Supersymmetric Higgs boson pair production at hadron colliders

We study the pair production of neutral Higgs bosons through gluon fusion at hadron colliders in the framework of the minimal supersymmetric standard model. We present analytical expressions for the relevant amplitudes, including both quark and squark loop contributions, and allowing for mixing between the superpartners of left- and right-handed quarks. Squark loop contributions can increase the cross section for the production of two CP-even Higgs bosons by more than two orders of magnitude, if the relevant trilinear soft breaking parameter is large and the mass of the lighter squark eigenstate is not too far above its current lower bound. In the region of large tan β, neutral Higgs boson pair production might even be observable in the 4b final state during the next run of the Fermilab Tevatron collider. ©1999 The American Physical Society.

Strong-interaction effects in stop pair production at e+e- colliders

We discuss perturbative and non-perturbative strong-interaction effects in the pair production of stop squarks (t̃1) at e+e- colliders. Events with an additional hard gluon allow to detect or exclude t̃1t̃*1 production even in scenarios with very small mass splitting between ti and an invisible lightest supersymmetric particle (LSP). Such events can also help to establish that t̃1 transforms as a triplet under SU(3)C. We also carefully study non-perturbative t̃1 fragmentation, which is currently not well understood: not only is the t̃1 fragmentation function not known very well, but also there are ambiguities in the algorithm employed to model fragmentation. We present numerical results both for CERN LEP-183 and for a proposed future e+e- collider operating at center-of-mass energy s1/2 = 500 GeV.

Supersymmetric Higgs boson pair production: Discovery prospects at hadron colliders

We study the potential of hadron colliders in the search for the pair production of neutral Higgs bosons in the framework of the minimal supersymmetric standard model. We perform a detailed signal and background analysis, working out efficient kinematical cuts for the extraction of the signal. The important role of squark loop contributions to the signal is re-emphasized. If the signal is sufficiently enhanced by these contributions, it could even be observable at the next run of the upgraded Tevatron collider in the near future. At the LHC the pair production of light and heavy Higgs bosons might be detectable simultaneously.

Left-right asymmetries and exotic vector-boson discovery in lepton-lepton colliders

By considering left-right (L-R) asymmetries we study the capabilities of lepton colliders in searching for new exotic vector bosons. Specifically we study the effect of a doubly charged bilepton boson and an extra neutral vector boson appearing in a 3-3-1 model on the L-R asymmetries for the processes e-e- → e-e-, μ-μ- → μ-μ- and e-μ- → e-μ- and show that these asymmetries are very sensitive to these new contributions and that they are in fact powerful tools for discovery of this sort of vector bosons.

New limits on doubly charged bileptons from CERN LEP data and the search at future electron-positron and electron-photon colliders

We show that the accumulated CERN LEP-II data taken at √s = 130-206 GeV can establish more restrictive bounds on doubly charged bilepton couplings and masses than any other experiment so far. We also analyze the discovery potential of a prospective linear collider operating in both e+e- and e γ modes.

Direct signals for large extra dimensions in the production of fermion pairs at linear colliders

We analyze the potential of the next generation of e+e- linear colliders to search for large extra dimensions via the production of fermion pairs in association with Kaluza-Klein gravitons (G), i.e., e+e- →ff̃G. This process leads to a final state exhibiting a significant amount of missing energy in addition to acoplanar lepton or jet pairs. We study in detail this reaction using the full tree level contributions due to the graviton emission and the standard model backgrounds. After choosing the cuts to enhance the signal, we show that a linear collider with a center-of-mass energy of 500 GeV will be able to probe quantum gravity scales from 0.96 (0.86) up to 4.1 (3.3) TeV at a 2 (5)σ level, depending on the number of extra dimensions. ©2001 The American Physical Society.

Sensitivity of AMPA receptor channel to calcium oscillations: A computational study

We used a computational model of biochemical pathways that are involved in the phosphorylation/dephosphorylation of AMPA receptor to study the receptor responses to calcium oscillations. In the model, the biochemical pathways are assumed to be located immediately under the postsynaptic membrane and we included three states of AMPA receptor: dephosphorylated, and phosphorylated in one or in two sites. To characterize the effects of calcium oscillations on the AMPA receptor, we exposed the model to stimuli with three varying parameters, namely frequency, number of pulses and calcium spike duration. Our model showed sensitivity to all of these three parameters. © 2002 Elsevier Science B.V. All rights reserved.

Benomyl sensitivity of isolates of Colletotrichum acutatum and C. gloeosporioides from citrus

Postbloom fruit drop (PFD) of citrus, caused by Colletotrichum acutatum, produces orange-brown lesions on petals and results in premature fruit drop and the retention of calyces. C. gloeosporioides is common in groves and causes postharvest anthracnose on fruit. Both diseases are controlled effectively by the fungicide benomyl in research fields and commercial orchards. Highly sensitive and resistant isolates of C. gloeosporioides were found, whereas all isolates of C. acutatum tested were moderately resistant. In preliminary studies conducted in vitro with three isolates of each, mycelial growth of sensitive isolates of C. gloeosporioides was inhibited completely by benomyl (Benlate 50 WP) at 1.0 μg/ml, whereas resistant isolates grew well at 10 μg/ml. Growth of all isolates of C. acutatum was inhibited by about 55% at 0.1 μg/ml and by 80% at 1.0 μg/ml. Spore germination of C. acutatum was inhibited more at 0.1 μg/ml than at 1.0 μg/ml or higher concentrations. In all, 20 isolates of C. acutatum from 17 groves and 20 isolates of C. gloeosporioides from 7 groves were collected from locations with different histories of benomyl usage in São Paulo, Brazil, and Florida, United States. Benomyl at 1.0 μ.g/ml completely inhibited growth of 133 isolates of C. gloeosporioides, with the exception of 7 isolates that were highly resistant to the fungicide, whereas all isolates of C. acutatum were only partially inhibited at 0.1 and 1.0 μg/ml. Analysis of variance indicated that the sensitivity of the isolates of C. acutatum was not affected by benomyl usage or grove of origin, and country of origin had only minor effects. No highly resistant or sensitive isolate of C. acutatum was recovered. Partial sequencing of the β-tubulin gene did not reveal nucleotide substitutions in codons 198 or 200 in C. acutatum that usually are associated with benomyl resistance in other fungi.

On designing linearly tunable high-Q OTA-C filters with low sensitivity

This paper discusses a design approach for a high-Q low-sensitivity OTA-C biquad bandpass section. An optimal relationship is established between transconductances defining the differenceβ - γ in the Q-factor denominator, setting the Q-sensitivity to tuning voltages around unity. A 30-MHz filter was designed based on a 0.35μn CMOS process and VDD=3.3V. A range of circuit simulation supports the theoretical analysis. Q-factor spans from 20.5 to 60, while ensuring filter stability along the tuning range. Although a Mode-operating OTA is used, the procedure can be extended to other types of transconductor.

A low-voltage low-sensitivity sinusoidal VCO for DPLL realizations

A quasi-sinusoidal linearly tunable OTA-C VCO built with triode-region transconductors is presented. Oscillation upon power-on is ensured by RHP poles associated with gate-drain capacitances of OTA input devices. Since the OTA nonlinearity stabilizes the amplitude, the oscillation frequency f0 is first-order independent of VDD, making the VCO adequate to mixed-mode designs. A range of simulations attests the theoretical analysis. As part of a DPLL, the VCO was prototyped on a 0.8μm CMOS process, occupying an area of 0.15mm2. Nominal f0 is 1MHz, with K VCo=8.4KHz/mV. Measured sensitivity to VDD is below 2.17, while phase noise is -86dBc at 100-KHz offset. The feasibility of the VCO for higher frequencies is verified by a redesign based on a 0.35μm CMOS process and VDD=3.3V, with a linear frequency-span of l3.2MHz - 61.5MHz.

High sensitivity low cost capacitive strain gage

This paper describes a high senstivity low cost capacitive strain gage sensor. The theory, design, and sensor construction details are presented. It consists of eight capacitive sensors connected in two full bridges. The capacitive strain gage sensor structure was designed in order to produce high sensitivity and low dependence with temperature. By using a simple signal conditioning circuit constituted by a differential amplifier, a band-pass filter, and a precision rectifier the device can measure forces with resolution of 0.009 N and precision of 98.7%. It is rugged, presents linear response, and good repeatability. It presents sensitivity of 8.7 V/N and fall time of 12 ms.

The effect of adhesive and flowable composite on postoperative sensitivity: 2-Week results

Objective: To measure 2-week postoperative sensitivity in Class II composite restorations placed with a self-etching adhesive (Clearfil SE Bond) or a total-etch adhesive (Prime&Bond NT) with or without a flowable composite as cervical increment. Method and materials: Upon approval by the University of Guarulhos Committee on Human Subjects, 100 restorations were inserted in 46 patients who required Class II restorations in their molars and premolars. Enamel and dentin walls were conditioned with a self-etching primer (for Clearfil SE Bond) or etched with 34% phosphoric acid (for Prime&Bond NT). A 1- to 2-mm-thick increment of a flowable composite (Filtek Flow) was used in the proximal box in 50% of the restorations of each adhesive. Preparations were restored with a packable composite (Surefil). The restorations were evaluated preoperatively and 2 weeks postoperatively for sensitivity to cold, air, and masticatory forces using a visual analog scale. Marginal integrity of the accessible margins was also evaluated. Statistical analysis used a mixed linear model with subject as a random effect. Results: Ninety-eight teeth from 44 subjects were observed at 2 weeks. The type of adhesive and use of flowable composite had no significant effects or interaction for any of the four outcomes of interest, ie, change from baseline to 2 weeks in sensitivity and response time for the cold or air stimulus. For the air stimulus, the overall average change from baseline was not significant for either sensitivity or response time. For the cold stimulus, the overall average change from baseline was significant for both sensitivity and response time. No case of sensitivity to masticatory forces was observed. Conclusion: No differences in postoperative sensitivity were observed between a self-etch adhesive and a total-etch adhesive at 2 weeks. The use of flowable composite did not decrease postoperative sensitivity.

A new firefly luciferase with bimodal spectrum: Identification of structural determinants of spectral pH-sensitivity in firefly luciferases

Fireflies emit flashes in the green-yellow region of the spectrum for the purpose of sexual attraction. The bioluminescence color is determined by the luciferases. It is well known that the in vitro bioluminescence color of firefly luciferases can be shifted toward the red by lower pH and higher temperature; for this reason they are classified as pH-sensitive luciferases. However, the mechanism and structural origin of pH sensitivity in fireflies remains unknown. Here we report the cloning of a new luciferase from the Brazilian twilight active firefly Macrolampis sp2, which displays an unusual bimodal spectrum. The recombinant luciferase displays a sensitive spectrum with the peak at 569 nm and a shoulder in the red region. Comparison of the bioluminescence spectra of Macrolampis, Photinus and Cratomorphus firefly luciferases shows that the distinct colors are determined by the ratio between green and red emitters under luciferase influence. Comparison of Macrolampis luciferase with the highly similar North American Photinus pyralis luciferase (91%) showed few substitutions potentially involved with the higher spectral sensitivity in Macrolampis luciferase. Site-directed mutagenesis showed that the natural substitution E354N determines the appearance of the shoulder in the red region of Macrolampis luciferase bioluminescence spectrum, helping to identify important interactions and residues involved in the pH-sensing mechanism in firefly luciferases. © 2005 American Society for Photobiology.

Low ethanol consumption induces enhancement of insulin sensitivity in liver of normal rats

Moderate amounts of alcohol intake have been reported to have a protective effect on the cardiovascular system and this may involve enhanced insulin sensitivity. We established an animal model of increased insulin sensitivity by low ethanol consumption and here we investigated metabolic parameters and molecular mechanisms potentially involved in this phenomenon. For that, Wistar rats have received drinking water either without (control) or with 3% ethanol for four weeks. The effect of ethanol intake on insulin sensitivity was analyzed by insulin resistance index (HOMA-IR), intravenous insulin tolerance test (IVITT) and lipid profile. The role of liver was investigated by the analysis of insulin signaling pathway, GLUT2 gene expression and tissue glycogen content. Rats consuming 3% ethanol showed lower values of HOMA-IR and plasma free fatty acids (FFA) levels and higher hepatic glycogen content and glucose disappearance constant during the IVITT. Neither the phosphorylation of insulin receptor (IR) and insulin receptor substrate-1 (IRS-1), nor its association with phosphatidylinositol-3-kinase (PI3-kinase), was affected by ethanol. However, ethanol consumption enhanced liver IRS-2 and protein kinase B (Akt) phosphorylation (3 times, P < 0.05), which can be involved in the 2-fold increased (P < 0.05) hepatic glycogen content. The GLUT2 protein content was unchanged. Our findings point out that liver plays a role in enhanced insulin sensitivity induced by low ethanol consumption. © 2005 Elsevier Inc. All rights reserved.

Sensitivity analysis for overload-relief in transmission lines using an implicitly coupled method (CRIC)

The restructuring of energy markets to provide free access to the networks and the consequent increase of the number of power transactions has been causing congestions in transmission systems. As consequence, the networks suffer overloads in a more frequent way. One parameter that has strong influence on transfer capability is the reactive power flow. A sensitivity analysis can be used to find the best solution to minimize the reactive power flows and relief, the overload in one transmission line. The proposed methodology consists on the computation of two sensitivities based on the use of the Lc matrix from CRIC (Constant Reactive Implicitly Coupled) power flow method, that provide a set of actions to reduce the reactive power flow and alleviate overloads in the lines: (a) sensitivity between reactive power flow in lines and reactive power injections in the buses, (b) sensitivity between reactive power flow in lines and transformer's taps. © 2006 IEEE.