Multifunctional Ti–Me (Me=Al, Cu) thin film systems for biomedical sensing devices

Ti-Me binary intermetallic thin films based on a titanium matrix doped with increasing amounts of Me (Me = Al, Cu) were prepared by magnetron sputtering (under similar conditions), aiming their application in biomedical sensing devices. The differences observed on the composition and on the micro(structural) features of the films, attributed to changes in the discharge characteristics, were correlated with the electrical properties of the intermetallic systems (Ti-Al and Ti-Cu). For the same Me exposed areas placed on the Ti target (ranging from 0.25 cm2 to 20 cm2) the Cu content increased from 3.5 at.% to 71.7 at.% in the Ti-Cu system and the Al content, in Ti-Al films, ranged from 11 to 45 at.%. The structural characterization evidenced the formation of metastable Ti-Me intermetallic phases for Al/Ti atomic ratios above 0.20 and for Cu/Ti ratios above 0.25. For lower Me concentrations, the effect of the α-Ti(Me) structure domains the overall structure. With the increase amount of the Me into Ti structure a clear trend for amorphization was observed. For both systems it was observed a significant decrease of the electrical resistivity with increasing Me/Ti atomic ratios (higher than 0.5 for Al/Ti atomic ratio and higher than 1.3 for Cu/Ti atomic ratio). Although similar trends were observed in the resistivity evolution for both systems, the Ti-Cu films presented lower resistivity values in comparison to Ti-Al system.

Desenvolvimento de um processador VLIW

Dissertação de mestrado integrado em Engenharia Eletrónica Industrial e Computadores

Tailored deposition of coloured coatings: on the widening of the available colour range

Dissertação de mestrado integrado em Engenharia de Materiais

Development of multifunctional coatings deposited on polymers based sensors for biomedical applications

Tese de Doutoramento (Programa Doutoral em Engenharia de Materiais)

O género na construção de personagens 3D: do binário ao fluído

Relatório de estágio de mestrado em Média Interativos

As fontes jornalísticas na era digital: relações e encenação

Dissertação de mestrado em Ciências da Comunicação (área de especialização em Informação e Jornalismo)

Mortality due to cardiovascular disease in women during the reproductive age (15 to 49 years), in the State of São Paulo, Brazil, from 1991 to 1995

OBJECTIVE: To describe mortality due to cardiovascular diseases in women during the reproductive age (15 to 49 years) in the state of São Paulo, Brazil, from 1991 to 1995. METHODS: A list of all deaths and their underlying causes, coded according to the International Classification of Diseases, 9th revision, multiple causes of death, and estimates of the female population according to age groups were provided by the SEADE Foundation. Specific coefficients for 100 thousand women for each year as well as the medians of these coefficients related to 5 years, and the percentage of death by subgroups were calculated. RESULTS: Cerebrovascular diseases have the highest coefficients (14.24 for 100 thousand females), followed by ischemic heart disease (7.37), other heart diseases (6.39), hypertensive disease (3.03), chronic rheumatic heart disease (1.58), pulmonary vascular diseases (1.29), and active rheumatic fever (0.05). Systemic arterial hypertension, as an associated cause, occurred in 55.3% to 57.8% of all the deaths due to intracerebral hemorrhage and in 30.4% to 30.8% due to subarachnoid hemorrhage. CONCLUSION: The significance of cerebrovascular diseases, coronary artery disease, and systemic arterial hypertension as causes of mortality suggests the need to emphasize preventive actions for young women who have the potential to reproduce to avoid possible complications in future pregnancies, and premature mortality.

Depressed mothers and infants are more relaxed during breastfeeding versus bottlefeeding interactions: brief report

Depressed and non-depressed mothers and their 3-month-old infants were videotaped during breastfeeding and bottlefeeding interactions. The videotapes were subsequently coded for a number of feeding interaction behaviors as well as being rated on the Interaction Rating Scales. No differences were noted between the depressed and non-depressed mothers. Several breastfeeding versus bottlefeeding group effects were observed. The breastfeeding mothers showed less burping and less intrusive behavior during the nipple-in periods as well as during the nipple-out periods. In addition, the breastfeeding mothers and their infants received better ratings on the Interaction Rating Scales. These data suggest that the depressed mothers and their infants not unlike the non-depressed mothers and their infants were benefited by breastfeeding.

Vapor - liquid equilibrium of systems containing perfluoromethyl-cyclohexane and hydrocarbons

Vapor - liquid equilibrium data for the binary systems: Perfluoromethylcyclohexane + n-Hexane and Perfluoromethylcyclohexane + 1-Hexene were determined at 93.3 KPa and 328.15 K. The vapor pressure for the pure components were also measured to calculate the Antoine constants. The data were correlated by using the Van-Laar, Margules, Wilson, NRTL and UNIQUAC equations. UNIFAC group-contribution parameters between CH, and CF,, and CH,=CH and CF, were also calculated.

Some observations on asymmetrical separation in thermal diffusion columns

Data have been obtained in steady-state batch operated thermogravitational separation columns using different binary mixtures to test the theory recently published by Morgado et al. The experimental results confirm that separations by thermal diffusion are asymmetrical except when the initial concentration is 0.5 and that the asymmetry is larger as the initial concentration deviates from 0.5 and as the separation potential increases.

The application of the equivalent annulus width concept in thermal diffusion separations

The equivalent annulus width concept is used to characterize a small commercial thermogravitational hermal diffusion column and its validity checked experimentally by separating batchwise in the column mixtures of n-heptanebenzene with different initial concentrations. The equation of Ruppell and Coull was used to analyse the data in the short separation times range and determine the equivalent annulus width. Good agreement was obtained between the experimental and predicted time-separation curves when using the equivalent annulus width value and on averaged value of the thermal diffusion constant. A new method is presented for the simultaneous determination of the equivalent annulus width and the thermal diffusion constant of a binary mixture from a single set of experimental data.

Crosscorrelation properties between perfect sequences

Binary sequence, perfect sequence, autocorrelation, crosscorrelation, Hadamard transform

Meta-Analysis of Ultrafiltration versus Diuretics Treatment Option for Overload Volume Reduction in Patients with Acute Decompensated Heart Failure

Introduction: Although diuretics are mainly used for the treatment of acute decompensated heart failure (ADHF), inadequate responses and complications have led to the use of extracorporeal ultrafiltration (UF) as an alternative strategy for reducing volume overloads in patients with ADHF. Objective: The aim of our study is to perform meta-analysis of the results obtained from studies on extracorporeal venous ultrafiltration and compare them with those of standard diuretic treatment for overload volume reduction in acute decompensated heart failure. Methods: MEDLINE, EMBASE, and the Cochrane Central Register of Controlled Trials databases were systematically searched using a pre‑specified criterion. Pooled estimates of outcomes after 48 h (weight change, serum creatinine level, and all-cause mortality) were computed using random effect models. Pooled weighted mean differences were calculated for weight loss and change in creatinine level, whereas a pooled risk ratio was used for the analysis of binary all-cause mortality outcome. Results: A total of nine studies, involving 613 patients, met the eligibility criteria. The mean weight loss in patients who underwent UF therapy was 1.78 kg [95% Confidence Interval (CI): −2.65 to −0.91 kg; p < 0.001) more than those who received standard diuretic therapy. The post-intervention creatinine level, however, was not significantly different (mean change = −0.25 mg/dL; 95% CI: −0.56 to 0.06 mg/dL; p = 0.112). The risk of all-cause mortality persisted in patients treated with UF compared with patients treated with standard diuretics (Pooled RR = 1.00; 95% CI: 0.64–1.56; p = 0.993). Conclusion: Compared with standard diuretic therapy, UF treatment for overload volume reduction in individuals suffering from ADHF, resulted in significant reduction of body weight within 48 h. However, no significant decrease of serum creatinine level or reduction of all-cause mortality was observed.

Bounding right-arm rotation distances

Rotation distance quantifies the difference in shape between two rooted binary trees of the same size by counting the minimum number of elementary changes needed to transform one tree to the other. We describe several types of rotation distance, and provide upper bounds on distances between trees with a fixed number of nodes with respect to each type. These bounds are obtained by relating each restricted rotation distance to the word length of elements of Thompson's group F with respect to different generating sets, including both finite and infinite generating sets.

Absolute type shaft encoding using LFSR

Maximal-length binary sequences have been known for a long time. They have many interesting properties, one of them is that when taken in blocks of n consecutive positions they form 2ⁿ-1 different codes in a closed circular sequence. This property can be used for measuring absolute angular positions as the circle can be divided in as many parts as different codes can be retrieved. This paper describes how can a closed binary sequence with arbitrary length be effectively designed with the minimal possible block-length, using linear feedback shift registers (LFSR). Such sequences can be used for measuring a specified exact number of angular positions, using the minimal possible number of sensors that linear methods allow.