose hardness is 22.1 MPa and elastic modulus is 299.5 GPa. Adhesion strength of epitaxial GaN to sapphire is high, and critical load reaches 1.6 N. Friction coefficient against GCr15 ball is steadily close to 0.13, while GaN films turns to be broken rapidly by using Si3N4 ceramic ball as counterpart.

Nano-layer structure of silicon-on-insulator materials

Silicon-on-insulator (SOI) has been recognized as a promising semiconductor starting material for ICs where high speed and low power consumption are desirable, in addition to its unique applications in radiation-hardened circuits. In the present paper, three novel SOI nano-layer structures have been demonstrated. ULTRA-THIN SOI has been fabricated by separation by implantation of oxygen (SIMOX) technique at low oxygen ion energy of 45 keV and implantation dosage of 1.81017/cm2. The formed SOI layer is uniform with thickness of only 60 nm. This layer is of crystalline quality. and the interface between this layer and the buried oxide layer is very sharp, PATTERNED SOI nanostructure is illustrated by source and drain on insulator (DSOI) MOSFETs. The DSOI structure has been formed by selective oxygen ion implantation in SIMOX process. With the patterned SOI technology, the floating-body effect and self-heating effect, which occur in the conventional SOI devices, are significantly suppressed. In order to improve the total-dose irradiation hardness of SOI devices, SILICON ON INSULATING MULTILAYERS (SOIM) nano-structure is proposed. The buried insulating multilayers, which are composed of SiOx and SiNy layers, have been realized by implantation of nitride and oxygen ions into silicon in turn at different ion energies, followed by two steps of high temperature annealing process, respectively, Electric property investigation shows that the hardness to the total-dose irradiation of SOIM is remarkably superior to those of the conventional SIMOX SOI and the Bond-and-Etch-Back SOI.

An investigation on the pressure-induced phase transition of nanocrystalline ZnS

An in situ energy dispersive x-ray diffraction study on nanocrystalline ZnS was carried out under high pressure up to 30.8 GPa by using a diamond anvil cell. The phase transition from the wurtzite to the zinc-blende structure occurred at 11.5 GPa, and another obvious transition to a new phase with rock-salt structure also appeared at 16.0 GPa-which was higher than the value for the bulk material. The bulk modulus and the pressure derivative of nanocrystalline ZnS were derived by fitting the Birch-Murnaghan equation. The resulting modulus was higher than that of the corresponding bulk material, indicating that the nanomaterial has higher hardness than the bulk material.

Formation and Properties of a Novel Heavy-Metal Chalcogenide Glass Doped with a High Dysprosium Concentration

A novel heavy-metal chalcogenide glass doped with a high dysprosium ion (Dy(3+)) concentration was prepared by the well-established melt-quenching technique from high-purity elements. The results show that when Cadmium (Cd) is introduced into chalcogenide glass, the concentration of Dy(3+) ions doped in GeGaCdS glasses is markedly increased, the thermodynamic performance improves, and the difference between T(g) and T(x) is >120 degrees C. The Vickers microhardness is also modified greatly, about 245 kgf/mm(2). The optical spectra indicate that all absorption and emission bands of Dy(3+) are clearly observed and red-shifted with increasing Dy(3+) concentration.

黄土高原半干旱区农田干旱防御与抗旱措施

系统分析农田抗旱管理与相应措施对黄土高原半干旱区社会和经济的协调健康发展以及粮食安全具有重要意义。黄土高原半干旱区干旱发生的特点决定了农田抗旱管理的复杂性和艰巨性。论文阐述了农田抗旱管理中防、抗与避三种措施的主要内容,并就农田抗旱管理系统进行了介绍。认为通过建立完善的农业技术推广服务体系和针对地区特点的抗旱管理措施,是半干旱区农业可持续发展一项重要而积极的对策,不仅需要从资金和政策上给予扶持和倾斜,更需要在管理机制上予以重视。