Asymmetric hydrogen flame in a heated micro-channel: role of Darrieus-Landau and thermal-diffusive instabilities

Present work examines numerically the asymmetric behavior of hydrogen/air flame in a micro-channel subjected to a non-uniform wall temperature distribution. A high resolution (with cell size of 25 μm × 25 μm) of two-dimensional transient Navier–Stokes simulation is conducted in the low-Mach number formulation using detailed chemistry evolving 9 chemical species and 21 elementary reactions. Firstly, effects of hydrodynamic and diffusive-thermal instabilities are studied by performing the computations for different Lewis numbers. Then, the effects of preferential diffusion of heat and mass transfer on the asymmetric behavior of the hydrogen flame are analyzed for different inlet velocities and equivalence ratios. Results show that for the flames in micro-channels, interactions between thermal diffusion and molecular diffusion play major role in evolution of a symmetric flame into an asymmetric one. Furthermore, the role of Darrieus–Landau instability found to be minor. It is also found that in symmetric flames, the Lewis number decreases behind the flame front. This is related to the curvature of flame which leads to the inclination of thermal and mass fluxes. The mass diffusion vectors point toward the walls and the thermal diffusion vectors point toward the centerline. Asymmetric flame is observed when the length of flame front is about 1.1–1.15 times of the channel width.

Rational design of a (S)-selective-Transaminase for asymmetric synthesis of (1S)-1-(1,1'-biphenyl 2-yl)ethanamine

Amine transaminases offer an environmentally sustainable synthesis route for the production ofpure chiral amines. However, their catalytic efficiency towards bulky ketone substrates isgreatly limited by steric hindrance and therefore presents a great challenge for industrialsynthetic applications. Hereby we report an example of rational transaminase enzyme design tohelp alleviate these challenges. Starting from the Vibrio fluvialis amine transaminase that has nodetectable catalytic activity towards the bulky aromatic ketone 2-acetylbiphenyl, we employed arational design strategy combining in silico and in vitro studies to engineer the transaminaseenzyme with a minimal number of mutations, achieving an high catalytic activity and highenantioselectivity. We found that by introducing two mutations W57G/R415A detectableenzyme activity was achieved. The rationally designed best variant,W57F/R88H/V153S/K163F/I259M/R415A/V422A, showed an improvement in reaction rateby > 1716-fold towards the bulky ketone under study, producing the corresponding enantiomericpure (S)-amine (ee value of > 99%). 

The use of binary mixtures of 1-butyl-1-methylpyrrolidinium bis{(trifluoromethyl)sulfonyl}imide and aliphatic nitrile solvents as electrolyte for supercapacitors

Abstract The development of high voltage electrolytes is one of the key aspects for increasing both energy and power density of electrochemical double layer capacitors (EDLCs). The usage of blends of ionic liquids and organic solvents has been considered as a feasible strategy since these electrolytes combine high usable voltages and good transport properties at the same time. In this work, the ionic liquid 1-butyl-1-methylpyrrolidinium bis{(trifluoromethyl)sulfonyl}imide ([Pyrr14][TFSI]) was mixed with two nitrile-based organic solvents, namely butyronitrile and adiponitrile, and the resulting blends were investigated regarding their usage in electrochemical double layer capacitors. Both blends have a high electrochemical stability, which was confirmed by prolonged float tests at 3.2 V, as well as, good transport properties. In fact, the butyronitrile blend reaches a conductivity of 17.14 mS·cm−1 and a viscosity of 2.46 mPa·s at 20 °C, which is better than the state-of-the-art electrolyte (1 mol·dm−3 of tetraethylammonium tetrafluoroborate in propylene carbonate).

Binary Mixtures of 1-Butyl-1-Methylpyrrolidinium Bis{(trifluoromethyl)Sulfonyl}Imide and Aliphatic Nitrile Solvents As Electrolyte for Electrochemical Double Layer Capacitors (Invited).

Electrochemical double layer capacitors (EDLCs), also known as supercapacitors, are promising energy storage devices, especially when considering high power applications [1]. EDLCs can be charged and discharged within seconds [1], feature high power (10 kW·kg-1) and an excellent cycle life (>500,000 cycles). All these properties are a result of the energy storage process of EDLCs, which relies on storing energy by charge separation instead of chemical redox reactions, as utilized in battery systems. Upon charging, double layers are forming at the electrode/electrolyte interface consisting of the electrolyte’s ions and electric charges at the electrode surface.In state-of-the-art EDLC systems activated carbons (AC) are used as active materials and tetraethylammonium tetrafluoroborate ([Et4N][BF4]) dissolved in organic solvents like propylene carbonate (PC) or acetonitrile (ACN) are commonly used as the electrolyte [2]. These combinations of materials allow operative voltages up to 2.7 V - 2.8 V and an energy in the order of 5 Wh·kg-1[3]. The energy of EDLCs is dependent on the square of the operative voltage, thus increasing the usable operative voltage has a strong effect on the delivered energy of the device [1]. Due to their high electrochemical stability, ionic liquids (ILs) were thoroughly investigated as electrolytes for EDLCs, as well as, batteries, enabling high operating voltages as high as 3.2 V - 3.5 V for the former [2]. While their unique ionic structure allows the usage of neat ILs as electrolyte in EDLCs, ILs suffer from low conductivity and high viscosity increasing the intrinsic resistance and, as a result, a lower power output of the device. In order to overcome this issue, the usage of blends of ionic liquids and organic solvents has been considered a feasible strategy as they combine high usable voltages, while still retaining good transport properties at the same time.In our recent work the ionic liquid 1-butyl-1-methylpyrrolidinium bis{(trifluoromethyl)sulfonyl}imide ([Pyrr14][TFSI]) was combined with two nitrile-based organic solvents, namely butyronitrile (BTN) and adiponitrile (ADN), and the resulting blends were investing regarding their usage in electrochemical double layer capacitors [4,5]. Firstly, the physicochemical properties were investigated, showing good transport properties for both blends, which are similar to the state-of-the-art combination of [Et4N][BF4] in PC. Secondly, the electrochemical properties for EDLC application were studied in depth revealing a high electrochemical stability with a maximum operative voltage as high as 3.7 V. In full cells these high voltage organic solvent based electrolytes have a good performance in terms of capacitance and an acceptable equivalent series resistance at cut-off voltages of 3.2 and 3.5 V. However, long term stability tests by float testing revealed stability issues when using a maximum voltage of 3.5 V for prolonged time, whereas at 3.2 V no such issues are observed (Fig. 1).Considering the obtained results, the usage of ADN and BTN blends with [Pyrr14][TFSI] in EDLCs appears to be an interesting alternative to state-of-the-art organic solvent based electrolytes, allowing the usage of higher maximum operative voltages while having similar transport properties to 1 mol∙dm-3 [Et4N][BF4] in PC at the same time.

Carbon Dioxide Uptake from Natural Gas by Binary Ionic Liquid-Water mixtures

Carbon dioxide solubility in a set of carboxylate ionic liquids formulated with stoicheiometric amounts of water is found to be significantly higher than for other ionic liquids previously reported. This is due to synergistic chemical and physical absorption. The formulated ionic liquid/water mixtures show greatly enhanced carbon dioxide solubility relative to both anhydrous ionic liquids and aqueous ionic liquid solutions, and are competitive with commercial chemical absorbers, such as activated N-methyldiethanolamine or monoethanolamine.

Investigation of explosion characteristics of multiphase fuel mixtures with air

Otto-von-Guericke-Universität Magdeburg, Fakultät für Verfahrens- und Systemtechnik, Dissertation, 2016

Complex organochlorine pesticide mixtures as determinant factor for breast cancer risk: a population-based case–control study in the Canary Islands (Spain)

[EN]All the relevant risk factors contributing to breast cancer etiology are not fully known. Exposure to organochlorine pesticides has been linked to an increased incidence of the disease, although not all data have been consistent. Most published studies evaluated the exposure to organochlorines individually, ignoring the potential effects exerted by the mixtures of chemicals.

Evaluation of fly ash in water reduced paving mixtures, 1984

Fly ash was used to replace 15% of the cement in C3WR and C6WR concrete paving mixes containing ASTM C494 Type A water reducin9 admixtures. Two Class C ashes and one Class F ash from Iowa approved sources were examined in each mix. When Class C ashes were used they were substituted on the basis of 1 pound of ash added for each pound of cement deleted. When Class F was used it was substituted on the basis of 1.25 pounds of ash added for each pound of cement deleted. Compressive strengths of the water reduced mixes, with and without fly ash, were determined at 7, 28, and 56 days of age. In every case except one the mixes containing the fly ash exhibited higher strengths than the same concrete mix without the fly ash. An excellent correlation existed between the C3WR and C6WR mixes both with and without fly ash substitutions. The freeze-thaw durability of the concrete studied was not affected by presence or absence of fly ash. The data gathered suggests that the present Class C water reduced concrete paving mixes can be modified to allow the substitution of 15% of the cement with an approved fly ash.

Studies on the Catalytic Asymmetric Fischer Indolization

This work describes further developments and applications of the catalytic asymmetric Fischer indolization. In the first part of this thesis, the development of an organocatalytic asymmetric synthesis of helicenes via a Fischer indolization is discussed. The application of a novel SPINOL-derived phosphoric acid, featuring extended π-surfaces as 3,3‘-substituents which can potentially participate in π-interactions with the polyaromatic intermediate, afforded the corresponding products in high yields and enantioselectivities. The second part of this work describes the development of a catalytic asymmetric dearomatizing synthesis of 1,4-diketones via an interrupted Fischer indolization. Employing aryl hydrazines with α-substituents next to the hydrazine group prevents the rearomatization which takes place in common Fischer indole syntheses, thus enabling the hydrolysis of the generated diimine species. In the presence of STRIP as catalyst, a variety of different 1,4-diketones could be obtained in generally high yields, diastereo- and enantioselectivities. The last part of this thesis deals with the development of an organocatalytic asymmetric stereodivergent synthesis of novel 3H- and 2H-pyrroles, applying an interrupted Fischer indolization and for the 2H-pyrroles a subsequent stereospecific [1,5]-alkyl shift. Employing STRIP as catalyst afforded the corresponding products in good to excellent yields and enantioselectivities. Preliminary biological investigations of these novel structure motifs in cell-based assays, monitoring biological signal transduction pathways showed an inhibition of the Hedgehog signaling pathway in a μM range.

Asymmetric polygons with maximum area

We say that a polygon inscribed in the circle is asymmetric if it contains no two antipodal points being the endpoints of a diameter. Given n diameters of a circle and a positive integer k < n, this paper addresses the problem of computing a maximum area asymmetric k-gon having as vertices k < n endpoints of the given diameters. The study of this type of polygons is motivated by ethnomusiciological applications.

How to deal with uncertainties regarding the occupational exposure to antineoplastic mixtures: additive effect should always be considered?

Risk assessment considerations - The concept that “safe levels of exposure” for humans can be identified for individual chemicals is central to the risk assessment of compounds with known toxicological profiles. Selection of agents for combination chemotherapy regimens involves minimize overlapping of mechanisms of action, antitumor activity and toxicity profile. Although the toxicological profile and mechanism of action of each individual drug is well characterized, the toxicological interactions between drugs are likely, but poorly established at occupational exposure context. The synergistic nature of interactions may help in understanding the adverse health effects observed in healthcare workers, where exposure situations are characterized by complex mixtures of chemical agents, and the levels of individual exposing agents are often not sufficiently high to explain the health complaints. However, if a substance is a genotoxic carcinogen, this would be the “lead effect”; normally, no OEL based on a NOEL would be derived and the level would be set so low that it would be unlikely that other effects would be expected. Aim of the study - Recently research project developed in Portuguese Hospitals characterize the occupational exposure to antineoplastic agents and the health effects related. The project aimed to assess exposure of the different risk groups that handle antineoplastic agents in the hospital setting, namely during preparation and administration of these drugs. Here it is presented and discussed the results in a study developed in two hospitals from Lisbon.

Endocrine disruptors mixtures: the real scenario of human exposure

Endocrine disrupting chemicals (EDCs) are exogenous agents that have the ability to interfere with/or mimic estrogenic hormones and, therefore can simultaneously and differentially trigger specific signaling pathways responsible for the nature and magnitude of biological responses in diverse cell types. Human exposure to EDCs, particularly at low-doses, is ubiquitous, persistent and occurs in complex mixtures. These compounds can bioaccumulate in lipid compartments of tissues forming a mixed “body burden” of contaminants of different origins. Although the independent action of chemicals has been considered the main principle in EDCs mixture toxicity, several effects cannot be predicted when analyzing single compounds individually. Based in a revision of the literature, focused in studies that evaluated EDCs mixtures, we hypothesize the scenario of a pregnant woman environmentally exposed to three different EDCs as a potential real scenario of human exposure supported by data describing where exposure to these compounds occur.

Rhodium-catalysed enantioselective C-H functionalization in asymmetric synthesis