Conservative prosthetic-periodontal treatment for molar class iii furcation involvement: Case report

Purpose: The treatment for furcation involvement is a great challenge to the general dentists. Tunneling may be a treatment alternative for class II and III furcation involvements in mandibular molars with large angle separation and great divergence between the mesial and distal roots. This alternative is a conservative treatment that allows a great condition to oral hygiene maintenance by the patient. Thus, the aim of this case report was to describe a conservative and therapeutic treatment modality for the horizontal defect of periodontal tissues in the furcal area with buccal-lingual extension (class III furcation involvement). Case Report: A patient with class III furcation involvement in the first mandibular molar was submitted to root resection and periodontal surgery to expose the clinical crown for the full-coverage restoration with tunnel preparation. Results: The final result of the treatment with tunneled crown was favorable and predictable due to adequate hygiene condition to avoid plaque accumulation and occurrence of root caries. Clinical Significance: A multidisciplinary approach is essential to achieve a correct treatment plan including surgical-periodontal procedures integrated to the prosthetic rehabilitation. Besides, the recommendation for oral hygiene maintenance is essential for the treatment longevity with tunneled crown. © 2011 Nova Science Publishers, Inc.

The effects of exposure time on the surface microhardness of three dual-cured dental resin cements

This study evaluated the exposure time of light-curing of the polymers used for cementation on microhardness test in different storage times. The polymers (specifically called resin cements) were RelyX ARC, RelyX U100, and SET. Five specimens of each group were prepared and photo-polymerized with exposure times of 20 s and 180 s, using a LED polymerization unit with wavelength of 440 ~ 480 nm and light output was consistently 1,500 mW/cm2. The Vickers hardness test was performed in a MMT-3 Microhardness Tester. Data were submitted to ANOVA and Tukey's test (α = 0.05). The values of RelyX ARC showed statistically significant difference to groups with light exposure when considering only chemical cure (p < 0.05). The groups with light exposure (20 s and 180 s) showed no significant difference between them (p > 0.05). The RelyX U100 cured only chemically showed statistically significant difference between 48 h and 7 days (p < 0.05). The SET resin cement showed no significant difference to groups without light exposure for all storage times (p > 0.05). The values of hardening of the dual-cured resin cements improved after setting by light and chemical activation demonstrating the importance of light curing. © 2011 by the authors.

Thickness dependence of structure and piezoelectric properties at nanoscale of polycrystalline PZT thin films

Lead zirconate titanate Pb(Zr 0.50Ti 0.50)O 3 (PZT) thin films were deposited by a polymeric chemical method on Pt(111)/Ti/SiO2/Si substrates to understand the mechanisms of phase transformations and the effect of film thickness on the structure, dielectric and piezoelectric properties in these films. PZT films pyrolyzed at temperatures higher than 350 °C present a coexistence of pyrochlore and perovskite phases, while only perovskite phase grows in films pyrolyzed at temperatures lower than 300 °C. For pyrochlore-free PZT thin films, a small (100) orientation tendency near the film-substrate interface was observed. Finally, we demonstrate the existence of a self-polarization effect in the studied PZT thin films. Results suggest that Schottky barriers and/or mechanical coupling near the filmsubstrate interface are not primarily responsible for the observed self-polarization effect in our films. © 2012 IEEE.

A DC-DC converter based on the three-state switching cell for high current and voltage step-down applications

This paper presents a pulsewidth modulation dc-dc nonisolated buck converter using the three-state switching cell, constituted by two active switches, two diodes, and two coupled inductors. Only part of the load power is processed by the active switches, reducing the peak current through the switches to half of the load current, as higher power levels can then be achieved by the proposed topology. The volume of reactive elements, i.e., inductors and capacitors, is also decreased since the ripple frequency of the output voltage is twice the switching frequency. Due to the intrinsic characteristics of the topology, total losses are distributed among all semiconductors. Another advantage of this converter is the reduced region for discontinuous conduction mode when compared to the conventional buck converter or, in other words, the operation range in continuous conduction mode is increased, as demonstrated by the static gain plot. The theoretical approach is detailed through qualitative and quantitative analyses by the application of the three-state switching cell to the buck converter operating in nonoverlapping mode $(D < 0.5)$. Besides, the mathematical analysis and development of an experimental prototype rated at 1 kW are carried out. The main experimental results are presented and adequately discussed to clearly identify its claimed advantages. © 1986-2012 IEEE.

Description and interpretation of Cenozoic vertebrate ichnofossils in Rio Grande do Sul State, Brazil

In the neighborhood of the city of Boqueirão do Leão (State of Rio Grande do Sul, Brazil) a set of three big-sized tunnels has been found. One of the tunnels is only partially filled with sand and accessible along its entire length. It is horizontal, slightly sinuous, 36 m long, up to 4.2 m wide and up to 2.0 m high. The surface morphology of the walls is composed of anthropogenic marks, speleothems, black incrustations and traces like digging scratches and smoothed surfaces. The 2nd tunnel has its entrance blocked by sand and sandstone cobbles, but the end of the tunnel is only partially clogged and therefore accessible. This accessible portion is 12 m long, 3 m wide and 1.5 m high. The 3rd tunnel is completely filled and collapsed and is nowadays only indicated by concave roof features at its end. The general features of the tunnel system and the analysis of the surface morphology of the walls of the accessible portions permit to conclude that the tunnels were produced by ground sloths of the Cenozoic South American megafauna. The size of the tunnels suggests that its excavation was gradually carried out by successive generations of sloth herds, and not by a single individual animal. The primary function of the tunnels probably was not protection from predators, which had easy access to structures of this size, but to shelter during a drier climate. However, it is not yet possible to relate the tunnels to a specific ground sloth genus, a task that depends on the discovery of better-preserved tunnel systems. © 2013 by the Sociedade Brasileira de Paleontologia.

Influência de pontas de pulverização e adjuvantes no potencial de redução de deriva em túnel de vento

The drift is intimately linked to inappropriate use of pesticides and an important factor for reducing it, is the correct selection of spray nozzles and adjuvants. The objective of this work was to evaluate the drift potential in wind tunnel with different spray nozzles and different concentrations of adjuvants. The experiment was composed by six spray solutions (vegetable oil (in three concentrations), mineral oil, surfactant and reducing drift), which were applied with two nozzles, one pre-orifice flat fan (DG 8003 VS) and other with air induction (AI 8003 VS), totaling 12 treatments, with three repetitions. The equipment used was a wind tunnel, where the drift collections were made at different points. The treatments averages were compared using Confidence Interval at 5% probability. The analysis of the percentage of drift showed that the treatments had different behaviors. The nonylphenol ethoxylate adjuvant presented the highest drift when applied with the nozzle of pre-orifice and the lowest drift when applied with the air induction. The behavior of these nozzles when the oil-based adjuvant was used showed apposite results to those obtained for the surfactant. For the DG nozzles the lowest percentage of drift, at all analyzed distances, was observed to the treatment with vegetable oil (1.0%) and with the AI nozzles the lower drift was found for the treatment with nonylphenol ethoxylate (0.0625%), for the four distances in the collection. The result showed that both the spray nozzles and adjuvants alter directly the drift potential. There was no proportionately between the concentration of the oil-based adjuvant and the drift percentage.

Photodynamic therapy for the treatment of induced mammary tumor in rats

The objective of this work was to evaluate photodynamic therapy (PDT) by using a hematoporphyrin derivative as a photosensitizer and light-emitting diodes (LEDs) as light source in induced mammary tumors of Sprague-Dawley (SD) rats. Twenty SD rats with mammary tumors induced by DMBA were used. Animals were divided into four groups: control (G1), PDT only (G2), surgical removal of tumor (G3), and submitted to PDT immediately after surgical removal of tumor (G4). Tumors were measured over 6 weeks. Lesions and surgical were LEDs lighted up (200 J/cm2 dose). The light distribution in vivo study used two additional animals without mammary tumors. In the control group, the average growth of tumor diameter was approximately 0.40 cm/week. While for PDT group, a growth of less than 0.15 cm/week was observed, suggesting significant delay in tumor growth. Therefore, only partial irradiation of the tumors occurred with a reduction in development, but without elimination. Animals in G4 had no tumor recurrence during the 12 weeks, after chemical induction, when compared with G3 animals that showed 60 % recurrence rate after 12 weeks of chemical induction. PDT used in the experimental model of mammary tumor as a single therapy was effective in reducing tumor development, so the surgery associated with PDT is a safe and efficient destruction of residual tumor, preventing recurrence of the tumor. © 2012 Springer-Verlag London Ltd.

Ethopharmacological evaluation of the rat exposure test: A prey-predator interaction test

The rat exposure test (RET) is a prey (mouse)-predator (rat) situation that activates brain defensive areas and elicits hormonal and defensive behavior in the mouse. Here, we investigated possible correlations between the spatiotemporal [time spent in protected (home chamber and tunnel) and unprotected (surface) compartments and frequency of entries into the three compartments] and ethological [e.g., duration of protected and unprotected stretched-attend postures (SAP), duration of contact with the rat's compartment] measures (Experiment 1). Secondly, we investigated the effects of systemic treatment with pro- or anti-aversive drugs on the behavior that emerged from the factor analysis (Experiment 2). The effects of chronic (21 days) imipramine and fluoxetine on defensive behavior were also investigated (Experiment 3). Exp. 1 revealed that the time in the protected compartment, protected SAP and rat contacts loaded on factor 1 (defensive behavior), while the total entries and unprotected SAP loaded on factor 2 (locomotor activity). Exp. 2 showed that alprazolam (but not diazepam) selectively changed the defensive factor. Caffeine produced a mild proaversive-like effect, whereas yohimbine only decreased locomotor activity (total entries). Fluoxetine (but not imipramine) produced a weak proaversive-like effect. 5-HT1A/5-HT2 receptor ligands did not change any behavioral measure. In Exp. 3, chronic fluoxetine (but not imipramine) attenuated the defensive behavior factor without changing locomotion. Given that the defensive factor was sensitive to drugs known to attenuate (alprazolam and chronic fluoxetine) and induce (caffeine) panic attack, we suggest the RET as a useful test to assess the effects of panicolytic and panicogenic drugs. © 2012 Elsevier B.V.

Thickness dependence of structure and piezoelectric properties at nanoscale of polycrystalline lead zirconate titanate thin films

Lead zirconate titanate Pb(Zr0.50Ti0.50)O3 (PZT) thin films were deposited by a polymeric chemical method on Pt(111)/Ti/SiO2/Si substrates to understand the mechanisms of phase transformations and the effect of film thickness on the structure, dielectric, and piezoelectric properties in these films. PZT films pyrolyzed at temperatures higher than 350 °C present a coexistence of pyrochlore and perovskite phases, while only perovskite phase grows in films pyrolyzed at temperatures lower than 300 °C. For pyrochlore-free PZT thin films, a small (100)-orientation tendency near the film-substrate interface was observed. Finally, we demonstrate the existence of a self-polarization effect in the studied PZT thin films. The increase of self-polarization with the film thickness increasing from 200 nm to 710 nm suggests that Schottky barriers and/or mechanical coupling near the film-substrate interface are not primarily responsible for the observed self-polarization effect in our films. © 2013 AIP Publishing LLC.

Composição de cores através da calibração radiométrica e fotométrica de LEDs: Teoria e experimento

In the present work, the basic concepts of radiometric, photometric and colorimetric calibration are presented, which were applied to three light-emitting diodes (LEDs) used to compose the different color sensations that the human eye perceives in the visible region of the electromagnetic spectrum. In this sense, an experimental setup comprising a LED drive circuit and a home-made integrating sphere was assembled for the initial radiometric and photometric calibration as well as to obtain a set of intensity and spectral combinations associated to different colorimetric CIE (Commission Internationale de l'Eclairage) coordinates. The reader can, therefore, understand, in a simple manner, the process of color composition inside a color monitor or display picture element (pixel ). © Sociedade Brasileira de Física.

Performance of laying hens and economic viability of different climatization systems

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Esforço de escavação e teor de lipídios em rainhas da formiga cortadeira Atta sexdens rubropilosa

Nest digging spends a lot of energy existing a question about how much energy is required to dig the tunnel and initial chamber. It was hypothesized that the lipid content is used during nest digging. This hypothesis was tested by comparing the consequences of increasing digging effort in queens that were experimentally stimulated to excavate a complete founding nest either once, twice or three times consecutively, compared to control queens that didn't dig. Weight and lipid content of queens were quantified. Results showed that, in contrast with the initial expectations, weight and lipid content were not affected by the increased digging effort in the experimentally-induced successive excavations. It was conclude that the excavation by the queens did not affect the percentages of lipids and consequently the energy content, in their bodies. Probably, energy resources for the excavation wasn't originated from lipid reserves, but from other energy sources, perhaps carbohydrates.

Fontes e doses de nitrogênio na nutrição, produção e qualidade do feijoeiro

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Resposta do milho à adição de níveis de fitomassa de Brachiaria decumbens Stapf e nitrogênio em latossolo vermelho

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Produção de plantas de arroz sob a ação de silício e nitrogênio

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)