Plug-in de procesado visual (OpenCV) en OpenDomo OS

Este proyecto consiste en el diseño y desarrollo de un plug-in que permita usar el sistema de procesado de imagen OpenCV desde el sistema operativo OpenDomo OS.

Electric field distribution in silicon edgeless detector

This Master’s Thesis work reports about electric field distribution in recently developed silicon edgeless detector with a new current terminating structure. This structure enables the essential reduction of insensitive detector area as well as allows separation of the current flowing through the active area from the current flowing at the cut edge. The reliable operation of this detector is strongly needed due to the installation inside LHC. In accordance with formulated problems SEM was used as an investigation tool for collecting the data about electric field distribution.

Automated flow-injection method for cadmium determination with pre-concentration and reagent preparation on-line

The spectrophotometric determination of Cd(II) using a flow injection system provided with a solid-phase reactor for cadmium preconcentration and on-line reagent preparation, is described. It is based on the formation of a dithizone-Cd complex in basic medium. The calibration curve is linear between 6 and 300 µg L-1 Cd(II), with a detection limit of 5.4 µg L-1, an RSD of 3.7% (10 replicates in duplicate) and a sample frequency of 11.4 h-1. The proposed method was satisfactorily applied to the determination of Cd(II) in surface, well and drinking waters.

Flow analysis by using solenoid valves for As(III) determination in natural waters by an on-line separation and pre-concentration system coupled to a tungsten coil atomizer

A flow system coupled to a tungsten coil atomizer in an atomic absorption spectrometer (TCA-AAS) was developed for As(III) determination in waters, by extraction with sodium diethyldithiocarbamate (NaDDTC) as complexing agent, and by sorption of the As(III)-DDTC complex in a micro-column filled with 5 mg C18 reversed phase (10 µL dry sorbent), followed by elution with ethanol. A complete pre-concentration/elution cycle took 208 s, with 30 s sample load time (1.7 mL) and 4 s elution time (71 µL). The interface and software for the synchronous control of two peristaltic pumps (RUN/ STOP), an autosampler arm, seven solenoid valves, one injection valve, the electrothermal atomizer and the spectrometer Read function were constructed. The system was characterized and validated by analytical recovery studies performed both in synthetic solutions and in natural waters. Using a 30 s pre-concentration period, the working curve was linear between 0.25 and 6.0 µg L-1 (r = 0.9976), the retention efficiency was 94±1% (6.0 µg L-1), and the pre-concentration coefficient was 28.9. The characteristic mass was 58 pg, the mean repeatability (expressed as the variation coefficient) was 3.4% (n=5), the detection limit was 0.058 µg L-1 (4.1 pg in 71 µL of eluate injected into the coil), and the mean analytical recovery in natural waters was 92.6 ± 9.5 % (n=15). The procedure is simple, economic, less prone to sample loss and contamination and the useful lifetime of the micro-column was between 200-300 pre-concentration cycles.

Immigrant occupational mobility: Longitudinal evidence from Spain

This article examines the occupational mobility of immigrants between their countries of origin and Spain on the basis of one of the few surveys available internationally with longitudinal information on immigrant employment in home and host countries. The evidence shows that the occupational status of immigrants in the Spanish labour market is, in general, substantially worse than in their countries of origin. The severe loss of occupational status experienced by immigrants is explained by the combined effect of the intense initial downgrading they experience when entering the Spanish labour market and their very slow occupational progress during their stay in Spain. These findings are more in line with the segmented assimilation theory, which suggests a limited or blocked immigrant occupational mobility, than with the assimilation theory, which predicts a U-shaped evolution in the occupational status of immigrants between their home and host countries. As a result, the Spanish case contrasts sharply with previous evidence for other advanced countries, which tends to support the assimilation perspective. Finally, the empirical evidence suggests that one of the elements impeding the occupational mobility of immigrants in Spain is the significant size of the secondary segment of the labour market, which restricts immigrants' opportunities mainly to low-status occupations.

Estudi sociomorfològica a Manresa : el segment velar en algunes formes del PI i el PS dels verbs anar, fer, veure i haver

Des d’una perspectiva sociomorfològica, aquest estudi analitza la correlació que hi ha entre les variables socials de l’edat, el gènere i la classe social i un dels trets morfofonològics més característics del parlar dels joves de Manresa: la presència del segment velar /g/ en la primera persona del singular del present d’indicatiu, i en les persones primera, segona i tercera del singular i en la tercera del plural del present de subjuntiu dels verbs irregulars anar, fer, veure i haver (ex. vaic i vaigui).

Microwave Slot Transmission Line Filled with Ferroelectric and Ferromagnetic Layers

Now when the technology is fast developing it is very important to investigate new hybrid structures. One way is to use ferrite ferroelectric layered structures. Theoretical and experimental investigation of such structures was made. These structures have advantages of both layers and it is possible to tune the behavior of this structure by external electric and magnetic field. But these structures have some disadvantages connected with presence of thick ferroelectric layer. One way to overcome this problem is to use slotline. So this is another new way to create hybrid ferrite ferroelectric structures, but it is needed to create new theory and find experimental proof that the behavior of these structures can be tuned with external magnetic and electric fields.

Prehospital ticagrelor in ST-segment elevation myocardial infarction

Background:The direct-acting platelet P2Y receptor antagonist ticagrelor can reduce the incidence of major adverse cardiovascular events when administered at hospital admission to patients with ST-segment elevation myocardial infarction (STEMI). Whether prehospital administration of ticagrelor can improve coronary reperfusion and the clinical outcome is unknown. Methods: We conducted an international, multicenter, randomized, double-blind study involving 1862 patients with ongoing STEMI of less than 6 hours' duration, comparing prehospital (in the ambulance) versus in-hospital (in the catheterization laboratory) treatment with ticagrelor. The coprimary end points were the proportion of patients who did not have a 70% or greater resolution of ST-segment elevation before percutaneous coronary intervention (PCI) and the proportion of patients who did not have Thrombolysis in Myocardial Infarction flow grade 3 in the infarct-related artery at initial angiography. Secondary end points included the rates of major adverse cardiovascular events and definite stent thrombosis at 30 days. Results: The median time from randomization to angiography was 48 minutes, and the median time difference between the two treatment strategies was 31 minutes. The two coprimary end points did not differ significantly between the prehospital and in-hospital groups. The absence of ST-segment elevation resolution of 70% or greater after PCI (a secondary end point) was reported for 42.5% and 47.5% of the patients, respectively. The rates of major adverse cardiovascular events did not differ significantly between the two study groups. The rates of definite stent thrombosis were lower in the prehospital group than in the in-hospital group (0% vs. 0.8% in the first 24 hours; 0.2% vs. 1.2% at 30 days). Rates of major bleeding events were low and virtually identical in the two groups, regardless of the bleeding definition used

Disseny i elaboració d'un gimnàs on-line

L’evolució que ha experimentat la societat, les grans ciutats, la industrialització i molts altres factors han modificat l’estil de vida de les persones accentuant-ne, irremediablement, el sedentarisme i l’abstinència de realitzar exercici físic. La pràctica esportiva i/o d’exercici físic realitzada sota les condicions recomanades pels professionals, és beneficiosa per millorar el nivell de salut o mantenir-lo en tot el possible, ja que provoca modificacions beneficioses sobre el metabolisme, el sistema cardiovascular i l’aparell locomotor. Lamentablement, l’hàbit de realitzar exercici físic no és comú en totes les persones, ja sigui per l’estil de vida que genera incompatibilitats d’horaris amb la feina, fills i familiars o bé per mandra o desgana d’haver d’aprofitar aquelles estones de temps lliure per dedicar-los al culte del cos i de la salut. Els efectes negatius que suposa una modalitat de vida sedentària per a la salut són notablement elevats, amb la qual cosa, cal buscar sistemes per augmentar l’ interès de la població per la pràctica de l’esport i l’activitat física. La creació d’aquest projecte neix de la idea d’unir el fet d’enginyar un mètode per incrementar l’interès de les persones per l’exercici físic amb els avenços tecnològics que s’han realitzat aquesta última dècada relacionats amb el desenvolupament web i multimèdia. A grans trets, la idea general d’aquest projecte es basa en el cas d’un gimnàs real i en actiu, amb necessitat de crear un portal web que serveixi alhora de pàgina web informativa i d’eina de gestió acadèmica del centre proporcionant certes funcionalitats als clients tot presentant-los una nova modalitat de realitzar exercici físic dirigit: realitzar-lo des de casa. Per desenvolupar tot el sistema informàtic que ho durà a terme, després de realitzar una recerca, anàlisi i elecció de les eines mitjançant les quals poder-ho realitzar, s’ha optat per crear l’entorn web mitjançant els llenguatges HTML i PHP en combinació amb els fulls d’estil CSS. Pel que fa a l’entorn de desenvolupament, s’ha utilitzat Notepad++ i com a entorn de proves, WAMP Server. Per últim, pel que fa a la transmissió del contingut multimèdia (vídeos de les sessions d’activitats) s’ha utilitzat Flash Media Interactive Server en combinació de Flash Media Live Encoder per codificar-ne el contingut. L’usuari final, des de qualsevol punt del planeta, podrà realitzar (sempre i quan disposi del temps i el material necessari i una connexió a Internet) en temps real i en directe les classes dirigides que es realitzen al centre. Tanmateix, també s’ha desenvolupat una botiga virtual on qualsevol persona podrà comprar-hi, entre d’altres coses relacionades amb la pràctica de l’exercici físic, tot el material necessari per realitzar qualsevol de les activitats que s’imparteixen al gimnàs i ho rebrà còmodament a casa. Aprofitar unes circumstàncies econòmiques adverses per generar una nova manera de captar clients proporcionant-los una alternativa econòmica, diferent, nova i original d’anar al gimnàs. Temps de crisis, temps d’oportunitats. Aquesta és la moralitat que pretén donar aquest projecte.

Desenvolupament d'una aplicació per a la creació de pressupostos on-line

En aquests moments, el mercat no es troba en una bona situació, per aquest motiu les empreses han de buscar noves maneres de créixer, expandir-se i noves formes d’interactuar amb els clients. La idea original d’aquest projecte sorgeix de la necessitat de disposar d’una manera diferent de promocionar-se i oferir nous serveis a través d’internet mitjançant una pàgina web. Degut a la situació actual, el preu és un aspecte molt important i influent a l’hora de realitzar una obra. Per aquest motiu es va pensar que seria molt interessant que el client pogués demanar de forma fàcil i ràpida un pressupost, i a l’instant tingués un preu orientatiu del que li pot costar la obra. D’aquesta manera l’interessat s’estalvia i agilitza molts passos previs abans de començar una obra. Després d’analitzar quina era la millor manera de portar a terme el projecte informàtic, s’ha determinat que la pàgina web es desenvoluparà utilitzant els llenguatges HTML i PHP combinant-lo amb el framework CodeIgniter. El disseny de la web es realitzarà mitjançant fulles d’estil CSS conjuntament amb el framework BootStrap. Per realitzar l’aplicació web que realitza els pressupostos s’utilitzarà AJAX i jQuery perquè d’aquesta manera el procés sigui dinàmic. L’entorn de desenvolupament escollit és el NetBeans i per provar el projecte s’utilitza el XAMPP. Un usuari només necessitarà un navegador i connexió a internet per fer servir totes les funcions de la web. Podrà realitzar pressupostos, concertar visites, contactar i per suposat veure tota la part informativa de la pàgina

Enhancing Customer Knowledge and Its Sharing At a Paper Production Line

This study has been made for specific paper production line at an international forest industry company in Finland. The main purpose for the study was a need to examine the current situation of the customer knowledge and its’ sharing at case production line, recognize the problems in it and finally, find out the improvement actions. The study is composed of theoretical and empirical parts. In theoretical part, knowledge management and information sharing in addition to customer knowledge management are presented. Empirical data from case production line was collected by using survey questionnaires. The results are analyzed in discussion and conclusions and finally, study ends with summary which includes recommendations. Based on the study, the amount and quality of customer knowledge and gaining and transferring the customer knowledge were found as the main challenges. The proposed solutions were discovered from moving towards more dynamic operating environment and in the area of customer knowledge management, especially from the communities of creation.

Determination of etoricoxib in human plasma using automated on-line solid-phase extraction coupled with LC-APCI/MS/MS

A liquid chromatography-tandem mass spectrometry method with atmospheric pressure chemical ionization (LC-APCI/MS/MS) was validated for the determination of etoricoxib in human plasma using antipyrin as internal standard, followed by on-line solid-phase extraction. The method was performed on a Luna C18 column and the mobile phase consisted of acetonitrile:water (95:5, v/v)/ammonium acetate (pH 4.0; 10 mM), run at a flow rate of 0.6 mL/min. The method was linear in the range of 1-5000 ng/mL (r²>0.99). The lower limit of quantitation was 1 ng/mL. The recoveries were within 93.72-96.18%. Moreover, method validation demonstrated acceptable results for the precision, accuracy and stability studies.