The analysis of the transient temperature distribution of double-slab Nd:YAG laser medium

A novel double-slab Nd:YAG laser, which uses face-pumped slab medium cooled by liquid with different temperatures on both sides, is proposed. The thermal distortion of wavefront caused by the non-uniform temperature distribution in the laser gain media can be self-compensated. According to the method of operation, the models of the temperature distribution and stress are presented, and the analytic solutions for the model are derived. Furthermore, the numerical simulations with pulse pumping energy of 10 J and repetition frequencies of 500 and 1000 Hz are calculated respectively for Nd:YAG laser medium. The simulation results show that the temperature gradient remains the approximative linearity, and the heat stress is within the extreme range. Then the absorption coefficient is also discussed. The result indicates that the doping concentration cannot be too large for the high repetition frequency laser. It has been proved that the high repetition frequency, high laser beam quality, and high average output power of the order of kilowatt of Nd: YAG slab laser can be achieved in this structure.

A kilowatt diode-pumped solid-state heat-capacity double-slab laser

A kilowatt diode-pumped solid state heat capacity laser is fabricated with a double-slab Nd:YAG. Using the theoretical model of heat capacity laser output laser characteristics, the relationships between the output power, temperature and time are obtained. The slab is 59 x 40 4.5mm(3) in size. The average pump power is 11.2kW, the repetition rate is 1kHz, and the duty cycle 20%. During the running time of 1s, the output energy of the laser has a fluctuation with the maximal output energy at 2.06J, and the maximal output average power is 2.06kW. At the end of the second, the output energy declines to about 50% compared to the beginning. The thermal effects can be improved with one slab cooled by water. The experimental results are consistent with calculation data.

110-W fiber laser with homemade double-clad fiber

A high-power ytterbium-doped fiber laser (YDFL) with homemade double-clad fiber (DCF) is introduced in this letter. The geometric parameter and laser characteristics of the fiber have been studied. With one-end-pumping scheme, pumped by a high-power laser diode with launching power of 280 W, a maximum continuous wave (CW) output of 110 W is obtained with an optical-to-optical efficiency of 40%.

Double-cladding Yb3+ fiber for free-space optical communication

The experiment result of Nd:YVO4 laser pumped by laser diode that was amplified by double-cladding Yb3+ fiber is reported. Stable mode-locking pulses are obtained at repetition rate of 320 MHz and the output power is 15 mW. When laser power is amplified by Yb3+- doped double-cladding fiber amplifier, its power can get to 600 mW. Based on these, experiment of double-frequency is carried out, and green laser with power of 4 mW is obtained. (c) 2007 Wiley Periodicals, Inc.

Comparison of Yb-doped fiber laser with one-end and double-end pumping configuration

A high-power Ytterbium-doped fiber laser (YDFL) with homemade double clad fiber (DCF) is introduced in this paper. The output power characteristics of a linear cavity fiber laser have been studied theoretically by solving the rate equations and experimentally tested with single- and double-end-pumping configurations. When both ends of the fiber are pumped by two high-power laser diodes with a launched power of similar to 300 W each, a maximum CW output of 444 W is obtained with a slope efficiency of similar to 75%. (c) 2006 Elsevier Ltd. All rights reserved.

A study of a Q-switched double-clad ytterbium-doped fiber laser with amplifying effect

A high repetition rate ytterbium-doped double-clad (YDDC) fiber laser with amplifying effect is described by using acousto-optic modulator. The characteristic of Q-switched pulses are studied with accurate control of opening gate time of modulator. The stable Q-switched pulses with tens of nanoseconds width can be observed at high repetition rate varied from 50 kHz to 500 kHz using this laser. The stable operation area of the Q-switched fiber laser is discussed and the analysis results agree well with that of the experiment. (c) 2007 Elsevier B.V. All rights reserved.

Structural role of fluoride in aluminophosphate sol-gel glasses: High-resolution double-resonance NMR studies

The local structure of Na-Al-P-O-F glasses, prepared by a novel sol-gel route, was extensively investigated by advanced solid-state NMR techniques. Al-21{F-19} rotational echo double resonance (REDOR) results indicate that the F incorporated into aluminophosphate glass is preferentially bonded to octahedral Al units and results in a significant increase in the concentration of six-coordinated aluminum. The extent of Al-F and Al-O-P connectivities are quantified consistently by analyzing Al-27{P-31} and Al-21{F-19} REDOR NMR data. Two distinct types of fluorine species were identified and characterized by various F-19{Al-27}, F-19{Na-23}, and F-19{P-31} double resonance experiments, which were able to support peak assignments to bridging (Al-F-Al, -140 ppm) and terminal (Al-F, -170 ppm) units. On the basis of the detailed quantitative dipole-dipole coupling information obtained, a comprehensive structural model for these glasses is presented, detailing the structural speciation as a function of composition.

Gain and noise figure of a double-pass waveguide amplifier based on Er/Yb-doped phosphate glass

A waveguide amplifier is fabricated by Ag+-Na+ two-step ion exchange on Er/Yb-doped phosphate glass. The spectroscopic performance of glass and the properties of channel waveguide are characterized. A double-pass configuration is adopted to measure the gain and noise figure (NF) of the waveguide amplifier, and the comparison of gain and NF for the single and double-pass configuration of the waveguide amplifier is presented. The results show that the double-pass configuration can make the gain increase from 8.8dB (net gain 2.2dB/cm) of the single-pass one to 14.6 dB (net gain 3.65 dB/cm) for small input power at 1534 nm, and the NF are all lower than 5.5dB for both the configurations.

Modeling Innovative Power Take-Off Based on Double-Acting Hydraulic Cylinders Array for Wave Energy Conversion

One of the key systems of a Wave Energy Converter for extraction of wave energy is the Power Take-Off (PTO) device. This device transforms the mechanical energy of a moving body into electrical energy. This paper describes the model of an innovative PTO based on independently activated double-acting hydraulic cylinders array. The model has been developed using a simulation tool, based on a port-based approach to model hydraulics systems. The components and subsystems used in the model have been parameterized as real components and their values experimentally obtained from an existing prototype. In fact, the model takes into account most of the hydraulic losses of each component. The simulations show the flexibility to apply different restraining torques to the input movement depending on the geometrical configuration and the hydraulic cylinders on duty, easily modified by a control law. The combination of these two actions allows suitable flexibility to adapt the device to different sea states whilst optimizing the energy extraction. The model has been validated using a real test bench showing good correlations between simulation and experimental tests.

Environmental taxes and the Double dividend hypothesis

In this End of Degree Dissertation I built a basic economic model, where two perfectly competitive markets interact, as a tool to understand, illustrate and evaluate environmentalfiscal reforms that have already been implemented or have been announced in many developed countries. Thus, in this dissertation I try to explain as simply as possible the theorical aspects of the “double dividend” hyphotesis and provide a numerical example with illustrative purpose.

As histórias de coletivos para uma psicologia brasileira contemporânea

Este trabalho pretende problematizar as concepções de coletivo que se apresentam nos discursos da psicologia brasileira contemporânea. Tomamos como campo os artigos da revista Psicologia e Sociedade e construímos duas imagens: a imagem do coletivo representação é acompanhada por concepções naturalizantes das categorias com as quais trabalha. Nesta imagem de coletivo a separação entre indivíduo e sociedade é bem marcada e acaba produzindo construções abstratas dos seus fenômenos. Ao percorrer uma breve história da psicologia vemos esta surgir como uma tecnologia voltada para a ?gestão? dos coletivos, construindo e reproduzindo conhecimentos acerca dos indivíduos e do social. A imagem dos coletivos clandestinos é pautada em referências que desestabilizam as fronteiras impostas das ciências modernas e concebem tanto o indivíduo quanto o social efeito de uma produção simultânea, problematizando as fprmas de cpnhecimento das ciências tradicionais. A metodologia conta com a perspectiva histórica de Michel Foucault que afirma a primazia das relações de poder, e com as contribuições de Bruno Latour e suas conexões criando hibridismos. A proposta metodológica foi um importante instrumento ara romper com as barreiras separatistas, acentuando a presença do pesquisadpr como participante igual aos outros elementos do campo de pesquisa, enfatizando que o modo de pesquisar é com o outro e não sobre o outro. Desta forma As histórias de coletivos para uma psicologia brasileira pretende desnaturalizar modos de produzir conhecimento e categorias de coletivos herméticas. Para finalizar entre formas de fazer e perceber o coletivo temos o trabalho de campo atravessado pordois sociólogos, Emile Durkheim e Gabriel Tarde, contribuindo com as problematizações dos coletivos representação e clandestinos. Gabriel Tarde contribui produzindo uma concepção de coletivo processual, onde a imitação e a invenção ressaltam o caráter relacional do indivíduo e do social e os coloca numa produção de dupla emergência.

Double proximity effect in lateral S-NF-S junctions

We investigate planar Josephson junctions where the intermediate spacer between the two superconductors is an hybrid structure made by a normal metal and a ferromagnet. The different behaviors of the S-N-S junctions with thicknesses of 50 nm in both Cu and Nb layers, and S-N/F-S junctions with 10 nm of Co, 50 nm of Cu and 50 nm of Nb are studied. In this way, we analyze the influence of the ferromagnetic exchange interaction on the proximity effect. A dramatic supression of the josephson critical current of the Nb-(Cu/Co)-Nb junctions is observed. We believe that the reason for this is due to the length scale of the superconducting correlations of the electrons and holes of the weak link is larger than the thickness of Cu/Co bilayer.

Double layers in gravity theories

Gravitational double layers, unlike their classical electromagnetic counterparts, are thought to be forbidden in gravity theories. It has been recently shown, however, that they are feasible in, for instance, gravity theories with a Lagrangian quadratic in the curvature. This is surprising with many potential consequences and the possibility of new physical behaviours. While a clear interpretation seems elusive, several lines of research are open. I present the field equations for double layers, the new physical quantities arising, and several explicit examples