Application of WRF-Chem to Forecasting PM10 Concentration Over Poland

The meteorological and chemical transport model WRF-Chem was implemented to forecast PM10 concentrations over Poland. WRF-Chem version 3.5 was configured with three one-way nested domains using the GFS meteorological data and the TNO MACC II emissions. The 48 hour forecasts were run for each day of the winter and summer period of 2014 and there is only a small decrease in model performance for winter with respect to forecast lead time. The model in general captures the variability in observed PM10 concentrations for most of the stations. However, for some locations and specific episodes, the model performance is poor and the results cannot yet be used by official authorities. We argue that a higher resolution sector-based emission data will be helpful for this analysis in connection with a focus on planetary boundary layer processes in WRF-Chem and their impact on the initial distribution of emissions on both time and space.

Agreed-upon procedures report on the City of Mount Ayr, Iowa for the period July 1, 2014 through June 30, 2015

Agreed-upon procedures report on the City of Mount Ayr, Iowa for the period July 1, 2014 through June 30, 2015

Multi-Scale Dynamic Study of Secondary Impact During Drop Testing of Surface Mount Packages

This dissertation focuses on design challenges caused by secondary impacts to printed wiring assemblies (PWAs) within hand-held electronics due to accidental drop or impact loading. The continuing increase of functionality, miniaturization and affordability has resulted in a decrease in the size and weight of handheld electronic products. As a result, PWAs have become thinner and the clearances between surrounding structures have decreased. The resulting increase in flexibility of the PWAs in combination with the reduced clearances requires new design rules to minimize and survive possible internal collisions impacts between PWAs and surrounding structures. Such collisions are being termed ‘secondary impact’ in this study. The effect of secondary impact on board-level drop reliability of printed wiring boards (PWBs) assembled with MEMS microphone components, is investigated using a combination of testing, response and stress analysis, and damage modeling. The response analysis is conducted using a combination of numerical finite element modeling and simplified analytic models for additional parametric sensitivity studies.

Environmental factors affecting soil metals near outlet roads in Poznan, Poland: impact of grain size, soil depth, and wind dispersal

We determined the Cd, Cr, Cu, Ni, Pb, and Zn concentrations in soil samples collected along the eight main outlet roads of Poznan. Samples were collected at distances of 1, 5, and 10 m from the roadway edges at depth intervals of 0-20 and 40-60 cm. The metal content was determined in seven grain size fractions. The highest metal concentrations were observed in the smallest fraction (<0.063 mm), which were up to four times higher than those in sand fractions. Soil Pb, Cu, and Zn (and to a lesser extent Ni, Cr, and Cd) all increased in relation to the geochemical background. At most sampling sites, metal concentrations decreased with increasing distance from roadway edges and increasing depth. In some locations, the accumulation of metals in soils appears to be strongly influenced by wind direction. Our survey findings should contribute in predicting the behavior of metals along outlet road, which is important by assessing sources for further migration of heavy metals into the groundwater, plants, and humans.

Depositional conditions on an alluvial fan at the turn of the Weichselian to the Holocene – a case study in the Żmigród Basin, southwest Poland

Presented are the results of research into the fluvio-aeolian sedimentary succession at the site of Postolin in the Żmigród Basin, southwest Poland. Based on lithofacies analysis, textural analysis, Thermoluminescence and Infrared-Optical Stimulated Luminescence dating and GIS analysis, three lithofacies units were recognised and their stratigraphic suc- cession identified: 1) the lower unit was deposited during the Pleni-Weichselian within a sand-bed braided river fun- ctioning under permafrost conditions within the central part of the alluvial fan; 2) the middle unit is the result of aeolian deposition and fluvial redeposition on the surface of the fan during long-term permafrost and progressive decrease of humidity of the climate at the turn of the Pleni- to the Late Weichselian; 3) the upper unit accumulated following the development of longitudinal dunes at the turn of the Late Weichselian to the Holocene; the development of dunes was interrupted twice by the form being stabilised by vegetation and soil development.

Factors influencing temporal changes in chemical composition of biogenic deposits in the middle Tążyna River Valley (Kuyavian Lakeland, central Poland)

The present paper discusses the influence of geochemical properties on biogenic deposits in the Wilkostowo mire near Toruń, central Poland. The analysed core has allowed the documentation of environmental changes between the older part of the Atlantic Period and the present day (probably interrupted at the turn of the Meso- and Neoholocene). In order to reconstruct the main stages in the sedimentation of biogenic deposits, we have used stratigraphic variability of selected litho-geochemical elements (organic matter, calcium carbonate, biogenic and terrigenous silica, macro- and micro-elements: Na, K, Mg, Ca, Fe, Mn, Cu, Zn, Pb, Cr and Ni). The main litho-geochemical component is CaCO 3 ; its content ranges from 4.1 per cent to 92 per cent. The variability of CaCO 3 content reflects mainly changes in hydrolog- ical and geomorphological conditions within the catchment area. The effects of prehistoric anthropogenic activities in the catchment of the River Tążyna, e.g., the use of saline water for economic purposes, are recorded in a change from calcareous gyttja into detritus-calcareous gyttja sedimentation and an increased content of lithophilous elements (Na, K, Mg and Ni) in the sediments. Principal component analysis (PCA) has enabled the distinction the most important factors that affected the chemical composition of sediments at the Wilkostowo site, i.e., mechanical and chemical den- udation processes in the catchment, changes in redox conditions, bioaccumulation of selected elements and human activity. Sediments of the Wilkostowo mire are located in the direct vicinity of an archaeological site, where traces of intensive settlement dating back to the Neolithic have been documented. The settlement phase is recorded both in li- thology and geochemical properties of biogenic deposits which fill the reservoir formed at the bottom of the Parchania Canal Valley.

Isotope characterisation of deep aquifers in the Gwda catchment, northern Poland

We present the results of isotope measurements (δ 18 O, δ D, δ 13 C DIC and 14 C) and chemical analyses (TDS, TOC, HCO 3– , SO 42– , Cl – , NO 3– , NH 4+ , Ca 2+ , Mg 2+ Na + and K + ) conducted on groundwater samples collected from deep Cenozoic aqui- fers. These aquifers are the basic source of drinking water at numerous localities within the study area in northern Po- land. Most of the δ 18 O determinations are characterised by low variability (i.e., > 70 per cent of δ 18 O are between –9.5‰ and –9.2‰). In most cases tritium activity was not detected or its content slightly exceeded the uncertainty of measure- ment (from ±0.3 T.U. to ± 0.5 T.U.). On average, 14 C activity is twice higher than that under similar conditions and in hydrogeological systems. The δ 13 C DIC values fall within the –13.6‰ to –12.8‰ range. A slight variability is observed when considering all isotope and chemical data within the study area and under these hydrogeological conditions. In general, the results of isotope and chemical analyses seem to be homogeneous, indicating the presence of closely similar groundwaters in the system, irrespective of geological formation. It is likely that there is a significant hydraulic connec- tion between shallow and deep aquifers in the Gwda catchment, which indicates the potential for seepage of pollutants from shallow Pleistocene to deep Miocene aquifers. This can endanger the latter by e.g., high concentrations of NO 3– , SO 42– and Cl – ions from shallow aquifers within the Gwda catchment.

Analyses of permeability and porosity of sedimentary rocks in terms of unconventional geothermal resource explorations in Poland

Petrophysical investigations are fundamental to natural resource exploration. In order to recognise the geothermal potential of sedimentary rocks in central Poland, 259 samples were collected from prospective deep-lying geothermal reservoirs. Parameters measured include bulk density, skeletal density, effective porosity, permeability, average pore diameter and specific surface. Results indicate that at great depths (mostly > 3,000 m below surface) sedimentary rocks show low values of porosity (mainly less than 5%) and permeability (only sporadically in excess of 1 md). These values call for a petrothermal use of reservoirs, for which an Enhanced Geothermal System (EGS) was developed. Reser- voirs suited for the EGS are Carboniferous and Lower Triassic sandstones in the central part of Poland (Mogilno-Łódź Trough region and a small part of the Kujawy Swell and Fore-Sudetic regions). In addition, Carboniferous limestones in this area are potentially prospective.

Learning by failure in entrepreneurship - Case study of selling Xylitol to Poland

My thesis aim is to find out what factors that can explain the entrepreneurial failure in my own entrepreneurial venture to sell Finnish xylitol product to Poland. In addition I seek to answer to the question of why Finnish xylitol products are not sold in Poland. This area has not been studied prior to my thesis. The study method is case study. Data collection is based on auto-ethnographic method where field notes and documents generated from my business venture were used. I discovered that Polish consumers are not exposed to consumer education of xylitol health benefits. The underlying potential in xylitol products expansion from Finland to foreign countries is still mostly unleveraged. My business venture failed because I was not able to convince Finnish confectionery companies Fazer and Cloetta to give enough support for my project. Polish dentists were also opposed having a competitor from Finland to Wrighley company which dominates the Polish confectionery markets.

Energy efficiency and appliance’s characteristics considered prior to purchase: Differences and similarities between the United Kingdom, Germany, Portugal, Greece, Poland, Spain and Italy

This article reports country differences in the consumer’s most considered characteristics when choosing electrical appliances, including but not restricted to the energy efficiency aspect. A survey was performed to store customers from 7 countries: the United Kingdom; Germany; Portugal; Greece; Poland; Spain; Italy. Results showed consistency between countries in the top three characteristics considered: cost; quality; and a balance between price and quality. Differences were found for reported environmental attitudes and behaviours, purchase motives, and store employees evaluation. The results may support national policies and store level energy efficiency interventions. Specifically, they can provide input for store employee’s training, in persuading customers towards the purchase of energy efficient appliances.

Pontic Influence In The Territory Of Present-Day Poland As Illustrated By Leafshaped Points Without A Marked Tang

This publication constitutes the fruits of National Science Centre research projects (grant no 2011/01/M/HS3/02142 – 6 articles) and the National Programme for the Development of the Humanities (grant no 0108/NPH3/H12/82/2014 – 3 articles). We would like to acknowledge and at the same time express our sincere gratitude for the generosity shown by the following at the Adam Mickiewicz University in making this publication possible: the Dean of the Department of History, Institute of Pre-history and the Eastern Institute.

Interpreting Poland

The paper aims to interpret the political situation in Poland after 2015 double elections in terms of non-Marxian historical materialism. According to presented interpretation the taking power by Law and Justice Party not only limits the scope of influence of the previous ruling party but can lead to significant redistribution of political power, economic profits and intellectual influence. In the last part of paper, the prognosis about future development of situation in Poland is proposed