Evidence for u.v. induction of CDKN2 mutations in melanoma cell lines

The CDKN2 gene, encoding the cyclin dependent kinase inhibitor p16, is a tumour suppressor gene involved in melanoma and maps to chromosome band 9p22. Mutations or interstitial deletions of this gene have been found both in the germline of familial melanoma cases and somatically in melanoma cell lines. Previous mutation analyses of melanoma cell lines have indicated a high frequency of C:G to T:A transitions, with all of these mutations occurring at dipyrimidine sites. Including three melanoma cell lines carrying tandem CC to TT mutations, the spectrum of mutations so far reported indicates a possible role for u.v. radiation in the mutagenesis of this gene in some tumours. To further examine this hypothesis we have characterised mutations of the CDKN2 gene in 30 melanoma cell lines. Nineteen lines carried complete or partial homozygous deletions of the gene. Of the remaining cell lines, eight were shown by direct sequencing of PCR products from exon 1 and exon 2 to carry a total of nine different mutations of CDKN2. Two cell lines carried tandem CC to TT mutations and a high rate of C:G to T:A transitions was observed. This study provides further evidence for the role of u.v. light in the genesis of melanoma, with one target being the CDKN2 tumour suppressor gene.

Demonstration of cellulosic ethanol production from sugarcane bagasse in Australia : the Mackay Renewable Biocommodities Pilot Plant

The ready availability of sugarcane bagasse at an existing industrial facility and the potential availability of extra fibre through trash collection make sugarcane fibre the best candidate for early stage commercialisation of cellulosic ethanol technologies. The commercialisation of cellulosic ethanol technologies in the sugar industry requires both development of novel technologies and the assessment of these technologies at a pre-commercial scale. In 2007, the Queensland University of Technology (QUT) received funding from the Australian and Queensland Governments to construct a pilot research and development facility for the production of bioethanol and other renewable biocommodities from biomass including sugarcane bagasse. This facility has been built on the site of the Racecourse Sugar Mill in Mackay, Queensland and is known as the Mackay Renewable Biocommodities Pilot Plant (MRBPP). This research facility is capable of processing cellulosic biomass by a variety of pretreatment technologies and includes equipment for enzymatic saccharification, fermentation and distillation to produce ethanol. Lignin and fermentation co-products can also be produced in the pilot facility.

Exploring the process of implementing a smoking cessation intervention in pregnancy training program for midwives

The question of how to implement evidence effectively reveals a deficiency in our knowledge and understanding of the compound factors involved in such a process (Kitson, Rycroft-Malone et al. 2008). Although there is some awareness of the complexities of the process, there has been little exploration of the effectiveness of implementing evidence-based programs in health care. Despite public awareness of the dangers of smoking in pregnancy, and widespread public health measures to prevent smoking-related disease, women still continue to smoke in pregnancy (Ananth, Savitz et al. 1997; Laws and Hilder 2008). Evaluation of public health measures concludes that smoking cessation interventions during pregnancy increase quit rates among pregnant women (Melvin, Dolan-Mullen et al. 2000; Albrecht, Maloni et al. 2004; Lumley, Oliver et al. 2007). Notwithstanding the potential for improvement in health outcomes for pregnant women and their unborn babies, smoking interventions are often conducted poorly or not at all. Although midwives understand why women smoke in pregnancy and parenthood and are aware of the risks of smoking to both the pregnancy and the unborn child, they require specific knowledge and skills in the provision of support and advice on smoking for pregnant women (Bull and Whitehead 2006) . Organisational-change research demonstrates the complexity of the process of planned change in professionalised institutions such as health care (Greenhalgh, Robert et al. 2005). Some innovations and interventions are never accepted, and others are poorly supported (Greenhalgh, Robert et al. 2004). Comprehension of the change process around health promotion is crucial to the implementation of new health promotion interventions within health care (Riley, Taylor et al. 2003). This study utilised a case study approach to explore the process of implementing a smoking cessation training program for midwives in Queensland metropolitan and regional clinical areas, who attended a ‘Train-the-Trainer program’. The study draws on the organisational change work of Greenhalgh et al (2004) as the theoretical framework through which situational and structural factors are explored and examined as they inform the implementation of smoking cessation programs. The research data constituted staged interviews with midwives who instituted training programs for midwives, as well as organisational and policy documentation. Analysis of the data identified some areas that were not fully addressed in the theoretical model; these formed the basis of the Discussion and Implications for Future Research.

The QUTeach@Redcliffe program

The QUTeach@Redcliffe program enables senior secondary students from a disadvantaged region of Queensland to commence teacher education degrees while completing school. Introduced in mid-2008, QUTeach is a collaboration between Queensland University of Technology and Queensland’s Bays Cluster of State High Schools. It is currently in pilot form. The program emerged as the result of equity concerns in relation to students who face barriers to university entrance, in terms of social, racial or financial disadvantage. It was also motivated by a desire to generate a stream of new teachers who come from the region and understand its circumstances, and who can relate well to the school students they teach. Rather than learning as individuals on a university campus, students in the program are taught as a class so that they can learn from one another as well as from their instructors. The classes are conducted two evenings per week on the premises of Redcliffe State High School, which is more familiar and easier to access than the university campus. However, the students also attend the QUT’s Kelvin Grove campus one or two days each semester to familiarise themselves with the university environment and participate in lectures on campus.

Investigation of the effect of organics on the water uptake of marine aerosols

Water uptake refers to the ability of atmospheric particles to take up water vapour from the surrounding atmosphere. This is an important property that affects particle size and phase and therefore influences many characteristics of aerosols relevant to air quality and climate. However, the water uptake properties of many important atmospheric aerosol systems, including those related to the oceans, are still not fully understood. Therefore, the primary aim of this PhD research program was to investigate the water uptake properties of marine aerosols. In particular, the effect of organics on marine aerosol water uptake was investigated. Field campaigns were conducted at remote coastal sites on the east coast of Australia (Agnes Water; March-April 2007) and west coast of Ireland (Mace Head; June 2007), and laboratory measurements were performed on bubble-generated sea spray aerosols. A combined Volatility-Hygroscopicity-Tandem Differential Mobility Analyser (VH-TDMA) was employed in all experiments. This system probes the changes in the hygroscopic properties of nanoparticles as volatile organic components are progressively evaporated. It also allows particle composition to be inferred from combined volatility-hygroscopicity measurements. Frequent new particle formation and growth events were observed during the Agnes Water campaign. The VH-TDMA was used to investigate freshly nucleated particles (17-22.5 nm) and it was found that the condensation of sulphate and/or organic vapours was responsible for driving particle growth during the events. Aitken mode particles (~40 nm) were also measured with the VH-TDMA. In 3 out of 18 VH-TDMA scans evaporation of a volatile, organic component caused a very large increase in hygroscopicity that could only be explained by an increase in the absolute water uptake of the particle residuals, and not merely an increase in their relative hygroscopicity. This indicated the presence of organic components that were suppressing the hygroscopic growth of mixed particles on the timescale of humidification in the VH-TDMA (6.5 secs). It was suggested that the suppression of water uptake was caused by either a reduced rate of hygroscopic growth due to the presence of organic films, or organic-inorganic interactions in solution droplets that had a negative effect on hygroscopicity. Mixed organic-inorganic particles were rarely observed by the VH-TDMA during the summer campaign conducted at Mace Head. The majority of particles below 100 nm in clean, marine air appeared to be sulphates neutralised to varying degrees by ammonia. On one unique day, 26 June 2007, particularly large concentrations of sulphate aerosol were observed and identified as volcanic emissions from Iceland. The degree of neutralisation of the sulphate aerosol by ammonia was calculated by the VH-TDMA and found to compare well with the same quantity measured by an aerosol mass spectrometer. This was an important verification of the VH-TMDA‘s ability to identify ammoniated sulphate aerosols based on the simultaneous measurement of aerosol volatility and hygroscopicity. A series of measurements were also conducted on sea spray aerosols generated from Moreton Bay seawater samples in a laboratory-based bubble chamber. Accumulation mode sea spray particles (38-173 nm) were found to contain only a minor organic fraction (< 10%) that had little effect on particle hygroscopicity. These results are important because previous studies have observed that accumulation mode sea spray particles are predominantly organic (~80% organic mass fraction). The work presented here suggests that this is not always the case, and that there may be currently unknown factors that are controlling the transfer of organics to the aerosol phase during the bubble bursting process. Taken together, the results of this research program have significantly improved our understanding of organic-containing marine aerosols and the way they interact with water vapour in the atmosphere.

Data flow analysis of embedded program expressions

Data flow analysis techniques can be used to help assess threats to data confidentiality and integrity in security critical program code. However, a fundamental weakness of static analysis techniques is that they overestimate the ways in which data may propagate at run time. Discounting large numbers of these false-positive data flow paths wastes an information security evaluator's time and effort. Here we show how to automatically eliminate some false-positive data flow paths by precisely modelling how classified data is blocked by certain expressions in embedded C code. We present a library of detailed data flow models of individual expression elements and an algorithm for introducing these components into conventional data flow graphs. The resulting models can be used to accurately trace byte-level or even bit-level data flow through expressions that are normally treated as atomic. This allows us to identify expressions that safely downgrade their classified inputs and thereby eliminate false-positive data flow paths from the security evaluation process. To validate the approach we have implemented and tested it in an existing data flow analysis toolkit.

Demonstration of closed-­loop airborne sense-­and-­avoid using machine vision

This paper describes a vision-based airborne collision avoidance system developed by the Australian Research Centre for Aerospace Automation (ARCAA) under its Dynamic Sense-and-Act (DSA) program. We outline the system architecture and the flight testing undertaken to validate the system performance under realistic collision course scenarios. The proposed system could be implemented in either manned or unmanned aircraft, and represents a step forward in the development of a “sense-and-avoid” capability equivalent to human “see-and-avoid”.

goDesign travelling design workshop program for regional secondary students

goDesign Travelling Workshop Program for Regional Secondary Students was an initiative of Queensland University of Technology (QUT) and the Design Institute of Australia (DIA) Queensland Branch, which aligned with the DIA unleashed: Queensland design on tour 2010 Exhibition. It was designed be delivered by university design academics in state secondary schools in Chinchilla, Mt Isa, Quilpie, Emerald, Gladstone and Bundaberg between February and September 2010, to approximately 95 secondary students and 24 teachers from the subject areas of visual art, graphics and industrial technology and design. A talk by a visiting design practitioner whose work was displayed in the exhibition, also features in the final day of the program in each town, and student work from the workshop was displayed in the exhibition alongside the professional design work. The three-day workshop is a design immersion program for regional Queensland Secondary Schools, which responds to specific actions outlined in the Queensland Government Design Strategy 2020 to ‘Build Design Knowledge and Learning’ and ‘Foster a Design Culture’. Underpinned by a place-based approach and the integration of Dr Charles Burnette’s IDESIGN teaching model, the program gives students and teachers the opportunity to explore, analyse and reimagine their local town through a series of scaffolded problem solving activities around the theme of ‘place’. The program allows students to gain hands-on experience designing graphics, products, interior spaces and architecture to assist their local community, with the support of design professionals. Students work individually and in groups on real design problems learning sketching, making, communication, presentation and collaboration skills to improve their design process, while considering social, cultural and environmental opportunities. The program was designed to facilitate an understanding of the value of design thinking and its importance to regional communities, to give students more information about various design disciplines as career options, and provide a professional development opportunity for teachers. Advisory assistance for the program was gained through Kelvin Grove State College, Queensland Studies Authority and QMI/Manufacturing Skills Queensland Manager, Manufacturing & Engineering Gateway Schools Project.

Preparing general technology teachers in China for new roles and responsibilities

This paper discusses the conceptualization, implementation and initial findings of a professional learning program (PLP) which used LEGO® robotics as one of the tools for teaching general technology (GT)in China’s secondary schools. The program encouraged teachers to design learning environments that can be realistic, authentic, engaging and fun. 100 general technology teachers from high schools in 30 provinces of China participated. The program aimed to transform teacher classroom practice, change their beliefs and attitudes, allow teachers to reflect deeply on what they do and in turn to provide their students with meaningful learning. Preliminary findings indicate that these teachers had a huge capacity for change. They were open-minded and absorbed new ways of learning and teaching. They became designers who developed innovative models of learning which incorporated learning processes that effectively used LEGO® robotics as one of the more creative tools for teaching GT.

Resourceful Adolescent Program for Teachers (RAP-T) : a program for teachers to promote school connectedness in teenagers

Recent research has shown that school connectedness is one of the most important protective factors against teenage depression. RAP-T aims to increase teachers’ recognition of the importance of school connectedness and to develop strategies to promote four key elements of school connectedness.