Dangers of the after-dark wonderlands : Part B - A review of the impact of the physical environment design on nightclub violence

Violence in nightclubs is a serious problem that has the Australian government launching multimillion dollar drinking campaigns. Research on nightclub violence has focused on identifying contributing social and environmental factors, with many concentrating on a variety of specific issues ranging from financial standpoints with effective target marketing strategies to legal obligations of supplying alcohol and abiding regulatory conditions. Moreover, existing research suggests that there is no single factor that directly affects the rate violence in licensed venues. As detailed in the review paper of Koleczko and Garcia Hansen (2011), there is little research about the physical environment of nightclubs and which specific design properties can be used to determine design standards to ensure/improve the physical design of nightclub environments to reduce patron violence. This current study seeks to address this omission by reporting on a series of interviews with participants from management and design domains. Featured case studies are both located in Fortitude Valley, a Mecca for party-goers and the busiest nightclub district in Queensland. The results and analysis support the conclusions that a number of elements of the physical environment influence elevated patron aggression and assault.

A restrike waveform predictive model for shunt capacitor bank switching with point-on-wave recommendation

Circuit-breakers (CBs) are subject to electrical stresses with restrikes during capacitor bank operation. Stresses are caused by the overvoltages across CBs, the interrupting currents and the rate of rise of recovery voltage (RRRV). Such electrical stresses also depend on the types of system grounding and the types of dielectric strength curves. The aim of this study is to demonstrate a restrike waveform predictive model for a SF6 CB that considered the types of system grounding: grounded and non-grounded and the computation accuracy comparison on the application of the cold withstand dielectric strength and the hot recovery dielectric strength curve including the POW (point-on-wave) recommendations to make an assessment of increasing the CB remaining life. The simulation of SF6 CB stresses in a typical 400 kV system was undertaken and the results in the applications are presented. The simulated restrike waveforms produced with the identified features using wavelet transform can be used for restrike diagnostic algorithm development with wavelet transform to locate a substation with breaker restrikes. This study found that the hot withstand dielectric strength curve has less magnitude than the cold withstand dielectric strength curve for restrike simulation results. Computation accuracy improved with the hot withstand dielectric strength and POW controlled switching can increase the life for a SF6 CB.

Innovation strategies for developing the traditional souvenir craft industry

This paper describes the concept of innovation strategies for traditional souvenir craft industries. There are many traditional souvenir craft industries in Indonesia, and they have to compete in today‘s global markets. The craftsmanship and uniqueness of traditional crafts must be developed to attract a larger market. This competition is not easy for craftspeople, neither financially nor culturally. The authors propose some innovation strategies to facilitate craftspeople in generating ideas based on their traditional value, to ensure their sustainability in global context. However, even though there are a number of studies about the craft industry and souvenirs, there is little research focused on the souvenir product development process, especially in the traditional craft industry. Considering that souvenirs are products for pleasure which require hedonic value more than utilitarian value, the offered innovation strategy refers to the strategy applied in existing industries that produce hedonic products. Innovation strategy in the fashion industry is selected as a reference, which is discussed by considering the context of the traditional souvenir craft industry. This investigation will support further research about knowledge sharing systems to enable collaborative learning within traditional craftspeople.

A sustainable approach to community based rehabilitation in rural and remote Australia

This paper presents a summary of an extensive review of the health, disability and rehabilitation literature conducted for the purposes of informing the formulation of a sustainable approach to community based rehabilitation in rural and remote Australia. It begins with a review of definitions of disability and rehabilitation, which is followed by differentiating 'rehabilitation in the community' and 'community based rehabilitation'. Finally, a network of community based rehabilitation coalitions is proposed as a sustainable approach to community based rehabilitation in rural and remote Australia. Each coalition would have a community rehabilitation facilitator and community specific database of resources, as well as a register of local community rehabilitation assistants who can support the work of health professionals by providing rehabilitation interventions under the latter's direction. In this approach, rehabilitation is conceptualised as being about people's lives rather than only a series of interventions provided by health care professionals. As such, rehabilitation becomes everybody's business.

Photocatalytic hydrogen production with iron oxide under solar irradiation

As solar hydrogen is a sustainable and environmental friendly energy carrier, it is considered to take the place of fossil fuels in the near future. Solar hydrogen can be generated by splitting of water under solar light illumination. In this study, the use of nanostructured hematite thin-film electrodes in photocatalytic water splitting was investigated. Hematite (á-Fe2O3) has a narrow band-gap of 2.2 eV, which is able to utilise approximately 40% of solar radiation. However, poor photoelectrochemical performance is observed for hematite due to low electrical conductivity and a high rate of electron-hole recombination. An extensive review of useful measures taken to overcoming the disadvantages of hematite so as to enhance its performance was presented including thin-film structure, nanostructuring, doping, etc. Since semiconductoring materials which exhibit an inverse opal structure are expected to have a high surface-volume ratio, unique optical characteristics and a shorter distance for photogenerated holes to travel to the electrode/electrolyte interface, inverse opals of hematite thin films deposited on FTO glass substrate were successfully prepared by doctor blading using PMMA as a template. However, due to the poor adhesion of the films, an acidic medium (i.e., 2 M HCl) was employed to significantly enhance the adhesion of the films, which completely destroyed the inverse opal structure. Therefore, undoped, Ti and Zn-doped hematite thin films deposied on FTO glass substrate without an inverse opal structure were prepared by doctor blading and spray pyrolysis and characterised using SEM, EDX, XRD, TGA, UV-Vis spectroscopy and photoelectrochemical measurements. Regarding the doped hematite thin films prepared by doctor blading, the photoelectrochemical activity of the hematite photoelectrodes was improved by incorporation of Ti, most likely owing to the increased electrical conductivity of the films, the stabilisation of oxygen vacancies by Ti4+ ions and the increased electric field of the space charge layer. A highest photoresponse was recorded in case of 2.5 at.% Ti which seemed to be an optimal concentration. The effect of doping content, thickness, and calcination temperature on the performance of the Ti-doped photoelectrodes was investigated. Also, the photoactivity of the 2.5 at.% Ti-doped samples was examined in two different types of electrochemical cells. Zn doping did not enhance the photoactivity of the hematite thin films though Zn seemed to enhance the hole transport due to the slow hole mobility of hematite which could not be overcome by the enhancement. The poor performance was also obtained for the Ti-doped samples prepared by spray pyrolysis, which appeared to be a result of introduction of impurities from the metallic parts of the spray gun in an acidic medium. Further characterisation of the thin-film electrodes is required to explain the mechanism by which enhanced performance was obtained for Ti-doped electrodes (doctor blading) and poor photoactivity for Zn and Ti-doped samples which were synthesised by doctor blading and spray pyrolysis, respectively. Ti-doped hematite thin films will be synthesised in another way, such as dip coating so as to maintain an inverse opal structure as well as well adhesion. Also, a comparative study of the films will be carried out.

Selection of solar energy for green building using superiority and inferiority multi-criteria ranking (SIR) method

Green energy is one of the key factors, driving down electricity bill and zero carbon emission generating electricity to green building. However, the climate change and environmental policies are accelerating people to use renewable energy instead of coal-fired (convention type) energy for green building that energy is not environmental friendly. Therefore, solar energy is one of the clean energy solving environmental impact and paying less in electricity fee. The method of solar energy is collecting sun from solar array and saves in battery from which provides necessary electricity to whole house with zero carbon emission. However, in the market a lot of solar arrays suppliers, the aims of this paper attempted to use superiority and inferiority multi-criteria ranking (SIR) method with 13 constraints establishing I-flows and S-flows matrices to evaluate four alternatives solar energies and determining which alternative is the best, providing power to sustainable building. Furthermore, SIR is well-known structured approach of multi-criteria decision support tools and gradually used in construction and building. The outcome of this paper significantly gives an indication to user selecting solar energy.

Co-constructing self-efficacy narratives : a study of four mature age university students

This thesis reports on a study in which research participants, four mature aged females starting an undergraduate degree at a regional Australian university, collaborated with the researcher in co-constructing a self-efficacy narrative. For the purpose of the study, self-efficacy was conceptualized as a means by which an individual initiates action to engage in a task or set of tasks, applies effort to perform the task or set of tasks, and persists in the face of obstacles encountered in order to achieve successful completion of the task or set of tasks. Qualitative interviews were conducted with the participants, initially investigating their respective life histories for an understanding of how they made the decision to embark on their respective academic program. Additional data were generated from a written exercise, prompting participants to furnish specific examples of self-efficacy. These data were incorporated into the individual's self-efficacy narrative, produced as the outcome of the "narrative analysis". Another aspect of the study entailed "analysis of narrative" in which analytic procedures were used to identify themes common to the self-efficacy narratives. Five main themes were identified: (a) participants' experience of schooling . for several participants their formative experience of school was not always positive, and yet their narratives demonstrated their agency in persevering and taking on university-level studies as mature aged persons; (b) recognition of family as an early influence . these influences were described as being both positive, in the sense of being supportive and encouraging, as well as posing obstacles that participants had to overcome in order to pursue their goals; (c) availability of supportive persons – the support of particular persons was acknowledged as a factor that enabled participants to persist in their respective endeavours; (d) luck or chance factors were recognised as placing participants at the right place at the right time, from which circumstances they applied considerable effort in order to convert the opportunity into a successful outcome; and (e) self-efficacy was identified as a major theme found in the narratives. The study included an evaluation of the research process by participants. A number of themes were identified in respect of the manner in which the research process was experienced as a helpful process. Participants commented that: (a) the research process was helpful in clarifying their respective career goals; (b) they appreciated opportunities provided by the research process to view their life from a different perspective and to better understand what motivated them, and what their preferred learning styles were; (c) their past successes in a range of different spheres were made more evident to them as they were guided in self-reflection, and their self-efficacious behaviour was affirmed; and (d) the opportunities provided by their participation in the research process to identify strengths of which they had not been consciously aware, to find confirmation of strengths they knew they possessed, and in some instances to rectify misconceptions they had held about aspects of their personality. The study made three important contributions to knowledge. Firstly, it provided a detailed explication of a qualitative narrative method in exploring self-efficacy, with the potential for application to other issues in educational, counselling and psychotherapy research. Secondly, it consolidated and illustrated social cognitive theory by proposing a dynamic model of self-efficacy, drawing on constructivist and interpretivist paradigms and extending extant theory and models. Finally, the study made a contribution to the debate concerning the nexus of qualitative research and counselling by providing guidelines for ethical practice in both endeavours for the practitioner-researcher.

Building info-skills by degrees : embedding information literacy in university study

Late last year teaching staff at Griffith University participated in a symposium entitled 'Spotlight on Generic Skills & Flexible Learning'. This event brought together academic staff as well as library staff, learning advisers and other support staff interested in teaching and learning issues. The discussion was based on the premise that the University has a responsibility to ensure that its courses emphasise broad educational values and 'produce highly sought after graduates with globally applicable skills for the international market'(1). It was acknowledged that the University consistently scores very highly with graduates for its development of generic skills. However at the same time staff expressed concern at the challenge of developing more flexible, student-centred learning environments that have generic skills embedded across all programs (2). As a result there has been much debate in the University about which skills are important, how they will be acquired and how they could effectively be built into the curriculum. One outcome of these discussions is the project described in this paper. What follows is an overview of the project and a discussion about the integration and development of information literacy as a generic attribute in the curriculum and some suggestions on ways forward.

Surveying the state of higher education in energy efficiency, in Australian engineering curriculum

This paper presents the method and results of a survey of 27 of the 33 Australian universities teaching engineering education in late 2007, undertaken by The Natural Edge Project (hosted by Griffith University and the Australian National University) and supported by the National Framework for Energy Efficiency. This survey aimed to ascertain the extent of energy efficiency (EE) education, and to identify preferred methods to assist in increasing the extent to which EE education is embedded in engineering curriculum. In this paper the context for the survey is supported by a summary of the key results from a variety of surveys undertaken over the last decade internationally. The paper concludes that EE education across universities and engineering disciplines in Australia is currently highly variable and ad hoc. Based on the results of the survey, this paper highlights a number of preferred options to support educators to embed sustainability within engineering programs, and future opportunities for monitoring EE, within the context of engineering education for sustainable development (EESD).

Quality and efficacy of the Indigenous Tutorial Assistance Scheme (ITAS) for university students

Designed as a 'supplementary' tuition scheme, the Indigenous Tutorial Assistance Scheme (hereafter referred to as ITAS) is a strategic initiative of the National Indigenous Education Policy (DEET, 1989). This paper seeks to contribute to the literature of the analysis of the quality and efficacy of ITAS. Currently, the delivery of ITAS to Indigenous students requires enormous administration and commitment by the staff of Indigenous education support centres. In exploring the essential but problematic provision of ITAS to Indigenous university students, this paper provides insights into significant aspects of our program that move beyond assumptions of student deficit, by researching the quality of teaching and learning through ITAS, analysing administrative workload, and sharing innovations to our program as a result of participatory research with important ITAS stakeholders.

The development of a new signal processing program at the Queensland University of Technology

The School of Electrical and Electronic Systems Engineering at Queensland University of Technology, Brisbane, Australia (QUT), offers three bachelor degree courses in electrical and computer engineering. In all its courses there is a strong emphasis on signal processing. A newly established Signal Processing Research Centre (SPRC) has played an important role in the development of the signal processing units in these courses. This paper describes the unique design of the undergraduate program in signal processing at QUT, the laboratories developed to support it, and the criteria that influenced the design.