Comparative effectiveness of solar disinfection using small-scale batch reactors with reflective, absorptive and transmissive rear surfaces

This study investigated the enhancement of solar disinfection using custom-made batch reactors with reflective (foil-backed) or absorptive (black-backed) rear surfaces, under a range of weather conditions in India. Plate counts of Escherichia coli ATCC11775 were made under aerobic conditions and under conditions where reactive oxygen species (ROS) were neutralised, i.e. in growth medium supplemented with 0.05% w/v sodium pyruvate plus incubation under anaerobic conditions. While the addition of either an absorptive or a reflective backing enhanced reactor performance under strong sunlight, the reflective reactor was the only system to show consistent enhancement under low sunlight, where the process was slowest. Counts performed under ROS-neutralised conditions were slightly higher than those in air, indicating that a fraction of the cells become sub-lethally injured during exposure to sunlight to the extent that they were unable to grow aerobically. However, the influence of this phenomenon on the dynamics of inactivation was relatively small

Influence Of Additives On The Drain Down Characteristics Of Stone Matrix Asphalt Mixtures

In Kerala highways, where traditional dense graded mixtures are used for the surface courses, major distress is due to moisture induced damages. Development of stabilized Stone Matrix Asphalt (SMA) mixtures for improved pavement performance has been the focus of research all over the world for the past few decades. Many successful attempts are made to stabilize SMA mixtures with synthetic fibres and polymers. India, being an agricultural economy produces fairly huge quantity of natural fibres such as coconut, sisal, banana, sugar cane, jute etc.. Now- a -days the disposal of waste plastics is a major concern for an eco- friendly sustainable environment. This paper focuses on the influence of additives like coir, sisal, banana fibres (natural fibres), waste plastics (waste material) and polypropylene (polymer) on the drain down characteristics of SMA mixtures. A preliminary investigation is conducted to characterize the materials used in this study. Drain down sensitivity tests are conducted to study the bleeding phenomena and drain down of SMA mixtures. Based on the drain down characteristics of the various stabilized mixtures it is inferred that the optimum fibre content is 0.3% by weight of mixture for all fibre mixtures irrespective of the type of fibre. For waste plastics and polypropylene stabilized SMA mixtures, the optimum additive contents are respectively 7% and 5% by weight of mixture. Due to the absorptive nature of fibres, fibre stabilizers are found to be more effective in reducing the drain down of the SMA mixture. The drain values for the waste plastics mix is within the required specification range. The coir fibre additive is the best among the fibres investigated. Sisal and banana fibre mixtures showed almost the same characteristics on stabilization.

Design and Development of Compact Chipless RFID Tags with High Data Encoding Capacity

The main objective of this thesis is to develop a compact chipless RFID tag with high data encoding capacity. The design and development of chipless RFID tag based on multiresonator and multiscatterer methods are presented first. An RFID tag using using SIR capable of 79bits is proposed. The thesis also deals with some of the properties of SIR like harmonic separation, independent control on resonant modes and the capability to change the electrical length. A chipless RFID reader working in a frequency band of 2.36GHz to 2.54GHz has been designed to show the feasibility of the RFID system. For a practical system, a new approach based on UWB Impulse Radar (UWB IR) technology is employed and the decoding methods from noisy backscattered signal are successfully demonstrated. The thesis also proposes a simple calibration procedure, which is able to decode the backscattered signal up to a distance of 80cm with 1mW output power.

Evaluation of Stress Reducing Capacity of Selected Anaesthetics for the Live Transportation of Green Chromide Etroplus suratensis

Transport of live aquatic organisms which is more than a century old, perhaps started in the 1870's (Norris et al, 1960). Live fish transportation is an essential practice in aquaculture particularly in rural areas of developing countries representing the only means of supplying fry to small scale aqua culturists (Taylor and Ross, 1988). Very often, large numbers of fry, fingerlings, juveniles and adult fish are being transported from the hatchery to fish farms, fish farms to market, processors and consumers. Live fish command large economic importance in the fresh fish market than dead and iced fish. Medina Pizzali (2001) observed that live fish in the Kolkata market was usually sold at higher prices than dead fish and most consumers were prepared to pay premium prices for live fish, which is considered as the best guarantee of freshness, quality, and intrinsic characteristics of its flesh (better texture and delicate flavour) in comparison with fresh/chilled seafood. Various government and private agencies undertake transport of live fish for commercial live fish market or for artificial propagation of game

Seismic behavior of capacity designed masonry walls in low seismicity regions

Eurocode 8 representing a new generation of structural design codes in Europe defines ‎requirements for the design of buildings against earthquake action. In Central and ‎Western Europe, the newly defined earthquake zones and corresponding design ground ‎acceleration values, will lead in many cases to earthquake actions which are remarkably ‎higher than those defined so far by the design codes used until now in Central Europe. ‎ In many cases, the weak points of masonry structures during an earthquake are the corner ‎regions of the walls. Loading of masonry walls by earthquake action leads in most cases ‎to high shear forces. The corresponding bending moment in such a wall typically causes a ‎significant increase of the eccentricity of the normal force in the critical wall cross ‎section. This in turn leads ultimately to a reduction of the size of the compression zone in ‎unreinforced walls and a high concentration of normal stresses and shear stresses in the ‎corner regions. ‎ Corner-Gap-Elements, consisting of a bearing beam located underneath the wall and ‎made of a sufficiently strong material (such as reinforced concrete), reduce the effect of ‎the eccentricity of the normal force and thus restricts the pinching effect of the ‎compression zone. In fact, the deformation can be concentrated in the joint below the ‎bearing beam. According to the principles of the Capacity Design philosophy, the ‎masonry itself is protected from high stresses as a potential cause of brittle failure. ‎ Shaking table tests at the NTU Athens Earthquake Engineering Laboratory have proven ‎the effectiveness of the Corner-Gap-Element. The following presentation will cover the ‎evaluation of various experimental results as well as a numerical modeling of the ‎observed phenomena.‎

Evaluation of water retention capacity and flood control function of the forest catchment

This research quantitatively evaluates the water retention capacity and flood control function of the forest catchments by using hydrological data of the large flood events which happened after the serious droughts. The objective sites are the Oodo Dam and the Sameura Dam catchments in Japan. The kinematic wave model, which considers saturated and unsaturated sub-surface soil zones, is used for the rainfall-runoff analysis. The result shows that possible storage volume of the Oodo Dam catchment is 162.26 MCM in 2005, while that of Samerua is 102.83 MCM in 2005 and 102.64 MCM in 2007. Flood control function of the Oodo Dam catchment is 173 mm in water depth in 2005, while the Sameura Dam catchment 114 mm in 2005 and 126 mm in 2007. This indicates that the Oodo Dam catchment has more than twice as big water capacity as its capacity (78.4 mm), while the Sameura Dam catchment has about one-fifth of the its storage capacity (693 mm).

Relationship between physical capacity and quality of life in workers university

Aim: Examine the relationship between the functional capacity and the quality of life related to health in university workers. Methodology: Cross-sectional study in 146 subjects, divided in two groups: Low functional Capacity (< 9 METs) and High functional Capacity (> 9.1 METs). We evaluated quality of life related to health (HRQOL-Health Questionnaire SF-12) and functional capacity (Questionnaire PAR/PAF) as indicators of health status. Results: 47.3% (69 men) and 52.7% (78 women). The average age of the groups was 35.0 ± 9.7 years (range 19,0-60,0 years). For HRQOL, the average found in the population assessed was 45.2 ± 4.42 (range 33,0-58,1) and 43.8 ± 6.87 (range 19,8-43,8) in components Physical Component Summary (PCS-12) and Mental Component Summary (MCS-12), respectively p = NS. Significant differences were found when comparing functional ability and sex, p<0,001 in both groups. Similarly, sex and mental component MCS-12 (group of Lower Functional) p = 0,049 as well as women and the physical component PCS-12, p = 0,05 between groups. Finally, a better score in HRQL observed in the group of High Capacity and functional components in both sex OR 0.59 (0.25-1.38). Conclusions: The results of this study demonstrate the relationship between High functional Capacity and a better HRQOL in this population.

Controlling regional monopolies in the natural gas industry: the role of transport capacity

This paper analyzes some optimal fiscal, pricing, and capacity investment policies for controlling regional monopoly power in the natural gas industry. By letting the set of control instruments available to the social planner vary, we provide a characterization of the technological and demand conditions under which “excess” capacity in the transport network arises in response to the loss of the two other control instruments, namely, transfers and pricing. Hence, the analysis yields some insights on an economy’s incentives to invest in infrastructures for the purpose of integrating geographically isolated markets.

Investment in transport capacity and regulation of regional monopolies in natural gas commodity markets

This paper develops a model of the regulator-regulated firm relationship in a regional natural gas commodity market which can be linked to a competitive market by a pipeline. We characterize normative policies under which the regulator, in addition to setting the level of the capacity of the pipeline, regulates the price of gas, under asymmetric information on the firm’s technology, and may (or may not) operate (two-way) transfers between consumers and the firm. We then focus on capacity and investigate how its level responds to the regulator’s taking account of the firm’s incentive compatibility constraints. The analysis yields some insights on the role that transport capacity investments may play as an instrument to improve the efficiency of geographically isolated markets.

Building Professional Capacity Aiming to Improve the Educational Position of Migrant Children : a reflection on the Sirius network activities

Resumen basado en el de la publicaci??n

A comparative study of two methods of measuring loss of capacity to hear speech

This paper discusses a study to compare two tests of loss of capacity to hear speech.