维生素C二步发酵中巨大芽孢杆菌对氧化葡萄糖酸杆菌生长和产酸的影响

通过测定氧化葡萄糖酸杆菌转化L－山梨糖中成ZKGA的细胞酶活性、摇瓶发酵及中长变化，研究了Vc:步发酵中巨大茅孢杆菌对氧化葡萄糖酸杆菌生长和产酸作用的影响。结果显示：巨大芽孢杆菌胞外液和胞内液均可促进氧化葡萄糖酸杆菌的增殖，主要表现为缩短其中长周期中的延迟期；巨大芽孢杆菌通过所产生的部分生物活性物质增强氧化葡萄糖酸杆菌产酸的细胞酶活性，促进氧化葡萄糖酸杆菌转化L一山梨糖生成2KGA.

有机碳源添加对不同C/N比有机物料氮矿化进程的影响

采用室内恒温控湿好气培养法,研究了掺混不同C/N比有机物料土壤中有机氮的矿化进程,及有机碳源添加对其的影响。培养 30周的结果表明:掺混大豆粉的土壤有机氮的矿化速率最快,在第 30d时达到最大;掺混玉米秸粉土壤有机氮的矿化速率最慢;有机碳源的添加明显抑制了有机氮的矿化进程,但这种抑制作用只是暂时的,最终将以有机氮的矿化分解为发展总趋势。

High-quality hydrogen from the catalyzed decomposition of formic acid by Pd-Au/C and Pd-Ag/C

Pd-Au/C and Pd-Ag/C were found to have a unique characteristic of evolving high-quality hydrogen dramatically and steadily from the catalyzed decomposition of liquid formic acid at convenient temperature, and further this was improved by the addition of CeO2(H2O)(x).

Order-Order Transition of C -> sdG -> sL -> S in ABC Triblock Copolymer Thin Film Induced by Solvent Vapor

The morphology transition of polystyrene-block-poly(butadiene)-block-poly(2-vinylpyridine) (SBV) triblock thin film induced in benzene vapor showing weak selectivity for PS is investigated. The order-order transitions (OOT) in the sequence of core-shell cylinders (C), sphere in 'diblock gyroid' (sdG), sphere in lamella (sL) and sphere (S) are observed. The projection along (111) direction in Gyroid phase (sdG(111)) is found to epitaxially grow from C(001) in the film.

Effect of Heat Treatment Temperature on the Catalytic Performances of PtRu/C Catalysts for Methanol Electro-Oxidation

Non-ionic surfactant Triton X-100 was used as a stabilizer to prepare PtRu/C catalysts for methanol oxidation reaction (MOR). The cyclic voltammogram was used to investigate the catalytic activity for MOR of different PtRu/C catalysts. TG-DTA, EDX, XRD, XPS and TEM were Used to characterize the composition, structure and morphology of the as-prepared PtRu/C catalysts. It is found that the heat treatment plays a crucial role in the particles size, particles distribution of the PtRu/C catalysts and the oxidation state of platinum. The results show that 350 degrees C is an optimum heat treatment temperature. The as-synthesized catalyst heat-treated at this temperature exhibits the best catalytic performance for MOR.

Fe对Pt-Fe/C催化剂电催化氧还原反应活性的影响

制备了用作直接甲醇燃料电池的碳载Pt-Fe(Pt-Fe/C)阴极催化剂,X射线能量色散谱(EDX)、X射线衍射谱和电化学测量的结果表明,在Pt-Fe/C催化剂中,Fe以3种形式存在.质量分数大约为20%的Fe进入Pt的晶格,形成Pt-Fe合金,质量分数大约为80%的Fe没有进入Pt的晶格而以Fe和Fe2O3的形式单独存在.该催化剂经酸处理后,非合金化Fe和Fe2O3被溶解,而使Pt-Fe/C催化剂的电化学活性比表面积要比未经酸处理前的增加约30%左右,导致Pt-Fe/C催化剂对氧还原的电催化活性优于未经酸处理前的Pt-Fe/C催化剂.研究结果表明,Pt-Fe/C催化剂的电化学活性比表面积对氧还原的电催化活性起重要的作用,另外,只有与Pt形成合金的Fe能提高Pt对氧还原的电催化活性,而非合金化的Fe对Pt催化剂对氧还原的电催化活性基本没有影响.

CoTPP-Pt/C作直接甲醇燃料电池阴极催化剂

制备了炭载四苯基钴卟啉(CoTPP)和Pt(CoTPP-Pt/C)复合催化剂,研究了炭载四苯基铁卟啉对氧还原的电催活性。电化学研究发现,CoTPP-Pt/C催化剂对氧还原有很高的电催化活性。CoTPP-Pt/C催化剂对氧还原的极限电流密度比Pt/C催化剂高30%左右,但抗甲醇的能力未改善。

Electrochemical and spectroscopic study on the interaction of cytochrome c with anionic lipid vesicles

The structure and the electron-transfer of cytochrome c binding on the anionic lipid vesicles were analyzed by electrochemical and various spectroscopic methods. It was found that upon binding to anionic lipid membrane, the formal potential of. cytochrome c shifted 30 mV negatively indicating an eager redox interaction than that in its native state. This is due to the local alteration of the coordination and the heme crevice. The structural Perturbation in which a molten globule-like state is formed during binding to anionic lipid vesicles is more important. This study may help to understand the mechanism of the electron-transfer reactions of cytochrome c at the mitochondrial membrane.

Determination of gold, platinum and palladium in geological samples by inductively coupled plasma-mass spectrometry after separation and preconcentration with C-410 anion exchange resin

A method for the determination of Au, Pt and Pd in geological samples is described. Au, Pt and Pd can be separated and concentrated quantitatively by C-410 anion-exchange resin in the condition of 1.5 mol/L HCl with the adsorption rates of 91.2%, 100.0% and 95.7% respectively. No interference exists from coexisting elements except for Ge(IV), Cr(VI),Ti(IV) in inductively coupled plasma-mass spectrometry. The detection limits are 0.27 mug/L, 0.40 mug/L and 0.19 mug/L for Au, Pt and Pd respectively. The results of these elements in standard geological materials are in agreement with certified values with precision of 19.2% RSD for Au (n = 8), 28.1% RSD for Pt (n=8), and 15.6% RSD for Pd (n=8).

Effect of properties of active carbon supports on performance of Pt/C catalysts in polymer electrolyte membrane fuel cell

The Pt/C catalysts were prepared with pine active carbon and Vulcan XC-72 active carbon as the supports. The performances of the Pt/C catalysts in polymer electrolyte membrane fuel cell were compared. The result indicates that the performance of Pt/Vulcan XC-72 is better than that of Pt/pine. The physical and chemical properties of the two active carbons were measured using several analysis techniques. It was found that the pore size, specific conductivity and the surface function group significantly influence the performance of the electrocatalyst.

C-410树脂分离富集-电感耦合等离子体质谱法测定地质样品中的金、铂、钯

研究了地质样品中超痕量Au、Pt和Pd的测定方法。采用C 4 1 0阴离子交换树脂在 1 .5mol LHCl条件下对Au、Pt、Pd的吸附率分别为 91 .2 %、1 0 0 .0 %、95 .7%。共存离子除Ge4+ 、Cr6 + 、Ti4+ 外 ,无显著性干扰。用ICP MS测定Au、Pt、Pd的检出限分别为 0 .2 7、0 .4 0和 0 .1 9μg L。当n =8时 ,Au的RSD为 1 9.2 % ;Pt的RSD为 2 8.1 % ;Pd的RSD为 1 5 .6%。

Phase transition and transition kinetics of a thermotropic poly(amide-imide) derived from 70% pyromellitic dianhydride, 30% terephthaloyl chloride, and 1,3-bis[4-(4 '-aminophenoxy)cumyl]benzene

The phase transition and transition kinetics of a liquid crystalline copoly(amide-imide) (PAI37), which was synthesized from 70 mol% pyromellitic dianhydride, 30 mol% terephthaloyl chloride, and 1,3-bis[4-(4'-aminophenoxy)cumyl]benzene, was characterized by differential scanning calorimetry, polarized light microscopy, X-ray diffraction, and rheology. PAI37 exhibits a glass transition temperature at 182 degreesC followed by multiple phase transitions. The crystalline phase starts to melt at similar to 220 degreesC and forms smectic C (S-C) phase. The Sc phase transforms into smectic A (S-A) phase when the temperature is above 237 degreesC. The S-C to S-A transition spans a broad temperature range in which the S-A phase vanishes and forms isotropic melt. The WARD fiber pattern of PAI37 pulled from the anisotropic melt revealed an anomalous chain orientation, which was characterized by its layer normal perpendicular to the fiber direction. The transition kinetics for the mesophase and crystalline phase formation was also studied.

Investigation of Pr valence and relationship between bond covalency and T-c in Y1-xPrxBa2Cu3O7 (x = 0-1)

The valence of Pr and relationship between bond covalency and T-c in Y1-xPrxBa2Cu3O7 (x = 0-1) have been studied using complex chemical bond theory. The results indicate that the depression of superconductivity in Y1-xPrxBa2Cu3O7 can be reasonably explained by bond covalency difference for the bonds between CuO2 plane and CuO chain. T-c decreases with the decreasing of bond covalency difference and reaches zero when bond covalency difference is zero (or bond covalency in CuO2 exceeds that in CuO chain) at Pr concentration 0.55 and valence +3.30. These are in good agreement with the experiments and meanwhile suggest that the valence of Pr is + 3.30 in Y1-xPrxBa2Cu3O7. The results also indicate that for Pr valence less than +3.15, superconductivity always exists for whatever Pr concentration, whereas for Pr with a valence of +4.0, superconductivity disappears as soon as Pr concentration exceeds 0.19. This supports with the viewpoint that higher valence Pr will contribute more electrons to CuO2 plane, filling the mobile holes responsible for conduction. For PrBa2Cu3O7 with no Ba-site Pr, our calculation suggests that it will be a superconductor if the average valence of Pr is less than +3.15. (C) 1998 Published by Elsevier Science B.V. All rights reserved.

High efficient extraction of M@C-2n (M = La, Ce) by a high pressure and high temperature method

A high pressure and high temperature method was used to efficiently extract on a large scale metallofullerenes M@C-2n (M=La,Ce) in a closed vessel under argon gas protection. With pyridine as the HPHT solvent, about 60-80% M@C-2n and 30-55% M@C-82 can be enriched, M@C-82 is dissolved selectively; With toluene as the HPHT solvent, M@C-2n can also be efficiently extracted, especially M@C-74, which is a new member of M@C-2n soluble species. (C) 1998 Elsevier Science Ltd. All rights reserved.