连续碳纤维增强的聚芳醚酮在Ⅰ型循环载荷下的层间破坏

用双悬臂梁(DCB)试件研究了连续碳纤维增强的聚芳醚酮复合材料(CF/PEK-C),在Ⅰ型循环载荷作用下的层间裂纹扩展行为.循环载荷采用载荷控制模式,最小载荷与最大载荷之比为0.5.在疲劳试验中,仍然发现有“阻力曲线”现象存在.层间裂纹扩展速率用指数定律与相应的应变能释放速率联系起来,并对结果进行了讨论.

ELECTROCHEMICAL STUDY OF ISOPOLY AND HETEROPOLY OXOMETALLATE FILM MODIFIED MICROELECTRODES .5. PREPARATION AND ELECTROCHEMICAL-BEHAVIOR OF A 2/18-MOLYBDODIPHOSPHATE ANION MONOLAYER MODIFIED ELECTRODE

In this paper a carbon fibre (CF) microelectrode modified with the 2:18-molybdodiphosphate anion by simple adsorption is described and its electrochemical behaviour is reported. The 2:18-molybdodiphosphate anion (alpha-P2Mo18O626-), which is a Dawson structure, undergoes five successive multielectron reductions in acidic solution. The first three redox waves correspond to the two-electron process, and the last two waves are four-electron and six-electron processes respectively. On the basis of the experimental results it is shown that the electrode process of alpha-P2Mo18O626- on the CF electrode in acidic solution is simultaneously controlled by the diffusion and adsorption of alpha-P2Mo18O626- anions. When the concentration of the alpha-P2Mo18O626- in the solution is reduced, the electrode process mainly exhibits non-diffusion-controlled behaviour, and the diffusion-limited process takes over as the concentration of alpha-P2Mo18O626- becomes higher. The CF electrode modified with a thin film of alpha-P2Mo18O626- exhibits very good stability and redox behaviour in aqueous acidic solution. The alpha-P2Mo18O626- is reduced to heteropoly blue, with an accompanying protonation process. The addition of more than six electrons to the alpha-P2Mo18O626- anion in an aqueous solution does not result in its decomposition. The result obtained is not the same as that reported previously.

ELECTROCHEMICAL STUDY OF ISOPOLY-OXOMETALLATE AND HETEROPOLY-OXOMETALLATE FILM MODIFIED MICROELECTRODES .2. ELECTROCHEMICAL-BEHAVIOR OF ISOPOLYMOLYBDIC ACID MONOLAYER MODIFIED CARBON-FIBER MICROELECTRODES

In this paper the electrochemical properties of isopolymolybdic anion thin film modified carbon fibre (CF) microelectrode prepared by simple dip coating have been described. The modified electrode shows three couples of surface redox waves between + 0.70 and - 0.1 V vs. sce in 2 M H2SO4 solution with good stability and reversibility. The pH of solution has a marked effect on the electrochemical behaviour and stability of the film, the stronger the acidity of electrolyte solution is, the better the stability and reversibility of isopolymolybdic anion film CF microelectrode will be. The scanning potential range strongly influences on the electrochemical behaviour of the film. The isopolymolybdic anion film prepared by the dip coating resulting a monolayer with estimated surface concentration (F) 2.8 x 10(-11) mol cm-2. From the half-peak widths and peak areas of the surface redox waves of the film electrode, the first three surface waves are corresponding to two-electron processes. The electron energy spectra show the products by six electrons reduction are a mixture of Mo(VI) and Mo(V) species. The electrochemical reaction of the isopolymolybdic anion monolayer can be expressed as Mo8O264- + mH+ + 2ne half arrow right over half arrow left [HmMo8-2n(VI)Mo2n(V)O26](4,2n-m)-n = 1, 2, 3; m = 2, 5, 7.

XPS STUDY OF RADIATION CROSS-LINKED COPOLYMER OF TETRAFLUOROETHYLENE WITH HEXAFLUOROPROPYLENE

In this work the radiation-induced structural changes in F-46 were studied by XPS. In carbon-1s spectra of a highly crosslinked F-46 sheet, the slight increase observed in relative area under the peak due to CF3 was explained by the radiation-induced scission of polymer chains. The peak at 287.6 eV appearing in the spectra caused by ionizing radiation was attributed to carbon structures without primary fluorine substituents, in both branching and unsaturated structures, while that at 289.3 eV was assigned to = CF groups in mid-chain double bonds.

ELECTROCHEMICAL STUDY OF ISOPOLYOXOMETALLATES AND HETEROPOLYOXOMETALLATES FILM MODIFIED MICROELECTRODES .1. PRETREATMENT AND MODIFICATION OF THE MO80-26(4-) MODIFIED CARBON-FIBER MICROELECTRODE

In this paper the preparation of isopoly- and heteropolyoxometallates (IPA and HPA) thin film modified carbon fiber (CF) microelectrodes and the factor that influences the modification of IPA and HPA films are described. IPA and HPA film modified CF microelectrodes can all be prepared by cyclic potential scan and simple dip coating. The modified electrodes prepared are very stable and reversible in acidic solution with monolayer characteristics. The electrochemical pretreatment of CF microelectrodes plays an important role in the modification of IPA and HPA film. The absorption of IPA and HPA film on electrode surfaces has been discussed on the basis of surface conditions of the CF microelectrode and the structure of IPA and HPA.

同多酸和杂多酸修饰微电极的电化学研究——Ⅳ.1:2-磷钼杂多酸薄膜修饰碳纤维微电极的制备和电化性质

本文报道了1:12-磷铜杂多酸(PMo_(12)薄膜修饰碳纤维(CF)微电极的制备及其电化学性质。采用简单,快速的浸渍吸附制备的PMo_(12)薄膜修饰CF���极在酸性介质中具有很高的稳定性和氧化还原活性,电解质溶液的pH值和扫描电位范围对PMo_(12)膜的稳定性和电化学性质产生较大的影响。另一方面,PMo_(12)薄膜修饰CF���电极对酸性水溶液中的PMo_(12)和氯酸根离子(ClO)_3~-)的电催化还原作用也进行了描述。

AN ELECTROCHEMICAL MICROSENSOR FOR CHLORIDE

The potential-response of a microdisk electrode made with a chloride-doped polypyrrole (PPY) film on a carbon fibre (CF) has been examined. The effect of the polymerization conditions on the response characteristics is discussed. The optimum conditions for preparing the electrode are: cycling potential from +0.8 to +1.0 V in 0.1-0.2M pyrrole (Py) containing 0.1M LiCl, electropolymerization time 15-20 min. The electrode gives a Nernstian response of 56-58 mV/pCl and a detection limit of 3.6 x 10(-5)M chloride. It has the advantages of low resistance, short conditioning time and fast response. It has been used satisfactorily for detection of chloride in serum.

STUDIES ON RADIATION EFFECTS OF PTFE .2. RADIATION-INDUCED STRUCTURAL-CHANGES AND THE TEMPERATURE EFFECT

In this work PTFE sheets irradiated with gamma-rays at 150-degrees-C and 200-degrees-C were studied using x-ray photoelectron spectroscopy (XPS). The main structural changes in PTFE due to radiation are the formation of CF3 and CF groups. An irradiation temperature dependence of the relative content of the three kinds of groups in irradiated PTFE was observed. The CF3 groups, especially when irradiation is carried out a lower temperatures, can defluorinate in the same manner as previosly reported for CF2 groups. The CF groups, on the other hand, are observed to increase with increasing irradiation dose and irradiation temperature; the latter was explained as due to an increase in branching structures.

连续碳纤维增强的聚芳醚酮复合材料的层间破坏

用双悬臂梁和端开口弯曲试件分别研究了连续碳纤维增强的聚芳醚酮复合材料(CF/PEK-C)的Ⅰ型和Ⅱ型的层间破坏。CF/PEK-C的Ⅰ型层破坏的线弹性断裂判据G_(Ⅰc)和弹塑性断裂判据J_(Ⅰc)分别为0.69KJ/m~2且与裂纹长度无关。CF/PEK-C的Ⅱ型层间破坏的稳定性,与裂纹和半距之比α/L有关。当α/L小于0.7时,表现为不稳定的Ⅱ型层间破坏的断裂韧性G_(Ⅱc)为1.62KJ/m~2。当α/L大于0.7时,则为稳定的Ⅱ型层间破坏。此时的G_(Ⅱc)与临界点的选择有关。由亚临界点和0.95点法得出的G_(Ⅱc)值分别为1.73和2.74KJ.M~2。

Improving Ship Detection with Polarimetric SAR based on Convolution between Co-polarization Channels

The convolution between co-polarization amplitude only data is studied to improve ship detection performance. The different statistical behaviors of ships and surrounding ocean are characterized a by two-dimensional convolution function (2D-CF) between different polarization channels. The convolution value of the ocean decreases relative to initial data, while that of ships increases. Therefore the contrast of ships to ocean is increased. The opposite variation trend of ocean and ships can distinguish the high intensity ocean clutter from ships' signatures. The new criterion can generally avoid mistaken detection by a constant false alarm rate detector. Our new ship detector is compared with other polarimetric approaches, and the results confirm the robustness of the proposed method.