大兴安岭北坡火后紫貂冬季生境恢复研究(英文)

由自然和人为原因引起的生境丧失与生境破碎化已严重影响到野生动物的生存。大兴安岭北坡是国家一级保护动物紫貂(Marteszibellina)的主要分布区,1987年发生在这里的特大森林火灾造成了森林景观的严重破碎化,紫貂的生存面临极大的威胁。本文的研究目的是为了确定火灾13年后,紫貂冬季生境的恢复程度。首先根据紫貂对冬季生境的喜好选取对其生存影响较大的生态因子,结合数字化林相图,利用地理信息系统软件ArcGIS编制火烧前后的生境适宜性类型图。然后选取相关的景观格局指标,对火灾烧前后的生境格局进行对比分析。结果显示:尽管火后采取了一系列的森林恢复措施,但紫貂冬季适宜生境仍有大幅度减少,特别是中等适宜生境类型减少最为明显。适宜生境破碎化加剧,隔离度增加。适宜生境斑块的形状趋于简单,软边界比重有所增加。以上结果表明,与火前相比,紫貂生境明显恶化,需要较长的时间恢复。图4表5参41。

科尔沁西部碱化草甸草地改良配套技术试验研究

对科尔沁西部典型重度碱化草地进行了改良试验研究,采用的方法包括翻耙补播沙打旺Astragalus adsurgens、施N肥、施土壤改良剂(石膏)。经过3年改良试验,结果表明,这些技术的有机结合可以显著地提高碱化草甸草地牧草的产量和质量,土壤理化性质明显改善:翻耙补播沙打旺增加草地产量2.18-3.52倍;土壤容重、pH值、含盐量下降;土壤水分状况、孔隙度、有机C、全N、速效N、速效P等均明显增加;在翻耙补播的基础上施用(NH4)2SO475-225 kg/hm2和CaSO41 500-4 500 kg/hm2,牧草产量可分别提高4.5%-20.2%和17.4%-49.9%。

一种改进的统计机器翻译系统融合方法

本文提出一种基于一致性网络和最小贝叶斯风险联合解码的统计机器翻译系统融合方法。首先利用N-best译文集合建立一致性网络,从一致性网络产生的新译文中选出得分最高的前N个译文,然后从这N个候选译文中选出具有最小贝叶斯风险的译文作为最佳译文．实验结果表明这种方法比直接使用一致性网络解码算法在BLEU-SBP上的表现要好。

不同氮磷施肥量对玉米生育期土壤微生物量的影响

通过田间小区试验研究了不同N、P施肥量对玉米生育期土壤微生物量C、N、P的影响。结果表明,不同N、P施肥量对微生物量C无明显影响;施N肥量高(225km/hm~2)时降低微生物量N;当施P肥达225 km/hm~2时则对微生物量P产生明显的抑制作用。

农村水塘系统对非点源水污染的调控作用研究

以辽阳市沙岭镇大闯屯村为例,对北方平原地区农村水塘系统污染现状、非点源污染物的迁移途径、控制方法进行了初步研究,研究结果表明,农田径流与村落生活污水的排放方式对农村地表水环境质量具有重要影响,进行合理的生态设计,充分利用自然净化单元,对改善地表水环境质量将会起到积极的作用。

农田防护林木材材质物理特性研究

对早柳和小青杨的年轮宽度、年轮密度、木材纤维长度和干缩率及其径向变异进行了研究．结果表明，木材物理特性受年轮年龄的影响显著，而纤维长度不受年轮宽度影响．综合材质物理特性的径向变异规律，可将旱柳和小青杨整个生长期划分为４个时期：幼林期、速生期、成熟期和更新期，确定了各生长期的年龄值．

热解吸-气相色谱法测定植物源挥发性有机物

以Tenax-TA、Carboxen 1000和Carbosieve SⅢ为采样管填充料,将植物源挥发性有机物吸附于采样管内,样品通过二次热解吸仪解吸后,随载气进入气相色谱仪,采用氢火焰离子化检测器(FID)测定,建立了利用二次热解吸仪与气相色谱联用技术测定植物挥发性有机物的分析方法。载气N2流速为30 mL/min,60℃下吹扫吸附管2 min,然后在250℃下解吸吸附管5 min,冷却1 min后,在275℃下解吸聚焦管3 min,样品经传输线进入气相色谱。气相色谱载气N2压力为190 kPa,FID检测器温度280℃;进样口温度225℃;初始柱温40℃,停留5 min,以2℃/min升温至120℃,保留1 min,然后以20℃/min升温至200℃,保留10 min。方法重现性好,精密度高,线性相关系数大于0.99;检出限均低于9×10-9g/L;解吸效率大于96%,适用于植物源挥发性有机物的测定。

中巴地球资源卫星在辽东区域环境监测中的应用评价研究

对中巴资源一号卫星 CCD传感器接收的辽宁省营口幅数据 ,从几何精度、空间分辨率、数据噪声等方面 ,进行了图像数据质量评价 ,认为从总体上讲 ,达到了设计要求 ,具有广阔的应用前景 ,同时指出 ,CCD传感器在稳定性和同一性方面尚需改进

Size-controlled synthesis and characterization of quantum-size SnO2 nanocrystallites by a solvothermal route

By using ethylenediamine as both an alkali and ligand, quantum size SnO2, nanocrystallites were synthesized with a solvothermal route. The transmission electron micrographs (TEM) were employed to characterize the morphologies of the products. The crystal sizes of the as-synthesized SnO2 were ranged form 2.5 to 3.6 nm. The crystal structure and optical properties of the products were investigated by X-ray diffraction, Fourier transform infrared spectroscopy, optical absorption spectra, photoluminescence and Raman spectra.

First principles investigation on the structural, mechanical and electronic properties of OsC2

The structural, mechanical and electronic properties Of OsC2 were investigated by use of the density functional theory. Seven structures were considered, i.e., orthorhombic Cmca (No. 12, OsSi2), Pmmn (No. 59, 002) and Pnnm (No. 58, OsN2); tetragonal P4(2)/mnm (No. 136, OsO2) and 14/mmm (No. 139, CaC2); cubic Fm-3m (No. 225, CaF2) and Pa-3 (No. 205, PtN2). The results indicate that Cmca in OsSi2 type structure is energetically the most stable phase among the considered structures. It is also stable mechanically. OsC2 in Pmmn phase has the largest bulk modulus 319 GPa and shear modulus 194 GPa. The elastic anisotropy is discussed. (C) 2009 Elsevier B.V. All rights reserved.

Chitosan(Chitin)/Cellulose Composite Biosorbents Prepared Using Ionic Liquid for Heavy Metal Ions Adsorption

Chitosan(chitin)/cellulose composites as biodegradable biosorbents were prepared under an environment-friendly preparation processes using ionic liquids. Infrared and X-ray photoelectron spectra indicated the stronger intermolecular hydrogen bond between chitosan and cellulose, and the hydroxyl and amine groups were believed to be the metal ion binding sites. Among the prepared biosorbents, freeze-dried composite had higher adsorption capacity and better stability. The capacity of adsorption was found to be Cu(II) (0.417 mmol/g) > Zn(II) (0.303 mmol/g) > Cr(VI) (0.251 mmol/g) > Ni(II) (0.225 mmol/g) > Ph(II) (0.127 mmol/g) at the same initial concentration 5 mmol L-1. In contrast to some other chitosan-type biosorbents, preparation and component of the biosorbent were obviously more environment friendly. Moreover, adsorption capacity of chitosan in the blending biosorbent could be fully shown.

Online study of the formation of PA6 droplets in PP matrix under shear flow

Breakup process of polyamide 6 (PA6) in polypropylene (PP) matrix under shear flow was online studied by using a Linkam CSS 450 stage equipped with optical microscopy. Both tip streaming and fracture breakup modes of PA6 droplets were observed in this study. It was reported that the droplet would break up by tip streaming model when the radio of the droplet phase viscosity to the matrix phase viscosity (n(r) = n(d)/n(m)) is smaller than 0.1 (Taylor, Proc R Soc London A 1934, 146, 501; Grace, Chem Eng Commun 1982, 14, 225; Bartok and Mason, J Colloid Sci 1959, 14, 13; Rumscheidt and Mason, J Colloid Sci 1961, 16, 238; de Bruijn, Chem Eng Sci 1993, 48, 277). However, the tip streaming model was observed even when the viscosity ratio was much greater than 0.1 (n(r) = 1.9). In this study for the tip streaming mode, small droplets were ruptured from the tip of the mother droplet. On the other hand, the mother droplet was broken into two or more daughter droplets with one or several satellite droplets between them for the fracture mode. It was found that PA6 droplet was much elongated at first, and then broke up via tip streaming or fracture to form daughter droplets or small satellite droplets with the shape of fiber or ellipse.